Using appearance and context for outdoor scene object classification

We propose a probabilistic object classifier for outdoor scene analysis as a first step in solving the problem of scene context generation. The method begins with a top-down control, which uses the previously learned models (appearance and absolute location) to obtain an initial pixel-level classification. This information provides us the core of objects, which is used to acquire a more accurate object model. Therefore, their growing by specific active regions allows us to obtain an accurate recognition of known regions. Next, a stage of general segmentation provides the segmentation of unknown regions by a bottom-strategy. Finally, the last stage tries to perform a region fusion of known and unknown segmented objects. The result is both a segmentation of the image and a recognition of each segment as a given object class or as an unknown segmented object. Furthermore, experimental results are shown and evaluated to prove the validity of our proposal

Correction of shading effects in vision-based UUV localization

This paper describes the improvements achieved in our mosaicking system to assist unmanned underwater vehicle navigation. A major advance has been attained in the processing of images of the ocean floor when light absorption effects are evident. Due to the absorption of natural light, underwater vehicles often require artificial light sources attached to them to provide the adequate illumination for processing underwater images. Unfortunately, these flashlights tend to illuminate the scene in a nonuniform fashion. In this paper a technique to correct non-uniform lighting is proposed. The acquired frames are compensated through a point-by-point division of the image by an estimation of the illumination field. Then, the gray-levels of the obtained image remapped to enhance image contrast. Experiments with real images are presented

Towards a real-time vision-based navigation system for a small-class UUV

This paper deals with the problem of navigation for an unmanned underwater vehicle (UUV) through image mosaicking. It represents a first step towards a real-time vision-based navigation system for a small-class low-cost UUV. We propose a navigation system composed by: (i) an image mosaicking module which provides velocity estimates; and (ii) an extended Kalman filter based on the hydrodynamic equation of motion, previously identified for this particular UUV. The obtained system is able to estimate the position and velocity of the robot. Moreover, it is able to deal with visual occlusions that usually appear when the sea bottom does not have enough visual features to solve the correspondence problem in a certain area of the trajectory

Behaviours implemented using a vision system based on coded light projection

In a search for new sensor systems and new methods for underwater vehicle positioning based on visual observation, this paper presents a computer vision system based on coded light projection. 3D information is taken from an underwater scene. This information is used to test obstacle avoidance behaviour. In addition, the main ideas for achieving stabilisation of the vehicle in front of an object are presented

Projeto e construção de um robô móvel AGV/ROV não-holonômico com habilidade para navegação autônoma do tipo wall-following

Esta dissertação de mestrado apresenta o projeto e a construção de um robô móvel terrestre denominado LOGBOT, com tração de movimento do tipo diferencial – com duas rodas motoras e uma roda livre para manter a estabilidade de sua estrutura em relação à superfície. O controle do robô dispõe dos modos de telemetria e autônomo. No modo de controle por telemetria (ROV), a comunicação do robô com a estação de controle é feita por radiofreqüência a uma distância de até um quilometro em ambientes externos, e até cem metros em ambientes internos. No modo de controle autônomo (AGV), o robô tem habilidade para navegar em ambientes internos e desconhecidos usando sempre a parede à sua esquerda como referência para a trajetória de seu movimento. A seqüência de movimentos para execução da trajetória é enviada para a estação de controle que realiza análises de desempenho do robô. Para executar suas tarefas no modo autônomo, a programação do robô conta com um agente inteligente reativo, que detecta características do ambiente (obstáculos, final de paredes, etc.) e decide sobre qual atitude deve ser executada pelo robô, com objetivo de contornar os obstáculos e controlar a velocidade de suas rodas. Os problemas de erro odométrico e suas correções com base no uso de informações sensoriais externas são devidamente tratados. Técnicas de controle hierárquico do robô como um todo e controle em malha fechada da velocidade das rodas do robô são usadas. Os resultados mostraram que o robô móvel LOGBOT é capaz de navegar, com estabilidade e precisão, em ambientes internos no formato de um corredor (wall following).

