Understanding and Managing the Late Time of Ratooning Effect on Cane Yield

Each year growers are faced with the decision of when to harvest individual blocks of sugarcane throughout the harvest season. This decision influences the yield of the current crop and can affect the yield in the following season. Growers must therefore decide which blocks to harvest early and which to harvest later in the harvest season. Usually, the latest harvested cane is the lowest yielding the following year (the �late harvest� effect). Block productivity data from Tully were used to determine the effects of harvest timing on cane yield of the current and subsequent crop. The results are tabulated to provide a ready reference to these time of harvest effects on the current and future crop in either a single year or over the full crop cycle for the Tully district.

Sugar and coffee: A history of settler agriculture in nineteenth-century Liberia

This dissertation is about commercial agriculture in nineteenth-century Liberia. Based primarily on the archives of the American Colonization Society (founder of Liberia), it examines the impact of environmental and demographic constraints on an agrarian settler society from 1822 to the 1890s. Contrary to the standard interpretation, which linked the poor state of commercial agriculture to the settlers' disdain for cultivation, this dissertation argues that the scarcity of labor and capital impeded the growth of commercial agriculture. The causes of the scarcity were high mortality, low immigration and the poverty of the American “Negroes” who began to settle Liberia in 1822. ^ Emigration to Liberia meant almost certain death and affliction for many immigrants because they encountered a new set of diseases. Mortality was particularly high during the early decades of colonization. From 1822 to 1843, about 48 percent of all immigrants died of various causes, usually within their first year. The bulk of the deaths is attributed to malaria. There was no natural increase in the population for this early period and because American “Negroes” were unenthusiastic about relocation to Liberia, immigration remained sparse throughout the century. Low immigration, combined with the high death rate, deprived the fledgling colony of its potential human resource, especially for the cultivation of labor-intensive crops, like sugar cane and coffee. Moreover, even though females constituted approximately half of the settlers, they seldom performed agricultural labor. ^ The problem of labor was compounded by the scarcity of draft animals. Liberia is in the region where trypanosomiasis occurs. The disease is fatal to large livestock. Therefore, animal-drawn plows, common in the United States, were never successfully transplanted in Liberia. Besides, the dearth of livestock obstructed the development of the sugar industry since many planters depended on oxen-powered mills because they could not afford to buy the more expensive steam engine mills. ^ Finally, nearly half of the immigrants were newly emancipated slaves. Usually these former bondsmen arrived in Liberia penniless. Consequently, they lacked the capital to invest in large-scale plantations. The other categories of immigrants (e.g., those who purchased their freedom), were hardly better off than the emancipated slaves. ^

Aproveitamento sustentável do bagaço de cana de açúcar para obtenção do acetato de celulose

The sustainable use of waste resulting from the agribusiness is currently the focus of research, especially the sugar cane bagasse (BCA), being the lignocellulosic waste produced in greater volume in the Brazilian agribusiness, where the residual biomass has been applied in production energy and bioproducts. In this paper, pulp was produced in high purity from the (BCA) by pulping soda / anthraquinone and subsequent conversion to cellulose acetate. Commercial cellulose Avicel was used for comparison. The obtained cellulose acetate was homogeneous acetylation reaction by modifying the variables, the reaction time in hours (8, 12, 16, 20 and 24) and temperature in ° C (25 and 50). FTIR spectra showed characteristic bands identical to cellulosic materials, demonstrating the efficiency of separation by pulping. The characterization of cellulose acetate was obtained and by infrared spectroscopy (FTIR), X-ray diffraction (XRD), thermogravimetric analysis (TG / DTG / DSC), scanning electron microscopy (SEM) and determining the degree of substitution (DS ) for the cellulose acetate to confirm the acetylation. The optimal reaction time for obtaining diacetates and triacetates, at both temperatures were 20 and 24 h. Cellulose acetate produced BCA presented GS between 2.57 and 2.7 at 25 ° C and 50 ° C GS obtained were 2.66 and 2.84, indicating the actual conversion of cellulose BCA of di- and triacetates. Comparative mode, commercial cellulose Avicel GS showed 2.78 and 2.76 at 25 ° C and 2.77 to 2.75 at 50 ° C. Data were collected in time of 20 h and 24 h, respectively. The best result was for the synthesis of cellulose acetate obtained from the BCA GS 2.84 to 50 ° C and 24 hours, being classified as cellulose triacetate, which showed superior result to that produced with the commercial ethyl cellulose Avicel, demonstrating converting potential of cellulose derived from a lignocellulosic residue (BCA), low cost, prospects of commercial use of cellulose acetate

