The study of ultra-low energy deposition of hydrogenated amorphous carbon thin films

This thesis is dedicated to the production and analysis of thin hydrogenated amorphous carbon films. A cascaded arc plasma source was used to produce a high density plasma of hydrocarbon radicals that deposited on a substrate at ultra low energies. The work was intended to create a better understanding of the mechanisms responsible for the film formation, by an extensive analysis on the properties of the films in correlation with the conditions used in the plasma cell. Two different precursors were used: methane and acetylene. They revealed a very different picture for the mechanism of film formation and properties. Methane was less successful, and the films formed were soft, with poor adhesion to the substrate and decomposing with time. Acetylene was the better option, and the films formed in this case were harder, with better adhesion to the substrate and stable over time. The plasma parameters could be varied to change the character of films, from polymer-like to diamond-like carbon. Films deposited from methane were grown at low deposition rates, which increased with the increase in process pressure and source power and decreased with the increase in substrate temperature and in hydrogen fraction in the carrier gas. The films had similar hydrogen content, sp3 fractions, average roughness (Ra) and low hardness. Above a deposition temperature of 350°C graphitization occurred - an increase in the sp2 fraction. A deposition mechanism was proposed, based upon the reaction product of the dissociative recombination of CH4+. There were small differences between the chemistries in the plasma at low and high precursor flow rates and low and high substrate temperatures; all experimental conditions led to formation of films that were either polymer-like, soft amorphous hydrogenated carbon or graphitic-like in structure. Films deposited from acetylene were grown at much higher deposition rates on different substrates (silicon, glass and plastics). The film quality increased noticeably with the increase of relative acetylene to argon flow rate, up to a certain value, where saturation occurred. With the increase in substrate temperature and the lowering of the acetylene injection ring position further improvements in film quality were achieved. The deposition process was scaled up to large area (5 x 5 cm) substrates in the later stages of the project. A deposition mechanism was proposed, based upon the reaction products of the dissociative recombination of C2H2 +. There were large differences between the chemistry in the plasma at low and medium/high precursor flow rates. This corresponded to large differences in film properties from low to medium flow rates, when films changed their character from polymer-like to diamond-like, whereas the differences between films deposited at medium and high precursor flow rates were small. Modelling of the film growth on silicon substrates was initiated and it explained the formation of sp2 and sp3 bonds at these very low energies. However, further improvements to the model are needed.

Properties of ultra fast deposited diamond-like hydrogenated carbon films

Hydrogenated amorphous carbon films with diamond like structures have been formed on different substrates at very low energies and temperatures by a plasma enhanced chemical vapor deposition process employing acetylene as the precursor gas. The plasma source was of a cascaded arc type with Ar as carrier gas. The films were grown at very high deposition rates. Deposition on Si, glass and plastic substrates has been studied and the films characterized in terms of sp3 content, roughness, hardness, adhesion and optical properties. Deposition rates up to 20 nm/s have been achieved at substrate temperatures below 100°C. The typical sp3 content of 60-75% in the films was determined by X-ray generated Auger electron spectroscopy. Hardness, reduced modulus and adhesion were measured using a MicroMaterials Nano Test Indenter/Scratch tester. Hardness was found to vary from 4 to 13 GPa depending on deposition conditions. Adhesion was significantly influenced by the substrate temperature and in situ DC cleaning. Hydrogen content in the film was measured by a combination of the Fourier transform infrared and Rutherford backscattering techniques. Advantages of these films are: low ion energy and deposition temperature, very high deposition rates, low capital cost of the equipment and the possibility of film properties being tailored according to the desired application.

Light-activated phytotoxic thiophenes in Flaveria linearis L.

Chromatographic analyses of crude leaf extracts of Flaveria linearis L. revealed the presence of four acetylenic monothiophenes. Three of these metabolites were purified and structurally characterized by UV, NMR, IR, and GC-MS. Germination, growth, and survival/mortality studies with and without UVA, the activating wavelengths of these metabolites, were conducted with the crude leaf extracts and the purified compounds (taken individually and combined) against selected crop species (lettuce, radish, and carrot). Results suggest that acetylenic metabolites are phytotoxic against lettuce, carrot, and radish, but with variability in response among species. These variations in sensitivity and the allelopathic potential of F. linearis is discussed.

Seawater carbonate chemistry and particulate organic particles during a semicontinuous batch culture experiment with Trichodesmium IMS101, 2007

Diazotrophic (N2-fixing) cyanobacteria provide the biological source of new nitrogen for large parts of the ocean. However, little is known about their sensitivity to global change. Here we show that the single most important nitrogen fixer in today's ocean, Trichodesmium, is strongly affected by changes in CO2 concentrations. Cell division rate doubled with rising CO2 (glacial to projected year 2100 levels) prompting lower carbon, nitrogen and phosphorus cellular contents, and reduced cell dimensions. N2 fixation rates per unit of phosphorus utilization as well as C:P and N:P ratios more than doubled at high CO2, with no change in C:N ratios. This could enhance the productivity of N-limited oligotrophic oceans, drive some of these areas into P limitation, and increase biological carbon sequestration in the ocean. The observed CO2 sensitivity of Trichodesmium could thereby provide a strong negative feedback to atmospheric CO2 increase.

