An isolate of Apple stem grooving virus associated with Cleopatra mandarin fruit intumescence

A citrus tatter leaf isolate (CTLV-Cl) of Apple stem grooving virus (ASGV) has been found to be associated with a fruit rind intumescence in Cleopatra mandarin (Citrus reshni) in Limeira (SP). The CTLV-Cl was mechanically transmitted to the main experimental herbaceous hosts of CTLV. Chenopodium quinoa and C. amaranticolor reacted with local lesions and systemic symptoms while other test plants reacted somewhat differently than what is reported for CTLV. A pair of primers designed for specific detection of ASGV and CTLV amplified the expected 801 bp fragment from the CTLV-Cl-infected plants. Typical capillovirus-like particles were observed by the electron microscope in experimentally infected C. quinoa and C. amaranticolor leaves.

Minimum number of assessment times to compare chemical control treatments for papaya fruit anthracnose

The chemical treatment evaluation in the field to control post-harvest fruit anthracnose (Colletotrichum gloeosporioides) requires a suitable disease incidence assessment on harvested papaya (Carica papaya) fruits. The minimum number of papaya fruit harvests was determined for valid treatment comparison in field trials for anthracnose chemical control. Repeatability analysis was done using previously published data. The coefficient determination (R²) estimate range, using four methods, and based on means of 12 assessment times, was 92.58 < R² < 94.45%. The number of assessment times required for R²=90% varied from seven to nine. The R² values of 85.1 < R² < 91.3% estimated by ANOVA suggested that any seven successive assessment times were sufficient for treatment comparison.

Protection between strains of Passion fruit woodiness virus in sunnhemp

The main objective of the present study was to evaluate the effect of the sunhemp (Crotalaria juncea) host species on the protective ability of two mild strains of Passion fruit woodiness virus (PWV), named F-101 and F-144, which had failed to protect passion flowers (Passiflora edulis f. flavicarpa) in previous experiments. The nucleotide sequences of the capsid protein (CP) gene and the 3'-non-translated region (3'-NTR) of these mild strains and the severe strain of PWV-SP were compared to confirm their relationship. The results of two protective tests with sunhemp plants in the greenhouse and one test under field conditions showed that all plants infected with either mild strain were protected against infection and/or symptom expression of the severe strain of PWV-SP. Evaluation of the relative concentration of the mild strains in sun hemp leaves showed an apparent uniformity in virus distribution in the leaf tissues, different than that which was previously reported for these mild strains in passion flower leaves. These results agree with previous studies that showed the effect of the concentration of the protective strains and the host species in the protection process.

Guava fruit loss caused by rust

The aim of this paper was to estimate the loss caused by rust (Puccinia psidii) to 'Paluma' guava production in orchards located in Rio de Janeiro State. The disease intensity on the reproductive organs of plants was observed during two chemical control experiments carried out in 2003 and 2004. The loss was estimated based on simple linear regression and the production reduction (fruit number and weight ha-1) on the incidence of diseased buds and fruits. In the first experiment, no relationship was established between incidence of diseased buds and loss since there was a delay in spraying and the incidence of buds showing rust was high (mean of 47%) at the beginning of flowering. In the second experiment (2003-2004), spraying occurred at the beginning of the epidemics and there was a linear relationship between incidence of diseased buds and loss, justifying fungicide intervention at this stage. For the fruiting stage, a significant relationship was found between incidence of diseased fruits and loss in both experiments. In the absence of chemical control, rust reduced fruit production by around 90%.

FRUIT MORPHOLOGY AND PRODUCTIVITY OF BABASSU PALMS IN NORTHERN MINAS GERAIS STATE, BRAZIL1

ABSTRACT The objectives of this study were to morphologically characterize fruits of the babassu palm tree (Attalea vitrivir) and to estimate their productivity in the north of Minas Gerais State, Brazil. Twenty mature fruits were collected from 10 plants in three different areas in Januária, Minas Gerais. Eighteen biometric parameters of the fruits were measured, the oil contents of the seeds was determined, the adherence to normal distribution was evaluated, distribution frequencies were evaluated and the effects of individuals and areas on the variables and the correlations between them were analyzed. The production of fruit bunches per plant and the number of fruits per bunch from 10 plants were quantified in three areas and the potential production under both natural harvesting and cultivation conditions were estimated. Significant differences were found among all of the biometric parameters examined between the different individuals and the different areas, which shows wide morphological variability in the fruits. The average oil content was 45.7%, but with significant differences among individuals. The observed variability favors the selection of productive individuals in genetic improvement programs. The potential productivity of endocarps and oil based on a density of 400/plants per hectare would be respectively 6.4 and 1.2 tons/ha, which indicates the possibility of using A. vitrivir for producing charcoal, bio fuels, and for carbon fixation.

