Frost heave testing of norwegian materials for road infrastructure

In areas of seasonal frost, frost susceptibility composed by frost heaving during the winter and thaw softening during the spring is one of the most dangerous phenomenon for transportation, road and railway infrastructure. Therefore, the need for frost protection layer becomes imperative. The purpose of frost protection layer is to prevent frost from penetrating down through the pavement and into the sub-soils. Frost susceptible soils under the road can be cause damages on the roads or other structures due to frost heave or reduced capacity characteristics thaw period. "Frost heave" is the term given to the upwards displacement of the ground surface caused by the formation of ice within soils or aggregates (Rempel et al., 2004). Nowadays in Scandinavia the most common material used in frost protection layer in the pavement structure of roads and in the ballast of the railway tracks are coarse-grain crushed rocks aggregates. Based on the capillary rise, the mechanics of frost heave phenomenon is based on the interaction between aggregates and water, as suggested by Konrad and Lemieux in 2005 that said that the fraction of material below the 0.063 mm sieve for coarse-grained soils must be controlled so as to reduce the sensitivity to frost heave. The study conducted in this thesis project is divided in two parts: - the analysis of the coarse grained aggregates used in frost protection layer in Norway; - the analysis of the frost heave phenomenon in the laboratory under known boundary conditions, through the use of the most widely used method, the frost heave test, in” closed system” (without access of water).

Traffic light policies for low penetration rate of monitoring devices

La gestione del traffico è una delle principali problematiche delle città moderne, e porta alla definizione di nuove sfide per quanto riguarda l’ottimizzazione del flusso veicolare. Il controllo semaforico è uno degli elementi fondamentali per ottimizzare la gestione del traffico. Attualmente la rilevazione del traffico viene effettuata tramite sensori, tra i quali vengono maggiormente utilizzate le spire magnetiche, la cui installazione e gestione implica costi elevati. In questo contesto, il progetto europeo COLOMBO si pone come obiettivo l’ideazione di nuovi sistemi di regolazione semaforica in grado di rilevare il traffico veicolare mediante sensori più economici da installare e mantenere, e capaci, sulla base di tali rilevazioni, di auto organizzarsi, traendo ispirazione dal campo dell’intelligenza artificiale noto come swarm intelligence. Alla base di questa auto organizzazione semaforica di COLOMBO vi sono due diversi livelli di politiche: macroscopico e microscopico. Nel primo caso le politiche macroscopiche, utilizzando il feromone come astrazione dell’attuale livello del traffico, scelgono la politica di gestione in base alla quantità di feromone presente nelle corsie di entrata e di uscita. Per quanto riguarda invece le politiche microscopiche, il loro compito è quello di deci- dere la durata dei periodi di rosso o verde modificando una sequenza di fasi, chiamata in COLOMBO catena. Le catene possono essere scelte dal sistema in base al valore corrente della soglia di desiderabilità e ad ogni catena corrisponde una soglia di desiderabilità. Lo scopo di questo elaborato è quello di suggerire metodi alternativi all’attuale conteggio di questa soglia di desiderabilità in scenari di bassa presenza di dispositivi per la rilevazione dei veicoli. Ogni algoritmo complesso ha bisogno di essere ottimizzato per migliorarne le performance. Anche in questo caso, gli algoritmi proposti hanno subito un processo di parameter tuning per ottimizzarne le prestazioni in scenari di bassa presenza di dispositivi per la rilevazione dei veicoli. Sulla base del lavoro di parameter tuning, infine, sono state eseguite delle simulazioni per valutare quale degli approcci suggeriti sia il migliore.

Relationship between DIAGNOdent values and sealant penetration depth on occlusal fissures

The aim of this in vitro study was to evaluate the relationship between laser fluorescence values and sealant penetration depth on occlusal fissures. One hundred and sixty-six permanent molars were selected and divided into four groups, which were each treated using a different sealant (two clear and two opaque). The teeth were independently measured twice by two experienced dentists using two laser fluorescence devices-DIAGNOdent (LF and LFpen)-before and after sealing, and then thermoclycled. After measuring, the teeth were histologically prepared and assessed for caries extension. Digital photographs of the cut sealed sites were assessed, and the sealant penetration depth was measured. All 166 sites were measured by one of the examiners taking as limits the outer and inner surface of the sealant into the fissure. For each device (LF and LFpen) and each group, the difference between the values at baseline and after sealing was plotted against the sealant penetration depth and scatter plots were provided. It could be observed that most of the points were concentrated around the zero line, for both LF and LFpen in the four groups. In conclusion, there is no relation between changes in DIAGNOdent values and increasing of depth sealant penetration within the occlusal fissures.

Impact of corneal cross-linking on drug penetration in an ex vivo porcine eye model

To analyze the influence of corneal cross-linking (CXL) using ultraviolet-A and riboflavin on corneal drug penetration of topically applied drugs.

