Leaf and root volatiles produced by tissue cultures of Alpinia zerumbet (pers.) Burtt & Smith under the influence of different plant growth regulators

Volatiles produced by plantlets of Alpinia zerumbet were obtained by means of simultaneous distillation-extraction (SDE). The effects of indole-3-acetic acid, kinetin, thidiazuron and 6-benzylaminopurine on leaf and root volatile composition obtained by tissue cultures were investigated. A higher content of b-pinene and a lower content of sabinene were observed in leaf volatile of plantlets cultured in control, IAA and IAA+ TDZ media, as compared with those of donor plants. In vitro conditions were favorable to increase caryophyllene content. Volatile compounds from the root were characterized mainly by camphene, fenchyl-acetate and bornyl acetate; which constitute about 60% of total volatile.

Otimização e validação de método multirresíduo para determinação de sulfonamidas em camarão cultivado por cromatografia líquida de alta eficiência com detecção por UV

This work reports the optimization and method validation for sulfonamides (sulfamethazine, sulfaquinoxaline, sulfadimethoxine and sulfathiazole) in shrimp muscle using HPLC-UV. The sulfonamides were extracted with acetonitrile and acetic acid, and the extract cleaned up with a Strata SCX SPE cartridge prior to analysis. The method presented linearity in the range of 20-120 µg kg-1, good linear correlation (r > 0.99), and limits of quantification in the range of 4.7-20.2 µg kg-1. The recovery for shrimp muscles spiked with 50-150 µg kg-1 ranged from 63.2-108.0%. Precision and accuracy analysis showed acceptable relative standard deviation. Commercial shrimps were analyzed and sulfonamides don't were found above of the method limit of quantification.

Isolation and quantitative HPLC-PDA analysis of lupeol in phytopharmaceutical intermediate products from Vernonanthura ferruginea (Less.) H. Rob.

Prior to obtain a standardized dried extract from V. ferruginea, lupeol was first time isolated from leaves and used as chemical maker. An analytical method using HPLC-PDA for lupeol determination in V. ferruginea intermediate products was developed using a C8 reverse-phase column, acetonitrile-acetic acid (99.99:0.01, v/v) as mobile phase at 0.8 mL min-1, oven temperature at 23-25 ºC, sample injection volume at 30 µL and detection at 210 nm. The method presented linearity from 10 to 160 µg mL-1, accuracy, precision, robustness and suitable sensitivity proving to be a useful tool to the obtainment process of lupeol standardized dried extracts of V. ferruginea.

Flavonoids and other bioactive phenolics isolated from Cenostigma macrophyllum (Leguminosae)

This work describes the phytochemical study of stem bark and leaves of Cenostigma macrophyllum Tul. (Leguminosae). Through usual chromatographic techniques were isolated bergenin as the primary compound of the stem bark of and from the leaves gallic acid, methyl gallate, ellagic acid, quercetin, quercetin-3-O-β-D-glucopyranoside, quercetin-3-O-(6"-O-galloyl)-β-D-glucopyranoside (tellimoside), quercetin-3-O-(6"-O-E-p-coumaroyl)-β-D-glucopyranoside (helichrysroside), agathisflavone and vitexin were obtained. The isolates were identified by spectroscopic data analysis, and bergenin showed dose-related antinociception when assessed in acetic acid-induced writhing in mice.

Development and validation of a High Performance Liquid Chromatographic method for determination of etoposide in biodegradable polymeric implants

A method using HPLC-UV was developed and validated for the determination of etoposide incorporated into polycaprolactone implants. The method was carried out in isocratic mode using a C18 column (250 x 4.6 mm; 5 µm), at 25 ºC, with acetonitrile and acetic acid 4% (70:30) as mobile phase, a flow rate of 2 mL/min, and UV detection at 285 nm. The method was linear (r² > 0.99) over the range of 5 to 65 µg/mL, precise (RSD < 5%), accurate (recovery of 98.7%), robust, selective regarding excipient of the sample, and had a quantitation limit equal to 1.76 µg/mL. The validated method can be successfully employed for routine quality control analyses.

