Análise matemática da potência gerada por sistemas fotovoltáicos e suas aplicações

A radiação solar constitui-se numa inesgotável fonte energética, havendo um enorme potencial de utilização por meio de sistemas de captação e conversão em outra forma de energia. Para a conversão direta da energia solar em elétrica, são utilizadas células fotovoltaicas constituídas, que associadas constituem um módulo fotovoltaico, sendo que também quando agrupados, formam painéis fotovoltaicos. Estes painéis associados a outros equipamentos que transformam ou armazenam energia elétrica para que ela possa ser utilizada é chamado de sistema fotovoltaico. Neste trabalho, foram determinadas analiticamente formas de obtenção de curvas de corrente e potência fotovoltaicas, e também o ponto de potência máxima. Tais métodos foram aplicados no sistema fotovoltaico localizado na FCA/UNESP, sendo utilizado um sistema constituído por três módulos fotovoltaicos. Para o desenvolvimento das equações que regem a potência dos sistemas fotovoltaicos, procurou-se estudar o circuito elétrico de células fotovoltaicas, sendo necessária também a aplicação de métodos numéricos iterativos para a determinação de alguns parâmetros elétricos. De acordo com os teoremas apresentados, foi possível determinar as expressões analíticas da resistência série e do ponto de potência máxima de uma célula fotovoltaica, possibilitando a geração dos gráficos de tais funções com os dados obtidos experimentalmente. Comparando-se os valores obtidos pelas funções com os valores padrões do sistema fotovoltaico instalado, o valor calculado apresentou um erro de 1,03% em relação ao dado pelo fabricante, representando uma excelente aproximação. Desta forma, pode-se concluir que os métodos e teoremas dos sistemas fotovoltaicos apresentados podem servir de auxílio a futuros dimensionamentos para aplicações destes sistemas.

Sistema fotovoltaico monocristalino para bombeamento de água

Since ancient times, it has been a huge challenge to all people around the world to manage to get their fresh water, keeping it clean and providing it to every human being, so that it can be used for their daily needs. This is especially true for small properties in the countryside and in isolated areas with low demographic density. Pumping the water in those regions is a solution that rationalizes its use in domestic chores, in animal rearing and in the irrigation systems of cultivated areas. Making feasible local, renewable and non-polluted energetic alternatives is the aim for those areas that are usually far away from the public electric network. Using photovoltaic solar energy is the alternative now proposed. For this objective was built a system with two monocrystalline panels, one pump, two water tanks, two level sensors and a solenoid valve to pump water, using a pump powered an array of monocrystalline solar panels. The main goal was to compare their rate of water flow and their energy consumption. The use of one data acquisition equipment allowed collecting meteorological, electrical and hydraulic values, and also serving for the control and activation of the pumping system. During four months in a row as from April 2009, arrangements with one or two panels were tested. Mathematics correlations and adjustment lines were used to interpret the behavior of obtained dataset. During the analyzed period the system followed the linear equations with great accuracy. The daily average amount of water pumped by the several tested arrays stayed between 1,100 and 2,500 liters, and that is enough to supply a small rural property. The pumping system with two panels effectively showed the major amount of water, but a system with one panel can be an economical solution until 1,500 liters on day. It did not characterize a direct relationship between power or quantity of photovoltaic panels and daily outflow of water pumping.

Aloimunização de doadores de sangue como fonte de anti-soros e hemácias raras

Pós-graduação em Pesquisa e Desenvolvimento (Biotecnologia Médica) - FMB

Avaliação de desempenho no processo de lixamento de madeiras das espécies Pinus elliottii e Corymbia citriodora

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Conversor inversor integrado três estados buck-boost para geração distribuída, com operação conectada ou ilhada

Pós-graduação em Engenharia Elétrica - FEIS

Elaboração de um roteiro interpretativo para trilha de ciclista da Florestal Estadual Edmundo Navarro de Andrade, Rio Claro/SP

The State Forest Edmundo Navarro de Andrade (FEENA), Rio Claro/SP has a huge potential for cyclists tracks; the Unit already have a trail at the principal entrance, passing by firebreaks bordering the towers quadrants and finishing at the municipal road. This work aims the ambiental interpretation of this trail already established and implant activities planned before at the public use program of the State Forest according to the management plan of the Unit; to interpret the tracks for mountain bike cyclists; promote the conservation of natural, historic and cultural resources of the Forest. At the present work has been accomplished the Ambiental Interpretation through the panels, containing the characteristic native flora and fauna, the existing water resources at the Unit and also the representatives individuals of the exotic arboreal species, found around the trail. Ten points were chosen for interpretation, therefore, for preparation of the script it was considered besides the bibliographic literature, experiences of project team members at FEENA, Unit Management Plan knowledge relating the gaps in the public use program and field work. The panels contain figures and texts about the chosen topics, to promote a language easily understandable to the visitor and concomitantly, inform to the population who attends the Unit, increasing this way the user satisfaction

