Análise da estrutura genética populacional de duas espécies de Characiformes (Pygocentrus nattereri e Potamorhina latior) na região da bacia do Rio Madeira, Rondônia

Pós-graduação em Ciências Biológicas (Zoologia) - IBB

Predictive capacity of anthropometric indicators for abdominal fat in the oldest old

Cardiovascular diseases are a growing public health problem that affects most people over the age of 65 years and abdominal obesity is one of the risk factors for the development of these diseases. There are several methods that can be used to measure body fat, but their accuracy needs to be evaluated, especially in specific populations such as the elderly. The aim of this study was to assess the accuracy of anthropometric indicators to estimate the percentage of abdominal fat in subjects aged 80 years or older. A total of 125 subjects ranging in age from 80 to 95 years (83.5 ± 3), including 79 women (82.4 ± 3 years) and 46 men (83.6 ± 3 years), were studied. The following anthropometric indicators were used: body mass index (BMI), waist circumference (WC), waist-hip ratio (WHR), and waist-to-height ratio (WHtR). The percentage of abdominal fat was measured by DEXA. Sensitivity and specificity were analyzed using an ROC curve. The sensitivity, specificity and AUC were 0. 578, 0. 934 and 0. 756 for BMI, respectively; 0.703, 0.820 and 0.761 for WC; 0.938, 0.213 and 0.575 for WHR, and 0.984, 0.344 and 0.664 for WHtR. BMI and WC were the anthropometric indicators with the largest area under the curve and were therefore more adequate to identify the presence or absence of abdominal obesity.

Mortalidade de idosos em município do Sudeste brasileiro de 2006 a 2011

O objetivo foi descrever a mortalidade entre idosos em Araraquara (SP), no período de 2006 a 2011. Estudo epidemiológico descritivo, tendo como fontes de dados o Sistema de Informações sobre Mortalidade e a Fundação Sistema Estadual de Análise de Dados. Foi calculada razão entre coeficientes de mortalidade por ponto (R) e por intervalo de 95% de confiança (IC95%). Observou-se mais de 60% dos idosos com nível baixo de escolaridade, sendo que 76% faleceram em hospitais. Entre 2006 e 2008, as diferenças foram estatisticamente significantes entre homens e mulheres, predominando as doenças circulatórias com R = 1,41 (IC95%:1,24-1,58), respiratórias com R = 1,49 (IC95%:1,22-1,76) e neoplasias com R = 1,79 (IC95%: 1,40-2,18). Entre 2009 e 2011, obteve-se, para as causas circulatórias R = 1,18 (IC95%:1,03-1,33), sendo significativas as diferenças para as respiratórias com R = 1,33 (IC95%:1,11-1,55) e câncer sendo R = 1,94 (IC95%:1,53-2,35). O diabetes mellitus e as causas externas apareceram, respectivamente, como quarta e quinta causas de mortes mais frequentes na população idosa. O padrão de mortalidade encontrado ressalta a importância de ações voltadas à redução das principais causas de morte, como o incremento da cobertura da vacina contra a influenza e o controle da hipertensão arterial e do diabetes mellitus.

Perda de solo na bacia hidrográfica do Córrego Rico - SP, utilizando técnicas de geoprocessamento

Pós-graduação em Agronomia (Produção Vegetal) - FCAV

Validação dos parâmetros aeróbio e anaeróbio a partir de protocolo não invasivo aplicado ao exercício resistido - supino reto

The purpose of this study was to investigate the validity of critical force test from maximal lactate steady state (MLSS) during resistance test using straight bench press. Five healthy male volunteers aged (22.6 ± 2.88 years), weight (76.3 ± 11.49 kg) e height (182.6 ± 7.54cm), trained in resistance exercise, and performed four diferent test to determine: one maximal effort (1RM), critical force using the critical power model (force vs 1/time limit - 20, 25 and 30% 1RM). The CF was the linear coefficient and the anaerobic impulse capacity (CIA) was the angular. MLSS was determined using loads of 80, 90, 100 and 110% of critical force. Blood lactate samples were abtained at each 300sec between each stage of total 1200sec. Maximal 30s test (M30) was accomplished with load of 25% of body weight in SBP. The results showed that the 1 RM was 79.4 Kgf (± 16.98), CF 10.1N (± 2.25), CIA 1756.82 N.s (± 546.96) and the R² 0.984 (± 0,02). The MLSS occurs at 100% CF load. The lactate concentration at the MLSS was 2.2 mmol/L (± 0.77). Significant correlation was observed between MLSS and CF on SBP (r = 0.88 p = 0.05). In M30 the minimum, mean and peak power were (25.0 ± 4.9, 28.0 ± 4.9, and 30.0 ± 4.6 kgf.rps, respectively). The fatigue index was 18.0% (± 6,8). The M30 was significantly correlated with Ppeak and Pmean (r = 0.98 for both, p = 0.003). The CF means has been validated to predict the resistance training and the CIA show to be a representative anaerobic parameter in straight bench press.

