Geochemistry on manganese deposit from the Median Valley of the Mid-Atlantic Ridge

A manganese oxide crust from an extensive deposit in the median valley of the Mid-Atlantic Ridge was found to be unusually high in manganese (up to 39.4% Mn), low in Fe (as low as 0.01% Fe), low in trace metals and deficient in Th230 and Pa231 with respect to the parent uranium isotopes in the sample. The accumulation rate is 100 mm to 200 mm/10 million year, or 2 orders of magnitude faster than the typical rate for deep-sea ferromanganese deposits. The rapid growth rate and unusual chemistry are consistent with a hydrothermal origin or with a diagenetic origin by manganese remobilized from reduced sediments. Because of the association with an active ridge, geophysical evidence indicative of hydrothermal activity, and a scarcity of sediment in the sampling area, we suggest that a submarine hot spring has created the deposit.

Chemical composition and accumulation rates of chemical elements in metalliferous sediments from axial zones of the East Pacific Rise and the Mid-Atlantic Ridge

In the monograph metalliferous sediments of the East Pacific Rise near 21°S are under consideration. Distribution trends of chemical, mineral and grain size compositions of metalliferous sediments accumulated near the axis of this ultrafast spreading segment of the EPR are shown. On the basis of lithological and geochemical investigations spatial and temporal variations of hydrothermal activity are estimated. Migration rates of hydrothermal fields along the spreading axis are calculated. The model of cyclic hydrothermal process is suggested as a result of tectono-magmatic development of the spreding centre.

Geochemistry on manganese nodules from Timor

Fossil Mn nodules of Cretaceous age from western Timor exhibit chemical, structural and radioisotope compositions consistent with their being of deep-sea origin. These nodules show characteristics similar to nodules now found at depths of 3,500-5,000 m in the Pacific and Indian Oceans. Slight differences in the fine structure and chemistry of these nodules and modern deep-sea nodules are attributed to diagenetic alteration after uplift of enclosing sediments.

Holocene corals from the South China Sea

The South China Sea (SCS) is well connected with the western Pacific and influenced by the East Asian monsoon. We have examined temporal variations in radiocarbon marine reservoir ages (R) and regional marine reservoir corrections (DeltaR) of the SCS during the Holocene using paired measurements of AMS 14C and TIMS 230Th on 20 pristine corals. The results show large fluctuations in both R and DeltaR values over the past 7500 years (yrs) with two distinct plateaus during 7.5-5.6 and 3.5-2.5 thousand calendar years before present (cal ka BP). The respective weighted mean DeltaR values of these plateaus are 151 ± 85 and 89 ± 59 yrs, which are significantly higher than its modern value of -23 ± 52 yrs. This suggests that using a constant modern DeltaR value to calibrate 14C dates of the SCS marine samples will introduce additional errors to the calibrated ages. Our results provide the first database for the Holocene R and DeltaR values of the SCS for improved radiocarbon calibration of marine samples. We interpret the two DeltaR plateaus as being related to two intervals with weakened El Niño - Southern Oscillation (ENSO) and intensified East Asian summer monsoon (EASM). This is because the 14C content of the SCS surface water is controlled by both the 14C concentration of the Pacific North Equatorial Current (NEC) which is in turn influenced by ENSO-induced upwelling along the Pacific equator and vertical upwelling within the SCS as a result of moisture transportation to midlatitude region to supply the EASM rainfall.

Concentrations and isotopic ratios of thorium and uranium in pelagic sediments

The predictable in situ production of 230Th from the decay of uranium in seawater, and its subsequent removal by scavenging onto falling particles, provides a valuable tool for normalizing fluxes to the seafloor. We describe a new application, determination of the 232Th that dissolves in the water column and is removed to the seafloor. 232Th is supplied to the ocean in continental minerals, dissolution of which leads to a measurable standing stock in the water column. Sedimentary adsorbed 232Th/230Th ratios have the potential to provide a proxy for estimating the amount of dissolved material that enters the ocean, both today and in the past. Ten core top samples were treated with up to eight different leaching techniques in order to determine the best method for the separating adsorbed from lattice bound thorium. In addition, separate components of the sediments were analyzed to test whether clay dissolution was an important contribution to the final measurement. There was no systematic correlation between the strength of acid used in the leach and the measured 232Th/230Th ratios. In all cases clean foraminifera produced the same ratio as leaches on bulk sediment. In three out of five samples leaches performed on non-carbonate detritus in the <63 µm size fraction were also identical. Without additional water column data it is not yet clear whether there is a simple one to one correlation between the expected deep-water 232Th/230Th and that produced by leaching, especially in carbonate-rich sediments. However, higher ratios, and associated high 232Th adsorbed fluxes, were observed in areas with high expected detrital inputs. The adsorbed fraction was ~35-50% of the total 232Th in seven out of ten samples. Our 230Th normalized 232Th fluxes are reasonable by comparison to global estimates of detrital inputs to the ocean. In nine cases out of ten, the total 230Th-normalized 232Th flux is greater than predicted from the annual dust fall at each specific location, but lower than the average global detrital input from all sources.

Rare and trace element analyses from DSDP Holes 31-291 and 31-294 from the Philippine Sea

Metal-rich sediments were found in the West Philippine Basin at DSDP sites 291 (located about 500 km SW of the Philippine Ridge or Central Basin Fault) and 294/295 (located about 580 km NE of the Philippine Ridge). In both cases the metalliferous deposits constitute a layer, probably Eocene in age, resting directly above the basaltic basement at the bottom of the sediment column. The chemistry of the major (including Fe and Mn) and trace elements (including trace metals, rare earth elements, U and Th) suggest a strong similarity of these deposits to metalliferous deposits produced by hydrothermal activity at oceanic spreading centers. Well-crystallized hematite is a major component of the metal-rich deposits at site 294/295. We infer that the Philippine Sea deposits were formed at some spreading center by hydrothermal processes of metallogenesis, similar to processes occurring at oceanic spreading centers. A locus for their formation might have been the Philippine Ridge (Central Basin Fault), probably an extinct spreading center. We conclude that metallogenesis of the type occurring at oceanic spreading centers can take place also in marginal basins. This has implications for the origin of metal deposits found in some ophiolite complexes, such as those in Luzon (Philippines), which may represent fragments of former marginal basins rather than of oceanic lithosphere.

Composition of Mn-oxide crusts from the south-west Pacific island arc

Hydrothermal deposits of a wide variety of types are being found with increasing frequency on or near actively spreading mid-ocean ridges. However, they also have a potential to occur in other submarine volcanic settings, including island arcs. To follow up indications of mineralization associated with submarine hydrothermal activity in the south-west Pacific island arc, a joint New Zealand Oceanographic Institute/Imperial College research cruise was mounted in May 1981 aboard the RV Tangaroa. During this cruise, over 130 sampling stations were occupied, at one of which were dredged manganese deposits with strong hydrothermal affinities. This is the first report of such deposits from an island arc setting.