1000 resultados para Soro de Leite
Resumo:
Leaking of diesel oil from gas stations is frequent in Brazil. The presence of polycyclic aromatic hydrocarbons (PAHs), which are highly toxic is an indication of contamination by heavy hydrocarbons from diesel oil. Here were present the determination of the distribution coefficient (Kd) of benzo(a)pyrene (the most carcinogenic of the PAHs) in tropical soils using the sorption isotherm model. The sorption curves acquired for benzo(a)pyrene were of the S-type, probably due to the water/methanol experimental conditions. The sorption curves allowed calculation of the distribution coefficient (Kd). The experimental Kd values were lower than those calculated from literature Koc values (partition coefficient normalized by organic carbon), due mainly to the cosolvency effect and the percentage of organic matter and clay in soil.
Resumo:
This work presents a little of the history which marked the development of the dairy industry in Brazil and in the world. It shows problems and solutions related to the preservation of milk. In general, it also describes the traditional manufacture of cheese and applications of membrane technology as an auxiliary tool in the processing of some types of cheese.
Resumo:
A micellar electrokinetic chromatographic method (MEKC) is described for determining residues of amphenicols(chloramphenicol,thiamphenicol and florfenicol) in bovine milk. MEKC is conducted by using a separation buffer consisting of 20 mM Na2HPO4, 10 mM Na2B4O7, 50 mM SDS at pH 8.0; UV detection at 210 nm and 10 kV of voltage. The limit of detection ranged from 4.3-5.3 µg L-1. The MEKC method was applied for the simultaneous determination of amphenicols in milk samples spiked with amphenicols at three concentration levels: 10, 30 and 50 µg L-1. Recoveries ranging from 91-105% were obtained by following a simple extraction/preconcentration procedure.
Resumo:
A method for HPLC determination of sulfadimethoxyne in milk is presented. The analyte isolation and concentration were performed by solid-phase extraction through a C-8 cartridge, pre-conditioned with hexane, methanol and water and eluted with MeOH. The recovery determination was done with a spiked solution of 20, 50 or 100 µg L-1. In this concentration range, the recovery was 83.2% with a RDS of 15.4%. For quantification, a Zorbax Eclipse XDB-C8 (4.6 mm x 150 mm, 5 µm), a mobile phase of MeCN: 0.01 mol L-1 KH2PO4 aq. (1:4), and a variable wavelength detector (275 nm) were used.
Resumo:
Least-squares support vector machines (LS-SVM) were used as an alternative multivariate calibration method for the simultaneous quantification of some common adulterants found in powdered milk samples, using near-infrared spectroscopy. Excellent models were built using LS-SVM for determining R², RMSECV and RMSEP values. LS-SVMs show superior performance for quantifying starch, whey and sucrose in powdered milk samples in relation to PLSR. This study shows that it is possible to determine precisely the amount of one and two common adulterants simultaneously in powdered milk samples using LS-SVM and NIR spectra.
Resumo:
Sulfur emission in coal power generation is a matter of great environmental concern and limestone sorbents are widely used for reducing such emissions. Thermogravimetry was applied to determine the effects of the type of limestone (calcite and dolomite), particle size (530 and 650 µm) and atmosphere (air and nitrogen) on the kinetics of SO2 sorption by limestone. Isothermal experiments were performed for different temperatures (650 to 950 ºC), at local atmospheric pressure. The apparent activation energies, as indicated by the slope of the Arrhenius plot, resulted between 3.03 and 4.45 kJ mol-1 for the calcite, and 11.24 kJ mol-1 for the dolomite.
Resumo:
Human milk fat is essential for development of newborn infants. Many studies detail chemical characteristics of human milk fat; however there are no studies about its physical properties. The objective of this work was to analyze the centesimal composition of human milk and to compare the calculated energy value with the estimated energy by the creamatocrit method. Chemical composition and physical properties of human milk lipids and Betapol - a structured lipid - were also studied. The results showed that energy values of human milk estimated by creamatocrit and calculated by the centesimal composition didn't present significant correlation. Human milk lipids and Betapol presented distinct physico-chemical properties.
Resumo:
Deficiency of micronutrients is a public health problem. Cow milk is a source of retinol. The objective of this study is to evaluate the retinol concentration in milk commercialized in Natal/RN. Ten samples were taken of each brand of UHT milk. Vitamin content was determined by HPLC using the Shimadzu LC-10 AD Chromatograph, coupled to the Shimadzu SPD 10 A UV-VIS Detector and the Shimadzu C-R6A Chromatopac Integrator with Shim-pack CLC-ODS (M) column, measuring 4.6 mm x 25 cm. The mobile phase was 100% methanol, with a flow of 1 mL/min. The mean retinol concentration varied between 22.7 ± 4.9 µg/100 mL and 44.1 ± 4.1 µg/100 mL, with the differences statistically significant (p<0.001). Only one of the 7 brands had retinol concentration below the normal requirements for human consumption.