High interstitial fluid pressure is associated with low tumour penetration of diagnostic monoclonal antibodies applied for molecular imaging purposes

The human epithelial cell adhesion molecule (EpCAM) is highly expressed in a variety of clinical tumour entities. Although an antibody against EpCAM has successfully been used as an adjuvant therapy in colon cancer, this therapy has never gained wide-spread use. We have therefore investigated the possibilities and limitations for EpCAM as possible molecular imaging target using a panel of preclinical cancer models. Twelve human cancer cell lines representing six tumour entities were tested for their EpCAM expression by qPCR, flow cytometry analysis and immunocytochemistry. In addition, EpCAM expression was analyzed in vivo in xenograft models for tumours derived from these cells. Except for melanoma, all cell lines expressed EpCAM mRNA and protein when grown in vitro. Although they exhibited different mRNA levels, all cell lines showed similar EpCAM protein levels upon detection with monoclonal antibodies. When grown in vivo, the EpCAM expression was unaffected compared to in vitro except for the pancreatic carcinoma cell line 5072 which lost its EpCAM expression in vivo. Intravenously applied radio-labelled anti EpCAM MOC31 antibody was enriched in HT29 primary tumour xenografts indicating that EpCAM binding sites are accessible in vivo. However, bound antibody could only be immunohistochemically detected in the vicinity of perfused blood vessels. Investigation of the fine structure of the HT29 tumour blood vessels showed that they were immature and prone for higher fluid flux into the interstitial space. Consistent with this hypothesis, a higher interstitial fluid pressure of about 12 mbar was measured in the HT29 primary tumour via "wick-in-needle" technique which could explain the limited diffusion of the antibody into the tumour observed by immunohistochemistry.

Nature, Poetry, and Liminality in the Poetry of Robert Frost

Explores how Frost examines and configures the divide between life’s imperfections and its rewards. I am particularly interested in how Frost positions both the non-human natural world and poetry itself as intermediary (or liminal) realms that might help us live simultaneously in the worlds of reality and the imagination, or truth and beauty, or heaven and earth.

Ocular penetration of caspofungin in a rabbit uveitis model

BACKGROUND: Little is known about the ocular penetration of echinocandin antifungals. We studied the ocular distribution of systemically administered caspofungin in a rabbit uveitis model. METHODS: Caspofungin (1 mg/kg per day) was given intravenously to rabbits as a single dose or as repeated daily doses on 7 days starting 24 h after induction of unilateral uveitis by intravitreal endotoxin injection. Caspofungin concentrations were determined by high-performance liquid chromatography in the cornea, aqueous humor, vitreous humor, and serum 4, 8, 16, and 24 h after administration of a single dose and 24 h after the last of seven doses. RESULTS: The mean caspofungin concentration in the aqueous of the inflamed eye 4 and 8 h after single-dose administration was 1.30 +/- 0.39 mug/ml and 1.12 +/- 0.34 mug/ml, respectively. Drug concentrations decreased to 0.24 +/- 0.09 mug/ml at 16 h and 0.26 +/- 0.14 mug/ml at 24 h. In the vitreous of inflamed eyes drug levels were undetectable at all time points. No drug was found in the aqueous of inflamed eyes 24 h after the last of seven repeated doses, and the vitreous only contained trace amounts. In the corneas of inflamed eyes concentrations reached 1.64 +/- 0.48 mug/g at 4 h, peaked at 2.16 +/- 1.14 mug/g at 8 h, and declined to 1.87 +/- 0.52 mug/g and 1.49 +/- 0.48 mug/g at 16 and 24 h, respectively. After repeated dosing, corneal concentrations of caspofungin were 0.8 and 1.0 mug/g and below the limit of detection in two of four animals. In non-inflamed eyes no drug was detectable in the aqueous and vitreous humor, and the corneas at any time point. CONCLUSIONS: In our model, caspofungin reached therapeutically relevant levels in the aqueous and cornea but not in the vitreous humor of inflamed eyes. Intraocular drug deposition was critically dependent on a disrupted blood-eye barrier. These findings suggest a limited role for caspofungin in the treatment of fungal endophthalmitis.

Penetration of ASM 981 in canine skin: a comparative study

ASM 981 has been developed for topical treatment of inflammatory skin diseases. It specifically inhibits the production and release of pro-inflammatory cytokines. We measured the skin penetration of ASM 981 in canine skin and compared penetration in living and frozen skin. To make penetration of ASM 981 visible in dog skin, tritium labelled ASM 981 was applied to a living dog and to defrosted skin of the same dog. Using qualitative autoradiography the radioactive molecules were detected in the lumen of the hair follicles until the infundibulum, around the superficial parts of the hair follicles and into a depth of the dermis of 200 to 500 microm. Activity could not be found in deeper parts of the hair follicles, the dermis or in the sebaceous glands. Penetration of ASM 981 is low in canine skin and is only equally spread in the upper third of the dermis 24 hours after application. Penetration in frozen skin takes even longer than in living canine skin but shows the same distribution.

Penetration ability and microleakage of a fissure sealant applied on artificial and natural enamel fissure caries

OBJECTIVES AND METHODS: This study investigated the sealing ability of a current available unfilled fissure sealant applied over sound (n=80), artificially created (n=80) and naturally carious fissures (n=80) under different humidity conditions (90+/-2 and 45+/-2% relative humidity) and etching times (40 and 60s). All samples were submitted to 5000 thermal cycles and examined by light microscopy after sectioning. Microleakage, penetration ability, fissure type, fissure entrance angle, sealant occlusal length, caries location and caries depth were assessed. RESULTS: The significantly longer sealant occlusal length and larger entrance angle exhibited by shallow fissures, contributed to their higher microleakage and smaller amounts of unfilled areas compared to deep fissures. Sealant microleakage was significantly influenced by the condition of the enamel (sound, artificial and natural caries) and the caries location in the fissures, but not by enamel caries depth (D1 and D2), etching time, or humidity condition. Natural caries exhibited significantly higher microleakage than sound or artificially created carious fissures. CONCLUSIONS: Based on the results of this study, it can be concluded that location of caries in the fissure rather than its depth should be taken into account when applying a fissure sealant. When the borders of the fissure sealant are on carious enamel, a significantly higher microleakage must be expected. The artificial caries model was not a suitable method to assess the behavior of natural fissure caries.