The study of the ergosan and vibromax effects on growth performances, survival rate and increase of the resistance to some of the environmental stresses in post larvae stage of the Indian white shrimp

In this study, which has been done in Hormoz larve Hatchery at Kohestak in Minab at 1385, the efficiency of Ergosen and Vibromax vaccine and the effect of them on growth factors such as total length, Carapase, dry weight and the number of upper mordents of rostrum and survival of the stages of larvae and post larvae of Indian white shrimp was studied. Thus in order to comparison the effects of Vibromax and Ergosen, each of them separately, in one treatment, and in another simultaneously with one control treatment was used. Vaccination against larvae shrimps was done through Artemia. This study used four treatments with three replicates in a completely randomized design and comparison of means was done through Duncan test. Breeding larvae and post larvae of Indian white shrimp from zoa I stage to PL 15 was done in 20 litter plastic buckets. Present results indicated that the highest amount of growth and survival factors in larvae stage (from zoa to PL1), and also in stages of PL5 and PL15, in the treatment of Ergoson effect + vaccine and it was with a little difference from that treatment of Ergoson effect which was in high significance difference in regard to control treatment at α<0.01 level and treatment of vaccine effect and control treatment at α<0.01 level often have no significant difference. This research used environmental stress tests to study the quality of post larvae under experiment. Studying in this field showed that feeding vaccine to larvae of Indian shrimps which was done through Artemia nauplii enrichment ,and ergosen , in treatment of ergosen vaccine lead to more resistance of post larvaes against salinity stress tests and formalin .This case was observed in every three stages ,so that in stress formalin test 100 parts per million and also 10 and 20 salinity parts in thousands the most survival was observed in treatment of Ergosan effect+vaccine and after that in treatment of Ergoson effect and with a little difference in treatment of vaccine effect. Of course this case, in treatment of Ergoson effect + vaccine due to the synergistic properties vaccine with Ergoson was more than to other treatments, while every three treatments, in most stages had significant difference toward control treatment at α<0.01 level and the control treatment because of not having Ergoson and nauplii artemia with vaccine, having the least survival rate in this stages.

The study of Indian shrimp larvae feeding by enriched rotifer with vitamin C and unsaturated fatty acid (epa, dha) and its effects on growth factors, survival rate and environmental stresses

In this experiment, the feeding of Indian white shrimp larvae by unenriched rotifers (treatment 1) and enriched with highly unsaturated fatty acid (treatment 2) and highly unsaturated fatty acid along with vitamin C (treatment 3) on the growth factors, survival and resistance against salinity and formalin stress tests were studied and their differences with control treatment including newly hatched Artemia nauplii is compared. In this the study four treatments in a completely randomized design with 3 replicates per treatment were used. Farming of shrimp larvae of Zoea II to postlarvae 5 was done in 20 liter plastic bucket. Present results indicated that growth factors and survival rate of stage Zoea II to postlarvae 1 in treatments 1, 2 and 3 improve rather than control in which this case was due to optimal size rotifer rather than Artemia nauplii. Also, treatments 2 and 3 feeding with oil liver cod emulsion enriched rotifer have the highest concentration of DHA (mg/g DW) and the ratio DHA/EPA in which due to have shown the highest growth factors and a significant difference (P<0.05) with treatments 1 and control. The highest survival at stage PL1 were observed in treatment 3 that was enriched with ascorbyl palmitate in which have to the synergistic properties of vitamin C rather than treatments 2, 1 and control and showed a significant difference (P<0.05). But in stage PL5 the highest amount of growth and survival rates were related to control treatment which showed a significant difference (P<0.05) with other treatments that control has higher size rather than treatments 1, 2 and 3. Also, among experiment treatments that the two treatments 2 and 3 due to enrichment had higher growth and survival rates compared with treatment 1 in which their differences have also been significant (P<0.05). In the case of stress tests, results indicated that the highest survival rate has been reported when specimens were offered a diet containing high levels of highly unsaturated fatty acids with vitamin C. So that in stage PL1 in the salinity stress tests 10 and 20 ppt the highest survival rate was observed in treatment 3. As for the second, treatment 2 showed a significant difference (P<0.05) with treatment 3. It is worth mentioning that treatment 3 showed a higher survival rate compared to treatment 2 due to the synergistic properties of vitamin C. The difference between these two treatments with treatment 1 and control was also significant. No significant difference was observed in formalin stress test 100 ppm in this stage between treatments 3 and 2 which shows the highest survival rate. But their difference with treatments 1 and control was significant (P<0.05). Also, in stage PL5 in the salinity stress tests 10 and 20 ppt the highest survival rate was observed in treatment 3 which showed no significant difference (P<0.05) with control treatment. While their difference in the amount of survival rate with treatment 1 and 2 was significant (P<0.05). In this stage, the highest observed survival rate in formalin stress test 100 ppm included treatments control, 3 and 2 among which there were no significant differences (P<0.05). While the difference between these three treatments with treatment 1 was significant.

