Effect of segmented anodes on the performance and plume of a hall thruster

Development of alternative propellants for Hall thruster operation is an active area of research. Xenon is the current propellant of choice for Hall thrusters, but can be costly in large thrusters and for extended test periods. Condensible propellants may offer an alternative to xenon, as they will not require costly active pumping to remove from a test facility, and may be less expensive to purchase. A method has been developed which uses segmented electrodes in the discharge channel of a Hall thruster to divert discharge current to and from the main anode and thus control the anode temperature. By placing a propellant reservoir in the anode, the evaporation rate, and hence, mass flow of propellant can be controlled. Segmented electrodes for thermal control of a Hall thruster represent a unique strategy of thruster design, and thus the performance of the thruster must be measured to determine the effect the electrodes have on the thruster. Furthermore, the source of any changes in thruster performance due to the adjustment of discharge current between the shims and the main anode must be characterized. A Hall thruster was designed and constructed with segmented electrodes. It was then tested at anode voltages between 300 and 400 V and mass flows between 4 and 6 mg/s, as well as 100%, 75%, 50%, 25%, and <5% of the discharge current on the shim electrodes. The level of current on the shims was adjusted by changing the shim voltage. At each operating point, the thruster performance, plume divergence, ion energy, and multiply charged ion fraction were measured performance exhibited a small change with the level of discharge current on the shim electrodes. Thrust and specific impulse increased by as much as 6% and 7.7%, respectively, as discharge current was shifted from the main anode to the shims at constant anode voltage. Thruster efficiency did not change. Plume divergence was reduced by approximately 4 degrees of half-angle at high levels of current on the shims and at all combinations of mass flow and anode voltage. The fraction of singly charged xenon in the thruster plume varied between approximately 80% and 95% as the anode voltage and mass flow were changed, but did not show a significant change with shim current. Doubly and triply charged xenon made up the remainder of the ions detected. Ion energy exhibited a mixed behavior. The highest voltage present in the thruster largely dictated the most probable energy; either shim or anode voltage, depending on which was higher. The overall change in most probable ion energy was 20-30 eV, the majority of which took place while the shim voltage was higher than the anode voltage. The thrust, specific impulse, plume divergence, and ion energy all indicate that the thruster is capable of a higher performance output at high levels of discharge current on the shims. The lack of a change in efficiency and fraction of multiply charged ions indicate that the thruster can be operated at any level of current on the shims without detrimental effect, and thus a condensible propellant thruster can control the anode temperature without a decrease in efficiency or a change in the multiply charged ion fraction.

Topographic and meteorological influences on spatial scaling of heavy convective rainfall in mountainous regions

Characterizing the spatial scaling and dynamics of convective precipitation in mountainous terrain and the development of downscaling methods to transfer precipitation fields from one scale to another is the overall motivation for this research. Substantial progress has been made on characterizing the space-time organization of Midwestern convective systems and tropical rainfall, which has led to the development of statistical/dynamical downscaling models. Space-time analysis and downscaling of orographic precipitation has received less attention due to the complexities of topographic influences. This study uses multiscale statistical analysis to investigate the spatial scaling of organized thunderstorms that produce heavy rainfall and flooding in mountainous regions. Focus is placed on the eastern and western slopes of the Appalachian region and the Front Range of the Rocky Mountains. Parameter estimates are analyzed over time and attention is given to linking changes in the multiscale parameters with meteorological forcings and orographic influences on the rainfall. Influences of geographic regions and predominant orographic controls on trends in multiscale properties of precipitation are investigated. Spatial resolutions from 1 km to 50 km are considered. This range of spatial scales is needed to bridge typical scale gaps between distributed hydrologic models and numerical weather prediction (NWP) forecasts and attempts to address the open research problem of scaling organized thunderstorms and convection in mountainous terrain down to 1-4 km scales.