Equipo AVORA de Robótica Marina de la ULPGC: experiencia y Perspectivas

[ES] AVORA es un grupo de trabajo multidisciplinar integrado por 11 estudiantes (este año con un nuevo miembro, Michael Smith proveniente de la Universidad de Rhode Island, USA) y 3 supervisores. Se ha creado para diseñar y desarrollar un AUV (Autonomous Underwarter Vehicle) capaz de detectar objetos bajo el agua sin supervisión, así como navegar de manera autónoma con la ayuda de un sonar. Todo esto se está llevando a cabo para superar las misiones que se plantean en la competición europea SAUCE. Como novedad este año, el equipo tiene intenciones también de presentarse a la competición EUROATHLON

Prüftechnik für RFID bei Hochgeschwindigkeitsanwendungen im Transportwesen

Im Rahmen des Forschungsprojektes TagDrive wird die Applikation von passiven Transpondern auf 13,56 MHz-Basis untersucht, die auf der Fahrbahn befestigt und zur Spurführung und Navigation von Fahrzeugen verwendet werden. Um den Einsatz von Folientranspondern (Smart Labels) bei hohen Fahrzeuggeschwindigkeiten in Zusammenhang mit Transponderlesegeräten am Fahrzeug zu testen, wurde ein Hochgeschwindigkeitsprüfstand für Relativgeschwindigkeiten zwischen Transponder und Lesegerät von bis zu 100 km/h entwickelt und Versuche bei variierenden Leseabständen durchgeführt. Für mechanische Prüfungen der applizierten Transponder inklusive Gehäuse wurden Druckprüfungen mit Hilfe einer servohydraulischen Prüfeinrichtung durchgeführt und ein neuer pneumatischer Prüfstand entwickelt, der den Überrollvorgang durch ein Rad nachbildet. Für klimatische Tests unter anderem nach DIN EN 60068-2-67 bzw. IEC 68-2-67 wurde ein Klimaschrank verwendet.

The Nurturing of Seagliders By the National Oceanographic Partnership Program

The National Oceanographic Partnership Program provided critical support to the development of Seaglider long-range autonomous underwater vehicles. This support enabled: (1) development and integration of chemical and biological sensors, (2) transition to low-power, bi-directional satellite communication, and (3) software upgrades to enhance capability and reliability. Sponsored improvements led to setting the mission endurance and range records for autonomous underwater vehicles, wide use by the oceanographic community and licensing for commercialization.

Under ice shelf photographs from Drescher Inlet (Riiser Larsen Ice Shelf) taken by seal mounted cameras during expedition DRE2003

While modern sampling techniques, such as autonomous underwater vehicles, are increasing our knowledge of the fauna beneath Antarctic sea ice of only a few meters in depth, greater sampling difficulties mean that little is known about the marine life underneath Antarctic ice shelves over 100 m thick. In this study, we present underwater images showing the underside of an Antarctic ice shelf covered by aggregated invertebrate communities, most likely cnidarians and isopods. These images, taken at an average depth of 145 m, were obtained with a digital still camera system attached to Weddell seals Leptonychotes weddellii foraging just beneath the ice shelf. Our observations indicate that, similar to the sea floor, ice shelves serve as an important habitat for a remarkable amount of marine invertebrate fauna in Antarctica.

Physical oceanography from eight Seaglider missions in the Mediterranean Sea, Eastern Basin

In 2008, the Oceanography Center at the University of Cyprus acquired two underwater gliders in the framework of a nationally-managed infrastructure upgrade program. The gliders were purchased from the Seaglider Fabrication Center at the University of Washington. Both gliders are rated to 1000 m and carry a typical sensor payload: non-pumped conductivity-temperature-depth sensors (CTD), a dissolved oxygen sensor, an optical triplet to measure optical backscatter at 400 nm, 700 nm, and chlorophyll-a fluorescence. Since March of 2009, the gliders have been used in a long-term observing program of the Cypriot EEZ, and by September 2015, have covered more than 15300 km over ground and 3500 dive cycles in 940 glider days. Butterfly patterns have been flown in two configurations, either on the western or eastern side of the EEZ south of Cyprus. The glider endurance lines criss-cross the region in order to more accurately locate and investigate the mesoscale structures south of Cyprus, and in particular the Cyprus eddy which is often the dominant feature. Based on the near real time observations, the glider mission was sometimes altered in order to more fully sample the Cyprus eddy, or to locate its center or extent. A summary of the raw and processed data collected, and the quality control procedures are presented, in order for future users to take advantage of this unique data set.

