Estimation of yield of dry air bladders from eel fish

The findings are presented of a study conducted to determine a method for the calculation of the yield of dried air bladders of eel from the weight of the whole fish.

The effect of spirulina (fresh and dry) on some biological factors in Penaeus semisulcatus larvae

Spirulina is a filamentous cyanobacteria with many applications in food and drug industries, as a food in human, aquaculture, vet and poultry industries… . Semi and mass culture of Spirulina carries out in different countries. This study was carried out in five phases in order to produce this microalga in Iran. The first phase, Spirulina pure stock was imported from Indonesia. After identification of species, it was cultured in laboratory until we took 20 liters of biomass. The semi-mass culture was carried out in green house. Cell concentration and size of Spirulina were recorded during culture daily and their growth rates were calculated. After two weeks, when the size of Spirulina was suitable, biomass of Spirulina was harvested then accumulated Spirulina weighted and dried in 24 hours in laboratory. In order to microbiological study, the samples of Spirulina (dry and fresh) were cultured on blood agar medium and coliforms were counted. The chemical composition of produced Spirulina was measured by standard methods. Fatty acid and amino acid profiles were acquired by GC and HPLC instruments, respectively. The amount of chlorophyll in Spirulina was determined by spectroscopy method. Also astaxanthin pigment as an important carotenoid was measured by HPLC in Spirulina and Penaeus semisulcatus larvae fed on Spirulina. At final phase of this project, larva fed on produced Spirulina (biomass and dry powder) was compared to Z plus, microencapsulated Spirulina (M.C.F) and Chaetoceros algae as control. This experiment was carried from zoa to early post larvae stage then survival and growth rate of larvae were recorded. The growth rate of larvae was evaluated with ANOVA test and survival rate of treatments was assessed by Log Rank (Mantel –Cox) test. Also during larvae stage, two parameters of water such as nitrate and nitrite were measured in zoa, mysis and post larvae stages. The results of this study were shown that colifom counts were 1.85×106 and 92.3×105 coliform per ml in fresh and dry spirulina, respectively. Protein percent of dry spirulina was 50.93 % (dry weight) and the amount of astaxanthin in spirulina and larvae fed on spirulina were 0.21 and 0.01 mg/kg, respectively. The most survival rate of larvae were observed in zoa III (88.8%) with Z plus supplement treatment, in mysis III (76.5%) combination of Z plus and dry spirulina in comparative between treatments. Larvae growth (4.5mm) of control in early post larvae was the best.

Changes in phytoplankton communities and primary production

Lake Victoria is the second largest lake in the world (69000km2) by surface area, but it is the shallowest (69m maximum depth) of the African Great Lakes. It is situated across the equator at an altitude of 1240m and lies in a shallow basin between two uplifted ridges of the eastern and western rift valleys (Beadle 1974). Despite their tropical locations, African lakes exhibit considerable seasonality related to the alteration of warm, wet and cool, dry seasons and the accompanying changes in lucustrine stratification and mixing (Tailing, 1965; 1966; Melack 1979; Hecky& Fee 1981; Hecky& Kling,1981; 1987; Bootsma 1993; Mugidde 1992; 1993). Phytoplankton productivity, biomass and species composition change seasonally in response to variations in light environment and nutrient availability which accompany changes in mixed layer depth and erosion or stabilization of the metalimnion / hypolimnion (Spigel & Coulter 1996; Hecky et al., 1991; Tailing 1987). Over longer, millennial time scales, the phytoplankton communities of the African Great Lakes have responded to variability in the EastAfrican climate (Johnson 1996; Haberyan& Hecky, 1986) which also alters the same ecological factors (Kilham et al., 1986). Recently, over the last few decades, changes in external and or internal factors in Lake Victoria and its basin have had a profound inlluence on the planktic community of this lake (Hecky, 1993; Lipiatou et al., 1996). The lake has experienced 2-10x increases in chlorophyll and 2x increase in primary productivity since Tailing's observations in the early 1960s (Mugidde 1992, 1993). In addition to observed changes in the lake nutrient chemistry (Hecky & Mungoma, 1990; Hecky & Bugenyi 1992; Hecky 1993; Bootsma & Hecky 1993), the deep waters previouslyoxygenated to the sediment surface through most of the year are now regularly anoxic(Hecky et al., 1994).