Reactive mass transport modelling of a three-dimensional vertical fault zone with a finger-like convective flow regime

For a three-dimensional vertically-oriented fault zone, we consider the coupled effects of fluid flow, heat transfer and reactive mass transport, to investigate the patterns of fluid flow, temperature distribution, mineral alteration and chemically induced porosity changes. We show, analytically and numerically, that finger-like convection patterns can arise in a vertically-oriented fault zone. The onset and patterns of convective fluid flow are controlled by the Rayleigh number which is a function of the thermal properties of the fluid and the rock, the vertical temperature gradient, and the height and the permeability of the fault zone. Vigorous fluid flow causes low temperature gradients over a large region of the fault zone. In such a case, flow across lithological interfaces becomes the most important mechanism for the formation of sharp chemical reaction fronts. The degree of rock buffering, the extent and intensity of alteration, the alteration mineralogy and in some cases the formation of ore deposits are controlled by the magnitude of the flow velocity across these compositional interfaces in the rock. This indicates that alteration patterns along compositional boundaries in the rock may provide some insights into the convection pattern. The advective mass and heat exchanges between the fault zone and the wallrock depend on the permeability contrast between the fault zone and the wallrock. A high permeability contrast promotes focussed convective flow within the fault zone and diffusive exchange of heat and chemical reactants between the fault zone and the wallrock. However, a more gradual permeability change may lead to a regional-scale convective flow system where the flow pattern in the fault affects large-scale fluid flow, mass transport and chemical alteration in the wallrocks

Time-lapse pressure tomography for characterizing CO2 plume evolution in a deep saline aquifer

A time-lapse pressure tomography inversion approach is applied to characterize the CO2 plume development in a virtual deep saline aquifer. Deep CO2 injection leads to flow properties of the mixed-phase, which vary depending on the CO2 saturation. Analogous to the crossed ray paths of a seismic tomographic experiment, pressure tomography creates streamline patterns by injecting brine prior to CO2 injection or by injecting small amounts of CO2 into the two-phase (brine and CO2) system at different depths. In a first step, the introduced pressure responses at observation locations are utilized for a computationally rapid and efficient eikonal equation based inversion to reconstruct the heterogeneity of the subsurface with diffusivity (D) tomograms. Information about the plume shape can be derived by comparing D-tomograms of the aquifer at different times. In a second step, the aquifer is subdivided into two zones of constant values of hydraulic conductivity (K) and specific storage (Ss) through a clustering approach. For the CO2 plume, mixed-phase K and Ss values are estimated by minimizing the difference between calculated and “true” pressure responses using a single-phase flow simulator to reduce the computing complexity. Finally, the estimated flow property is converted to gas saturation by a single-phase proxy, which represents an integrated value of the plume. This novel approach is tested first with a doublet well configuration, and it reveals a great potential of pressure tomography based concepts for characterizing and monitoring deep aquifers, as well as the evolution of a CO2 plume. Still, field-testing will be required for better assessing the applicability of this approach.

Geochemistry and age determination of sediments from teh Rainbow hydrothermal plume

A geochemical investigation has been conducted of a suite of four sediment cores collected from directly beneath the hydrothermal plume at distances of 2 to 25 km from the Rainbow hydrothermal field. As well as a large biogenic component (>80% CaCO3) these sediments record clear enrichments of the elements Fe, Cu, Mn, V, P, and As from hydrothermal plume fallout but only minor detrital background material. Systematic variations in the abundances of "hydrothermal" elements are observed at increasing distance from the vent site, consistent with chemical evolution of the dispersing plume. Further, pronounced Ni and Cr enrichments at specific levels within each of the two cores collected from closest to the vent site are indicative of discrete episodes of additional input of ultrabasic material at these two near-field locations. Radiocarbon dating reveals mean Holocene accumulation rates for all four cores of 2.7 to 3.7 cm.kyr?1, with surface mixed layers 7 to 10+ cm thick, from which a history of deposition from the Rainbow hydrothermal plume can be deduced. Deposition from the plume supplies elements to the underlying sediments that are either directly hydrothermally sourced (e.g., Fe, Mn, Cu) or scavenged from seawater via the hydrothermal plume (e.g., V, P, As). Holocene fluxes into to the cores' surface mixed layers are presented which, typically, are an order of magnitude greater than "background" authigenic fluxes from the open North Atlantic. One core, collected closest to the vent site, indicates that both the concentration and flux of hydrothermally derived material increased significantly at some point between 8 and 12 14C kyr ago; the preferred explanation is that this variation reflects the initiation/intensification of hydrothermal venting at the Rainbow hydrothermal field at this time - perhaps linked to some specific tectonic event in this fault-controlled hydrothermal setting.