In vitro biomechanical comparison of six different fixation methods following 5-mm sagittal split advancement osteotomies

The sagittal split ramus osteotomy (SSRO) is a surgical technique used widely to treat many congenital and acquired mandibular discrepancies. Stabilization of the osteotomy site and the potential for skeletal relapse after the procedure are still major problems. The aim of this study was to compare the mechanical stability of six methods of rigid fixation in SSRO using a biomechanical test model. Sixty polyurethane replicas of human hemimandibles were divided into six groups. In group I, the osteotomies were fixed with two four-hole titanium miniplates; in group II, with one four-hole miniplate; in group III, with one four-hole miniplate + a bicortical screw; in group IV, with a grid miniplate; in group V, with a four-hole locking miniplate; and in group VI, with a six-hole miniplate. A linear load in the premolar region was applied to the hemimandibles. The resistance forces (N) needed to displace the distal segment by 1, 3, and 5 mm were recorded and the data transmitted from the load cell to a computer. One-way analysis of variance with Tukey's post hoc test was performed to compare the means between groups. For the three displacement conditions, there was a strong tendency for the 2.0-mm plate + screw and the grid plate to have higher values.

General characterization of Tityus fasciolatus scorpion venom. Molecular identification of toxins and localization of linear B-cell epitopes

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Esporte no contexto escolar: estudo do perfil dos professores de educação física qua atuam como técnicos nas olimpíadas estudantis no município de São Paulo

Pós-graduação em Ciências da Motricidade - IBRC

Sexualidade e doenças inflamatórias intestinais

Pós-graduação em Fisiopatologia em Clínica Médica - FMB

Options for the Control of Disease 3: Targeting the Environment

Management of wildlife disease can be targeted at pathogens, hosts or vector populations, but may also focus on the environment. As constituent elements of any given environment, resident wildlife populations, and their pathogens, may be profoundly influenced by environmental change, in terms of their abundance, distribution and behavior. Hence, it is reasonable to expect that incorporation of environmental manipulation into a program to control wildlife diseases may potentially result in outcomes as effective as direct intervention aimed at hosts, pathogens and vectors.

Lean diesel technology and human health: a case study in six Brazilian metropolitan regions

OBJECTIVE: Due to their toxicity, diesel emissions have been submitted to progressively more restrictive regulations in developed countries. However, in Brazil, the implementation of the Cleaner Diesel Technologies policy (Euro IV standards for vehicles produced in 2009 and low-sulfur diesel with 50 ppm of sulfur) was postponed until 2012 without a comprehensive analysis of the effect of this delay on public health parameters. We aimed to evaluate the impact of the delay in implementing the Cleaner Diesel Technologies policy on health indicators and monetary health costs in Brazil. METHODS: The primary estimator of exposure to air pollution was the concentration of ambient fine particulate matter (particles with aerodynamic diameters, <2.5 mu m, [PM2.5]). This parameter was measured daily in six Brazilian metropolitan areas during 2007-2008. We calculated 1) the projected reduction in the PM2.5 that would have been achieved if the Euro IV standards had been implemented in 2009 and 2) the expected reduction after implementation in 2012. The difference between these two time curves was transformed into health outcomes using previous dose-response curves. The economic valuation was performed based on the DALY (disability-adjusted life years) method. RESULTS: The delay in implementing the Cleaner Diesel Technologies policy will result in an estimated excess of 13,984 deaths up to 2040. Health expenditures are projected to be increased by nearly US$ 11.5 billion for the same period. CONCLUSIONS: The present results indicate that a significant health burden will occur because of the postponement in implementing the Cleaner Diesel Technologies policy. These results also reinforce the concept that health effects must be considered when revising fuel and emission policies.