Permeability and stiffness of sands at very low effective stresses

Loose saturated sandy soils may undergo liquefaction under cyclic loading, generating positive excess pore pressures due to their contractile nature and inability to dissipate pore pressures rapidly during earthquake loading. These liquefied soils have a near-zero effective stress state, and hence have very low strength and stiffness, causing severe damage to structures founded upon them. The duration for which this near-zero effective stress state persists is a function of the rate of reconsolidation of the liquefied soil, which in turn is a function of the permeability and stiffness of the soil at this very low effective stress. Existing literature based on observation of physical model tests suggests that the consolidation coefficient C v associated with this reconsolidation of liquefied sand is significantly lower than that of the same soil at moderate stress levels. In this paper, the results of a series of novel fluidisation tests in which permeability k and coefficient of consolidation C v were independently measured will be presented. These results allow calculation of the variation of stiffness E 0 and permeability k with effective stress. It is shown that while permeability increases markedly at very low effective stresses, the simultaneous drop in stiffness measured results in a decrease in consolidation coefficient and hence an increase in the duration for which the soil remains liquefied.

Dynamic compressive response of composite square honeycombs

Carbon fibre-epoxy composite square honeycombs, and the parent composite material, were tested in quasi-static compression at a strain rate of 10 -3 s -1 and in dynamic compression at strain rates of 10 3-10 4 s -1 using an instrumented Kolsky bar arrangement. Taken together, these tests provide an assessment of the potential of this composite topology for use as a lightweight sandwich core. The honeycombs had two relative densities, 0.12 and 0.24, and two material orientations, ±45° and 0/90° with respect to the prismatic, loading direction of the honeycomb. Honeycomb manufacture was by slotting, assembling and bonding together carbon fibre/epoxy woven plies of composite sheets of 2 × 2 twill weave construction. The peak value of wall stress in the honeycombs was about one third that of the parent material, for all strain rates. An elastic finite element analysis was used to trace the source of this knock-down in strength: a stress concentration exists at the root of the slots and leads to premature failure by microbuckling. Shock-wave effects were evident at impact velocities exceeding 50 ms -1 for the honeycomb of relative density 0.12. This was traced to stubbing of the buckled cell walls against the face of the Kolsky bar. © 2011 Elsevier Ltd. All rights reserved.

Compressive failure of finite size unidirectional composite laminates with a region of fibre waviness

The compressive behaviour of finite unidirectional composites with a region of misaligned reinforcement is investigated via finite element analyses. Models with and without fibre bending stiffness are compared, confirming that compressive strength is accurately predicted without modelling fibre bending stiffness for real composite components which typically have waviness defects of several millimetres wavelength. Various defect parameters are investigated. Results confirm the well-known sensitivity of compressive strength to misalignment angle, and also show that compressive strength falls rapidly with the proportion of laminate width covered by the wavy region. A simple empirical equation is proposed to model the effect of a single patch of waviness in finite specimens. Other parameters such as length and position of the wavy region are found to have a smaller effect on compressive strength. The modelling approach is finally adapted to model distributed waviness and thus determine the compressive strength of composites with realistic waviness defects. © 2011 Elsevier Ltd. All rights reserved.

Reconstruction of arbitrary biochemical reaction networks: A compressive sensing approach

Reconstruction of biochemical reaction networks (BRN) and genetic regulatory networks (GRN) in particular is a central topic in systems biology which raises crucial theoretical challenges in system identification. Nonlinear Ordinary Differential Equations (ODEs) that involve polynomial and rational functions are typically used to model biochemical reaction networks. Such nonlinear models make the problem of determining the connectivity of biochemical networks from time-series experimental data quite difficult. In this paper, we present a network reconstruction algorithm that can deal with ODE model descriptions containing polynomial and rational functions. Rather than identifying the parameters of linear or nonlinear ODEs characterised by pre-defined equation structures, our methodology allows us to determine the nonlinear ODEs structure together with their associated parameters. To solve the network reconstruction problem, we cast it as a compressive sensing (CS) problem and use sparse Bayesian learning (SBL) algorithms as a computationally efficient and robust way to obtain its solution. © 2012 IEEE.

Compressive response of glass fiber composite sandwich structures

Sandwich panels with crushable foam cores have attracted significant interest for impulsive load mitigation. We describe a method for making a lightweight, energy absorbing, glass fiber composite sandwich structure and explore it is through thickness (out-of-plane) compressive response. The sandwich structure utilized corrugated composite cores constructed from delamination resistant 3D woven E-glass fiber textiles folded over triangular cross section prismatic closed cell, PVC foam inserts. The corrugated structure was stitched to 3D woven S2-glass fiber face sheets and infiltrated with a rubber toughened, impact resistant epoxy. The quasi-static compressive stress-strain response of the panels was experimentally investigated as a function of the strut width to length ratio and compared to micromechanical predictions. Slender struts failed by elastic (Euler) buckling which transitioned to plastic microbuckling as the strut aspect ratio increased. Good agreement was observed between experimental results and micromechanical predictions over the wide range of core densities investigated in the study.

The predicted compressive strength of a pyramidal lattice made from case hardened steel tubes

A sandwich panel with a core made from solid pyramidal struts is a promising candidate for multifunctional application such as combined structural and heat-exchange function. This study explores the performance enhancement by making use of hollow struts, and examines the elevation in the plastic buckling strength by either strain hardening or case hardening. Finite element simulations are performed to quantify these enhancements. Also, the sensitivity of competing collapse modes to tube geometry and to the depth of case hardening is determined. A comparison with other lattice materials reveals that the pyramidal lattice made from case hardened steel tubes outperforms lattices made from solid struts of aluminium or titanium and has a comparable strength to a core made from carbon fibre reinforced polymers. © 2013 Elsevier Ltd. All rights reserved.