Caracterización de residuos de banano (pseudotallo y hojas) mediante análisis termogravimétrico para uso potencial como biocombustible sólido

Una alternativa para la producción de biocombustibles consiste en la transformación de residuos lignocelulósicos, entre los que se encuentran biomasas maderables y no maderables. Colombia al ser un país rico en recursos agrícolas genera grandes cantidades de residuos provenientes de monocultivos como es el café, la caña de azúcar, el banano entre otros. Los residuos de banano se producen en zonas en donde el acceso a la energía es escaso y el tratamiento actual dado a estos residuos se centra en los biológicos buscando un producto que ayude a disminuir la aplicación de fertilizantes a la tierra. Con este proyecto se busca estudiar el potencial aprovechamiento de estos residuos para su implementación como biocombustible para la combustión y obtener energía a partir de los mismos. En este trabajo se realizó una caracterización de los residuos de la planta del banano (pseudotallo y hoja) mediante análisis termogravimétrico con una termobalanza TA Instrument TGA Q500IF, con el fin de definir el contenido de los tres componentes principales (hemicelulosa, celulosa y lignina). Los experimentos fueron realizados bajo condiciones de pirólisis y por medio de un algoritmo implementado con la herramienta Scilab. Además, el objetivo fue desarrollar una herramienta para determinar los contenidos de cenizas, contenido de humedad, contenido de residuo carbonoso y contenidos de hemicelulosa, celulosa y lignina para un reactor de combustión desde un análisis termogravimétrico. Los valores encontrados permiten concluir que tanto el pseudotallo como la hoja de la planta de banano son residuos potenciales de aprovechamiento en el proceso de combustión con fines de generación de energía.

Amino acid composition of processed fish silage using different raw materials

The objective was to evaluate amino acid composition of silages produced from three raw materials. Commercial marine fish waste, commercial freshwater fish waste, and tilapia filleting residue were used to produce fish silage by acid digestion (20 ml/kg formic acid and 20 ml/kg sulfuric acid) and anaerobic fermentation (50 g/kg Lactobacillus plantarum, 150 g/kg sugar cane molasses). Protein content and amino acid composition were determined for raw materials and silage. Marine fish waste had higher crude protein content (776.7 g/kg) compared to freshwater fish waste (496.2 g/kg) and tilapia filleting residue (429.9 g/kg). All silages lacked up to three amino acids for each product according to FAO standards for essential amino acids. However, considering as the limiting factor only the amino acids below the 30% minimum requirement for fish in general, all products were satisfactory with respect to essential amino acids. Therefore, the results suggest that all products investigated are appropriate for use in balanced fish diets. (C) 2003 Elsevier B.V. B.V. All rights reserved.

Ocorrência de micorrizas arbusculares e da bactéria diazotrofica Acetobacter diazotrophicus em cana-de-açúcar.

Foi avaliada a ocorrência e a distribuição de espécies de fungos micorrízicos arbusculares e A. diazotrophicus em plantios de cana-de-açúcar em diferentes tipos de manejo nos Estados do Rio de Janeiro e Pernambuco. Foram feitas 35 coletas de amostras de solo da rizosfera e de raízes de 14 variedades de cana-de-açúcar para extração de esporos e isolamento da bactéria. O numero de esporos variou de 18 a 2.070/ 100 mL de solo, e os maiores numero e diversidade de espécies foram verificados nos canaviais de Campos, RJ, especialmente naqueles que não adotam a queima de palhico. As espécies predominantes nas três localidades amostradas foram: Acaulospora sp., Scutellospora heterogama, Glomus etunicatum, Glomus occultum e Gigaspora margarita. A. diazotrophicus estava presente nas amostras de raízes colhidas em canaviais de Campos, com exceção de uma coleta de cana-de-açúcar plantada num solo usado como bacia de sedimentação de vinhaça. Não foi possível isolar essa bactéria a partir de esporos desinfestados dos FMAs nativos, apenas dos esporos lavados com agua estéril The occurrence and distribution of species of arbuscular mycorrhizae fungi and Acetobacter diazotrophicus in sugar cane (Saccharum officinarum) grown in different regimes of crop management in the States of Rio de Janeiro and Pernambuco were studied. Thirty five samples of the rhizosphere soil and roots were collected from 14 varieties of sugar cane for the extraction of spores and isolation of the bacterium. The number of spores varied from 18 to 2.070 per 100 mL of soil, and the greatest diversity of fungal species was found in the sugarcane fields of Campos (Rio de Janeiro State), especially in those where the sugarcane trash was not burned at harvest. The predominant species found in the three localities sampled were: Scutellospora heterogama, Glomus etunicatum, Glomus occultum, Glomus macrocarpum, Acaulospora sp. and Gigaspora margarita. A. diazotrophicus was present in almost all samples of root with the exception of one harvest of sugar cane taken from an area used for the sedimentation of vinasse (distillery waste). It was not possible to detect the bacterium from surface sterilised spores of native arbuscular mycorrhizal fungi (AMF), only from washed ones using sterile water.