Solar drying of jack fruit almonds

Dryers heated by solar energy have been constructed and used in drying whole and half jack fruit almonds. The samples were dried during the day in direct sun and in the conventional solar dryer prepared for this purpose. Another piece of equipment was built for reception and accumulation of sun energy in a body of water, which was used as a heat source for night drying. The drying with the sun energy was compared with artificial drying. The jack fruit almonds were dried whole, half, with pellicle and without it. The storage of solar energy in water was technically viable for use in night drying. The drying by combining solar dryers in the day and night periods were completed in approximately 35 hours, and were equivalent to artificial drying between 40ºC and 70ºC. Almond cut in half and the pellicle removed reduced the drying time.

Technical and economic indicators of the yellow passion fruit tree irrigated with underground water supply

The research aimed to quantify technical and economic indicators of yellow passion fruit tree irrigated with fractions of irrigation with underground source of water, to generate information that helps farmers in decision making on the implementation of investment in irrigated fruit growing (yellow passion fruit). For this purpose, we used the passion fruit crop irrigated with Microjet type irrigation system, with conducting system in simple espaliers. The treatments consisted of five hours of application of the depth of water required by the crop with irrigation frequency of two days. The results showed that the highest yield (16660kg ha-1) was obtained with the fractionation of irrigation twice a day (50% to 7h and 50% to 21h30), which provided an increase in productivity of 54%, demonstrating the financial viability and being highly profitable to the interest rate of 2% per year, with low sensitivity of financial risk to real interest rates above the prevailing market.

Pressure drop coefficients for elliptic and circular sections in one, two and three-row arrangements of plate fin and tube heat exchangers

The objective of the present work is the experimental determination of pressure drop coefficients (loss coefficients) for elliptic and circular sections in one, two and three-row arrangements of plate fin and tube heat exchangers. The experiments permitted to correlate the dimensionless loss coefficient with the flow Reynolds number in the rectangular channel formed by the plate fins. The experimental technique consisted of the measurement of the longitudinal pressure distribution along the flow channel, for several values of air mass flow rate. The total number of data runs, each one characterized by the flow Reynolds number, was 216. The present geometry is used in compact heat exchangers for air conditioning systems, heaters, radiators, and others. Also, it is verified the influence of the utilization of elliptic tubes, instead of circular ones, in the pressure drop. The measurements were performed for Reynolds numbers ranging from 200 to 1900.

Turbulent heat transfer and pressure drop in pinned annular regions

Experiments were performed to determine average heat transfer coefficients and friction factors for turbulent flow through annular ducts with pin fins. The measurements were carried out by means of a double-pipe heat exchanger. The total number of pins attached to the inner wall of the annular region was 560. The working fluids were air, flowing in the annular channel, and water through the inner circular tube. The average heat transfer coefficients of the pinned air-side were obtained from the experimental determination of the overall heat transfer coefficients of the heat exchanger and from the knowledge of the average heat transfer coefficients of the circular pipe (water-side), which could be found in the pertinent literature. To attain fully developed conditions, the heat exchanger was built with additional lengths before and after the test section. The inner circular duct of the heat exchanger and the pin fins were made of brass. Due to the high thermal conductivity of the brass, the small tube thickness and water temperature variation, the surface of the internal tube was practically isothermal. The external tube was made of an industrial plastic which was insulated from the environment by means of a glass wool batt. In this manner, the outer surface of the annular channel can be considered adiabatic. The results are presented in dimensionless forms, in terms of average Nusselt numbers and friction factors as functions of the flow Reynolds number, ranging from 13,000 to 80,000. The pin fin efficiency, which depends on the heat transfer coefficient, is also determined as a function of dimensionless parameters. A comparison of the present results with those for smooth sections (without pins) is also presented. The purpose of such a comparison is to study the influence of the presence of the pins on the pressure drop and heat transfer rate.

Experimental analysis of pressure drop and flow redistribution in axial flows in rod bundles

Fuel elements of PWR type nuclear reactors consist of rod bundles, arranged in a square array, and held by spacer grids. The coolant flows, mainly, axially along the rods. Although such elements are laterally open, experiments are performed in closed type test sections, originating the appearance of subchannels with different geometries. In the present work, utilizing a test section of two bundles of 4x4 pins each, experiments were performed to determine the friction and the grid drag coefficients for the different subchannels and to observe the effect of the grids in the crossflow, in cases of inlet flow maldistribution.

Drop Size Measurements in a Laboratory Scale Venturi Scrubber

Venturi scrubbers are high efficiency gas cleaners in which suspended particles are removed from gas streams by droplets formed by liquid atomisation, usually in the venturi throat. The size of the droplets formed is of fundamental importance to the performance of the equipment, both in terms of pressure drop and collection efficiency. In this study, drop sizes in a cylindrical laboratory scale venturi scrubber were measured using a laser diffraction technique. Gas velocity and liquid to gas ratios varied from 50 to 90 m/s and 0.5 to 2.0 l/m3, respectively. Water was inserted as perpendicular jets at the beginning of the throat. Measurements were performed at three positions: two located along the throat, and the last one at the end of the diffuser. The data presented here are a typical example of pneumatic atomisation and can be relevant to other industrial applications such as combustion and engine technology. Finally, results are compared to available correlations and the validity of these equations is discussed.

