Probing top-gated field effect transistor of reduced graphene oxide monolayer made by dielectrophoresis

We demonstrate a top-gated field effect transistor made of a reduced graphene oxide (RGO) monolayer (graphene) by dielectrophoresis. The Raman spectrum of RGO flakes of typical size of 5 mu m x 5 mu m shows a single 2D band at 2687 cm(-1), characteristic of single-layer graphene.The two-probe current-voltage measurements of RGO flakes, deposited in between the patterned electrodes with a gap of 2.5 mu m using ac dielectrophoresis, show ohmic behavior with a resistance of similar to 37 k Omega. The temperature dependence of the resistance (R) of RGO measured between 305 K and 393 K yields a temperature coefficient of resistance [dR/dT]/R similar to -9.5 x 10(-4)/K, the same as that of mechanically exfoliated single-layer graphene. The field-effect transistor action was obtained by electrochemical top-gating using a solid polymer electrolyte (PEO + LiClO4) and Pt wire. The ambipolar nature of graphene flakes is observed up to a doping level of similar to 6 x 10(12)/cm(2) and carrier mobility of similar to 50 cm(2)/V s. The source-drain current characteristics show a tendency of current saturation at high source-drain voltage which is analyzed quantitatively by a diffusive transport model. (C) 2010 Elsevier Ltd. All rights reserved.

Parallel circuit partitioning on a reduced array architecture

The physical design of a VLSI circuit involves circuit partitioning as a subtask. Typically, it is necessary to partition a large electrical circuit into several smaller circuits such that the total cross-wiring is minimized. This problem is a variant of the more general graph partitioning problem, and it is known that there does not exist a polynomial time algorithm to obtain an optimal partition. The heuristic procedure proposed by Kernighan and Lin1,2 requires O(n2 log2n) time to obtain a near-optimal two-way partition of a circuit with n modules. In the VLSI context, due to the large problem size involved, this computational requirement is unacceptably high. This paper is concerned with the hardware acceleration of the Kernighan-Lin procedure on an SIMD architecture. The proposed parallel partitioning algorithm requires O(n) processors, and has a time complexity of O(n log2n). In the proposed scheme, the reduced array architecture is employed with due considerations towards cost effectiveness and VLSI realizability of the architecture.The authors are not aware of any earlier attempts to parallelize a circuit partitioning algorithm in general or the Kernighan-Lin algorithm in particular. The use of the reduced array architecture is novel and opens up the possibilities of using this computing structure for several other applications in electronic design automation.

STBCs with Reduced Sphere Decoding Complexity for Two-User MIMO-MAC

In this paper, Space-Time Block Codes (STBCs) with reduced Sphere Decoding Complexity (SDC) are constructed for two-user Multiple-Input Multiple-Output (MIMO) fading multiple access channels. In this set-up, both the users employ identical STBCs and the destination performs sphere decoding for the symbols of the two users. First, we identify the positions of the zeros in the R matrix arising out of the Q-R decomposition of the lattice generator such that (i) the worst case SDC (WSDC) and (ii) the average SDC (ASDC) are reduced. Then, a set of necessary and sufficient conditions on the lattice generator is provided such that the R matrix has zeros at the identified positions. Subsequently, explicit constructions of STBCs which results in the reduced ASDC are presented. The rate (in complex symbols per channel use) of the proposed designs is at most 2/N-t where N-t denotes the number of transmit antennas for each user. We also show that the class of STBCs from complex orthogonal designs (other than the Alamouti design) reduce the WSDC but not the ASDC.

Capillary-gravity waves against a corrugated vertical cliff

An analysis involving a transformation of the velocity potential and a Fourier Sine Transform technique is described to study the effect of surface tension on incoming surface waves against a vertical cliff with a periodic wall perturbation. Known results are recovered as particular cases of the general problem considered. An analytical expression is derived for the surface elevation, at far distances from the shore-line, by using Watson's lemma and a representative table of numerical values of the coefficients of the resulting asymptotic expansion is also presented.

Steady compressible flow of granular materials through a wedge-shaped hopper: The smooth wall, radial gravity problem

A continuum model based on the critical state theory of soil mechanics is used to generate stress and density profiles, and to compute discharge velocities for the plane flow of cohesionless materials. Two types of yield loci are employed, namely, a yield locus with a corner, and a smooth yield locus. The yield locus with a corner leads to computational difficulties. For the smooth yield locus, results are found to be relatively insensitive to the shape of the yield locus, the location of the upper traction-free surface and the density specified on this surface. This insensitivity arises from the existence of asymptotic stress and density fields, to which the solution tends to converge on moving down the hopper. Numerical and approximate analytical solutions are obtained for these fields and the latter is used to derive an expression for the discharge velocity. This relation predicts discharge velocities to within 13% of the exact (numerical) values. While the assumption of incompressibility has been frequently used in the literature, it is shown here that in some cases, this leads to discharge velocities which are significantly higher than those obtained by the incorporation of density variation.

