Effective exposure to solar UV in building workers: influence of local and individual factors.

Excessive exposure to solar UV light is the main cause of skin cancers in humans. UV exposure depends on environmental as well as individual factors related to activity. Although outdoor occupational activities contribute significantly to the individual dose received, data on effective exposure are scarce and limited to a few occupations. A study was undertaken in order to assess effective short-term exposure among building workers and characterize the influence of individual and local factors on exposure. The effective exposure of construction workers in a mountainous area in the southern part of Switzerland was investigated through short-term dosimetry (97 dosimeters). Three altitudes, of about 500, 1500 and 2500 m were considered. Individual measurements over 20 working periods were performed using Spore film dosimeters on five body locations. The postural activity of workers was concomitantly recorded and static UV measurements were also performed. Effective exposure among building workers was high and exceeded occupational recommendations, for all individuals for at least one body location. The mean daily UV dose in plain was 11.9 SED (0.0-31.3 SED), in middle mountain 21.4 SED (6.6-46.8 SED) and in high mountain 28.6 SED (0.0-91.1 SED). Measured doses between workers and anatomical locations exhibited a high variability, stressing the role of local exposure conditions and individual factors. Short-term effective exposure ranged between 0 and 200% of ambient irradiation, indicating the occurrence of intense, subacute exposures. A predictive irradiation model was developed to investigate the role of individual factors. Posture and orientation were found to account for at least 38% of the total variance of relative individual exposure, and were also found to account more than altitude on the total variance of effective daily exposures. Targeted sensitization actions through professional information channels and specific prevention messages are recommended. Altitude outdoor workers should also benefit from preventive medical examination.

Building Capacity in Developing Countries : OER for Food Safety

The Food Safety Knowledge Network (FSKN) was developed through the collaboration of Michigan State University and a professional network of international food industry retailers and manufacturers. The key objective of the FSKN project is to provide technical resources, in a cost effective way, in order to promote food safety in developing countries and for small and less developed companies. FSKN uses a competency based model including a framework, OERs, and assessments. These tools are being used to support face-to-face training, fully online training, and to gauge the learning outcomes of a series of pilot groups which were held in India, Egypt, and China.

AgShare : Building Community and Content with Multiple Partners

Michigan State University and OER Africa are creating a win-win collaboration of existing organizations for African publishing, localizing, and sharing of teaching and learning materials that fill critical resource gaps in African MSc agriculture curriculum. By the end of the 18-month planning and pilot initiative, African agriculture universities, faculty, students, researchers, NGO leaders, extension staff, and farmers will participate in building AgShare by demonstrating its benefits and outcomes and by building momentum and support for growth.

Building a Manifesto for OER sustainability : UK experiences

Evidence of sustainability, or the potential to achieve this, is increasingly a pre-requisite for OER activity, whether imposed by funders, by institutions requiring a 'business case' for OER, or practitioners themselves - academics, educational technologists and librarians, concerned about how to justify engagement with a unfamiliar, and unproven practices, in today's climate of limited resource. However, it is not clear what is meant by 'sustainability' in relation to OER, what will be needed to achieve or demonstrate this, nor who the expectation of sustainability relates to. This paper draws on experiences of UK OER projects to identify aspirations that those involved in delivering OER activity have for OER sustainability ¿ what a 'manifesto' for OER sustainability beyond project funding, based on OER use, might look like.

Monitorización de estructuras y gestión de edificios: Building Management

El objetivo del proyecto es realizar un sistema de monitorizacion de estructuras y gestión de edificios para controlar en todo momento el estado de los mismos. Se controlará cualquier aspecto que pueda afectar al edificio, como es la temperatura, la humedad, la oscilación del edificio; además de otros aspectos que ayuden a que el edificio se mantenga seguro y en perfecto estado como alarmas de seguridad, luminosidad, etc.

Pancreatic stone protein: a marker of organ failure and outcome in ventilator-associated pneumonia.

Background: Ventilator-associated pneumonia (VAP) is the most common hospital-acquired, life-threatening infection. Poor outcome and health-care costs of nosocomial pneumonia remain a global burden. Currently, physicians rely on their experience to discriminate patients with good and poor outcome. However, standardized prognostic measures might guide medical decisions in the future. Pancreatic stone protein (PSP)/regenerating protein (reg) is associated with inflammation, infection, and other disease-related stimuli. The prognostic value of PSP/reg among critically ill patients is unknown. The aim of this pilot study was to evaluate PSP/reg in VAP.Methods: One hundred one patients with clinically diagnosed VAP were assessed. PSP/reg was retrospectively analyzed using deep-frozen serum samples from VAP onset up to day 7. The main end point was death within 28 days after VAP onset.Results: Serum PSP/reg was associated with the sequential organ failure assessment score from VAP onset (Spearman rank correlation coefficient 0.49 P < .001) up to day 7. PSP/reg levels at VAP onset were elevated in nonsurvivors (n = 20) as compared with survivors (117.0 ng/mL [36.1-295.3] vs 36.3 ng/mL [21.0-124.0] P = .011). The areas under the receiver operating characteristic curves of PSP/reg to predict mortality/survival were 0.69 at VAP onset and 0.76 at day 7. Two PSP/reg cutoffs potentially allow for identification of individuals with a particularly good and poor outcome. Whereas PSP/reg levels below 24 ng/mL at YAP onset were associated with a good chance of survival, levels above 177 ng/mL at day 7 were present in patients with a very poor outcome.Conclusions: Serum PSP/reg is a biomarker related to organ failure and outcome in patients with VAP.

