Image quality assessment in digital mammography: part I. Technical characterization of the systems.

In many European countries, image quality for digital x-ray systems used in screening mammography is currently specified using a threshold-detail detectability method. This is a two-part study that proposes an alternative method based on calculated detectability for a model observer: the first part of the work presents a characterization of the systems. Eleven digital mammography systems were included in the study; four computed radiography (CR) systems, and a group of seven digital radiography (DR) detectors, composed of three amorphous selenium-based detectors, three caesium iodide scintillator systems and a silicon wafer-based photon counting system. The technical parameters assessed included the system response curve, detector uniformity error, pre-sampling modulation transfer function (MTF), normalized noise power spectrum (NNPS) and detective quantum efficiency (DQE). Approximate quantum noise limited exposure range was examined using a separation of noise sources based upon standard deviation. Noise separation showed that electronic noise was the dominant noise at low detector air kerma for three systems; the remaining systems showed quantum noise limited behaviour between 12.5 and 380 µGy. Greater variation in detector MTF was found for the DR group compared to the CR systems; MTF at 5 mm(-1) varied from 0.08 to 0.23 for the CR detectors against a range of 0.16-0.64 for the DR units. The needle CR detector had a higher MTF, lower NNPS and higher DQE at 5 mm(-1) than the powder CR phosphors. DQE at 5 mm(-1) ranged from 0.02 to 0.20 for the CR systems, while DQE at 5 mm(-1) for the DR group ranged from 0.04 to 0.41, indicating higher DQE for the DR detectors and needle CR system than for the powder CR phosphor systems. The technical evaluation section of the study showed that the digital mammography systems were well set up and exhibiting typical performance for the detector technology employed in the respective systems.

Update & Career Technical Education, 2000

Departmental report produced by the Department of Education.

Investigation of the Modified Beam-in-Slab Bridge System, Technical Report, 2004, Vol. 1

Technical Report

Implementing the Mechanistic-Empirical Pavement Design Guide: Technical Report, May 2005

With the release of the new Mechanistic-Empirical Pavement Design Guide (MEPDG), pavement design has taken a “quantum” leap forward. The current 1993 design guide is solidly based on the empirical interpretation of the results of the 1960 American Association of State Highway and Transportation Officials (AASHTO) Road Test. This report seeks to outline the technical aspects of the new MEPDG. Full detail is essentially impossible and impractical, since the release of the MEPDG was accompanied by eighteen volumes of technical justification and background. Consequently, this report seeks only to provide a potential user with a practical understanding of the workings of the new guide, with only sufficient technical depth to aid in understanding.

Malaria vaccines - The long synthetic peptide approach: Technical and conceptual advancements.

This review describes the advances in malaria antigen discovery and vaccine development using the long synthetic peptide platforms that have been made available during the past 5 years. The most recent technical developments regarding peptide synthesis with the optimized production of large synthetic fragments are discussed. Clinical trials of long synthetic peptides are also reviewed. These trials demonstrated that long synthetic peptides are safe and immunogenic when formulated with various adjuvants. In addition, long synthetic peptides can elicit an antibody response in humans and have demonstrated inhibitory activity against parasite growth in vitro. Finally, new approaches to exploit the abundance of genomic data and the flexibility and speed of peptide synthesis are proposed.

Tariff Equivalent of Technical Barriers to Trade with Imperfect Substitution and Trade Costs, November 2005

The price-wedge method yields a tariff-equivalent estimate of technical barriers to trade (TBT). An extension of this method accounts for imperfect substitution between domestic and imported goods and incorporates recent findings on trade costs. We explore the sensitivity of this revamped TBT estimate to its key determinants (substitution elasticity, preference for home good, and trade cost). We use the augmented approach to investigate the ongoing US-Japan apple trade dispute and find that removing the Japanese TBT would yield limited export gains to the United States. We then draw policy implications of our findings.