Photobleaching reduced fluorescence correlation spectroscopy

A dual beam excitation-depletion pulse technique is proposed for photobleaching reduced fluorescence correlation spectroscopy (FCS). Excitation pulse promote the molecules to the excited singlet state (S-1), a fraction of that population goes to energetically favorable metastable triplet state (T-1) due to strong intersystem crossing. The depletion pulse followed by excitation pulse instantaneously depletes the triplet states thereby recycling the bleached molecules back to the ground state (S-0). FCS study on diffusing Fluorescein and Rh6G molecules show more than 95% reduction in triplet state population and the associated photobleaching. (c) 2010 American Institute of Physics.

Parallel min-cut placement on reduced hardware SIMD architecture.

Massively parallel SIMD computing is applied to obtain an order of magnitude improvement in the executional speed of an important algorithm in VLSI design automation. The physical design of a VLSI circuit involves logic module placement as a subtask. The paper is concerned with accelerating the well known Min-cut placement technique for logic cell placement. The inherent parallelism of the Min-cut algorithm is identified, and it is shown that a parallel machine based on the efficient execution of the placement procedure.

Steady incompressible flow of cohesionless granular materials through a wedge-shaped hopper: Frictional 14kinetic solution to the smooth wall, radial gravity problem

Hybrid frictional-kinetic equations are used to predict the velocity, grain temperature, and stress fields in hoppers. A suitable choice of dimensionless variables permits the pseudo-thermal energy balance to be decoupled from the momentum balance. These balances contain a small parameter, which is analogous to a reciprocal Reynolds number. Hence an approximate semi-analytical solution is constructed using perturbation methods. The energy balance is solved using the method of matched asymptotic expansions. The effect of heat conduction is confined to a very thin boundary layer near the exit, where it causes a marginal change in the temperature. Outside this layer, the temperature T increases rapidly as the radial coordinate r decreases. In particular, the conduction-free energy balance yields an asymptotic solution, valid for small values of r, of the form T proportional r-4. There is a corresponding increase in the kinetic stresses, which attain their maximum values at the hopper exit. The momentum balance is solved by a regular perturbation method. The contribution of the kinetic stresses is important only in a small region near the exit, where the frictional stresses tend to zero. Therefore, the discharge rate is only about 2.3% lower than the frictional value, for typical parameter values. As in the frictional case, the discharge rate for deep hoppers is found to be independent of the head of material.

Synthesis of Reduced Metabolites of Isoflavonoids, and their Enantiomeric Forms

Isoflavonoids are naturally occurring plant derived biochemicals, which act as phytoalexins. Isoflavonoids are of interest due to their estrogenic and other potential physiological properties, particularly in mammals that typically consume isoflavonoid rich nutrients such as soy and red clover. The literature review of this thesis mainly focuses on the reduced metabolites of hydroxy and/or methoxy substituted isoflavones with four groups: isoflavan-4-ols, isoflav-3-enes, isoflavans and α-methyldeoxybenzoins (1,2-diarylpropan-1-ones), which are all reduced metabolites of food derived isoflavones in mammals. Related isoflavan-4-ones are briefly discussed. Results of an extensive survey of the literature concerning the synthesis of polyhydroxy- or methoxysubstituted isoflavonoids and especially asymmetric approaches are discussed. The experimental section describes new synthetic methods to prepare polyphenolic reduced isoflavonoid structures such as isoflav-3-enes, isoflavan-4-ones, cis- and trans-isoflavan-4-ols, 1,2-diarylpropan-1-ones and isoflavans by various hydride reagents and hydrogenations. The specific reactivity differences of various hydride reagents toward isoflavonoids are discussed. The first enantioselective synthesis of natural (S)-(-)-equol and the opposite enantiomer (R)-(+)-equol is also described by the asymmetric iridium PHOX catalysed hydrogenation of isoflav-3-enes. Both of these equol enantiomers are found to possess biological activity in mammals due to estrogen receptor binding activity. The natural enantiomer prefers estrogen receptor β and the R-enantiomer prefers the estrogen receptor α. Also the precursor, isoflav-3-ene, is found to possess positive biological effects on mammals. In connection with the synthetic work, the (S)-(-)-equol was discovered from serum of ewes after isoflavone rich red clover feeding. The chiral HPLC method was developed to identify natural equol enantiomer for the first time in this species. The first synthesis of natural isoflavonoid (R)-(-)-angolensin and its enantiomer (S)-(+)-angolensin is desribed by the use of recyclable chiral auxiliaries (chiral pseudoephedrines). The method offers a general approach also to other natural polyphenolic 1,2-diarylpropan-1-ones and to further study isoflavonoid metabolism in human and other mammals. The absolute configurations of these new chiral isoflavonoid metabolites were determined by X-ray spectroscopy. Also thorough NMR and MS analysis of synthesised structures are presented.