National report of the frame survey 2010 on the Uganda side of Lake Victoria

This is a report on the results of the Frame Survey conducted in the Uganda side of Lake Victoria during August 2010 by the LVFO Institutions, namely: the Department of Fisheries Resources (DFR) Uganda and the National Fisheries Resources Research Institute (NaFIRRI) in close collaboration with the District Fisheries offices of Busia, Bugiri, Mayuge, Jinja, Mukono, Kampala, Wakiso, Mpigi, Masaka, Kalangala and Rakai. The authors are grateful to the LVEMP II, for providing funds for the survey and the LVFO secretariat coordination. Fisheries Frame surveys have been carried out on Lake Victoria biannually since 2000 to determine the number of fishers, fish landing sites, and facilities at the landing sites, as well as the composition of fishing crafts, their mode of propulsion, fishing gears and the fish species they target. This information is used to guide development and management of the lake’s fisheries. Following the reorganisation of landing sites into Beach Management Units (BMUs), the number of landing sites decreased from 597 in 2000 to 435 in 2008. The survey in 2010 showed an increase to 503 landing sites, an indication that new landing sites are coming up. The fish landing sites continue to have inadequate facilities such as fish shades, cold rooms to service the fisheries industry and very few (5%) have access to electricity and 32% had access to all weather roads. There has been some progressive improvement in the landing site coverage of basic hygiene and sanitation facilities, especially public toilet facilities from 17% in 2000 to 39% in 2010; and portable water from 4% to 17% respectively. However more effort is required to cover all landing sites. Most landing sites (83%) have access to mobile phone networks which eases communication. 46% of landing sites had access to a Health clinic and 64% had a Primary school within a radius of 2 km.

Modeling of MOS-side carrier injection in trench-gate IGBTs

A compact trench-gate IGBT model that captures MOS-side carrier injection is developed. The model retains the simplicity of a one-dimensional solution to the ambipolar diffusion equation, but at the same time captures MOS-side carrier injection and its effects on steady-state carrier distribution in the drift region and on switching waveforms. © 2007 IEEE.

Using a semiconductor optical amplifier integrated with a pump laser for mid-span spectral inversion and wavelength conversion

A semiconductor optical amplifier monolithically integrated with a distributed feedback pump laser is used for non-degenerate four wave mixing applications. Experimental results are presented which illustrate the use of this compact device for both wavelength conversion and dispersion compensation applications at high data rates.

A novel design of Thermally Actuated Magnetization Flux pump for high temperature superconducting bulks

High temperature superconductors, such as melt-processed YBCO bulks, have great advantages on trapping strong magnetic fields in liquid nitrogen. To enable them to function well, there are some traditional ways of magnetizing them, in which the YBCO bulks are magnetized instantly under a very strong source of magnetic field. These ways would consume great amounts of power to make the superconductors trap as much field as possible. Thermally Actuated Magnetization (TAM) Flux pump has been proved a perfect substitution for these expensive methods by using a relatively small magnet as the source. In this way, the field is developed gradually over many pulses. Unlike conventional flux pumping ways, the TAM does not drive the superconductor normal during the process of magnetization. In former experiments for the flux pump, some fundamental tests were done. In this paper, the experiment system is advanced to a new level with better temperature control to the thermal waves moving in the Gadolinium and with less air gap for the flux lines sweeping through the superconductor. This experiment system F leads to a stronger accumulation of the magnetic field trapped in the YBCO bulk. We also tried different ways of sending the thermal waves and found out that the pumping effect is closely related to the power of the heaters and the on and off time. © 2010 IEEE.

Biodiversity and socio-economic information of selected areas of Sri Lankan side of the Gulf of Mannar

Rapid biodiversity and socio-economic studies of the Gulf of Mannar were required as part of the process to propose the Sri Lankan side as a Biosphere Reserve. These included livelihoods; land use; infrastructure; biodiversity; agriculture; fisheries; archaeological and cultural significance; and development and environmental issues.