The identification of the pillars of education in the class comprehensiveness in healthcare

The objective of the present study was to verify, based on the analysis of student portfolio narratives, if the four pillars of education were approached in the class "Comprehensiveness in health care", part of the integrated curriculum of the Baccalaureate in Nursing Program of the University of Sao Paulo at Ribeirao Preto College of Nursing. A qualitative, documental study was performed using 46 portfolios constructed during the classes. Data collection was performed using an assessment tool that contained items addressing cognitive and affective dimensions. The data were submitted to thematic categorical analysis using the pillars of education as predefined categories. The results show that the pillars of education were, apparently, included in the class. Despite the present study findings, no evidence was found that the expected competencies were actually discussed among students and faculty, according to the records regarding the evaluations of each pedagogical cycle of the studied class.

Characterization of atmospheric aerosols in the city of So Paulo, Brazil: comparisons between polluted and unpolluted periods

The objective of this study was to determine the size and composition of atmospheric aerosols in the downtown area of the city of So Paulo, Brazil, for a polluted and an unpolluted period. Aerosols were sampled with a portable air sampler (PAS), Micro-Orifice Uniform Deposit Impactor (MOUDI), and Scanning Mobility Particle Sizer. At the study site, air quality is poor, especially during the winter, high concentrations of pollutants being emitted primarily by the light- and heavy-duty vehicle fleet. We analyzed mass, black carbon (BC), Al, Si, P, S, Cl, K, Ca, Ti, V, Cr, Mn, Fe, Ni, Cu, Zn, Br, Rb, Sn, Zr, and Pb. During the polluted period, diurnal PM(10) was higher than nocturnal PM(10), whereas the inverse was true during the unpolluted period. The FPM was rich in BC, S, and Pb, whereas CPM was rich in Al, Si, Ca, Ti, and Fe. Mass balance was performed by category: ammonium sulfate, sodium chloride, crustal material, BC, and other. The PAS-determined FPM was mainly BC. The MOUDI-determined FPM crustal material explained more mass than did ammonium sulfate and BC during the polluted period, whereas ammonium sulfate had the largest mass during the unpolluted period. Crustal material was the major CPM component, followed by ammonium sulfate and BC. During the unpolluted period, FPM concentrations were lower, whereas those of ammonium sulfate were relatively higher, especially at night, and particle number was inversely proportional to particle size. Aerosol growth was more intense during the polluted period.

Within-plant isoprene oxidation confirmed by direct emissions of oxidation products methyl vinyl ketone and methacrolein

Isoprene is emitted from many terrestrial plants at high rates, accounting for an estimated 1/3 of annual global volatile organic compound emissions from all anthropogenic and biogenic sources combined. Through rapid photooxidation reactions in the atmosphere, isoprene is converted to a variety of oxidized hydrocarbons, providing higher order reactants for the production of organic nitrates and tropospheric ozone, reducing the availability of oxidants for the breakdown of radiatively active trace gases such as methane, and potentially producing hygroscopic particles that act as effective cloud condensation nuclei. However, the functional basis for plant production of isoprene remains elusive. It has been hypothesized that in the cell isoprene mitigates oxidative damage during the stress-induced accumulation of reactive oxygen species (ROS), but the products of isoprene-ROS reactions in plants have not been detected. Using pyruvate-2-13C leaf and branch feeding and individual branch and whole mesocosm flux studies, we present evidence that isoprene (i) is oxidized to methyl vinyl ketone and methacrolein (iox) in leaves and that iox/i emission ratios increase with temperature, possibly due to an increase in ROS production under high temperature and light stress. In a primary rainforest in Amazonia, we inferred significant in plant isoprene oxidation (despite the strong masking effect of simultaneous atmospheric oxidation), from its influence on the vertical distribution of iox uptake fluxes, which were shifted to low isoprene emitting regions of the canopy. These observations suggest that carbon investment in isoprene production is larger than that inferred from emissions alone and that models of tropospheric chemistry and biotachemistryclimate interactions should incorporate isoprene oxidation within both the biosphere and the atmosphere with potential implications for better understanding both the oxidizing power of the troposphere and forest response to climate change.