Technical note: Preliminary estimation of rockfall runout zones

Rockfall propagation areas can be determined using a simple geometric rule known as shadow angle or energy line method based on a simple Coulomb frictional model implemented in the CONEFALL computer program. Runout zones are estimated from a digital terrain model (DTM) and a grid file containing the cells representing rockfall potential source areas. The cells of the DTM that are lowest in altitude and located within a cone centered on a rockfall source cell belong to the potential propagation area associated with that grid cell. In addition, the CONEFALL method allows estimation of mean and maximum velocities and energies of blocks in the rockfall propagation areas. Previous studies indicate that the slope angle cone ranges from 27° to 37° depending on the assumptions made, i.e. slope morphology, probability of reaching a point, maximum run-out, field observations. Different solutions based on previous work and an example of an actual rockfall event are presented here.

The Law of Impersonal Transactions: Meaning and Difficulties

Most economic interactions happen in a context of sequential exchange in which innocent third parties suffer information asymmetry with respect to previous "originative" contracts. The law reduces transaction costs by protecting these third parties but preserves some element of consent by property right holders to avoid damaging property enforcement-e.g., it is they as principals who authorize agents in originative contracts. Judicial verifiability of these originative contracts is obtained either as an automatic byproduct of transactions or, when these would have remained private, by requiring them to be made public. Protecting third parties produces a sort of legal commodity which is easy to trade impersonally, improving the allocation and specialization of resources. Historical delay in generalizing this legal commoditization paradigm is attributed to path dependency-the law first developed for personal trade-and an unbalance in vested interests, as luddite legal professionals face weak public bureaucracies.

Difficulties of familes in caring for children and adolescents with mental disorders: an integrative review

Objective To identify the difficulties of families with children and/or adolescents with mental disorder. Method This is an integrative review. In December 2013, an electronic search was performed on Latin American Caribbean Literature on Health Sciences databases (LILACS) and on Electronic Medicus Index of the National Library of Medicine (MEDLINE) indexed in the Health Virtual Library (BVS) using a combination of descriptors and boolean operators as follows: mental disorders and child or adolescent and caregivers and/not health staff. Results 557 studies were identified, of which 15 were selected for this study. The findings indicated difficulties related to the care for or to interaction with children/adolescents with mental disorder. Conclusion The studies revealed difficulties related to everyday practices of care and feelings expressed during care practices, as well as in relationships with children or adolescents with mental disorder.



Offshoring and directed technical change

To study the short-run and long-run implications on wage inequality, we introducedirected technical change into a Ricardian model of offshoring. A unique final good isproduced by combining a skilled and an unskilled product, each produced from a continuumof intermediates (tasks). Some of these tasks can be transferred from a skill-abundant Westto a skill-scarce East. Profit maximization determines both the extent of offshoring andtechnological progress. Offshoring induces skill-biased technical change because it increasesthe relative price of skill-intensive products and induces technical change favoring unskilledworkers because it expands the market size for technologies complementing unskilled labor.In the empirically more relevant case, starting from low levels, an increase in offshoringopportunities triggers a transition with falling real wages for unskilled workers in the West,skill-biased technical change and rising skill premia worldwide. However, when the extentof offshoring becomes sufficiently large, further increases in offshoring induce technicalchange now biased in favor of unskilled labor because offshoring closes the gap betweenunskilled wages in the West and the East, thus limiting the power of the price effectfueling skill-biased technical change. The unequalizing impact of offshoring is thus greatestat the beginning. Transitional dynamics reveal that offshoring and technical change aresubstitutes in the short run but complements in the long run. Finally, though offshoringimproves the welfare of workers in the East, it may benefit or harm unskilled workers inthe West depending on elasticities and the equilibrium growth rate.

Technical inefficiency and public capital in US States: A stochastic frontier approach

This paper estimates a translog stochastic frontier production function in the analysis of all 48 contiguous U.S. states in the period 1970-1983, to attempt to measure and explain changes in technical efficiency. The model allows technical inefficiency to vary over time, and inefficiency effects to be a function of a set of explanatory variables in which the level and composition of public capital plays an important role. Results indicated that U.S. state inefficiency levels were significantly and positively correlated with the ratio of public capital to private capital. The proportion of public capital devoted to highways is negatively correlated with technical inefficiency, suggesting that not only the level but also the composition of public capital influenced state efficiency.