Root Canal Area Increase Promoted by the EndoSequence and ProTaper Systems: Comparison by Computed Tomography

Introduction: The aim of this study was to compare the increase of the root canal area after instrumentation with EndoSequence or ProTaper rotary systems. Methods: Twenty-two mesial root canals from mandibular molars were instrumented. Teeth were mounted on a base, numbered, and divided into 2 groups; teeth from 1-11 (PT group) were instrumented by using the ProTaper system, and teeth from 12-22 (ES group) were instrumented by using the EndoSequence system. Cone beam computed tomography was performed on all teeth before and after instrumentation. Measurements at 3,5, and 7 mm as well as differences in instrument performance were statistically compared by the Student t test at 5% significance level. Results: Both systems increased significantly the root canal area (P < .05) at all levels. Comparison between the rotary systems showed significantly greater increase (P < .05) for EndoSequence at 3 mm, with no statistically significant difference (P < .05) at the other levels. Conclusions: Both rotary systems increased significantly the root canal area. (J Endod 2010;36:1179-1182)

Effects of Gestational and Lactational Fenvalerate Exposure on Immune and Reproductive Systems of Male Rats

The aim of this study was to determine the consequent reproductive developmental and immunotoxic effects due to exposure to fenvalerate during pregnancy and lactation in male offspring of maternal-treated rats. Pregnant rats were treated daily by oral gavage with 40 or 80 mg/kg of fenvalerate or corn oil (vehicle, control), from d 12 of pregnancy to d 21 of lactation. Immune and reproductive developmental effects were assessed in male offspring at postnatal days (PND) 40 (peripuberty), 60 (postpuberty), and 90 (sexual maturity). Treatment with the higher dose (80 mg/kg) resulted in convulsive behavior, hyperexcitability, and mortality in 45% of the dams. Fenvalerate was detected in the fetus due to placental transfer, as well as in pups due to breast-milk ingestion, persisting in male offspring until PND 40 even though pesticide treatment was terminated on PND 20. However, fenvalerate did not produce marked alterations in age of testicular descent to the scrotum and prepucial separation, parameters indicative of puberty initiation. In contrast, at puberty, there was a reduction in testicular weight and sperm production in male offspring of maternal-treated rats. At adulthood, the sperm counts and fertility did not differ between control and treated groups. Testosterone levels were not changed at any time during reproductive development. Similarly, no apparent exposure-related effects were detected in the histological structures of the lymphohematopoietic system. Data indicate that fenvalerate, in this experimental model, interfered with initial development of the male reproductive system, but that these effects on sperm production or fertility did not persist into adulthood. There was no apparent evidence that fenvalerate altered testosterone levels or produced a disruption in male endocrine functions.

Virtual States, Halos and Resonances in Three-Body Atomic and Nuclear Systems

By considering nuclear and ultracold trapped atomic systems, we review the trajectory of Efimov excited states in the complex plane by changing the two-body scattering lengths and one three-body scale.

On control and synchronization in chaotic and hyperchaotic systems via linear feedback control

This paper presents the control and synchronization of chaos by designing linear feedback controllers. The linear feedback control problem for nonlinear systems has been formulated under optimal control theory viewpoint. Asymptotic stability of the closed-loop nonlinear system is guaranteed by means of a Lyapunov function which can clearly be seen to be the solution of the Hamilton-Jacobi-Bellman equation thus guaranteeing both stability and optimality. The formulated theorem expresses explicitly the form of minimized functional and gives the sufficient conditions that allow using the linear feedback control for nonlinear system. The numerical simulations were provided in order to show the effectiveness of this method for the control of the chaotic Rossler system and synchronization of the hyperchaotic Rossler system. (C) 2007 Elsevier B.V. All rights reserved.

Pollination and dispersal systems in a Cerrado remnant (Brazilian Savanna) in Southeastern Brazil

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Vegetative and productive aspects of organically grown coffee cultivars under shaded and unshaded systems

Although Coffea arabica species has its origin in the African understories, there is great resistance on the part of the Brazilian producers for growing this species under agroforestry systems as they fear that shading reduces production. This study aimed at evaluating some vegetative traits and the productivity of organically grown coffee (Coffea arabica L.) cultivars under shaded and unshaded systems. Twelve treatments consisting of two cultivation systems (shaded and unshaded) and six coffee cultivars were arranged in randomized blocks with four replicates, in a split-plot scheme. Shading was provided by banana (Musa sp.) and coral bean plants (Erythrinaverna). Shading delayed fruit maturation. Late maturation cultivars, such as the Icatu and the Obatã, matured early in both cultivation systems, while medium and early maturation cultivars presented late maturation. Cultivation in the shaded system increased the leaf area and the number of lower branches, decreased the number of productive nodes per branch, and increased the distance between the nodes and the number of leaves present in the branches. Cultivation in the unshaded system presented greater number of plants with branch blight in relation to plants grown in the shade. The productivity of the cultivars was not different, at 30.0 processed bags per hectare in the shaded system, and 25.8 processed bags per hectare in the unshaded system. The most productive cultivars in the shaded system were the Tupi, the Obatã, and the Catuaí, while no differences between cultivars were obtained in the unshaded system.

