949 resultados para Solvent Extractable Biomarkers
Resumo:
The phase transition of two kinds of solvent-induced crystalline syndiotactic polystyrene (sPS). gamma-sPS and delta(c)-sPS, has been studied via WAXD and DSC. gamma-sPS transform to a-sPS at 195-225 degrees C before melt during heating, whereas delta(e)-sPS transform to first gamma-sPS and then a-sPS at 100-200 degrees C and 200-215 degrees C, respectively. The transition of delta(e)-gamma and gamma-a occurs for below melting point of sPS indicates they are all solid-solid transition.
Resumo:
A novel method for the highly sensitive determination of perchlorate was proposed. It was based on solvent extraction in the presence of Ru(bpy)(3)(2+) followed by Ru(bpy)(3)(2+) electrochemiluminescent determination. A linear calibration was obtained over the range of 0.1 to 10 mu mol l(-1) with a correlation coefficient of 0.998. The detection limit (S/N = 3) was 5.0 x 10(-8) mol l(-1). The relative standard deviation for 10 replicates of 1 mu mol l(-1) perchlorate was 1.6%. Interference studies suggest that this method is selective for the determination of perchlorate. Application of this method to the highly sensitive determination of other anions is suggested. (C) 1999 Elsevier Science S.A. All rights reserved.
Resumo:
The heterogeneous electron transfer rate constant (k(s)) of dimethylferrocene (DMFc) was estimated using cyclic voltammetric peak potential separations taken typically in a mixed diffusion geometry regime in a polyelectrolyte, and the diffusion coefficient (D) of DMFc was obtained using a steady-state voltammogram. The heterogeneous electron transfer rate constant and diffusion coefficient are both smaller by about 100-fold in the polymeric solvent than in the monomeric solvent. The results are in agreement with the difference of longitudinal dielectric relaxation time (tau(L)) in the two kinds of solvents, poly(ethylene glycol) (PEG) and CH3CN, indicating that k(s) varies inversely with tau(L); k(s), is proportional to D of DMFc. Both D and k(s) of DMFc in PEG containing different supporting electrolytes and at different temperatures have been estimated. These results show that D and k(s) of DMFc increase with increasing temperature in the polyelectrolyte, whereas they vary only slightly with changing the supporting electrolyte.
Resumo:
The extraction equilibria of Sc(III), Zr(IV), Ti(IV), Th(IV), Fe(III) and Lu(III) from sulphuric or hydrochloric acid media by Cyanex 923 (mixture of straight chain alkylated phosphine oxides) and Cyanex 925 (mixture of branched chain alkylated phosphine oxides) were studied at various aqueous acidities. The extractant Cyanex 923 demonstrated better scandium loading and selectivity for TI(IV). Fe(III) and Lu(III) than Cyanex 925. The effects of extractant concentration on the extractions of sulphuric acid and Sc(III) by Cyanex 923 were examined. The stoichiometries of the extraction reactions were postulated based on slope analysis. The experimental results indicate that Cyanex 923 can be employed to recover scandium directly from the hydrolytic mother solution arising from TiO2 production via the sulphate process. The parameters studied were scandium loading capacity, phase ratio, concentrations of Ti(IV) scrubbing and Sc(III) stripping agents. A new solvent extraction technology of scandium recovery was developed. The purity of the final Sc(III) product is above 95% with a yield > 94%. (C) 1998 Elsevier Science B.V.
Resumo:
Gadolinium fullerenols, as novel and potential contrast agents for magnetic resonance imaging, were synthesized, which showed excellent efficiency in enhancing water proton relaxation with a relaxivity of 47.0+/-1.0 mM(-1).s(-1).
Resumo:
The responses of a cryohydrogel tyrosinase enzyme electrode to four substrates in three pure water immiscible organic solvents were investigated. Kinetic parameters, the maximum kinetic current, I-max, the apparent Michaelis-Menten constant, K-m(app), and I-max/K-m(app), were calculated. The I-max/K-m(app) value was taken as an indicator of the catalytic efficiency of the sensor. The effect of the substrate hydrophobicity on I-max/K-m(app) and response time of the sensor were discussed. The effects of both hydrophobicity (log P) and dielectric constant (epsilon) of the organic solvent on the catalytic efficiency of the enzyme in the organic phase were studied. (C) 1997 Elsevier Science S.A.