Building energy saving techniques and indoor air quality : a dilemma

In European countries and North America, people spend 80 to 90% of time inside buildings and thus breathe indoor air. In Switzerland, special attention has been devoted to the 16 stations of the national network of observation of atmospheric pollutants (NABEL). The results indicate a reduction in outdoor pollution over the last ten years. With such a decrease in pollution over these ten years the question becomes: how can we explain an increase of diseases? Indoor pollution can be the cause. Indoor contaminants that may create indoor air quality (IAQ) problems come from a variety of sources. These can include inadequate ventilation, temperature and humidity dysfunction, and volatile organic compounds (VOCs). The health effects from these contaminants are varied and can range from discomfort, irritation and respiratory diseases to cancer. Among such contaminants, environmental tobacco smoke (ETS) could be considered the most important in terms of both health effects and engineering controls of ventilation. To perform indoor pollution monitoring, several selected ETS tracers can be used including carbon monoxide (CO), carbon dioxide (CO2), respirable particles (RSP), condensate, nicotine, polycyclic aromatic hydrocarbons (PAHs), nitrosamines, etc. In this paper, some examples are presented of IAQ problems that have occurred following the renewal of buildings and energy saving concerns. Using industrial hygiene sampling techniques and focussing on selected priority pollutants used as tracers, various problems have been identified and solutions proposed. [Author]

Mean intrinsic tensile properties of stone groundwood fibers from softwood

Stone groundwood (SGW) is a fibrous matter commonly prepared in a high yield process, and mainly used for papermaking applications. In this work, the use of SGW fibers is explored as reinforcing element of polypropylene (PP) composites. Due to its chemical and superficial features, the use of coupling agents is needed for a good adhesion and stress transfer across the fiber-matrix interface. The intrinsic strength of the reinforcement is a key parameter to predict the mechanical properties of the composite and to perform an interface analysis. The main objective of the present work was the determination of the intrinsic tensile strength of stone groundwood fibers. Coupled and non-coupled PP composites from stone groundwood fibers were prepared. The influence of the surface morphology and the quality at interface on the final properties of the composite was analyzed and compared to that of fiberglass PP composites. The intrinsic tensile properties of stone groundwood fibers, as well as the fiber orientation factor and the interfacial shear strength of the current composites were determined

Stone-ground wood pulp-reinforced polypropylene composites: water uptake and thermal properties

Two of the drawbacks of using natural-based composites in industrial applications are thermal instability and water uptake capacity. In this work, mechanical wood pulp was used to reinforce polypropylene at a level of 20 to 50 wt. %. Composites were mixed by means of a Brabender internal mixer for both non-coupled and coupled formulations. Differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA) were used to determine the thermal properties of the composites. The water uptake behavior was evaluated by immersion of the composites in water until an equilibrium state was reached. Results of water absorption tests revealed that the amount of water absorption was clearly dependent upon the fiber content. The coupled composites showed lower water absorption compared to the uncoupled composites. The incorporation of mechanical wood pulp into the polypropylene matrix produced a clear nucleating effect by increasing the crystallinity degree of the polymer and also increasing the temperature of polymer degradation. The maximum degradation temperature for stone ground wood pulp–reinforced composites was in the range of 330 to 345 ºC

Tensile strength characteristics of polypropylene composites reinforced with stone groundwood fibers from softwood

The behavior of stone groundwood / polypropylene injection-molded composites was evaluated with and without coupling agent. Stone groundwood (SGW) is a fibrous material commonly prepared in a high yield process and mainly used for papermaking applications. In this work, the use of SGW fibers was explored as a reinforcing element of polypropylene (PP) composites. The surface charge density of the composite components was evaluated, as well as the fiber’s length and diameter inside the composite material. Two mixing extrusion processes were evaluated, and the use of a kinetic mixer, instead of an internal mixer, resulted in longer mean fiber lengths of the reinforcing fibers. On the other hand, the accessibility of surface hydroxyl groups of stone groundwood fibers was improved by treating the fibers with 5% of sodium hydroxide, resulting in a noticeable increase of the tensile strength of the composites, for a similar percentage of coupling agent. A new parameter called Fiber Tensile Strength Factor is defined and used as a baseline for the comparison of the properties of the different composite materials. Finally the competitiveness of stone groundwood / polypropylene / polypropylene-co-maleic anhydride system, which compared favorably to sized glass-fiber / polypropylene GF/PP and glass-fiber / polypropylene / polypropylene-co-maleic anhydride composite formulations, was quantified by means of the fiber tensile strength factor

Gain-of-function haplotype in the epithelial calcium channel TRPV6 is a risk factor for renal calcium stone formation.

