Table de transcodage des opérations : VESKA (version 1979) - ICD-9-CM

Travaux effectués dans le cadre de l'étude "Case Mix" menée par l'Institut universitaire de médecine sociale et préventive de Lausanne et le Service de la santé publique et de la planification sanitaire du canton de Vaud, en collaboration avec les cantons de Berne, Fribourg, Genève, Jura, Neuchâtel, Soleure, Tessin et Valais.

Radiocarbon dating of modern groundwater: the role of the unsaturated zone

Biological and physical processes occurring in soils may lead to significant isotopic changes between the isotopic compositions of atmospheric CO2 and of soil CO2. Also, during water and gas transport from the soil surface to the water table, isotopic changes likely occur due to numerous physical processes such as gas production and diffusion, water advection, and gas-water-rock interactions. In most cases, these changes are not included in the correction models developed for groundwater dating, whereas they can significantly impact the calculation of the 14C age. We explore the role of these processes using: i) experimental data from two aquifer sites (Fontainebleau sands and Astian sands, France), ii) a distributed model to simulate the 14C activities of soil CO2, and iii) numerical simulations in order to highlight the role of the physical processes.¦The 13C content in soil CO2 showed seasonal variations and highlighted the competition between CO2 production and CO2 diffusion. Their respective contributions played a significant role in defining the isotopic composition of CO2 at the water table. On both study sites, variations of the 14C activity in soil CO2 reflect the competition between the fluxes of root derived-CO2 and organic matter derived-CO2. Since the nuclear weapon tests in the fifties and sixties, soil CO2 became significantly depleted in 14C compared to modern atmospheric CO2. Models that take into account this 14C depletion in soil CO2 for dating modern groundwater would lead to apparent younger 14C ages than models that only consider the 14C activity in atmospheric CO2. Moreover, since 2000-2005, the inverse effect is observed as soil CO2 is enriched in 14C compared to atmospheric CO2.¦Therefore, we conclude that the isotopic composition of CO2 at the water table have to be taken into account for the dating of modern groundwater. This requires a systematic sampling of soil CO2 and the measurement of its 13C and 14C contents. We used this information in a numerical simulation to calculate the evolution of isotopic composition of CO2 from the soil surface to the water table. This simulation integrated physical processes in the unsaturated zone (e.g. CO2 production and diffusion, water advection, etc.) and gas-water-rock interactions.

Predictive and distributed routing balancing (PR-DRB): high speed interconnection networks

Current parallel applications running on clusters require the use of an interconnection network to perform communications among all computing nodes available. Imbalance of communications can produce network congestion, reducing throughput and increasing latency, degrading the overall system performance. On the other hand, parallel applications running on these networks posses representative stages which allow their characterization, as well as repetitive behavior that can be identified on the basis of this characterization. This work presents the Predictive and Distributed Routing Balancing (PR-DRB), a new method developed to gradually control network congestion, based on paths expansion, traffic distribution and effective traffic load, in order to maintain low latency values. PR-DRB monitors messages latencies on intermediate routers, makes decisions about alternative paths and record communication pattern information encountered during congestion situation. Based on the concept of applications repetitiveness, best solution recorded are reapplied when saved communication pattern re-appears. Traffic congestion experiments were conducted in order to evaluate the performance of the method, and improvements were observed.

Design of Novel Frequency Generation Circuit with Application to Ultra-Wideband Distributed Oscillators

Given the urgence of a new paradigm in wireless digital trasmission which should allow for higher bit rate, lower latency and tigher delay constaints, it has been proposed to investigate the fundamental building blocks that at the circuital/device level, will boost the change towards a more efficient network architecture, with high capacity, higher bandwidth and a more satisfactory end user experience. At the core of each transciever, there are inherently analog devices capable of providing the carrier signal, the oscillators. It is strongly believed that many limitations in today's communication protocols, could be relieved by permitting high carrier frequency radio transmission, and having some degree of reconfigurability. This led us to studying distributed oscillator architectures which work in the microwave range and possess wideband tuning capability. As microvave oscillators are essentially nonlinear devices, a full nonlinear analyis, synthesis, and optimization had to be considered for their implementation. Consequently, all the most used nonlinear numerical techniques in commercial EDA software had been reviewed. An application of all the aforementioned techniques has been shown, considering a systems of three coupled oscillator ("triple push" oscillator) in which the stability of the various oscillating modes has been studied. Provided that a certain phase distribution is maintained among the oscillating elements, this topology permits a rise in the output power of the third harmonic; nevertheless due to circuit simmetry, "unwanted" oscillating modes coexist with the intenteded one. Starting with the necessary background on distributed amplification and distributed oscillator theory, the design of a four stage reverse mode distributed voltage controlled oscillator (DVCO) using lumped elments has been presented. All the design steps have been reported and for the first time a method for an optimized design with reduced variations in the output power has been presented. Ongoing work is devoted to model a wideband DVCO and to implement a frequency divider.