Progress in single junction microcrystalline silicon solar cells deposited by Hot-Wire CVD

Hot-Wire Chemical Vapor Deposition has led to microcrystalline silicon solar cell efficiencies similar to those obtained with Plasma Enhanced CVD. The light-induced degradation behavior of microcrystalline silicon solar cells critically depends on the properties of their active layer. In the regime close to the transition to amorphous growth (around 60% of amorphous volume fraction), cells incorporating an intrinsic layer with slightly higher crystalline fraction and [220] preferential orientation are stable after more than 7000 h of AM1.5 light soaking. On the contrary, solar cells whose intrinsic layer has a slightly lower crystalline fraction and random or [111] preferential orientation exhibit clear light-induced degradation effects. A revision of the efficiencies of Hot-Wire deposited microcrystalline silicon solar cells is presented and the potential efficiency of this technology is also evaluated.

Proteções contra queima solar de frutos de abacaxizeiro submetido a diferentes lâminas de irrigação

O objetivo deste trabalho foi avaliar o uso de proteção contra queima solar e o efeito de diferentes lâminas de irrigação na qualidade dos frutos de abacaxizeiro 'Pérola'. O experimento foi conduzido na área experimental, no município de Janaúba-MG. O sistema de irrigação utilizado foi o gotejamento e a quantidade de lâmina de irrigação aplicada foi calculada com base na evaporação do Tanque Classe-A (ECA). A proteção dos frutos contra queima solar foi realizada após o fechamento das últimas flores. O delineamento foi em blocos casualizados, segundo o esquema de parcelas subdivididas 5 x 5, tendo nas parcelas cinco lâminas de irrigação (30 %, 50 %, 70 %, 100 % e 150 % da ECA) e nas subparcelas 4 tipos de proteção: jornal, saco de papel marrom, TNT branco nº 40 e solução contendo cal a 10 %, além da testemunha, com quatro repetições. Avaliaram-se porcentagem de frutos com queima solar, firmeza, sólidos solúveis totais (SST), acidez total titulável (ATT), pH e relação SST/ATT da polpa. Os frutos protegidos com TNT apresentaram menor porcentagem de queima solar. A lâmina referente a 77 % da ECA, associada à proteção com TNT ou com a cal proporcionam maiores valores de SST.

Control of doped layers in p-i-n microcrystalline solar cells fully deposited with HWCVD

In this paper, the influence of the deposition conditions on the performance of p-i-n microcrystalline silicon solar cells completely deposited by hot-wire chemical vapor deposition is studied. With this aim, the role of the doping concentration, the substrate temperature of the p-type layer and of amorphous silicon buffer layers between the p/i and i/n microcrystalline layers is investigated. Best results are found when the p-type layer is deposited at a substrate temperature of 125 °C. The dependence seen of the cell performance on the thickness of the i layer evidenced that the efficiency of our devices is still limited by the recombination within this layer, which is probably due to the charge of donor centers most likely related to oxygen.

PROTETOR SOLAR DIMINUI A INCIDÊNCIA DAS PODRIDÕES ‘OLHO-D-BOI’ E ‘BRANCA’ EM MAÇÃS ‘FUJI STANDARD’ E ‘PINK LADY’

RESUMO A podridão-olho-de-boi (Cryptosporiosis perennans) e a podridão-branca (Botryosphaeria dothidea) estão entre as principais doenças de verão da macieira no Brasil. O objetivo deste trabalho foi avaliar o efeito de uma película protetora constituída de cera de carnaúba e argilas (Raynox® ), nas doses de 2,5 e 5,0%, na infecção por C. perennans e por B. dothidea em maçãs das cultivares Fuji Standard e Pink Lady. As macieiras foram pulverizadas cinco vezes de dezembro de 2007 a março de 2008, conforme previsão de condições adequadas para ocorrência dos danos e crescimento dos frutos. Na colheita, as maçãs foram inoculadas com os dois patógenos e avaliadas quanto à incidência das podridões. Indiferente à dose, o uso de Raynox® reduziu a incidência da podridão-branca e da podridão-olho-de-boi em 67% e 42% na ‘Fuji Standard’, e 43% e 42% na ‘Pink Lady’, respectivamente. O incremento da dose aumentou a eficiência do produto para o controle da podridão-olho-de-boi. Na dose de 2,5%, o controle da podridão-olho-de-boi foi de 19% e 20%, respectivamente, em maçãs ‘Fuji Standard’ e ‘Pink Lady’, enquanto para as mesmas cultivares, mas com a dose de 5,0%, estes valores foram de 65% e 63%. Mais estudos são necessários para o ajuste de dose e critérios de aplicação para que o protetor solar possa ser recomendado.

Current Sheet Regulation of Solar Near-relativistic Electron Injection Histories

We present a sample of three large near-relativistic (>50 keV) electron events observed in 2001 by both the ACE and the Ulysses spacecraft, when Ulysses was at high-northern latitudes (>60◦) and close to 2 AU. Despite the large latitudinal distance between the two spacecraft, electrons injected near the Sun reached both heliospheric locations. All three events were associated with large solar flares, strong decametric type II radio bursts and accompanied by wide (>212◦) and fast (>1400 km s−1) coronal mass ejections (CMEs). We use advanced interplanetary transport simulations and make use of the directional intensities observed in situ by the spacecraft to infer the electron injection profile close to the Sun and the interplanetary transport conditions at both low and high latitudes. For the three selected events, we find similar interplanetary transport conditions at different heliolatitudes for a given event, with values of the mean free path ranging from 0.04 AU to 0.27 AU. We find differences in the injection profiles inferred for each spacecraft. We investigate the role that sector boundaries of the heliospheric current sheet (HCS) have on determining the characteristics of the electron injection profiles. Extended injection profiles, associated with coronal shocks, are found if the magnetic footpoints of the spacecraft lay in the same magnetic sector as the associated flare, while intermittent sparse injection episodes appear when the spacecraft footpoints are in the opposite sector or a wrap in the HCS bounded the CME structure.