Dynamic centrifuge tests on shallow tunnel models in dry sand

In the framework of the Italian research project ReLUIS-DPC, a set of centrifuge tests were carried out at the Schofield Centre in Cambridge (UK) to investigate the seismic behaviour of tunnels. Four samples of dry sand were prepared at different densities, in which a small scale model of circular tunnel was inserted, instrumented with gauges measuring hoop and bending strains. Arrays of accelerometers in the soil and on the box allowed the amplification of ground motion to be evaluated; LVDTs measured the soil surface settlement. This paper describes the main results of this research, showing among others the evolution of the internal forces during the model earthquakes at significant locations along the tunnel lining. © 2010 Taylor & Francis Group, London.

Dry-transfer of aligned multiwalled carbon nanotubes for flexible transparent thin films

Herein we present an inexpensive facile wet-chemistry-free approach to the transfer of chemical vapour-deposited multiwalled carbon nanotubes to flexible transparent polymer substrates in a single-step process. By controlling the nanotube length, we demonstrate accurate control over the electrical conductivity and optical transparency of the transferred thin films. Uniaxial strains of up to 140% induced only minor reductions in sample conductivity, opening up a number of applications in stretchable electronics. Nanotube alignment offers enhanced functionality for applications such as polarisation selective electrodes and flexible supercapacitor substrates. A capacitance of 17F/g was determined for supercapacitors fabricated from the reported dry-transferred MWCNTs with the corresponding cyclic voltagrams showing a clear dependence on nanotube length. © 2012 Matthew Cole et al.

Local stress relaxation and shear banding in a dry foam under shear.

We have developed a realistic simulation of 2D dry foams under quasistatic shear. After a short transient, a shear-banding instability is observed. These results are compared with measurements obtained on real 2D (confined) foams. The numerical model allows us to exhibit the mechanical response of the material to a single plastication event. From the analysis of this elastic propagator, we propose a scenario for the onset and stability of the flow localization process in foams, which should remain valid for most athermal amorphous systems under creep flow.

2-Scale topography dry electrode for biopotential measurements.

The design and fabrication of a novel 2-scale topography dry electrode using macro and micro needles is presented. The macro needles enable biopotential measurements on hairy skin, the function of the micro needles is to decrease the electrode impedance even further by penetrating the outer skin layer. Also, a fast and reliable impedance characterization protocol is described. Based on this impedance measurement protocol, a comparison study is made between our dry electrode, 3 other commercial dry electrodes and a standard wet gel electrode. Promising results are already obtained with our electrodes which do not have skin piercing micro needles. For the proposed electrodes, three different conductive coatings (Ag/AgCl/Au) are compared. AgCl is found to be slightly better than Ag as coating material, while our Au coated electrodes have the highest impedance.

Dry oxidation and vacuum annealing treatments for tuning the wetting properties of carbon nanotube arrays.

In this article, we describe a simple method to reversibly tune the wetting properties of vertically aligned carbon nanotube (CNT) arrays. Here, CNT arrays are defined as densely packed multi-walled carbon nanotubes oriented perpendicular to the growth substrate as a result of a growth process by the standard thermal chemical vapor deposition (CVD) technique.(1,2) These CNT arrays are then exposed to vacuum annealing treatment to make them more hydrophobic or to dry oxidation treatment to render them more hydrophilic. The hydrophobic CNT arrays can be turned hydrophilic by exposing them to dry oxidation treatment, while the hydrophilic CNT arrays can be turned hydrophobic by exposing them to vacuum annealing treatment. Using a combination of both treatments, CNT arrays can be repeatedly switched between hydrophilic and hydrophobic.(2) Therefore, such combination show a very high potential in many industrial and consumer applications, including drug delivery system and high power density supercapacitors.(3-5) The key to vary the wettability of CNT arrays is to control the surface concentration of oxygen adsorbates. Basically oxygen adsorbates can be introduced by exposing the CNT arrays to any oxidation treatment. Here we use dry oxidation treatments, such as oxygen plasma and UV/ozone, to functionalize the surface of CNT with oxygenated functional groups. These oxygenated functional groups allow hydrogen bond between the surface of CNT and water molecules to form, rendering the CNT hydrophilic. To turn them hydrophobic, adsorbed oxygen must be removed from the surface of CNT. Here we employ vacuum annealing treatment to induce oxygen desorption process. CNT arrays with extremely low surface concentration of oxygen adsorbates exhibit a superhydrophobic behavior.