Characterization and catalytic activity of iron(III) mono(4-N-methyl pyridyl)-tris(halophenyl) porphyrins in homogeneous and heterogeneous systems

The synthesis, characterization and catalytic activity of the cationic iron porphyrins Fe[M(4-N-MePy)TDCPP]Cl-2 and Fe[M(4-N-MePy)TFPP]Cl-2 in the epoxidation of (Z)-cyclooctene by PhIO in homogeneous solution and supported on silica gel (SG), imidazole propyl gel (IPG) or SG modified with 2-(4-sulfonatophenyl)ethyl groups (SiSO3) have been accomplished. When supported on IPG, both cationic FeP bind to the support via Fe-imidazole coordination. Fe[M(4-N-MePy)TDCPP]IPG contains a mixture of low-spin bis-coordinated (FeP)-P-III and high-spin mono-coordinated (FeP)-P-III species, whereas Fe[M(4-N-MePy)TFPP]IPG only contains high-spin mono-coordinated (FeP)-P-III. These FePIPG catalysts also contain (FeP)-P-II species, whose presence was confirmed by EPR spectroscopy using NO as a paramagnetic probe. Both cationic FePs coordinate to SG through Fe-O ligation and they are present as high-spin (FeP)-P-III species. The cationic FePs supported on SiSO3- are also high-spin (FeP)-P-III species and they bind to the support via electrostatic interaction between the 4-N-methylpyridyl groups and the SO3- groups present on the matrix. In homogeneous solution, both Fe[M(4-N-MePy)TDCPP]Cl-2 and Fe[M(4-N-MePy)TFPP]Cl-2 have similar catalytic activity to Fe(TDCPP)Cl and Fe(TFPP)Cl, leading to cis-epoxycyclooctane yields of 92%. When supported on inorganic matrices,both FePs lead to epoxide yields comparable to their homogeneous analogues and their anchoring enables catalyst recovery and re-use. Recycling of Fe[M(4-N-MePy)TDCPP]SiSO3- shows that this FeP maintains its activity in a second reaction. (C) 1999 Elsevier B.V. B.V. All rights reserved.

Thermoeconomic analysis method for optimization of combined heat and power systems. Part I

This article presents a thermoeconomic analysis of cogeneration plants, applied as a rational technique to produce electric power and saturated steam. The aim of this new methodology is the minimum Exergetic Production Cost (EPC), based on the Second Law of Thermodynamics. The variables selected for the optimization are the pressure and the temperature of the steam leaving the boiler in the case of using steam turbine, and the pressure ratio, turbine exhaust temperature and mass flow in the case of using gas turbines. The equations for calculating the capital costs of the components and products are formulated as a function of these decision variables. An application of the method using real data of a multinational chemical industry located in São Paulo state is presented. The conditions which establish the minimum cost are presented as final output. (C) 2003 Elsevier Ltd. All rights reserved.

In vitro evaluation of root canal preparation using oscillatory and rotary systems in flattened root canals

Objective: the aim of this study was to evaluate the biomechanical preparation of flattened root canals using the following systems: Endo-Eze AET stainless steel oscillatory instruments (Ultradent) and RaCe rotary NiTi instruments (FKG Dentaire). Materials and Methods: Twenty extracted human mandibular incisors were randomly assigned to two groups: Group I Instrumentation with oscillatory Endo-Eze AET files (oscillatory technique); Group 2 - Instrumentation with rotary NiTi RaCe files (rotary technique). The teeth were decoronated, had their apices and coronal openings sealed with sticky wax and were embedded in crystal-clear orthophtalic polyester resin. The roots were sectioned transversally with diamond discs at 10 mm (middle third) and 5 mm (apical third) from the apex and the segments were reassembled for instrumentation. The sections were photographed before and after root canal instrumentation and evaluated with respect to whether the original root canal shape was modified by instrumentation. To evaluate the differences in the root canal shape before and after biomechanical preparation, scores were given regarding the instruments touch on the intracanal walls. Results: In middle third of the root canals instrumented with the rotary system, there was a change in the original canal anatomy (p < 0.05), with formation of a protuberance in the mesiodistal direction. This protuberance did not occur when the oscillatory instrumentation was used. The oscillatory system had better results in the middle and apical thirds as evaluated by Dunn's multiple-comparison test (p > 0.05). Conclusion: Under the tested conditions, Endo-Eze oscillatory system yielded the instrumentation of all flattened oot canal walls, maintaining the canal original shape throughout the biomechanical preparation, and was more effective than RaCe rotary system.