A Visual AGV-Urban Car using Fuzzy Control

The goal of the work described in this paper is to develop a visual line guided system for being used on-board an Autonomous Guided Vehicle (AGV) commercial car, controlling the steering and using just the visual information of a line painted below the car. In order to implement the control of the vehicle, a Fuzzy Logic controller has been implemented, that has to be robust against curvature changes and velocity changes. The only input information for the controller is the visual distance from the image center captured by a camera pointing downwards to the guiding line on the road, at a commercial frequency of 30Hz. The good performance of the controller has successfully been demonstrated in a real environment at urban velocities. The presented results demonstrate the capability of the Fuzzy controller to follow a circuit in urban environments without previous information about the path or any other information from additional sensors

Characterization of Atlantic Cod Spawning Habitat and Behavior in Icelandic Coastal Waters

The physical habitat used during spawning may potentially be an important factor affecting reproductive output of broadcast spawning marine fishes, particularly for species with complex, substrate-oriented mating systems and behaviors, such as Atlantic cod Gadus morhua. We characterized the habitat use and behavior of spawning Atlantic cod at two locations off the coast of southwestern Iceland during a 2-d research cruise (15–16 April 2009). We simultaneously operated two different active hydroacoustic gear types, a split beam echosounder and a dual frequency imaging sonar (DIDSON), as well as a remotely operated underwater vehicle (ROV). A total of five fish species were identified through ROV surveys: including cusk Brosme brosme, Atlantic cod, haddock Melanogrammus aeglefinus, lemon sole Microstomus kitt, and Atlantic redfish Sebastes spp. Of the three habitats identified in the acoustic surveys, the transitional habitat between boulder/lava field and sand habitats was characterized by greater fish density and acoustic target strength compared to that of sand or boulder/lava field habitats independently. Atlantic cod were observed behaving in a manner consistent with published descriptions of spawning. Individuals were observed ascending 1–5 m into the water column from the bottom at an average vertical swimming speed of 0.20–0.25 m s−1 and maintained an average spacing of 1.0–1.4 m between individuals. Our results suggest that cod do not choose spawning locations indiscriminately despite the fact that it is a broadcast spawning fish with planktonic eggs that are released well above the seafloor.

Cooperative Mapping and Exploration using Counter-rotational Potential Fields

This paper presents a novel technique for mapping and exploration using cooperating autonomous underwater vehicles. Rather than using the typical lawnmower sweep pattern to search an entire area, the proposed navigational plan involves guiding the formation directly towards each object of interest in turn, before arriving at a final goal position. This is achieved by the use of traditional artificial potential fields alongside counter-rotational potential fields. These clockwise and counter-clockwise fields are employed simultaneously by vehicles to ensure that the entire object is scanned rather than simply avoided as is the case with traditional collision avoidance techniques. The proposed methodology allows a formation to have fluid-like motion whilst a separation distance between cooperating agents (free of angular constraints) is maintained with a greater degree of flexibility than traditional formation control approaches. Owing to its nature, this technique is suited for applications such as exploration, mapping and underwater inspection to name a few. Simulation results demonstrate the efficacy of the proposed approach.

A visual system for distributed mosaics using an auvs fleet

The use of teams of Autonomous Underwater Vehicles for visual inspection tasks is a promising robotic field. The images captured by different robots can be also to aid in the localization/navigation of the fleet. In a previous work, a distributed localization system was presented based on the use of Augmented States Kalman Filter through the visual maps obtained by the fleet. In this context, this paper details a system for on-line construction of visual maps and its use to aid the localization and navigation of the robots. Different aspects related to the capture, treatment and construction of mosaics by fleets of robots are presented. The developed system can be executed on-line on different robotic platforms. The paper is concluded with a series of tests and analyses aiming at to system validation.