The rate-limiting step of dietary calcium absorption in the intestine requires the brush border calcium entry channel TRPV6. The TRPV6 gene was completely sequenced in 170 renal calcium stone patients. The frequency of an ancestral TRPV6 haplotype consisting of three non-synonymous polymorphisms (C157R, M378V, M681T) was significantly higher (P = 0.039) in calcium stone formers (8.4%; derived = 502, ancestral = 46) compared to non-stone-forming individuals (5.4%; derived = 645, ancestral = 37). Mineral metabolism was investigated on four different calcium regimens: (i) free-choice diet, (ii) low calcium diet, (iii) fasting and (iv) after a 1 g oral calcium load. When patients homozygous for the derived haplotype were compared with heterozygous patients, no differences were found with respect to the plasma concentrations of 1,25-vitamin D, PTH and calcium, and the urinary excretion of calcium. In one stone-forming patient, the ancestral haplotype was found to be homozygous. This patient had absorptive hypercalciuria. We therefore expressed the ancestral protein (157R+378V+681T) in Xenopus oocytes and found a significantly enhanced calcium permeability when tested by a (45)Ca(2+) uptake assay (7.11 +/- 1.93 versus 3.61 +/- 1.01 pmol/min/oocyte for ancestral versus derived haplotype, P < 0.01). These results suggest that the ancestral gain-of-function haplotype in TRPV6 plays a role in calcium stone formation in certain forms of absorptive hypercalciuria.

The building blocks of international ecological footprint inequality: a regression-based decomposition

This paper performs an empirical Decomposition of International Inequality in Ecological Footprint in order to quantify to what extent explanatory variables such as a country’s affluence, economic structure, demographic characteristics, climate and technology contributed to international differences in terms of natural resource consumption during the period 1993-2007. We use a Regression-Based Inequality Decomposition approach. As a result, the methodology extends qualitatively the results obtained in standard environmental impact regressions as it comprehends further social dimensions of the Sustainable Development concept, i.e. equity within generations. The results obtained point to prioritizing policies that take into account both future and present generations.

Academic Building Revenue Bond Funds, June 30, 2002

State University Audit Report

Pancreatic stone protein as an early biomarker predicting mortality in a prospective cohort of patients with sepsis requiring ICU management.

ABSTRACT: INTRODUCTION: Biomarkers, such as C-reactive protein [CRP] and procalcitonin [PCT], are insufficiently sensitive or specific to stratify patients with sepsis. We investigate the prognostic value of pancreatic stone protein/regenerating protein (PSP/reg) concentration in patients with severe infections. METHODS: PSP/reg, CRP, PCT, tumor necrosis factor-alpha (TNF-α), interleukin 1 beta (IL1-β), IL-6 and IL-8 were prospectively measured in cohort of patients ≥ 18 years of age with severe sepsis or septic shock within 24 hours of admission in a medico-surgical intensive care unit (ICU) of a community and referral university hospital, and the ability to predict in-hospital mortality was determined. RESULTS: We evaluated 107 patients, 33 with severe sepsis and 74 with septic shock, with in-hospital mortality rates of 6% (2/33) and 25% (17/74), respectively. Plasma concentrations of PSP/reg (343.5 vs. 73.5 ng/ml, P < 0.001), PCT (39.3 vs. 12.0 ng/ml, P < 0.001), IL-8 (682 vs. 184 ng/ml, P < 0.001) and IL-6 (1955 vs. 544 pg/ml, P < 0.01) were significantly higher in patients with septic shock than with severe sepsis. Of note, median PSP/reg was 13.0 ng/ml (IQR: 4.8) in 20 severely burned patients without infection. The area under the ROC curve for PSP/reg (0.65 [95% CI: 0.51 to 0.80]) was higher than for CRP (0.44 [0.29 to 0.60]), PCT 0.46 [0.29 to 0.61]), IL-8 (0.61 [0.43 to 0.77]) or IL-6 (0.59 [0.44 to 0.75]) in predicting in-hospital mortality. In patients with septic shock, PSP/reg was the only biomarker associated with in-hospital mortality (P = 0.049). Risk of mortality increased continuously for each ascending quartile of PSP/reg. CONCLUSIONS: Measurement of PSP/reg concentration within 24 hours of ICU admission may predict in-hospital mortality in patients with septic shock, identifying patients who may benefit most from tailored ICU management.