Resumo:
The objective of this paper was to evaluate the modifications in milkfat properties with the addition of sunflower oil (SO) and phytosterol esters (PE) and chemical interesterification. Fatty acid composition, softening point and consistency were determined. The saturation degree of milkfat decreased with the addition of SO and PE. Consequently, milkfat presented lower softening point and consistency. Chemical interesterification caused an increase in softening point due to the formation of higher amounts of trissaturated triacylglycerols with rearrangement. The incorporation of unsaturated fatty acids from SO and PE by milkfat triacylglycerols after chemical reaction caused linearization of consistency curves.
Resumo:
Valproic acid (VA) is a drug used to control seizures in several epileptic conditions. In VA pharmacotherapy, therapeutic drug monitoring is recommended to obtain adequate seizure control and avoid toxicity. The aim of this study was to validate a method for the determination of valproic acid in serum, employing high performance liquid chromatography with diode array detection (HPLC-DAD), after derivatization with phenacyl bromide. The calibration curve (y=0.0133x-0.0025) presented good linearity with r²=0.9999. Accuracy (101-115%), intra-assay precision (4.53-8.15%) and inter-assay precision (3.15-6.77%) were acceptable. The quantification limit was 2.0 µg/mL. The method presented similar results to enzyme immunoassay.
Resumo:
Human milk has characteristics of great importance for the newborn. Its composition shows all nutrients in quantity and quality needed, in addition to providing protection against infections and allergies and stimulating the immune system. Therefore, the composition of fatty acids and their distribution in the triacylglycerols are targets of studies on infant formula, and the triacylglycerols of human milk fat should serve as a model for the lipid components. This review aims to report studies of technology in lipids in order to produce structured lipids as substitutes of human milk fat.
Resumo:
Little information is available on the behavior of thiamethoxam in soils, whereas many studies show the effect of phosphate and vinasse in soils in Brazil. This study evaluated the sorption, desorption and retention of thiamethoxam in vinasse- and phosphate-amended samples of a dystrophic Red-Yellow Latosol (LVAd) and a distroferric Red Latosol (LVdf). The LVAd presented higher sorption of thiamethoxam. Phosphate did not affect the sorption or retention and vinasse increased the interaction of the compound with the soil particles, reducing desorption to the soil solution.
Resumo:
This work presents a detailed study about the sorption of crystal violet (CV) cationic dye onto polyether type polyurethane foam (PUF). The sorption process was based on the formation of an ionic-pair between cationic dye and dodecylsulfate anion (SDS), which presented high affinity by PUF. Set-up employed in the study was built up by adjusting a 200 mg cylinder of PUF to the arm of an overhead stirrer. The system was characterized in relation to equilibrium and kinetic aspects and it was modeled by employing Langmuir and Freundlich isotherms. Obtained results showed that the ratio between SDS and MB concentrations played an important role on the sorption process. According to results found it was possible to retain up to 3.4 mg of dye from 200 mL of a 5.0 x 10-5 mol L-1 CV solution containing 1.25 x 10-4 mol L-1 SDS, which represented a removal efficiency of around 92%.
Resumo:
The sorption of thiamethoxam in a Brazilian Oxisol was determined in soil samples with and without organic matter for two different dephs (0-0.1 and 0.4-0.7 m). The results indicated a predominant sorption of thiamethoxam on soil without organic matter. The following Kd values of 4.25 mL g-1 (0-0.1 m, r² = 0.8534) and 5.30 mL g-1 (0.4-0.7 m, r² = 0.9884) and Kf values, 7.65 mL g-1 (0-0.1 m, r² = 0.9623) and 7.72 mL g-1 (0.4-0.7 m, r² = 0.9775) were obtained. Those sorption coefficient values indicated a small interaction between thiamethoxam for both original soil and soil without organic matter.
Resumo:
This work proposes an analytical procedure for direct determination of calcium, magnesium, manganese and zinc in buffalo milk by flame atomic absorption spectrometry (FAAS). Samples were diluted with a solution containing 10% (v/v) of water-soluble tertiary amines (CFA-C) at pH 8. For comparison, buffalo milk samples were digested with HNO3 and H2O2. According to a paired t-test, the results obtained in the determination of Ca, Mg, Mn and Zn in digested samples and in 10% (v/v) CFA-C medium were in agreement at a 95% confidence level. The developed procedure is simple, rapid, decrease the possibility of contamination and can be applied for the routine determination of Ca, Mg, Mn and Zn in buffalo milk samples without any difficulty caused by matrix constituents, such as fat content, and particle size distribution in the milk emulsion.