Pliocene-Pleistocene distribution of benthic foraminifers from ODP Hole 110-672A (Table 2)

Site 672 is located on the Atlantic abyssal plain to the east of the Lesser Antilles forearc region. It serves as a stratigraphic reference section for sediments entering the Barbados accretionary prism. A relatively complete Pliocene through lower Pleistocene section was recovered from Site 672 that contains a moderately well-preserved population of benthic foraminifers. Q-mode factor analysis of the benthic population data identified three Pliocene-Pleistocene assemblages that inhabited this site. The Factor 1 fauna, characterized by Nuttallides umboniferus, is commonly associated with the presence of Antarctic Bottom Water (AABW). The Factor 2 assemblage is characterized by Globocassidulina subglobosa, Epistominella exigua, and a combined category of unilocular species. The Factor 3 assemblage is characterized by Epistominella exigua, and Planulina wuellerstorfi. The Factor 2 and 3 faunas are associated with bottom water significantly warmer than that preferred by the Factor 1 assemblage. The distribution of these assemblages has been used to distinguish three climatic intervals in the abyssal environment during the Pliocene-Pleistocene. An early Pliocene warm interval occurred from the Ceratolithus rugosus Subzone to the middle of the Discoaster tamalis Subzone. The upper Pliocene is characterized by oscillations between the Factor 1 and Factor 2 assemblages, which suggests climatic deterioration and increased pulses of AABW flow. The persistence of an essentially modern (Factor 1) fauna throughout the early Pleistocene suggests full glacial development at both poles and a substantial volume of AABW production.

Strength and deformation behavior of ODP Leg 110 sediments

The shape and morphology of the northern Barbados Ridge complex is largely controlled by the sediment yield and failure behavior in response to high lateral loads imposed by convergence. Loads in excess of sediment yield strength result in nonrecoverable deformations within the wedge, and failure strength acts as an upper limit beyond which stresses are released through thrust faults. Relatively high loading rates lead to delayed consolidation and in-situ pore pressures greater than hydrostatic. The sediment yield and failure behavior is described for any stress path by a generalized constitutive model. A yield locus delineates the onset of plastic (non-recoverable) deformation, as defined from the isotropic and anisotropic consolidation responses of high-quality 38-mm triaxial specimens; a failure envelope was obtained by shearing the same specimens in both triaxial compression and extension. The yield locus is shown to be rotated into extension space and is centered about a K-line greater than unity, suggesting that the in-situ major principal stress has rotated into the horizontal plane, and that the sediment wedge is being subjected to extensional effective stress paths.

Bulk and clay mineralogy of ODP Leg 110 holes

The mineralogy of both bulk- and clay-sized fractions of samples from Sites 671, 672, and 674 of ODP Leg 110 was determined by X-ray diffraction. The major minerals include quartz, calcite, plagioclase feldspar, and the clay minerals smectite, illite, and kaolinite. The smectite is a dioctahedral montmorillonite and is derived primarily from degradation of volcanic ash. Percentage of smectite varies with sediment age; Miocene and Eocene sediments are the most smectite-rich. High smectite content tends to correlate with elevated porosity, presumably because of the ability of smectite clays to absorb significant amounts of interlayer water. Because of a change in physical properties, the decollement zone at Site 671 formed in sediments immediately subjacent to a section of smectite-rich, high-porosity, Miocene-age sediments. Sediments above the decollement at Site 671, as well as all sediments analyzed from Sites 672 and 674, contain nearly pure smectite characteristic of the alteration of volcanic ash. Within the decollement zone and underthrust sequence, however, the smectite contains up to 65% illite interlayers. Although the illite/smectite could be interpreted as detrital clay derived from South America, its absence in the sediments stratigraphically equivalent to the decollement and underthrust sequences at Sites 672 and 674 favors the interpretation that it originated by diagenetic alteration of pre-existing smectite similar to that in the overlying sediments. A significant percentage of the freshening of the pore waters observed in these zones could be due to the water released during smectite dehydration.