Biogenic silica in the coastal plume of the Mississippi River

The surface distributions of dissolved silicic acid, chlorophyll and diatom abundance were measured in the plume of the Mississippi River and adjacent waters during spring (late April and early May 1993) and summer (July 1992). In spring, the time of maximum river flow, there was an intense diatom bloom with a mean diatom abundance of 1.5 x 10**7 cells/l, more than an order of magnitude higher than in summer. Mixing curves of silicic acid concentration ([Si(OH)4]) versus salinity indicate that biological uptake within the river plume removed >99% of the Si(OH)4 supplied by the river in spring and 80 to 95% in summer. In spring [Si(OH)4] was occasionally depleted to <0.2 µM-among the lowest values ever reported from the ocean-with extensive depletion to >=0.5 µM over the shelf. In summer [Si(OH)4] was less severely depleted; the lowest measured was 0.93 µM and all others were >=2.4 µM. 30Si kinetic experiments were performed during both spring and summer to measure the degree to which the rate of Si uptake by the natural diatom assemblages was limited in situ by substrate availability. In spring the dependence of the specific uptake rate (V) on extracellular [Si(OH)4] conformed much more closely to the Michaelis-Menten saturation function than has been observed in past studies. Strong dependence of V on [Si(OH)4] was observed throughout the most Si(OH)4-depleted (<0.5 µM) region, where V was limited to 12 to 45% of the diatom assemblages' maximum uptake rate (Vmax). Half-saturation concentrations for Si uptake (Ks) averaged 0.85 uM (range = 0.48 to 1.71; n = 7) in spring, with the lowest values equal to the lowest previously reported for natural diatom assemblages. There was only 1 station in summer where V was limited by [Si(OH)4], and at that station Ks was 5.3 µM-quite high in comparison with previous studies. At stations where V was limited by [Si(OH)4], in both spring and summer, Chaetoceros spp. were numerically dominant; where there was no Si limitation other diatoms, usually Skeletonema costatum, dominated. The data thus indicate strong Si limitation in spring, with diatom assemblages well adapted to low [Si(OH)4], but little or no Si limitation in summer. Historical data suggest that coastal Si(OH)4 depletion and Si limitation may be recent phenomena in the northern Gulf of Mexico, resulting from increasing [NO3-] and decreasing [Si(OH)4] in the Mississippi River during the past 30 to 50 yr.

(Table 1) Turbidity, temperature, and salinity in the hydrothermal plume and background waters above the northern part of the Mohn's Ridge at Station AMK36-3573-5

In July 1995 geological and biological studies in the axial zone of the northern part of the Mohn's Ridge (72°20'N) were carried out during Cruise 36 of R/V Akademik Mstislav Keldysh. Slopes of the neovolcanic zone, as well as a caldera on its crest were investigated with use of deep-sea manned submersibles Mir, geological and biological samples were also collected. Use of the Rosette sounding complex provided recognition of several major hydrothermal plumes. Bottom sediments of the marginal depression are enriched in metals characteristic for hydrothermal metalliferous sediments. Thus, a new unknown hydrothermal field was found.

Plume-top altitude time-series during May 2011 volcanic eruption of Grímsvötn, Iceland

Plume-top altitude time series of the volcanic plume during the eruption of Grímsvötn in Iceland 21-28 May 2011. The altitude was estimated from weather radar echo top data from two weather radars, Keflavik and Klaustur. Keflavik radar is a fixed position C-band weather radar close to Keflavik International Airport, at 64°01.583'N, 22°38.150'W. The height of the antenna is 47 m a.s.l. and the distance to Grímsvötn volcano is 257 km. Klaustur radar is a mobile X-band weather radar located close to Kirkjubaejarklaustur, at 63°46.500'N, 17°57.817'W. The height of the antenna is also 47 m a.s.l. and the distance to Grímsvötn volcano is 75 km.