Chemical Sensor Based on a Long-Period Fibre Grating Modified by a Functionalized Polydimethylsiloxane Coating

A chemical sensor based on a coated long-period grating has been prepared and characterized. Designer coatings based on polydimethylsiloxane were prepared by the incorporation of diphenylsiloxane and titanium cross-linker in order to provide enhanced sensitivity for a variety of key environmental pollutants and optimal refractive index of the coating. Upon microextraction of the analyte into the polymer matrix, an increase in the refractive index of the coating resulted in a change in the attenuation spectrum of the long-period grating. The grating was interrogated using ring-down detection as a means to amplify the optical loss and to gain stability against misalignment and power fluctuations. Chemical differentiation of cyclohexane and xylene was achieved and a detection limit of 300 ppm of xylene vapour was realized.

Analysis of friction factor reduction in turbulent water flow using a superhydrophobic coating

This study provides experimental and theoretical evidence that the coating of the inner surface of copper pipes with superhydrophobic (SH) materials induces a Cassie state flow regime on the flow of water. This results in an increase in the fluid's dimensionless velocity distribution coefficient, a, which gives rise to an increase in the apparent Reynolds number, which may approach the "plug flow state". Experimental evidence from the SH coating of a classic unsteady-state flow system resulted in a significant decrease in the friction factor and associated energy loss. The friction factor decrease can be attributed to an increase in the apparent Reynolds number. The study demonstrates that the Cassie effects imposed by SH coating can be quantitatively shown to decrease the frictional resistance to flow in commercial pipes.

A simply effective double-coating cathode with MnO2 nanosheets/graphene as functionalized interlayer for high performance lithium-sulfur batteries

Herein, we report a facile and effective adsorption strategy to improve the performance of Lithium-Sulfur (Li-S) batteries. MnO₂ nanosheets grown on the surface of highly conductive graphene resulted in a coupled composite bilayer electrode when coated onto a sulfur cathode. In this way, a high initial specific capacity of 1395 mA h g^-1 at a rate of 0.5C, a coulombic efficiency approaching 100% and steady cyclic efficiency with a fade rate of 0.3% per cycle from 10 to 100 cycles has been achieved. This hybrid electrode not only shows enhanced electrochemical performance but can also be easily controlled and scaled thereby aiding future commercialization of high-performance Li-S batteries.

Corrosion resistance of self-growing TiC coating on SIMP steel in LBE at 600 °C

SIMP steel was newly developed as a candidate structural material for the accelerator driven subcritical system. The serious decarburization of SIMP steel because of the high Si content was used to successfully form a self-growing TiC coating on the surface, after the Ti deposition as a first step. This TiC layer can effectively protect the surface from the static liquid lead-bismuth eutectic (LBE) corrosion at 600 °C up to 2000 h in the low oxygen LBE. However, in the oxygen saturated LBE, the TiC coating is oxidized into porous TiO2 after only 500 h and fails to protect. Therefore, the self-growing TiC coating is desired only when the oxygen content of LBE is strictly controlled on a low level.

SOL-GEL Lanthanum Phosphate, Composite and coating for functional Applications.

Lanthanum phosphate is one among the lanthanide family of “Rare Earths” following the periodic table of elements. Known under the generic name, Monazite, the rare earth phosphates have melting points above 1900 °C, high thermal phase stability, low thermal conductivity and thermal expansion coefficient similar to some of the high temperature oxides like alumina and zirconia.

Fungal contamination in one hotel room: does carpet coating in the floor enhance fungal contamination?

Interest in bioaerosol exposure has increased significantly because it is now recognized that exposure to fungal agents is associated with a wide range of adverse health effects with a major impact on public health. Fungi are able to grow on almost all natural and synthetic materials, especially if they are hygroscopic or wet. Aim of the study: Several materials used indoors can contribute to enhance fungal contamination indoors. This study intended to understand the carpet influence on fungal contamination when used in the floor of a hotel room.

Fungal contamination in one hotel room: Does carpet coating in the floor enhance fungal contamination?

Study developed in order to know the carpet influence when used in the floor of a hotel room. Twelve air samples of 250L (six in a room with carpet and six more in a room with wood floor) were collected through an impaction method with a flow rate of 140 L/min onto malt extract agar (MEA) supplemented with chloramphenicol (0.05%), using the Millipore air Tester (Millipore), during cleaning activities. Outdoor sample was also performed to be used as a reference. Surface samples from floor and desks, taken at the same time, were collected by the swabbing method. to 7 days. Besides fungal contamination, we also assessed particulate matter contamination in both rooms during the same cleaning tasks. In the analyzed sur- faces, isolates belonging to Aspergillus fumigatus complex were the only fungi found in the carpeted room, whereas in the other room we found Penicllium sp. (63.6%) and Aspergillus sp. (13.6%) as the most frequent genera. In the case of particles the room with carpet obtained significant higher values for both metrics (PMC and PNC), showing that carpet may has influence on particles’ contamination of the room.

Erratum to "Optimization of resin extraction from an Australian arid grass 'Triodia pungens' and its preliminary evaluation as an anti-termite timber coating" [Ind. Crops Prod. 59 (2014) 241–247]

The publisher regrets to inform the readers that the image that is appearing for Fig. 8 is incorrect and that the Supplementary material is missing on the published paper. The correct image for Fig. 8 and the Supplementary files are provided below: Fig. 8. (a) Timber blocks covered by invented plastic container bottom open, (b) timber blocks in the field after trial, (c) and (d) comparison between resin-coated blocks without termite damage and control blocks which were severely damaged by termites.

Efeitos bioquímicos da exposição ao nanomaterial óxido de grafeno em diferentes tecidos do camarão branco (Litopenaeus vannamei; Crustacea, Decapoda), através da suplementação na ração

O desenvolvimento da nanotecnologia vem se intensificando nos últimos anos. Sendo que os NM já estão sendo utilizados em vários produtos disponíveis no mercado. Dentre os NM mais utilizados estão os compostos de carbono que embora sejam compostos somente por este elemento podem ter estruturas diferentes que refletem em suas aplicações e possivelmente em seus efeitos. Dentre os NM de carbono, o grafeno e o óxido de grafeno apresentam promissoras características que ampliam sua utilização em diversos segmentos desde eletrônicos até a distribuição de medicamentos. A intensificação da produção e utilização destes NM é acompanhada pela liberação destes nanomateriais no ambiente que pode afetar os organismos vivos, principalmente os animais aquáticos. Entretanto, pouco se sabe sobre os efeitos do óxido de grafeno em crustáceos de importância comercial como é o caso do camarão branco Litopenaeus vannamei. Portanto, a presente dissertação teve como objetivo avaliar os efeitos biológicos da exposição ao óxido de grafeno em diferentes tecidos do camarão.