Método QuEChERS para determinação de ocratoxina a e citrinina em arroz e farelo de arroz

The present study was carried out to establish the optimal conditions for performing ochratoxin A (OTA) and citrinin (CIT) extraction using the QuEChERS method in rice. Employing the factorial experimental design, variables that significantly influenced the extraction stages were determined. The following variables were analyzed: addition of water, acidification of acetonitrile with glacial acetic acid, as well as amounts of magnesium sulfate, sodium acetate, sodium citrate and diatomaceous earth. The best combining procedure resulted in a predictive model using more water and less diatomaceous earth. Recoveries of CIT and OTA were 78-105%.

Optimization of wood flour acetylation by factorial design and partial least squares regression

Acetylation was performed to reduce the polarity of wood and increase its compatibility with polymer matrices for the production of composites. These reactions were performed first as a function of acetic acid and anhydride concentration in a mixture catalyzed by sulfuric acid. A concentration of 50%/50% (v/v) of acetic acid and anhydride was found to produced the highest conversion rate between the functional groups. After these reactions, the kinetics were investigated by varying times and temperatures using a 3² factorial design, and showed time was the most relevant parameter in determining the conversion of hydroxyl into carbonyl groups.

A fração volátil das aguardentes de cana produzidas no Brasil

The volatile fraction of sugar cane spirits plays a key role in the quality and acceptance of these beverages. The composition of this fraction is dependent on the way sugar cane collection, fermentation, distillation and aging are carried out. The materials used in these processes strongly influence chemical composition. Acetic acid, acetaldehyde, ethyl acetate, ethanol, 2.3-butanedione, n-propanol, 3-methyl-buthanol and isobuthanol were the major volatiles in spirits. Dimethyl sulfide and n-propanol impaired beverage flavor. Ethyl octanoate, 1.1-diethoxy-ethane, 2-phenylethanol and 3-methyl-butanol were important aroma contributors. Ageing allows the extraction of flavor-active components (e.g., phenolic compounds) from wood.

Implicações químicas na sistemática e filogenia de Bignoniaceae

Our solemn homage to the great Master Otto R. Gottlieb who knew how to teach the mystery of evolutionary relationships between chemistry and its natural sources. The micromolecular chemical study of the family Bignoniaceae shows a profile predominantly characterized by the occurrence of metabolites derived from acetic acid biosynthetic pathways such as terpenoids, quinones, flavonoids and special aromatic derivatives. Analysis of different chemosystematic parameters for the metabolite data collected, provided valuable information for the systematic characterization of the Bignoniaceae family within the Angiosperm derived taxa.

Registrador portátil de odorantes basado en la modulación de temperatura de un sensor mos comercial

A simple, portable and low-cost system for odor detection was developed using a single MOS commercial sensor and a microcontroller. The temperature modulation technique was implemented applying a DC signal pulse to the sensor heater by a bipolar transistor. Two odorant profiles, ethanol and acetic acid vapors, were obtained and distinguished based on their amplitude versus time responses. Response for acetic acid was not reported by the sensor manufacturer. An ethanol vapor calibration curve was also obtained. Experimental data showed a potential behavior according to the theoretical equation of the MOS sensors. Values of logK=0.457 and α=-0.213 for a 95% confidence level were obtained.

Um reator fotoquímico barato e eficiente para experimentos de química

In this work, we present an efficient and inexpensive device for undergraduate chemistry classes aimed at teaching and learning the photolytic synthesis concepts. A photochemical reactor was tested for the synthesis of the organometallic compound enneacarbonyldiiron from iron pentacarbonyl in acetic acid, and its formation evidenced by FTIR analysis. Although similar devices have been described in other studies, none of these offered the simplicity, low cost, class-compatible reaction times and good yields afforded by the procedure reported herein.

MÉTODO DE SÍNTESE DE AZIDAS AROMÁTICAS USANDO VINAGRE

The present paper describes a simple and low-cost procedure for preparation of aryl azides from anilines using vinegar as an unusual solvent/reagent. We observed the sequence of diazotation followed by diazo displacement with sodium azide can be carried out in aqueous solution of acetic acid

Methylene blue adsorption onto modified lignin from sugar cane bagasse

The adsorption kinetics and equilibrium of methylene blue (MB) onto reticulated formic lignin (RFL) from sugar cane bagasse was studied. The adsorption process is pH, temperature and ionic strength (µ) dependent and obeys the Langmuir model. Conditions for higher adsorption rate and capacity were determined. The faster adsorption (12 hours) and higher adsorption capacity (34.20 mg.g-1) were observed at pH = 5.8 (acetic acid-sodium acetate aqueous buffer), 50 ºC and 0.1 ionic strength. Under temperature (50 ºC) control and occasional mechanical stirring it took from 1 to 10 days to reach the equilibrium.

