Spray visualisation and acoustic analysis in a gas-turbine type burner

This paper presents the characterisation of self-excited oscillations in a kerosene burner. The combustion instability exhibits two different modes and frequencies depending on the air flow rate. Experimental results reveal the influence of the spray to shift between these two modes. Pressure and heat release fluctuations have been measured simultaneously and the flame transfer function has been calculated from these measurements. The Mie scattering technique has been used to record spray fluctuations in reacting conditions with a high speed camera. Innovative image processing has enabled us to obtain fluctuations of the Mie scattered light from the spray as a temporal signal acquired simultaneously with pressure fluctuations. This has been used to determine a transfer function relating the image intensity and hence the spray fluctuations to changes in air velocity. This function has identified the different role the spray plays in the two modes of instability. At low air flow rates, the spray responds to an unsteady air flow rate and the time varying spray characteristics lead to unsteady combustion. At higher air flow rates, effective evaporation means that the spray dynamics are less important, leading to a different flame transfer function and frequency of self-excited oscillation. In conclusion, the combustion instabilities observed are closely related with the fluctuations of the spray motion and evaporation.

On-line topographic analysis in the SEM

A novel method for on-line topographic analysis of rough surfaces in the SEM has been investigated. It utilises a digital minicomputer configured to act as a programmable scan generator and automatic focusing unit. The computer is coupled to the microscope through digital-to-analogue converters which enable it to generate ramp waveforms allowing the beam to be scanned over a small sub-region of the field under program control. A further digital-to-analogue converter regulates the current supply to the objective lens of the microscope. The video signal is sampled by means of an analogue-to-digital converter and the resultant binary code stored in the computer's memory as an array of numbers describing relative image intensity. Computations based on the intensity gradient of the image allow the objective lens current to be found for the in-focus condition, which may be related to the working distance through a previous calibration experiment. The sensitivity of the method for detecting small height changes is theoretically of the order of 1 μm. In practice the operator specifies features of interest by means of a mobile spot cursor injected into the SEM display screen, or he may scan the specimen at sub-regions corresponding to pre-determined points on a regular grid defined by him. The operation then proceeds under program control. | A novel method for on-line topographic analysis of rough surfaces in the SEM has been investigated. It utilizes a digital minicomputer configured to act as a programmable scan generator and automatic focusing unit. A further digital-to-analog converter regulates the current supply to the objective lens of the microscope. The video signal is sampled by means of an analog-to-digital converter and the resultant binary code stored in the computer's memory as an array of numbers describing relative image intensity. The sensitivity of the method for detecting small height changes is theroretically of the order of 1 mu m.

Topographical analysis in the SEM using an automatic focusing technique

A novel technique for automated topographical analysis in the SEM has been investigated. It utilizes a 16-bit minicomputer arranged to act as an automatic focusing unit. The computer is coupled to the objective lens of the microscope, by means of a digital to analogue converter, and may regulate the excitation of the lens under program control. Further digital-to-analogue converters allow the computer to act as a programmable scan generator by applying ramp waveforms to the scan amplifiers, permitting the beam to be swept over a small sub-region of the field of interest. The video signal is sampled and applied to an analogue-to-digital converter; the resultant binary numbers are stored in computer memory as an array of values representing relative image intensities within a subregion. A differencing algorithm applied to the collected data allows the level of objective lens excitation to be found at which the sharpness of the image is optimized, and the excitation may be related to the working distance for that subregion through a previous calibration experiment. The sensitivity of the method for detecting small height changes is theoretically of the order of 1 μm.

Estimation of ploidy and hybridization status by erythrocyte and nucleus size analysis in carps

The present experiment was designed to observe whether the nuclear volume and area are affected by the ploidy and hybrid status of the individual. Polyploidy was induced by heat shock treatment given at 44 ± 0.5°C for 30 seconds and 45 seconds which was found to be most effective (64.7%) for induction of triploidy in Cyprinus carpio. Cell and nuclear volume and cell and nuclear area varied significantly in triploid fishes as compared to those of controls. Triploid fishes showed significantly higher growth compared to diploid counterparts. It was also observed that catla x rohu hybrid and its parents showed significant difference in the nuclear volume and area of their erythrocytes. Except nuclear volume, all the parameters were significantly different between catla and catla x rohu hybrid. The hybrids showed a closer relationship with catla as compared to rohu.

Vibration and stress analysis in the presence of structural uncertainty

At medium to high frequencies the dynamic response of a built-up engineering system, such as an automobile, can be sensitive to small random manufacturing imperfections. Ideally the statistics of the system response in the presence of these uncertainties should be computed at the design stage, but in practice this is an extremely difficult task. In this paper a brief review of the methods available for the analysis of systems with uncertainty is presented, and attention is then focused on two particular "non- parametric" methods: statistical energy analysis (SEA), and the hybrid method. The main governing equations are presented, and a number of example applications are considered, ranging from academic benchmark studies to industrial design studies. © 2009 IOP Publishing Ltd.

Application of the phylogenetic analysis in mitochondrial disease study

Mitochondrial disease currently received an increasing concern. However, the case-control design commonly adopted in this field is vulnerable to genetic background, population stratification and poor data quality. Although the phylogenetic analysis could

Women in fisheries in Africa

The diverse and productive fisheries in Africa’s coastal countries depend greatly on the contributions of women, who are today increasingly asserting their right to livelihood and support. The 30,490 km of coastline around the African continent is home to many small-scale traditional fishing communities who depend on these shores for their livelihoods. In addition, the continent hosts vast lakes which provide critical sources of food and livelihoods for many inland communities.

Fishery resources: their exploitation, management and conservation in Africa

The beginning of the 20th century saw the discovery of Africa's vast natural resources. Not only did explorers "discover" lakes, rivers, forests and mountains but scientists and naturalists also "discovered what at that time were called new species of plants, fish and other animals. Thus scientific names were tagged to various species using the famed binomial nomenclature and immortalising the names of some of the people who first described those species. Africa of course abounds with thousands of different floral and faunal varieties and the early colonial scientists found the African environment lucrative fron the point of discovery of new species. This paper therefore attempts to descrihe the role science could only in the development and exploitation of one of Africa's renewable resources namely fisheries. This paper has attempted to expose the value of fish in human nutrition, provision of employment and uplifting of social and economic standards. The fishery resources of Africa are extensive and in the main not fully exploited. These resources like other natural resources are exhaustible although renewable. Efforts to exploit these resources must be encouraged but scientific planning and management of the resource is called for.