Geochemistry, microbiology and phospholipid fatty acid content of ODP Site 169-1036 sediments

Phospholipid fatty acids were measured in samples of 60°-130°C sediment taken from three holes at Site 1036 (Ocean Drilling Program Leg 169) to determine microbial community structure and possible community replacement at high temperatures. Five of six samples had similar concentrations of phospholipid fatty acids (2-6 pmol/g dry weight of sediment), and biomass estimates from these measurements compare favorably with direct microscopic counts, lending support to previous microscopic measures of deep sedimentary biomass. Very long-chain phospholipid fatty acids (21 to 30 carbons) were detected in the sediment and were up to half the total phospholipid fatty acid measured; they appear to increase in abundance with temperature, but their significance is not known. Community composition from lipid analysis showed that samples contained standard eubacterial membrane lipids but no detectable archaeal lipids, though archaea would be expected to dominate the samples at high temperatures. Cluster analysis of Middle Valley phospholipid fatty acid compositions shows that lipids in Middle Valley sediment samples are similar to each other at all temperatures, with the exception of very long-chain fatty acids. The data neither support nor deny a shift to a high-temperature microbial community in hot cores, so at the present time we cannot draw conclusions about whether the microbes observed in these hot sediments are active.

Underway water measurements of halocarbons during POSEIDON cruise POS399 in June 2010

Methyl iodide (CH3I), bromoform (CHBr3) and dibromomethane (CH2Br2), which are produced naturally in the oceans, take part in ozone chemistry both in the troposphere and the stratosphere. The significance of oceanic upwelling regions for emissions of these trace gases in the global context is still uncertain although they have been identified as important source regions. To better quantify the role of upwelling areas in current and future climate, this paper analyzes major factors that influenced halocarbon emissions from the tropical North East Atlantic including the Mauritanian upwelling during the DRIVE expedition. Diel and regional variability of oceanic and atmospheric CH3I, CHBr3 and CH2Br2 was determined along with biological and meteorological parameters at six 24 h-stations. Low oceanic concentrations of CH3I from 0.1-5.4 pmol/L were equally distributed throughout the investigation area. CHBr3 of 1.0-42.4 pmol/L and CH2Br2 of 1.0-9.4 pmol/L were measured with maximum concentrations close to the Mauritanian coast. Atmospheric mixing rations of CH3I of up to 3.3, CHBr3 to 8.9 and CH2Br2 to 3.1 ppt above the upwelling and 1.8, 12.8, respectively 2.2 ppt at a Cape Verdean coast were detected during the campaign. While diel variability in CH3I emissions could be mainly ascribed to oceanic non-biological production, no main driver was identified for its emissions in the entire study region. In contrast, oceanic bromocarbons resulted from biogenic sources which were identified as regional drivers of their sea-to-air fluxes. The diel impact of wind speed on bromocarbon emissions increased with decreasing distance to the coast. The height of the marine atmospheric boundary layer (MABL) was determined as an additional factor influencing halocarbon emissions. Oceanic and atmospheric halocarbons correlated well in the study region and in combination with high oceanic CH3I, CHBr3 and CH2Br2 concentrations, local hot spots of atmospheric halocarbons could solely be explained by marine sources. This conclusion is in contrast with previous studies that hypothesized the occurrence of elevated atmospheric halocarbons over the eastern tropical Atlantic mainly originating from the West-African continent.

Nitrogen isotope gradients off Peru and Ecuador related to upwelling, productivity, nutrient uptake and oxygen deficiency

We present new nitrogen isotope data from the water column and surface sediments for paleo-proxy validation collected along the Peruvian and Ecuadorian margins between 1°N and 18°S. Productivity proxies in the bulk sediment (organic carbon, total nitrogen, biogenic opal, C37 alkenone concentrations) and 15N/14N ratios were measured at more than 80 locations within and outside the present-day Peruvian oxygen minimum zone (OMZ). Microbial N-loss to N2 in subsurface waters under O2 deficient conditions leaves a characteristic 15N-enriched signal in underlying sediments. We find that phytoplankton nutrient uptake in surface waters within the high nutrient, low chlorophyll (HNLC) regions of the Peruvian upwelling system influences the sedimentary signal as well. How the d15Nsed signal is linked to these processes is studied by comparing core-top values to the 15N/14N of nitrate and nitrite (d15N[NOx]) in the upper 200 m of the water column. Between 1°N and 10°S, subsurface O2 is still high enough to suppress N-loss keeping d15NNOx values relatively low in the subsurface waters. However d15N[NOx] values increase toward the surface due to partial nitrate utilization in the photic zone in this HNLC portion of the system. d15N[sed] is consistently lower than the isotopic signature of upwelled [NO3]-, likely due to the corresponding production of 15N depleted organic matter. Between 10°S and 15°S, the current position of perennial upwelling cells, HNLC conditions are relaxed and biological production and near-surface phytoplankton uptake of upwelled [NO3]- are most intense. In addition, subsurface O2 concentration decreases to levels sufficient for N-loss by denitrification and/or anammox, resulting in elevated subsurface d15N[NOx] values in the source waters for coastal upwelling. Increasingly higher production southward is reflected by various productivity proxies in the sediments, while the north-south gradient towards stronger surface [NO3]- utilization and subsurface N-loss is reflected in the surface sediment 15N/14N ratios. South of 10°S, d15N[sed] is lower than maximum water column d15N[NOx] values most likely because only a portion of the upwelled water originates from the depths where highest d15N[NOx] values prevail. Though the enrichment of d15N[NOx] in the subsurface waters is unambiguously reflected in d15N[sed] values, the magnitude of d15N[sed] enrichment depends on both the depth of upwelled waters and high subsurface d15N[NOx] values produce by N-loss. Overall, the degree of N-loss influencing subsurface d15N[NOx] values, the depth origin of upwelled waters, and the degree of near-surface nitrate utilization under HNLC conditions should be considered for the interpretation of paleo d15N[sed] records from the Peruvian oxygen minimum zone.

Hydrochemistry measured on water bottle samples during METEOR cruise M60/5

We compare alkalinity and total dissolved inorganic carbon (DIC) measurements made during the Transient Tracers in the Ocean, North Atlantic Study (TTO-NAS) in 1981 with modern measurements from a TTO reoccupation cruise in 2004 (M60/5). We find that the TTO-NAS alkalinity values are 3.6 ± 2.3 µmol/kg higher than modern alkalinity data tied to Certified Reference Materials. The TTO-NAS DIC values re-calculated from original alkalinity and discrete-pCO2 data using currently accepted constants are 3.8 µmol/kg higher than those reported in the revised TTO data set. This difference is reduced to 0.7 µmol/kg when our suggested correction to the TTO-NAS alkalinity is applied. These re-calculated DIC values are 2.4 µmol/kg too low relative to contemporaneous measurements made by the vacuum extraction/manometric Certified method. Application of this correction brings the TTO data into almost perfect agreement with modern measurements for slowly-ventilated deep water of the eastern Atlantic.

Sediment grain size and carbon/carbonate at DSDO Leg 55 Holes

CaCO3 content was determined on board ship by the "Karbonat Bomb" technique (Müller and Gastner, 1971). In this simple procedure, a sample is powdered and treated with HCl in a closed cylinder. Any resulting CO2 pressure is proportional to the CaCO3 content of the sample. Application of the calibration factor to the manometer reading (x 100) yields per cent CaCO3. The error can be as low as 1 per cent for sediments high in CaCO3, and in general an accuracy of ±2 to 5 per cent can be obtained.