Sistema de monitoramento de perdas visíveis de cana-de-açúcar em colhedora de cana picada

In the last few years the sugar-cane mechanical harvested area has increased, especially in regions with appropriated slop. The use of this technology brings some inconveniences, such as, the increase in the percentage of extraneous matter, which causes the reduction of technological quality of the raw material, and losses in the field. Extraneous matter (trash) is composed of tops and leaves in major percentage, plus soil and roots, and eventually some metal parts. In the green cane harvest system the percentage of extraneous matter has a tendency to increase due to the great amount of vegetal matter to be processed. The increase in the blower fan speed to reduce the amount of extraneous matter can lead to an unacceptable economic level of raw material losses. The main objective of this work was, using a cane loss monitor, to evaluate and quantify the amount of visible losses of sugar cane through the primary extractor at two different fan speeds. Afterwards these losses were related to the harvester cleaning efficiency. The piezoelectric transducer shows a reasonable sensibility. The results show that the cleaning efficiency in the primary extractor (85% mean), the cane losses (between 5.68% and 2.15%) and fan speed are interrelated. The total losses and specially splinters (between 3.19% and 0.91%), showed a significant difference among the treatments.

Projeto de um cortador de base para colhedora de cana-de-açúcar utilizando otimização matemática

A base-cutter represented for a mechanism of four bars, was developed using the Autocad program. The normal force of reaction of the profile in the contact point was determined through the dynamic analysis. The equations of dynamic balance were based on the laws of Newton-Euler. The linkage was subject to an optimization technique that considered the peak value of soil reaction force as the objective function to be minimized while the link lengths and the spring constant varied through a specified range. The Algorithm of Sequential Quadratic Programming-SQP was implemented of the program computational Matlab. Results were very encouraging; the maximum value of the normal reaction force was reduced from 4,250.33 to 237.13 N, making the floating process much less disturbing to the soil and the sugarcane rate. Later, others variables had been incorporated the mechanism optimized and new otimization process was implemented .

Colheita de cana-de-açúcar com auxílio mecânico

Civil society and sugarcane farmer demands indicate that harvesting technology has enough limitations to jeopardize production in large sugar cane producing areas. This work analyses the current mechanical harvesting compared to a semi-mechanical harvesting proposal, on the bases of eleven characteristics considered determinant for a quick spreading of green cane harvesting on hilly areas, with lower impact on agricultural labor and farmers investment capacity.

Análise de aspectos socioeconômicos e tecnológicos da agropecuária na Bacia Hidrográfica do Rio Mogi Guaçu

Currently, owing to the occurrence of environmental problems, along with the need of environmental preservation, both the territory management of Hydrographic Basin and the conservation of natural resources have proven to have remarkable importance. Thus, the mean goal of the research is to raise and scrutinize social-economic and technologic data from the Mogi Guaçu River Hydrographic Basin (São Paulo, Brazil). The aim is to group municipalities with similar characteristics regarding the collected data, which may direct joint actions in the Hydrographic Basin Management. There were used both the methods of factorial analysis and automatic hierarchical classifications. Additionally, there is going to be applied a Geographical Information System to represent the outcomes of the methods aforementioned, through the evolvement of a geo-referenced database, which will allow the obtainment of information categorically distributed including theme maps of interest. The main characteristics adopted to group the municipalities were: agricultural area, sugar cane production, small farms, animal production, number of agriculture machinery and equipments and agricultural income. The methodology adopted in the Mogi Guaçu River Hydrographic Basin will be analyzed vis-à-vis its appropriateness on basin management, as well as the possibility of assisting the studies on behalf of the São Paulo Hydrographic Basin groups, to regional development.