Calcium carbonate vein compositions from drill sites in the Atlantic and Pacific

Chemical (Sr, Mg) and isotopic (d18O, 87Sr/86Sr) compositions of calcium carbonate veins (CCV) in the oceanic basement were determined to reconstruct changes in Sr/Ca and Mg/Ca of seawater in the Cenozoic. We examined CCV from ten basement drill sites in the Atlantic and Pacific, ranging in age between 165 and 2.3 Ma. Six of these sites are from cold ridge flanks in basement <46 Ma, which provide direct information about seawater composition. CCV of these young sites were dated, using the Sr isotopic evolution of seawater. For the other sites, temperature-corrections were applied to correct for seawater-basement exchange processes. The combined data show that a period of constant/low Sr/Ca (4.46 - 6.22 mmol/mol) and Mg/Ca (1.12 - 2.03 mol/mol) between 165 and 30 Ma was followed by a steady increase in Mg/Ca ratios by a factor of three to modern ocean composition. Mg/Ca - Sr/Ca relations suggest that variations in hydrothermal fluxes and riverine input are likely causes driving the seawater compositional changes. However, additional forcing may be involved in explaining the timing and magnitude of changes. A plausible scenario is intensified carbonate production due to increased alkalinity input to the oceans from silicate weathering, which in turn is a result of subduction-zone recycling of CO2 from pelagic carbonate formed after the Cretaceous slow-down in ocean crust production rate.

(Table 1) Petrological description and consolidation properties of ODP Site 186-1150 and Hole 186-1151A

In order to determine the shear parameters of the forearc sedimentary strata drilled during Ocean Drilling Program Leg 186, West Pacific Seismic Network, Japan Trench, eight whole-round samples were selected from different depths in the drilled sections of Sites 1150 and 1151. Whereas Site 1150 lays above the seismically active part of the subduction zone, Site 1151 is situated in an aseismic zone. The aim of the triaxial tests was, apart from determination of the static stress strain behavior of the sediments, to test the hypothesis that the static stress strain parameter could differ for each sites. In order to simulate undrained deformation conditions according to the high clay mineral content of the strata, consolidated undrained shear tests were performed in a triaxial testing setup. Measurements of water content, grain density, organic content, and microtextural investigations under the scanning electron microscope (SEM) accompanied the compression experiments. After the saturation and consolidation stages were completed, failure occurred in the compression stage of the experiments at peak strengths of 280-7278 kPa. The stiffness moduli calculated for each sample from differential stress vs. strain curves show a linear relationship with depth and range between 181 and 5827 kPa. Under the SEM, the artificial fault planes of the tested specimen only show partial alignment of clay minerals because of the high content of microfossils.

(Table 1) AMS radiocarbon ages from ODP Sites 169-1033 and 169-1034

This paper explores the paleoseismic record potentially preserved in the upper 40 m of hydraulic piston cores collected in 1996 at two sites in Saanich Inlet, British Columbia, during ocean drilling program (ODP) Leg 169S. The ODP cores are missing 1-2 m of water-rich sediment directly underlying the seafloor, but this sediment is preserved in shorter piston cores collected in 1989 and 1991. The upper part of the ODP cores consists of rhythmically laminated (varved) marine mud with intercalated massive beds, interpreted to be debris flow deposits. Some of the debris flow deposits are linked to past earthquakes, including the 1946 Vancouver Island earthquake (M7.2), a great (M8-9) plate-boundary earthquake at the Cascadia subduction zone in January 1700, and a large crustal or plate-boundary earthquake about 1000 yr ago. Earthquakes may also be responsible for debris flows in about AD 1600, 1500, 1250, 1150, 850, 450, 350, 180, and BC 200, 220, 500, 900, and 1050. If so, the average recurrence interval for moderate to large earthquakes, which trigger debris flows in Saanich Inlet, is about 150 yr. This recurrence interval is broadly consistent with the frequency of moderate to large earthquakes in the region during the historical period. Debris flows, however, can also be triggered by non-seismic processes, making it difficult to assemble a complete earthquake record from the Saanich Inlet cores. We propose that extensive debris flow deposits, emplaced by single large failures or many smaller coincident failures, probably have a seismic origin.