National report of the frame survey 2012 on the Uganda side of Lake Victoria

This is a report on the results of the Frame Survey conducted in the Uganda side of Lake Victoria during August 2012 by the LVFO Institutions, namely: the Department of Fisheries Resources (DFR) Uganda and the National Fisheries Resources Research Institute (NaFIRRI) in close collaboration with the District Fisheries offices of Busia, Bugiri, Namayingo, Mayuge, Jinja, Buvuma, Buikwe, Mukono, Kampala, Wakiso, Mpigi, Kalungu, Masaka, Kalangala and Rakai. In the 2012 Frame survey some indicators of fishing effort including e.g. number of fishers, fishing crafts and long line hooks increased; whereas others like the number of gillnets less than 5 inches decreased by 10.4% from that recorded in 2010. The other indicators of fishing effort, which showed decrease in 2012 included illegal beach seines and undersized gillnets (<5 inch mesh size). However, a large proportion (66%) of long line hooks recorded in the 2012 survey were in the smallest size range (hook size >10), which target small Nile perch. The number of other illegal gears, i.e. cast nets and monofilament gillnets showed modest increases (25%) between 2010 and 2012 while beach seines decrease by 15%. Recent crackdown on illegal fishing activities as part of measures for recovery of the Nile perch stocks which are faced with depletion appear to have had an impact but much more needs to be done to eradicate illegal fishing. The fisheries in the Ugandan waters have remained predominantly near shore with 61% of all fishing crafts using paddles out of which 17% were tiny three plank, flat bottomed boats locally known as parachutes. The 2012 survey shows an increase in the number of fishing crafts using sails by 65% from 682 in 2010 to 1125 in 2012. This is an encouraging trend as more fishers are able to access distant fishing grounds using free wind power. The Mukene fishery in the Ugandan waters of Lake Victoria remained underdeveloped comprising only 15.2% of all fishing crafts, of which 31% were motorised which is a great improvement from the situation recorded in 2010. The Catamarans increased to 18 with a majority in Buikwe district where there is a private investor fishing specifically for Mukene. The Catamarans in Kalangala were reported not to be working because of the high operating cost compared to ordinary Mukene fishing boats.

Optimization of thermal material in a flux pump system with high temperature superconductor

Superconductors are known for the ability to trap magnetic field. A thermally actuated magnetization (TAM) flux pump is a system that utilizes the thermal material to generate multiple small magnetic pulses resulting in a high magnetization accumulated in the superconductor. Ferrites are a good thermal material candidate for the future TAM flux pumps because the relative permeability of ferrite changes significantly with temperature, particularly around the Curie temperature. Several soft ferrites have been specially synthesized to reduce the cost and improve the efficiency of the TAM flux pump. Various ferrite compositions have been tested under a temperature variation ranging from 77K to 300K. The experimental results of the synthesized soft ferrites-Cu 0.3 Zn 0.7Ti 0.04Fe 1.96O 4, including the Curie temperature, magnetic relative permeability and the volume magnetization (emu/cm3), are presented in this paper. The results are compared with original thermal material, gadolinium, used in the TAM flux pump system.-Cu 0.3 Zn 0.7Ti 0.04 Fe 1.96O 4 holds superior characteristics and is believed to be a suitable material for next generation TAM flux pump. © 2011 IEEE.

Study of the turbulence in the air-side and water-side boundary layers in experimental laboratory wind induced surface waves

This study detailed the structure of turbulence in the air-side and water-side boundary layers in wind-induced surface waves. Inside the air boundary layer, the kurtosis is always greater than 3 (the value for normal distribution) for both horizontal and vertical velocity fluctuations. The skewness for the horizontal velocity is negative, but the skewness for the vertical velocity is always positive. On the water side, the kurtosis is always greater than 3, and the skewness is slightly negative for the horizontal velocity and slightly positive for the vertical velocity. The statistics of the angle between the instantaneous vertical fluctuation and the instantaneous horizontal velocity in the air is similar to those obtained over solid walls. Measurements in water show a large variance, and the peak is biased towards negative angles. In the quadrant analysis, the contribution of quadrants Q2 and Q4 is dominant on both the air side and the water side. The non-dimensional relative contributions and the concentration match fairly well near the interface. Sweeps in the air side (belonging to quadrant Q4) act directly on the interface and exert pressure fluctuations, which, in addition to the tangential stress and form drag, lead to the growth of the waves. The water drops detached from the crest and accelerated by the wind can play a major role in transferring momentum and in enhancing the turbulence level in the water side.On the air side, the Reynolds stress tensor's principal axes are not collinear with the strain rate tensor, and show an angle α σ≈=-20°to-25°. On the water side, the angle is α σ≈=-40°to-45°. The ratio between the maximum and the minimum principal stresses is σ a/σ b=3to4 on the air side, and σ a/σ b=1.5to3 on the water side. In this respect, the air-side flow behaves like a classical boundary layer on a solid wall, while the water-side flow resembles a wake. The frequency of bursting on the water side increases significantly along the flow, which can be attributed to micro-breaking effects - expected to be more frequent at larger fetches. © 2012 Elsevier B.V.