622 resultados para 13200-091
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
We report a measurement of the Lambda(0)(b) lifetime using a sample corresponding to 1.3 fb(-1) of data collected by the D0 experiment in 2002-2006 during run II of the Fermilab Tevatron collider. The Lambda(0)(b) baryon is reconstructed via the decay Lambda(0)(b)->mu(nu) over bar Lambda X-+(c). Using 4437 +/- 329 signal candidates, we measure the Lambda(0)(b) lifetime to be tau(Lambda(0)(b))=1.290(-0.110)(+0.119)(stat)(-0.091)(+0.087)(syst) ps, which is among the most precise measurements in semileptonic Lambda(0)(b) decays. This result is in good agreement with the world average value.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Li2TiSiO5 powders were synthesized by the polymeric precursor method. The calcination temperatures were progressively increased until the complete crystallization of the phase occurring at 870 degreesC. For the first time, a strong photoluminescence was measured at room temperature with a 488 nm excitation wavelength for the non-crystalline samples. This photoluminescence in disordered phases has been interpreted by means of high-level quantum mechanical calculations based on density functional theory. Two periodic models have been used to represent the crystalline and disordered powders. They allowed to calculate electronic properties consistent with experimental data and to explain the relations between photoluminescence and structural disorder. (C) 2004 Elsevier B.V. All rights reserved.
Resumo:
The temperature dependence of the electrical conductivity and the F-19 nuclear magnetic resonance (NMR) of PbGeO3-PbF2CdF, glasses and glass ceramics are investigated. The measured conductivity values of the glasses are above 10(-5) Skin at 500 K, and increase with increasing lead fluoride content. Activation energies extracted from the conductivity data are in the range 0.59-0.73 eV. Results are consistent with the hypothesis that in these oxyfluoride glasses lead fluoride rich clusters are dispersed in a metagermanate based matrix providing increasing mobility pathways for conducting ions. The conductivity of a sample of the glass ceramic of composition (mol%) 60PbGeO(3-)20PbF(2)-20CdF(2) was found to be smaller than that in the corresponding glass, suggesting that there are poor ionic conducting regions in the interface between the nanometer sized crystals. The temperature dependence of the F-19 relaxation times, measured in the range 100-800 K, exhibit the qualitative features associated with high fluorine mobility in both, glass and glass ceramics materials. We suggest that de-convolution of the spin-lattice relaxation rates observed in the glass ceramics shows that the observed high temperature rate maximum is associated with the diffusional motions of the fluorine ions in beta-PbF2 crystals. (c) 2005 Elsevier B.V. All rights reserved.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
Salting have been a very utilized fish conservation method, however only in the last years the basic mechanism involved in salting fish has been understood. The objectives of this study were determine the addition in brine salt of rosemary leaves, rosemary extracts and tocopherol, and your action in the followed parameters: water activity (Aw), moisture, ash, salt content and TBARS. The results showed that the addition of antioxidants was difficulted the salt absorption, however didn't have differences between rosemary or tocopherol use. In the salting time of 3 hours the values of Aw and salt levels, was respectively: 0.77±0.01 and 14.42±1.69. for control treatment; 0.85±0.02 and 9.09±1.39for rosemary filtrate; 0.78±0.03 and 10.63±0.69 rosemary without filtrating and 0.85±0.02 and 11.96±1.78 tocopherol, showed that didn't grow indigenous bacterias. Lipid oxidation was evaluated by TBARS and the results showed the oxidative effect of salt and the pro oxidant effects of alls antioxidants used in brine salting.
