Nd-Sr isotopic composition of foraminifera and bulk sediments

We present new isotopic data for sedimentary planktonic foraminifera, as well as for potential water column and sedimentary sources of neodymium (Nd), which confirm that the isotopic composition of the foraminifera is the same as surface seawater and very different from deep water and sedimentary Nd. The faithfulness with which sedimentary foraminifera record the isotopic signature of surface seawater Nd is difficult to explain given their variable and high Nd/Ca ratios, ratios that are often sedimentary foraminifera, ratios that are often much higher than is plausible for direct incorporation within the calcite structure. We present further data that demonstrate a similarly large range in Nd/Ca ratios in plankton tow foraminifera, a range that may be controlled by redox conditions in the water column. Cleaning experiments reveal, in common with earlier work, that large amounts of Nd are released by cleaning with both hydrazine and diethylene triamine penta-acetic acid, but that the Nd released at each step is of surface origin. While further detailed studies are required to verify the exact location of the surface isotopic signature and the key controls on foraminiferal Nd isotope systematics, these new data place the use of planktonic foraminifera as recorders of surface water Nd isotope ratios, and thus of variations in the past supply of Nd to the oceans from the continents via weathering and erosion, on a reasonably sure footing.

(Table 1) Compressional- and share-wave velocieties at elevated confining pressure of ODP Holes 136-842C and 136-843A

Identification of a sediment/basement contact using seismic reflection recordings has proven to be extremely difficult in wide areas of the North Pacific Ocean owing to the presence of massive, highly reflective chert layers within the sediment column. Leg 136 of the Ocean Drilling Program recovered coherent pieces of chert of sufficient size for the first comprehensive laboratory measurements of the seismic properties of this material. Compressional-wave velocities of six samples at 40-MPa confining pressure averaged 5.33 km/s, whereas shear-wave velocities at the same pressure averaged 3.48 km/s. Velocities were independent of porosity, which ranged from 5% to 13%, suggesting that pores within the samples were mostly high aspect ratio vugs as opposed to low aspect ratio cracks. Back-scattered electron images made with a scanning electron microscope confirmed this observation. Acoustic impedances were calculated for the chert samples and from shipboard measurements of the red clay sediment overlying the chert layers. An extremely large compressional-wave reflection coefficient (0.73) characterized the interface between the two lithologies. A synthetic seismogram was calculated using chert and typical pelagic carbonate properties to illustrate the influence of chert layers on a marine seismic-reflection section. Compressional-wave to shear-wave velocity ratios of the chert samples (Vp/Vs =1.53) are close to that of single-crystal quartz in spite of variable porosity. Shear-wave reflection coefficients are estimated to be approximately 0.94. A compressional-wave reflection coefficient for a basement/sediment (carbonate) interface is estimated to be approximately 0.50, significantly less than that of sediment/chert.