Análise de viabilidade de implementação de um centro inteligente de motores

Across the industry, regardless of the activity which is intended, the electricity distribution must meet the current and ever growing needs of the market, aiming at reliability and process efficiency. The energy must not only be available to ensure continuity of operation, but also to avoid the costs incurred due to deficiencies and failures. The tendency to migrate to intelligent systems is undeniable and this thesis will be analyzed the advantages that made this kind technology essential, focused on the analysis of the motor control center and as sturdy equipment fit to the concept of intelligent panels. The case study compares in a real scenario the acquisition of a system of low-voltage electrical panels comparing the cost to purchase the same set of panels made with and without the concept of intelligence

Estudo das propriedades ópticas de pós cerâmicos à base de Zn3Ga2Ge2O10: X% Cr3+ (X = 0 ; 0,5 ; 0,75 ; 1,0)

Ceramic powders based on Zn3Ga2Ge2O10: Cr3+ X% (X = 0.0; 0.5; 0.75; 1.0) were synthesized by solid-state reaction method. The gallium-zinc germanate doped with chromium presents an interesting property of phosphorescence, that means, it is capable of emitting light when excited by a source of radiation, and such emission remains for some time after stopping the source. For this reason, these materials can be widely applied in night-vision surveillance, (through the use of solar energy, for example), electronic devices screen, emergency routes signals, control panels indicators in dark environments, etc. In this job were considered different amounts of dopant in order to perform a comparison of structural and photoluminescent properties. For that, some analyses were performed on samples, such as XRD, FT-Raman, SEM, UV-vis and photoluminescence measurements (PL). Such analysis allowed to infer that the presence of chromium results in no phase transformation, so that the four compositions have the same set of phases: cubic, rhombohedral and hexagonal. Although the structure was not changed, chromium influences other properties / characteristics of these materials. Examples are: increase of band-gap, decrease of average particle size, small changes in binding energy checked by Raman and especially the increase of photoluminescent property. The chromium ions have great ease in replacing gallium ions in octahedral sites, resulting in emission of light with a wavelength of about 700 nm (infrared region), which is justified by the spin-forbidden 2E 4A2 transition. In other words, chromium is a favorable luminescent center, acting as a trap in the crystal structure, since it imprisons the excitation energy easily and releases it gradually, allowing the phosphorescence. It was observed that the composition ... (Complete abastract click electronic access below)

Proposta de controlador de carga com MPPT utilizando LabVIEW

This paper presents one proposal of the energy management's model system using photovoltaic panels. The module proposed seeks to monitor photovoltaic panels, which have intermittency in power generation caused by environmental or load conditions, in order to control the coupling between the panel and the load - through the charge controller, of aiming that the panel's operation will be always on the maximum power transfer point as possible. For this, it used the maximum power point tracking technique - MPPT, implemented in LabVIEW software, also utilizing the data acquisition card NI myDAQ. In addition, it was implemented the controller access remote module, from the sharing of network data, so the panels performance can be through a tablet, monitored and controlled with no need for direct contact with the Supervisory server

Elaboração de um roteiro interpretativo para trilha de ciclista da Florestal Estadual Edmundo Navarro de Andrade, Rio Claro/SP

The State Forest Edmundo Navarro de Andrade (FEENA), Rio Claro/SP has a huge potential for cyclists tracks; the Unit already have a trail at the principal entrance, passing by firebreaks bordering the towers quadrants and finishing at the municipal road. This work aims the ambiental interpretation of this trail already established and implant activities planned before at the public use program of the State Forest according to the management plan of the Unit; to interpret the tracks for mountain bike cyclists; promote the conservation of natural, historic and cultural resources of the Forest. At the present work has been accomplished the Ambiental Interpretation through the panels, containing the characteristic native flora and fauna, the existing water resources at the Unit and also the representatives individuals of the exotic arboreal species, found around the trail. Ten points were chosen for interpretation, therefore, for preparation of the script it was considered besides the bibliographic literature, experiences of project team members at FEENA, Unit Management Plan knowledge relating the gaps in the public use program and field work. The panels contain figures and texts about the chosen topics, to promote a language easily understandable to the visitor and concomitantly, inform to the population who attends the Unit, increasing this way the user satisfaction

