Investigation on microstructure and optical properties of titanium dioxide coatings annealed at various temperature

TiO2 coatings were prepared on fused silica with conventional electron beam evaporation deposition. After TiO2 thin films were annealed at different temperatures for 4 h, several properties were investigated by X-ray diffraction (XRD), spectrometer.. photoelectron spectroscopy (XPS) and AFM. It was found that with the annealing temperature increasing, the transmittance of TiO2 coatings decreased, and the cutoff wavelength shifted to long wavelength in near ultraviolet band. Especially, when coatings were annealed at high temperature, the optical loss is very serious, which can be attributed to the scattering and the absorption of TiO2 coatings. XRD patterns revealed that only anatase phase was observed in TiO2 coatings regardless of the different annealing temperatures. XPS results indicated that the fine chemical shift of TiO2 2p(1/2) should be attributed to existence of oxygen vacancies around Ti+4 ion. The investigation on surface morphology by AFM showed that the RMS of titania thin films gradually increases from less than 0.40 nm to 5.03 nm and it should be ascribed to the growth of titanium dioxide grain size with the increase of annealing temperature. (C) 2005 Elsevier B.V. All rights reserved.

Hole-Phonon Relaxation and Photocatalytic Properties of Titanium Dioxide and Zinc Oxide: First-Principles Approach

First-principles calculations for the temporal characteristics of hole-phonon relaxation in the valence band of titanium dioxide and zinc oxide have been performed. A first-principles method for the calculations of the quasistationary distribution function of holes has been developed. The results show that the quasistationary distribution of the holes in TiO2 extends to an energy level approximately 1eV below the top of the valence band. This conclusion in turn helps to elucidate the origin of the spectral dependence of the photocatalytic activity of TiO2. Analysis of the analogous data for ZnO shows that in this material spectral dependence of photocatalytic activity in the oxidative reactions is unlikely.

Size at first maturity of the anchovy (Engraulis encrasicolus) in Ghanaian waters and suggestions for appropriate mesh size in its fishery

The main length at first maturity of anchovy Engraulis encrasicolus in Ghanaian waters has been estimated using length-frequency and gonad data sampled between June 1983 and September 1986 off Accra and Tema, Ghana. The length at first maturity of these fish is around 5.7 cm (fork length). The minimum mesh size for rational exploitation of the resource in Ghanaian waters is put at about 20 mm (0.8 inch).

Escapement of the Cape rock lobster (Jasus lalandii ) through the mesh and entrance of commercial traps

Metal-framed traps covered with polyethylene mesh used in the fishery for the South African Cape rock lobster (Jasus lalandii) incidentally capture large numbers of undersize (<75 mm CL) specimens. Air-exposure, handling, and release procedures affect captured rock lobsters and reduce the productivity of the stock, which is heavily fished. Optimally, traps should retain legalsize rock lobsters and allow sublegal animals to escape before traps are hauled. Escapement, based on lobster morphometric measurements, through meshes of 62 mm, 75 mm, and 100 mm was investigated theoretically under controlled conditions in an aquarium, and during field trials. SELECT models were used to model escapement, wherever appropriate. Size-selectivity curves based on the logistic model fitted the aquarium and field data better than asymmetrical Richards curves. The lobster length at 50% retention (L50) on the escapement curve for 100-mm mesh in the aquarium (75.5 mm CL) approximated the minimum legal size (75 mm CL); however estimates of L50 increased to 77.4 mm in field trials where trapentrances were sealed, and to 82.2 mm where trap-entrances were open. Therfore, rock lobsters that cannot escape through the mesh of sealed field traps do so through the trap entrance of open traps. By contrast, the wider selection range and lower L25 of field, compared to aquarium, trials (SR = 8.2 mm vs. 2.6 mm; L25 =73.4 mm vs. 74.1 mm), indicate that small lobsters that should be able to escape from 100-mm mesh traps do not always do so. Escapement from 62-mm mesh traps with open entrance funnels increased by 40−60% over sealed traps. The findings of this study with a known size distribution, are related to those of a recent indirect (comparative) study for the same species, and implications for trap surveys, commercial catch rates, and ghost fishing are discussed.

Blue Crab, Callinectes sapidus, Trap Selectivity Studies: Mesh Size

Catch rates and sizes of blue crabs, Callinectes sapidus, were compared in traps with 2.54 cm (1.0 inch), 3.81 cm (1.5 inches), and 5.08 cm (2.0 inches) square mesh, 2.54 by 5.08 cm rectangular mesh, and 3.81 cm hexagonal mesh. Catch of legal blue crabs by number was significantly greater in the traditional hexagonal mesh trap than in all other trap types. Sublegal catch by number was highest (34.1-63.3% of total) in the 2.54 cm and 3.81 cm square mesh and rectangular mesh traps and lowest in the 5.08 cm square mesh trap. The hexagonal mesh trap had significantly lower catch rates of sublegal blue crabs than all other trap types except the 5.08 cm square mesh. Mean size of blue crabs by trap type exhibited an inverse pattern to that shown by catch of sublegal crabs. The most effective trap to maximize legal catch and minimize sublegal catch was the 3.81 cm hexagonal mesh trap followed by the 5.08 cm square mesh trap.

The Effects of Fish Trap Mesh Size on Reef Fish Catch off Southeastern Florida

Catch and mesh selectivity of wire-meshed fish traps were tested for eleven different mesh sizes ranging from 13 X 13 mm (0.5 x 0.5") to 76 x 152 mm (3 X 6"). A total of 1,810 fish (757 kg) representing 85 species and 28 families were captured during 330 trap hauls off southeastern Florida from December 1986 to July 1988. Mesh size significantly affected catches. The 1.5" hexagonal mesh caught the most fish by number, weight, and value. Catches tended to decline as meshes got smaller or larger. Individual fish size increased with larger meshes. Laboratory mesh retention experiments showed relationships between mesh shape and size and individual retention for snapper (Lutjanidae), grouper (Serranidae), jack (Carangidae), porgy (Sparidae), and surgeonfish (Acanthuridae). These relationships may be used to predict the effect of mesh sizes on catch rates. Because mesh size and shape greatly influenced catchability, regulating mesh size may provide a useful basis for managing the commercial trap fishery.