Resumo:
Mass spectra of LaxC2n (x = 1,2), well known endohedral metallofullerenes, and Lu2C2n (2n = 76-112), new members of extractable metallofullerenes, were studied. Positive-ion laser desorption/ionization (LDI) and electron impact (EI) mass spectra indicated that lutetium is a special lanthanide that prefers to form dilutetium fullerenes by the are-burning method. However, the signals for Lu2C2n become very weak in negative-ion LDI-MS, this is different from La-2@C-80, which has close relative abundances in positive- and negative-ion MS. The distinction between Lu2C2n and La-2@C-80 in the negative-ion LDI mass spectra may be due to the different structures of La- and Lu-containing fullerenes. (C) 1997 by John Wiley & Sons, Ltd.
Resumo:
Upper and lower critical solution temperature (UCST and LCST) behaviours have been examined for solution of PHB/PBHE blends in chloroform and chlorobenzene. Polymer-Solvent systems prepared with various solvents and concentrations were found to possess UCST and LCST characteristics. PHB/PBHE solution in chloroform displayed greater miscibility temperature region than that of the blend in chlorobenzene, but the relative tendency of both UCST and LCST were similar.
Resumo:
The solvent extraction of Sc(III), Zr(IV), Th(IV), Fe(III) and Lu(III) with Cyanex 302 (bis(2,4,4-trimethylpentyl)monothiophosphinic acid) and Cyanex 301 ( bis(2,4,4-trimethylpentyl) dithiophosphinic acid) in n-hexane from acidic aqueous solutions has been investigated systematically. The effect of equilibrium aqueous acidity on the extraction with these reagents was studied. The separation of Th(IV), Fe(III) and Lu(III) from Sc(III), or the separation of other metals from Lu(III) with Cyanex 302, can be achieved by controlling the aqueous acidity. However, Cyanex 301 exhibited a poor selectivity for the above metals, except for Lu(III). The extraction of these metals with Cyanex 272, Cyanex 302 and Cyanex 301 has been compared. The stripping percentages of Sc(III) for Cyanex 302 and Cyanex 301 in a single stage are near 78% and 75% with 3.5 mol/L and 5.8 mol/L sulphuric acid solutions, respectively. The effects of extractant concentration and temperature on the extraction of Sc(III) were investigated. The stoichiometry of the extraction of Sc(III) with Cyanex 302 was determined. The role of different components of Cyanex 302 in the extraction of Sc(III) was discussed.
Resumo:
The differences between the solvent extraction of Tb(III) and Tb(IV) periodate complexes with quaternary amine were studied carefully for the first time. The effects of extractant concentration, phase ratio, the pH value of stock solution, salting-out agent, extractant form, diluent, and extraction time were comprehensively investigated. Under optimal conditions the separation factor between Tb(IV) and Tb(III) periodate complexes is over 5.5.
Resumo:
A new method for electrochemically in situ conductivity measurements based on a reusable glassy carbon disc carbon fibre array double electrode is described. Using this technique and cyclic voltammetry, we have investigated the effects of the doping anion and solvent on the electrochemical properties of polypyrrole film. The electroactivity and potential dependent conductivity of polypyrrole film are strongly affected by solvent and the doping anion's solubility in the solvent, and also by the history of electrochemical treatments in different electrolyte solutions. It is very interesting that NO3-doped polypyrrole can completely keep its conducting state (doped state) at a reasonably negative potential (eg -0.8 V vs. sce) in acetonitrile solutions.
Resumo:
An expert system for solvent extraction of rare earths has been developed using LISP. The goal of this project was to mimic the chemists' inferential abilities to assist in the process of solvent extraction of rare earths. The system includes frequently used extractants, separation of specific rare earths, recommendation of procedures for the separation of mixtures of rare earths using (2-ethylhexyl)phosphonic acid 2-ethylhexyl monoester, selection of parameters for counter-current extraction and methods for evaluation of the technique, and the economics of the processing. The expert system runs on an IBM-PC/XT.