Resumo:
Purpose: This study assessed the shear bond strength of 4 hard chairside reline resins (Kooliner, Tokuso Rebase Fast, Duraliner II, Ufi Gel Hard) to a rapid polymerizing denture base resin (QC-20) processed using 2 polymerization cycles (A or B), before and after thermal cycling. Materials and Methods: Cylinders (3.5 mm x 5.0 mm) of the reline resins were bonded to cylinders of QC-20 polymerized using cycle A (boiling water-20 minutes) or B (boiling water; remove heat-20 minutes; boiling water-20 minutes). For each reline resin/polymerization cycle combination, 10 specimens (groups CAt e CBt) were thermally cycled (5 and 55°C; dwell time 30 seconds; 2,000 cycles); the other 10 were tested without thermal cycling (groups CAwt ad CBwt). Shear bond tests (0.5 mm/min) were performed on the specimens and the failure mode was assessed. Data were analyzed by 3-way ANOVA and Newman-Keuls post-hoc test (α=.05). Results: QC-20 resin demonstrated the lowest bond strengths among the reline materials (P<.05) and mainly failed cohesively. Overall, the bond strength of the hard chairside reline resins were similar (10.09±1.40 to 15.17±1.73 MPa) and most of the failures were adhesive/cohesive (mixed mode). However, Ufi Gel Hard bonded to QC-20 polymerized using cycle A and not thermally cycled showed the highest bond strength (P<.001). When Tokuso Rebase Fast and Duraliner II were bonded to QC-20 resin polymerized using cycle A, the bond strength was increased (P=.043) after thermal cycling. Conclusions: QC-20 displayed the lowest bond strength values in all groups. In general, the bond strengths of the hard chairside reline resins were comparable and not affected by polymerization cycle of QC-20 resin and thermal cycling.
Resumo:
Aim: The aim of this report is to present a case of severe fracture of the maxillary anterior alveolar process with substantial bone dislodgement associated with extrusive tooth luxation and avulsion. Background: Dentoalveolar trauma is a challenge to dentistry, especially in young patients, for it can lead to early tooth loss which compromises oral function, esthetics, self-esteem, and alter the long-term plan of care for the victim. Case Report: A 12-year-old girl with severe dentoalveolar trauma to the maxillary anterior region presented for emergency care for her injury. Treatment consisted of fracture reduction of the alveolar process, repositioning of the teeth that had suffered extrusive luxation, placement of a semi-rigid splint, and suturing of soft tissue lacerations. The traumatized teeth presented with pulpal necrosis and were treated endodontically. After 24 months of follow up, the fracture of the alveolar process was completely healed and the displaced teeth presented no signs of ankylosis or root resorption. Summary: First-aid care contributed remarkably to this case allowing the re-establishment of esthetics, function, and patient's self-esteem. In spite of trauma extension the treatment outcomes were favorable. Clinical Significance: Cases of dentoalveolar trauma should be evaluated on an individual basis. However, early emergency management and adequate follow-up can prevent further complications and contribute to treatment success.
Resumo:
An experiment was carried out to evaluate the performance of piglets fed rations containing fermented milk and zinc and copper amino acid complex. Sixty four piglets, littermates, were used. The experimental design was based on random block with two dietary treatments. One of these contained a basal diet (DB) with ZnO e CuSO 4 and the other one with the DB, but without CuSO 4 and with the addition of fermented milk and zinc and copper amino acid complex (SLF Lact +ZnCuAA). There were eight replicate pens per treatment, and pigs were grouped at 4 per pen. The SLF Lact + ZnCuAA didn't not affect (p>0.05) final live weight of the piglets. However, live weight was different (p<0.01) between males and females (24.3 vs. 24.0 kg) at end of experiment. The feed intake of animals feed with SLF Lact+ZnCuAA was higher (p<0.01) in 8% in the first 14 days (0.261 vs. 0.239 kg/d), 15% from 15 to 28 days (0.756 vs. 0.675 kg/ d) and 12% from 29 to 42 days (1.091 vs. 0.962 kg/ d) compared to control group. Daily average feed intake in the experimental period was 11% higher (p<0.01) for the animals fed with the diet contained SLF Lact+ZnCuAA. Weight gain of the treatment with SLFL act+ZnCuAA was higher (p<0.01) by 14% from 0 to 14 days (0.176 vs. 0.152 kg/d), 11% from 15 to 28 days (0.564 vs. 0.500 kg/d) and 12% from 29 to 42 days (0,572 vs. 0,501 kg/d). Average daily weight gain of 42 days of trial of treatment with SLF Lact +ZnCuAA was 12% higher (p<0.01) compared to control group (0.437 vs. 0.384 kg/d). Feed conversion ratio was 8% lower (p<0.01) for treatment with SLF Lact+ZnCuAA in the first 14 days (1.487 vs. 1.614). Supplementation with fermented milk and zinc and copper amino acid complex in diets containing zinc oxide improved growth performance of weanling piglets.
Resumo:
Inclut la bibliographie