Sulfur-isotope analyses of gypsium samples from the Southeast Greenland margin, southern Alaska and Gulf of Alaska (Table 1)

Gypsum grains were identified in Miocene-Pleistocene sediment cores from two deep-water ODP sites, Site 918 off the SE Greenland margin and Site 887 in the Gulf of Alaska, and in Holocene sediment cores from shallow-water localities in Disenchantment Bay and Muir Inlet in southern Alaska. Although initial morphologic and textural observations suggested a complex system in which the gypsum may have had more than one origin, quantitative sulfur isotope analyses of the gypsum provide evidence of its detrital nature. d34S values in gypsum from southern Alaska range between +0.0 and +7.1 per mil. Gypsum has d34S values between -27.1 and -27.5 per mil in the Gulf of Alaska and values between -28.5 and +0.2 per mil off the SE Greenland margin. All of these isotopic signatures are too highly depleted in d34S to have precipitated from seawater, present or past. In addition there is no significant change in d34S values for gypsum crystals with differing physical characteristics (abraded vs. unabraded) from the same stratigraphic horizon, suggesting all the gypsum is detrital regardless of the degree of abrasion. The isotopic and physical evidence, in combination with the onshore geology the environmental setting, and site characteristics of the gypsum-bearing marine localities, lead us to propose that the ultimate source of the gypsum is precipitation from freeze-induced terrestrial sediment or soil brines. Furthermore the combined evidence suggests that the subsequent occurrence of gypsum in glacimarine sediments results from ice-rafting (by icebergs or sea ice) of the frozen regolith and/or, in the proximal glacimarine setting of southern Alaska, very rapid burial via turbidity currents.

Stable oxygen and carbon isotope ratios of Globigerinoides obliquus of quantitative range chart of the ostracodes in the Pliocene-Pleistocene interval of ODP Hole 107-654A

Deep-water benthic ostracodes from the Pliocene-Pleistocene interval of ODP Leg 107, Hole 654A (Tyrrhenian Sea) were studied. From a total of 106 samples, 40 species considered autochthonous were identified. Detailed investigations have established the biostratigraphic distribution of the most frequent ostracode taxa. The extinction levels of Agrenocythere pliocenica (a psychrospheric ostracode) in Hole 654A and in some Italian land sections lead to the conclusion that the removal of psychrospheric conditions took place in the Mediterranean Sea during or after the time interval corresponding to the Small Gephyrocapsa Zone (upper part of early Pleistocene), and not at the beginning of the Quaternary, as previously stated. Based on a reduced matrix of quantitative data of 63 samples and 20 variables of ostracodes, four varimax assemblages were extracted by a Q-mode factor analysis. Six factors and eight varimax assemblages were recognized from the Q-mode factor analysis of the quantitative data of 162 samples and 47 variables of the benthic foraminifers. The stratigraphic distributions of the varimax assemblages of the two faunistic groups were plotted against the calcareous plankton biostratigraphic scheme and compared in order to trace the relationship between the benthic foraminifers and ostracodes varimax assemblages. General results show that the two populations, belonging to quite different taxa, display almost coeval changes along the Pliocene-Pleistocene sequence of Hole 654A, essentially induced by paleoenvironmental modifications. Mainly on the base of the benthic foraminifer assemblages (which are quantitatively better represented than the ostracode assemblages), it is possible to identify such modifications as variations in sedimentation depth and in bottom oxygen content.