Análise de viabilidade de implementação de um centro inteligente de motores

Across the industry, regardless of the activity which is intended, the electricity distribution must meet the current and ever growing needs of the market, aiming at reliability and process efficiency. The energy must not only be available to ensure continuity of operation, but also to avoid the costs incurred due to deficiencies and failures. The tendency to migrate to intelligent systems is undeniable and this thesis will be analyzed the advantages that made this kind technology essential, focused on the analysis of the motor control center and as sturdy equipment fit to the concept of intelligent panels. The case study compares in a real scenario the acquisition of a system of low-voltage electrical panels comparing the cost to purchase the same set of panels made with and without the concept of intelligence

Estudo das propriedades ópticas de pós cerâmicos à base de Zn3Ga2Ge2O10: X% Cr3+ (X = 0 ; 0,5 ; 0,75 ; 1,0)

Ceramic powders based on Zn3Ga2Ge2O10: Cr3+ X% (X = 0.0; 0.5; 0.75; 1.0) were synthesized by solid-state reaction method. The gallium-zinc germanate doped with chromium presents an interesting property of phosphorescence, that means, it is capable of emitting light when excited by a source of radiation, and such emission remains for some time after stopping the source. For this reason, these materials can be widely applied in night-vision surveillance, (through the use of solar energy, for example), electronic devices screen, emergency routes signals, control panels indicators in dark environments, etc. In this job were considered different amounts of dopant in order to perform a comparison of structural and photoluminescent properties. For that, some analyses were performed on samples, such as XRD, FT-Raman, SEM, UV-vis and photoluminescence measurements (PL). Such analysis allowed to infer that the presence of chromium results in no phase transformation, so that the four compositions have the same set of phases: cubic, rhombohedral and hexagonal. Although the structure was not changed, chromium influences other properties / characteristics of these materials. Examples are: increase of band-gap, decrease of average particle size, small changes in binding energy checked by Raman and especially the increase of photoluminescent property. The chromium ions have great ease in replacing gallium ions in octahedral sites, resulting in emission of light with a wavelength of about 700 nm (infrared region), which is justified by the spin-forbidden 2E 4A2 transition. In other words, chromium is a favorable luminescent center, acting as a trap in the crystal structure, since it imprisons the excitation energy easily and releases it gradually, allowing the phosphorescence. It was observed that the composition ... (Complete abastract click electronic access below)

Proposta de controlador de carga com MPPT utilizando LabVIEW

This paper presents one proposal of the energy management's model system using photovoltaic panels. The module proposed seeks to monitor photovoltaic panels, which have intermittency in power generation caused by environmental or load conditions, in order to control the coupling between the panel and the load - through the charge controller, of aiming that the panel's operation will be always on the maximum power transfer point as possible. For this, it used the maximum power point tracking technique - MPPT, implemented in LabVIEW software, also utilizing the data acquisition card NI myDAQ. In addition, it was implemented the controller access remote module, from the sharing of network data, so the panels performance can be through a tablet, monitored and controlled with no need for direct contact with the Supervisory server

A poluição do ar e o sistema respiratório

A poluição atmosférica encontra-se presente nos mais diferentes cenários ao longo dos últimos 250 anos, desde que a Revolução Industrial acelerou o processo de emissão de poluentes que, até então, estava limitado ao uso doméstico de combustíveis vegetais e minerais e às emissões vulcânicas intermitentes. Hoje, aproximadamente 50% da população do planeta vivem em cidades e aglomerados urbanos e estão expostas a níveis progressivamente maiores de poluentes do ar. Este estudo é uma revisão não sistemática sobre os diferentes tipos e fontes de poluentes do ar e os efeitos respiratórios atribuídos à exposição a esses contaminantes. Podem ser creditados aos poluentes particulados e gasosos, emitidos por diferentes fontes, aumentos nos sintomas de doenças, na procura por atendimentos em serviços de emergência e no número de internações e de óbitos. Mais do que descompensar doenças pré-existentes, exposições crônicas têm ajudado a aumentar o número de casos novos de asma, de DPOC e de câncer de pulmão, tanto em áreas urbanas quanto em áreas rurais, fazendo com que os poluentes atmosféricos rivalizem com a fumaça do tabaco pelo papel de principal fator de risco para estas doenças. Na rotina de clínicos e pneumologistas, esperamos contribuir para consolidar a importância da investigação sobre a exposição aos poluentes do ar e o reconhecimento de que esse fator de risco merece ser levado em conta na adoção da melhor terapêutica para o controle das descompensações agudas das doenças respiratórias e para a sua manutenção entre as crises.