Amorphous silicon thin film solar cells deposited entirely by Hot-Wire Chemical Vapour Deposition at low temperature (<150 ºC)

Amorphous silicon n-i-p solar cells have been fabricated entirely by Hot-Wire Chemical Vapour Deposition (HW-CVD) at low process temperature < 150 °C. A textured-Ag/ZnO back reflector deposited on Corning 1737F by rf magnetron sputtering was used as the substrate. Doped layers with very good conductivity and a very less defective intrinsic a-Si:H layer were used for the cell fabrication. A double n-layer (μc-Si:H/a-Si:H) and μc-Si:H p-layer were used for the cell. In this paper, we report the characterization of these layers and the integration of these layers in a solar cell fabricated at low temperature. An initial efficiency of 4.62% has been achieved for the n-i-p cell deposited at temperatures below 150 °C over glass/Ag/ZnO textured back reflector.

Applying Active Front End To Multilevel Inverter

The aim of this work was to make an active front end from IGBTs for a multilevel inverter. The work was done for Mosart II, a long term still ongoing Vacon Oyj project. The purpose of the AFE is to balance the DC-voltage and to put the returning power back to the grid instead of the breaking chopper and the capacitor. With a diode rectifier the bridge only allows power to pass in one direction and the switching times are not controllable. That means the rectifier always takes the highest phase and the phases are always conducting the same 120◦. With an AFE it is possible to actively change the rectifiers switching pattern. A diode bridge also generates much greater losses than an IGBT bridge. With these arguments it is rational to start researching the possibility of an AFE in a multilevel inverter.

Current Sheet Regulation of Solar Near-Relativistic Electron Injection Histories

We present a sample of three large near-relativistic (>50 keV) electron events observed in 2001 by both the ACE and the Ulysses spacecraft, when Ulysses was at high-northern latitudes (>60°) and close to 2 AU. Despite the large latitudinal distance between the two spacecraft, electrons injected near the Sun reached both heliospheric locations. All three events were associated with large solar flares, strong decametric type II radio bursts and accompanied by wide (>212°) and fast (>1400 km s-1) coronal mass ejections (CMEs). We use advanced interplanetary transport simulations and make use of the directional intensities observed in situ by the spacecraft to infer the electron injection profile close to the Sun and the interplanetary transport conditions at both low and high latitudes. For the three selected events, we find similar interplanetary transport conditions at different heliolatitudes for a given event, with values of the mean free path ranging from 0.04 AU to 0.27 AU. We find differences in the injection profiles inferred for each spacecraft. We investigate the role that sector boundaries of the heliospheric current sheet (HCS) have on determining the characteristics of the electron injection profiles. Extended injection profiles, associated with coronal shocks, are found if the magnetic footpoints of the spacecraft lay in the same magnetic sector as the associated flare, while intermittent sparse injection episodes appear when the spacecraft footpoints are in the opposite sector or a wrap in the HCS bounded the CME structure.

DC Boost Stage in Photovoltaic Systems

The performance of Grid connected Photovoltaic System working with DCBoost stage is investigated. The DC-Boost Converter topology is deduced from three phase half controlled bridge and controlled by Sliding Mode Control. Due to the fact that Grid connected Photovoltaic System includes Solar cells as a DC source and inverter for grid connection, those are under the scope of this research as well. The advantages of using MPPT are analyzed. The system is simulated in Matlab-Simulink™ environment.

Effects of solar activity and climate variability on large floods in Switzerland

The paper presents the variability of major floods in Switzerland for the period 1800-2008 from a summer index (INU). The index is constructed from the damage caused by flooding, with the aim of establishing the possible influence of the solar and climate variability on the major floods. The coincidence of flood-rich periods with those observed in other regions of different climate and fluvial regimes suggests that climate forcings and changes in the general circulation of the atmosphere are those who govern the appearance of these high-frequency temporal clusters.

A Method for Sky-Condition Classification from Ground-Based Solar Radiation Measurements

Identification of clouds from satellite images is now a routine task. Observation of clouds from the ground, however, is still needed to acquire a complete description of cloud conditions. Among the standard meteorologicalvariables, solar radiation is the most affected by cloud cover. In this note, a method for using global and diffuse solar radiation data to classify sky conditions into several classes is suggested. A classical maximum-likelihood method is applied for clustering data. The method is applied to a series of four years of solar radiation data and human cloud observations at a site in Catalonia, Spain. With these data, the accuracy of the solar radiation method as compared with human observations is 45% when nine classes of sky conditions are to be distinguished, and it grows significantly to almost 60% when samples are classified in only five different classes. Most errors are explained by limitations in the database; therefore, further work is under way with a more suitable database

Aplicação de radiação UV artificial e solar no tratamento fotocatalítico de efluentes de curtume

Tannery effluents are very dangerous for the environment since they contain large amounts of dangerous and biorecalcitrant contaminants (organic matter and Cr(VI)). This paper reports the efficiency of heterogeneous photocatalysis, based on the application of solar and artificial radiation, furnished by UV lamps, using TiO2 fixed on a flat plate, in the treatment of synthetic effluents. The results of COD and Cr(VI) demonstrate that the use of solar radiation is the most efficient way to perform the photocatalytic treatment of these effluents since a minimum removal of 62 and 61% was observed for Cr(VI) and organic matter, respectively.