Oxytocinergic and serotonergic systems involvement in sodium intake regulation: satiety or hypertonicity markers?

Previous studies demonstrated the inhibitory participation of serotonergic ( 5-HT) and oxytocinergic (OT) neurons on sodium appetite induced by peritoneal dialysis (PD) in rats. The activity of 5-HT neurons increases after PD- induced 2% NaCl intake and decreases after sodium depletion; however, the activity of the OT neurons appears only after PD-induced 2% NaCl intake. To discriminate whether the differential activations of the 5-HT and OT neurons in this model are a consequence of the sodium satiation process or are the result of stimulation caused by the entry to the body of a hypertonic sodium solution during sodium access, we analyzed the number of Fos-5-HT- and Fos-OT-immunoreactive neurons in the dorsal raphe nucleus and the paraventricular nucleus of the hypothalamus-supraoptic nucleus, respectively, after isotonic vs. hypertonic NaCl intake induced by PD. We also studied the OT plasma levels after PD- induced isotonic or hypertonic NaCl intake. Sodium intake induced by PD significantly increased the number of Fos-5- HT cells, independently of the concentration of NaCl consumed. In contrast, the number of Fos-OT neurons increased after hypertonic NaCl intake, in both depleted and nondepleted animals. The OT plasma levels significantly increased only in the PD- induced 2% NaCl intake group in relation to others, showing a synergic effect of both factors. In summary, 5-HT neurons were activated after body sodium status was reestablished, suggesting that this system is activated under conditions of satiety. In terms of the OT system, both OT neural activity and OT plasma levels were increased by the entry of hypertonic NaCl solution during sodium consumption, suggesting that this system is involved in the processing of hyperosmotic signals.

Phenotypic methods and commercial systems for the discrimination between C-albicans and C-dubliniensis

Candida dubliniensis is a recently described Candida species associated with oral candidosis that exhibits a high degree of phenotypic similarity to Candida albicans. However, these species show differences in levels of resistance to antimycotic agents and ability to cause infections. Therefore, accurate clinical identification of C. dubliniensis and C. albicans species is important in order to treat oral candidal infections. Phenotypic identification methods are easy-to-use procedures for routine discrimination of oral isolates in the clinical microbiology laboratory. However, C. dubliniensis may be so far underreported in clinical samples because most currently used identification methods fail to recognize this yeast. Phenotypic methods depend on growth temperature, carbon source assimilation, chlamydospore and hyphal growth production, positive or negative growth on special media and intracellular enzyme production, among others. In this review, some phenotypic methods are presented with a special emphasis on the discrimination of C. dubliniensis and C. albicans.

A CASE tool for the modeling of methods and information systems

MODSI is a multi-models tool for information systems modeling. A modeling process in MODSI can be driven according to three different approaches: informal, semi-formal and formal. The MODSI tool is therefore based on the linked usage of these three modeling approaches. It can be employed at two different levels: the meta-modeling of a method and the modeling of an information system.In this paper we start presenting different types of modeling by making an analysis of their particular features. Then, we introduce the meta-model defined in our tool, as well as the tool functional architecture. Finally, we describe and illustrate the various usage levels of this tool.

The characteristics of a test liquid formulation for use in evaluating the performance of handling and metering systems

Injection metering systems are an important option for the development of pesticide application equipment, with advantages relating to minimising the need for disposal of unused pesticide, improving the ease of cleaning and optimising the accuracy of chemical application. For all injection systems, characteristics such as the steady-state accuracy of delivered dose, dose stability and the time response for dose step changes are related to the ability of the system to operate with different chemical formulations. A system designed to inject liquids should be able to accommodate changes in viscosity and density. The aim of this study was to develop a methodology for testing chemical injection systems using liquids with different viscosities. The experimental arrangement simulating applications with injection metering systems used dye and salt solutions as tracers. Tests were conducted to analyse the influence of salt on the characteristics of the water and a viscous solution. Results showed that the salt interfered with the dye stability in the water solution. In tests with a viscous test liquid, the salt was introduced at different steps during the mixing process, providing four different liquids to be analysed in terms of viscosity, density and pH. Some differences in liquid characteristics were found which could influence the performance of the injection systems.