Titrimetric assay of lisinopril in aqueous and non-aqueous media

Four simple titrimetric procedures are described for the determination of lisinopril (LNP) in bulk and in pharmaceuticals based on the neutralization of basic-amino and acidic carboxylic acid groups present in LNP. Method A is based on the neutralization of basic amino groups using perchloric acid as titrant in anhydrous acetic acid medium. Method B, method C and method D are based on neutralization of carboxylic acid group using NaOH, sodium methoxide and methanolic KOH, as titrants, respectively. Method A is applicable over 2.0-20.0 mg range and the calculations are based in the molar ratio of 1:2 (LNP:HClO4). Method B, method C and method D are applicable over 2.0-20.0 mg, 1.0-10.0 mg and 5.0-15.0 mg range, respectively, and their respective molar ratios are 1:1 (LNP:NaOH), 1:2 (LNP:CH3ONa) and 1:1 (LNP:KOH). Intraday and inter day accuracy and precision of the methods were evaluated and the results showed intra- and inter-day precision less than 2.7% (RSD), and accuracy of < 2.5 % (RE). The developed methods were applied to determine LNP in tablets and the results were validated statistically by comparing the results with those of the reference method by applying the Student's t-test and F-test. The accuracy was further ascertained by recovery studies via standard addition technique. No interferences from common tablet exipients was observed.

Lämpötilan vaikutus kalvojen likaantumiseen erityisesti adsorptiolla

Työssä tutkittiin lämpötilan vaikutusta kalvon likaantumiseen mustalipeällä ja puuperäisellä hydrolysaatilla lämpötiloissa 20, 45 ja 70 °C:tta. Työn tavoitteena oli löytää lämpötila, jossa tutkimuksessa käytetyt puuperäiset liuokset likasivat kalvoja mahdollisimman vähän. Tutkimuksessa käytettiin Alfa Lavalin UFX5-ultrasuodatuskalvoa sekä Microdyn-Nadirin ultrasuodatuskalvoa UP010 ja nanosuodatuskalvoa NP010. Ennen puuperäisten liuosten adsorboimista kalvoihin säilöntäaineet poistettiin kalvoista sekä kalvojen toiminta stabiloitiin esikäsittelemällä kalvot. Esikäsittelyssä kalvoja pestiin alkalisella pesuaineella, puristettiin 8 bar:n paineessa sekä huuhdeltiin vedellä ja etikkahapolla. Esikäsitellyt kalvot karakterisoitiin mittaamalla malliaineliuoksen vuo ja malliaineiden retentiot suodattamalla polyetyleeniglykoliliuosta kolmikennosuodattimella paineissa 2, 4 ja 6 bar. Tämän jälkeen kalvot altistettiin lämpötiloissa 20, 45 ja 70 °C:tta mustalipeälle ja hydrolysaatille. Altistuksen jälkeen karakterisointi tehtiin uudelleen, jotta vuoarvoja ja retentioita vertaamalla voitiin arvioida altistuksen aikana tapahtunutta kalvojen likaantumista. Adsorboituneen lian puhdistusta kalvoista tutkittiin pesemällä kalvoja alkalisella pesuliuoksella 20 °C:ssa tehdyn altistuksen jälkeen. Mustalipeälle altistettujen kalvojen likaantuminen oli vähäisintä kokeissa, joissa lämpötila oli 20 °C. Alfa Lavalin UFX5-kalvolla 70 °C:ssa tehdyssä kokeessa kalvon likaantuminen oli myös erittäin vähäistä, sillä permeabiliteetti pieneni mustalipeäaltistuksen seurauksena alle 5 %. Hydrolysaatille altistetut kalvot likaantuivat adsorptiolla vähiten Alfa Laval UFX5-kalvoilla 20 °C:ssa tehdyissä kokeissa ja 45 °C:ssa Microdyn-Nadir NP010-kalvoilla tehdyissä kokeissa. Kokeiden perusteella tutkituista vaihtoehdoista korkein tutkimuksessa käytetty lämpötila 70 °C ja Alfa Lavalin UFX5-kalvo soveltuvatkin parhaiten mustalipeän kalvosuodatukseen adsorptiivisen likaantumisen kannalta.