Rhenium and osmium concentrations and isotopic compositions in altered ocean crust rocks at ODP Site 185-801

Re and Os concentrations and Os isotopic ratios were determined for composite samples prepared from volcanoclastics (VCL) and basaltic flows (FLO) from Jurassic oceanic crust (Ocean Drilling Program Leg 185, Site 801 in the western Pacific), with the aim of determining the effect of seafloor weathering on the Re-Os budget. A supercomposite sample, prepared from a proportionate mixture of the various composite powders, served to represent the average composition of the altered oceanic crust [Kelley, K.A., Plank, T., Ludden, J. and Staudigel, H., (2003). Composition of altered oceanic crust at ODP Sites 801 and 1149, Geochem. Geophys. Geosyst. 4(6) 8910, doi:10.1029/2002GC000435.]. Re contents vary from 0.2 to 1.3 ng/g, and from 2.2 to 3.1 ng/g in the VCL and FLO composites respectively. Os contents vary from 0.005 to 0.047 ng/g in the VCL, and from 0.008 to 0.027 ng/g in the FLO composites. The FLO composites have much higher Re/Os ratios and thus have more radiogenic Os compositions (187Os/188Os = 1.38 to 8.48) than the VCL composites (187Os/188Os = 0.32 to 4.40). The VCL composite from the upper section of the crust shows evidence for substantial Re loss and Os uptake, consistent with oxidative weathering processes. However, Re uptake during weathering processes under more reducing conditions, evident in the FLO samples from throughout the section and to a lesser extent in the lower VCL samples, more than compensates for this Re loss in the upper VCL. Os concentrations were essentially unchanged by these reductive processes. Model age calculations suggest that Re uptake continued for tens of millions of years after crust formation. Abundant secondary pyrite is found throughout the altered Hole 801C crust in zones of restricted seawater flow, and this may have accommodated an important part of the input Re. The Re content of the supercomposite (~2.2 ng/g) is about 1 ng/g higher than would be expected on the basis of its Yb content. If the results from Hole 801C are typical, they suggest that the Re concentration of at least the upper part of the oceanic crust may be nearly doubled during seafloor alteration. Such large extents of Re uptake would have a significant effect on the oceanic Re budget. Furthermore, assuming that they survive passage through the subduction zone, these elevated Re contents would greatly decrease the proportion of subducted oceanic crust required in the source region to explain the radiogenic Os compositions of many ocean island basalts.

(Table 1) Experimental shear strength values for IODP Exp315 and Exp316 holes

We investigate the mechanics of slope failures on the Nankai accretionary complex offshore Japan in the vicinity of a major out-of-sequence thrust fault (termed the "megasplay"). Incorporating laboratory-measured shear strength of slope sediments sampled during Integrated Ocean Drilling Project (IODP) Expeditions 315 and 316 with local seafloor slope angles from bathymetric data and constraints on in-situ effective stress conditions from drilling, we find that slopes in the study area are stable and submarine landslides are not expected to occur under static conditions. In order to assess the possibility of slope failure triggered by coseismic rupture of the megasplay fault, we use empirical relations for strong ground motion attenuation from earthquakes with Mw 6-9. We find that the slope sediments should be stable based on computations from one model, developed from a catalog of worldwide subduction zone earthquakes (Youngs et al., 1997, doi:10.1785/gssrl.68.1.58). However, using a different model developed primarily from a catalog of crustal earthquakes in Japan (Kanno et al., 2006, doi:10.1785/0120050138), we find that slopes should be unstable for earthquakes 8 <= Mw <= 9, and possibly unstable for events with 6 <= Mw < 8, depending on the proximity of rupture to the seafloor. Considering limitations of the models and geologic observations of slope failure recurrence, the true slope stability is likely to be in between the predictions of the two models, and we suggest that it may be modulated by long-term pore pressure fluctuations.