Assessment of dry weight by monitoring changes in blood volume during hemodialysis using Crit-Line.

BACKGROUND: Routine assessment of dry weight in chronic hemodialysis patients relies primarily on clinical evaluation of patient fluid status. We evaluated whether measurement of postdialytic vascular refill could assist in the assessment of dry weight. METHODS: Twenty-eight chronic, stable hemodialysis patients were studied during routine treatment sessions using constant dialysate temperature and dialysate sodium concentration, and relative changes in blood volume were monitored using Crit-Line III monitors throughout this study. The study was divided into three phases. Phase 1 studies evaluated the time-dependence of vascular compartment refill after completion of hemodialysis. Phase 2 studies evaluated the relationships in patient subgroups between intradialytic changes in blood volume and the presence of postdialytic vascular compartment refill during that last 10 minutes of hemodialysis after stopping ultrafiltration. Phase 3 studies evaluated the extent of dry weight changes following the application of a protocol for blood volume reduction, postdialytic vascular compartment refill, and correlation with clinical evidence of intradialytic hypovolemia and/or postdialytic fatigue. Phase 3 included anywhere from three to five treatments. RESULTS: Phase 1 studies demonstrated that despite interpatient variability in the magnitude of postdialytic vascular compartment refill, when significant refill was evident, it always continued for at least 30 minutes. However, the majority of refill took place within 10 minutes postdialysis. Phase 2 studies identified 3 groups of patients: those who exhibited intradialytic reductions in blood volume but not postdialytic vascular compartment refill (group 1), those who exhibited intradialytic reductions in blood volume and postdialytic vascular compartment refill (group 2), and those whose blood volume did not change substantially during hemodialysis treatment (group 3). In phase 3 studies, use of an ultrafiltration protocol for blood volume reduction and monitoring of postdialytic vascular compartment refill combined with clinical assessment of hypovolemia and postdialytic fatigue demonstrated that patients often had a clinical dry weight assessment which was too low or too high. In all 28 patients studied, dry weight was either increased or decreased following use of this protocol. CONCLUSION: Determination of the extent of both intradialytic decreases in blood volume and postdialytic vascular compartment refill, combined with clinical assessment of intradialytic hypovolemia and postdialytic fatigue, can help assess patient dry weight and optimize volume status while reducing dialysis associated morbidity. The number of hospital admissions due to fluid overload may be reduced.

Effect of dry oxidation on the performance of carbon nanotube arrays electrochemical capacitors

In this study, the effect of dry oxidation on the electrochemical properties of carbon nanotube arrays is investigated. Oxygenated surface functional groups were introduced to the arrays by oxygen plasma treatment, where their surface concentrations were varied by controlling the exposure time. The finding presented herein shows an augmentation of nearly thirty times in term of specific capacitance when the arrays are oxidized. Similar behavior is also observed in the non-aqueous electrolytes where the specific capacitance of the oxidized carbon nanotube arrays is measured more than three times higher than that of the pristine ones. However, overexposure to oxygen plasma treatment reverses this effect. At such high oxidation level, the damage to the graphitic structure becomes more pronounced such that the capacitive behavior of the arrays is overshadowed by their resistive behavior. These findings are important for further development of carbon nanotube based electrochemical capacitors. © 2012 Materials Research Society.