Triterpane and sterane biomarkers in the YA13-1 condensates from Qiongdongnan Basin, South China Sea
Resumo:
Triterpanes and steranes in condensates from the YA13-1 gas field, Qiongdongnan Basin, were monitored. The YA13-1 condensates have unusual biomarker distributions dominated by terpanes and steranes derived from higher plants. Anomalously abundant 1 got-oleanane and remarkably abundant bicadinanes are present in the YA13-1 condensates, whereas the 17alpha-hopane contents are extremely low. Taraxastane and significantly abundant 17alpha-diahopanes occur in the condensates. In addition, a number of unknown C-29 and C-30 pentacyclic triterpanes including previously unreported compounds were detected in the condensates, some of which are significantly abundant. The unknown compounds may be terrestrial biomarkers. C-29 homologues are relatively predominant among the regular and rearranged steranes. The diasterane concentrations are markedly higher than those of regular steranes. The maturity of the YA13-1 condensates is relatively high, at the peak to late oil generation stage (corresponding to 0.85-1.10% Ro), based on sterane and terpane and including bicadinane maturity parameters (i.e. T/(T-1 + R) and 2T/R bicadinane ratios). The above maturity assessment result is different from that based on diamondoid maturity parameters (%Ro = 1.60-1.70) [Org. Geochem. 25 (1996) 179], which can be explained by a contribution of hydrocarbons from two sources at different depths. The YA13-1 condensates were probably generated from the Yacheng and Lingshui coal-bearing source rocks buried both in the Qiongdongnan Basin (3400-5000 m) and in the Yinggehai Basin (>5000 m). The possible contribution of lower maturity hydrocarbons from the Yacheng and Lingshui Formations (3400-4100 m) in the Qiongdongnan Basin to the YA13-1 gases and condensates should not be neglected. (C) 2003 Elsevier Science B.V. All rights reserved.
Resumo:
Food Sources of three filter-feeding bivalves from two habitats (intertidal oyster Crassostrea gigas, mussel Mytilus galloprovincialis. and subtidal cultured scallop Chlamys farreri) of Jiaozhou Bay (Qingdao,China) were determined by fatty acid and stable isotope in analysis. Cultured scallop was characterized by significant diatom markets such as 16:1/16:0 close to 1 and high ratio of 20:5(n - 3)/22:6(n - 3), hence we assume that the scallop mainly feeds on diatoms. Fatty acid biomarkers specific to bacteria and terrestrial materials were also found in considerable amounts in scallop tissue, which suggested that there were Substantial bacterial and terrestrial input into the food of the species. Intertidal oyster and mussel, however, exhibited significant flagellate marker. 22:6(n - 3). and lower level of diatom markers. which indicated that flagellates are also part of intertidal bivalves' Planktonic food Sources: meanwhile, high level of Chlorophyta fatty acid marker, Sigma 18:2(n - 6) + 18:3(n - 3), suggested that Ulva pertusa (Chlorophyta) seaweed bed supplied important food sources to intertidal bivalves. Additionally, result of stable isotope analysis showed that phytoplankton contributed 86.2 to 89.0% to intertidal bivalves' carbon budget; macroalga U. pertusa origin source had a contribution of MIX, to 11.0%, which indicated its role Lis in important supplemental food source to intertidal bivalves. From this study. it is concluded that the dietary difference of three bivalves probably relates to the different potential food sources in the scallop farm and intertidal zone in Jiaozhou Bay.
Resumo:
The IR spectrum of 4-methyl-3-penten-2-one is interpreted with the aid of normal coordinate calculations within the Onsager self-consistent reaction field (SCRF) model, using a density functional theory (DFT) method at the Becke3LYP/6-31G* level. The solvent effects on the geometry, energy, dipole moment, and vibrational frequencies of 4-methyl-3-penten-2-one in the solution and in the liquid phase are calculated using the Onsager SCRF model. The calculated vibrational frequencies in the liquid-phase are in good agreement with the experimental values. The solvent reaction field has generally weak influence. For the two main bands of C=C and C=O mixed vibrational modes, small frequency shifts (5-6 cm(-1)), but relatively large changes in IR intensities (up to 101 km mol(-1) in the liquid phase) are found. (C) 1999 Elsevier Science BV. All rights reserved.