Pressure Drop in Vertical Core-Annular Flow

An experimental apparatus for the study of core annular flows of heavy oil and water at room temperature has been set up and tested at laboratory scale. The test section consists of a 2.75 cm ID galvanized steel pipe. Tap water and a heavy oil (17.6 Pa.s; 963 kg/m³) were used. Pressure drop in a vertical upward test section was accurately measured for oil flow rates in the range 0.297 - 1.045 l/s and water flow rates ranging from 0.063 to 0.315 l/s. The oil-water input ratio was in the range 1-14. The measured pressure drop comprises gravitational and frictional parts. The gravitational pressure drop was expressed in terms of the volumetric fraction of the core, which was determined from a correlation developed by Bannwart (1998b). The existence of an optimum water-oil input ratio for each oil flow rate was observed in the range 0.07 - 0.5. The frictional pressure drop was modeled to account for both hydrodynamic and net buoyancy effects on the core. The model was adjusted to fit our data and shows excellent agreement with data from another source (Bai, 1995).

Phenology, fruit set and dispersal of Cordia multispicata Cham., an important weed shrub of abandoned pastures in eastern Amazonia

ABSTRACT - (Phenology, fruit set and dispersal of Cordia multispicata Cham., an important weed shrub of abandoned pastures in eastern Amazonia). The reproductive ecology of the distylous tropical shrub Cordia multispicata was studied in an abandoned pasture in Paragominas County , Pará state, Brazil. It is a common species in the Amazon basin where it occurs as a weed in open and disturbed habitats. C. multispicata has many flowers per inflorescence (85 ± 12) but 84% abort before fertilization. Flowering occurs throughout the year. Fruits are small, with a red fleshy pericarp (skin-pulp) attractive to birds. Fruit set is lower during the dry season (less than 30%) and higher during the rainy season when there are many visits of insects to the flowers. Fruiting has a peak between the end of the dry season and the middle of the rainy season. Nineteen bird species were observed foraging for the fruits of C. multispicata, and 79% of those species can be considered as potential dispersal agents. The efficient seed dispersal and aggregated spatial distribution associated with some characteristics of the dispersors greatly contributed to the success of this species in abandoned pastures of eastern Amazonia.

Morphology and anatomy of the fruit and seed in development of Chorisia speciosa A. St.-Hil. - Bombacaceae

The structure of the fruit and seed in development of Chorisia speciosa are described with the main purpose of clarifying the origin and nature of the hairs that cover the seeds and aiding future taxonomical and ecological studies of the group. The fruit is an ellipsoid loculicide capsule and presents the exocarp formed by 7-10 cells layers, with very thick walls and evident simple pits. A great number of mucilage secretory cavities and ramified vascular bundles, accompanied by fibers, occur in the parenchymatic mesocarp. The endocarp derives from the ventral epidermis of the ovary wall, whose cells undergo a gradual elongation, become lignified, and constitute the trichomes which cover the mature seeds. The fruit aperture occurs by means of a suture evident in the ovarian wall in the middle region of the carpel leaf. Anatropous and bitegmic ovules, provided by a hypostase, give rise to campilotropous and bitegmic seeds. The testa is uniseriate, the exotegmen is completely formed by macrosclereids, and mucilage secretory cavities occur in the mesotegmen. The endotegmen, which is differentiated in the endothelium, is crushed in the mature seed. The plicate embryo, which occupies practically the entire seminal cavity, is found between endosperm layers, both being rich in lipids.

Seed characteristics and dispersal of dimorphic fruit segments of Cakile maritima Scopoli (Brassicaceae) population of southern Brazilian coastal dunes

Cakile maritima occurs sporadically along the southern Brazilian coast, where it is restricted to more protected sites at the base of foredunes. Somatic dimorphism in C. maritima is manifested as morphologically distinct upper and lower fruit segments (silicules). The two morphs were tested for differences in size, number of seeds, dispersal ability and natural establishment. In the C. maritima population of southern Brazil, the lower silicule has more seeds than upper silicule, and lower seeds are more likely to abort than the upper ones. Seeds from upper segments were significantly larger than those from lower ones; however, their mass ranges overlap. The mean silicule mass was not significantly different from both segments, but the silicule/seed mass ratio from upper and lower segments was significantly different. Both segments had high ability to float in sea water, more than 50% were still afloat after 70 days. Nevertheless, dispersal occurs mainly to landward due to dominant wind action. Most of the seedlings were restricted to within a one-metre radius of the mother plant, and were principally derived from lower fruit segments.