Seawater carbonate chemistry and combined physiological effects of CO2 and light on the N2-fixing cyanobacterium Trichodesmium IMS101 during experiments, 2010

Recent studies on the diazotrophic cyanobacterium Trichodesmium erythraeum(IMS101) showed that increasing CO2 partial pressure (pCO2) enhances N2 fixation and growth. Significant uncertainties remain as to the degree of the sensitivity to pCO2, its modification by other environmental factors, and underlying processes causing these responses. To address these questions, we examined the responses ofTrichodesmium IMS101 grown under a matrix of low and high levels of pCO2 (150 and 900 µatm) and irradiance (50 and 200 µmol photons m-2 s-1). Growth rates as well as cellular carbon and nitrogen contents increased with increasing pCO2 and light levels in the cultures. The pCO2-dependent stimulation in organic carbon and nitrogen production was highest under low light. High pCO2 stimulated rates of N2fixation and prolonged the duration, while high light affected maximum rates only. Gross photosynthesis increased with light but did not change with pCO2. HCO3- was identified as the predominant carbon source taken up in all treatments. Inorganic carbon uptake increased with light, but only gross CO2 uptake was enhanced under high pCO2. A comparison between carbon fluxes in vivo and those derived from 13C fractionation indicates high internal carbon cycling, especially in the low-pCO2treatment under high light. Light-dependent oxygen uptake was only detected underlow pCO2 combined with high light or when low-light-acclimated cells were exposed to high light, indicating that the Mehler reaction functions also as a photoprotective mechanism in Trichodesmium. Our data confirm the pronounced pCO2 effect on N2fixation and growth in Trichodesmium and further show a strong modulation of these effects by light intensity. We attribute these responses to changes in the allocation of photosynthetic energy between carbon acquisition and the assimilation of carbon and nitrogen under elevated pCO2. These findings are supported by a complementarystudy looking at photosynthetic fluorescence parameters of photosystem II, photosynthetic unit stoichiometry (photosystem I:photosystem II), and pool sizes of key proteins in carbon and nitrogen acquisition.

Evaluación del efecto de la inoculación de Bacillus spp. con potencial fijador de nitrógeno en cultivos de Chlorella sorokiniana

El uso de microalgas y PGPBs como principio activo de problemas ambientales ha generado interés científico en los últimos años -- Entre las soluciones propuestas se encuentra el uso de los cocultivos de estos 2 tipos de microrganismos para la formulación de bioinsumos y la biorremedación -- El objetivo de este estudio se centró en evaluar el efecto de la inoculación de Bacillus spp. con potencial fijador de nitrógeno ambiental en cultivos de Chlorella sorokiniana a nivel de matraz -- Se encontró que 10 cepas PGPB, del banco de cepas del grupo CIBIOP de la Universidad EAFIT, probablemente fijaron nitrógeno debido a que crecen en medio NFb -- De las cuales, Bacillus subtilis EA-CB0575 promueve el crecimiento de la microalga Chlorella sorokiniana UTEX 1230, aumentando en un 94% la densidad celular y en 4.5 veces el tamaño de la microalga comparada su crecimiento individual -- Finalmente se usó el método ARA para evaluar fijación de nitrógeno, y se encontró que la bacteria fue capaz de reducir el acetileno en etileno cuando se siembra en medio NFb y BBM libre de nitrógeno, además cuando se cocultivo con la microalga, lo que indicaría que posiblemente la fijación de nitrógeno sea el método de promoción de crecimiento microalgar

Ocorrência de bactérias diazotroficas e fungos micorrizicos arbusculares na cultura da mandioca.

Este trabalho teve como objetivo avaliar a ocorrencia, isolar e identificar fungos micorrízicos carbunculares associados a cultura da mandioca (Manihot esculenta). Amostras de solo rizosférico e de varias partes da planta (raízes, tubérculos, manivas e folhas) de locais nos Estados do Rio de Janeiro, São Paulo e Paraná, foram inoculadas nos meios LGI-P, NFb-malato e NFb-GOC, avaliando-se o numero mais provável de células e a atividade de redução de acetileno. Bactérias diazotróficas foram isoladas de todas as partes da planta, com exceção das folhas, sendo identificadas como Klebsiella sp., Azospirillum lipoferum e uma bactéria denominada "E", provavelmente pertencente ao gênero Burkholderia. A bactéria E acumulou de 7,63 mg a 14,84 mg de N/g de C em meio semi-solido, isento de N, e conseguiu manter a capacidade de fixação biológica de N, mesmo apos uma dezena de repicagens consecutivas. A colonização micorrízica variou de 31% a 69%, e a densidade de esporos de 10 a 384 esporos/100 mL de solo, predominando as espécies Entrophospora colombiana e Acaulospora scrobiculata no Rio de Janeiro, A. scrobiculata e Scutellospora heterogama no Paraná e em Piracicaba (São Paulo) e A. appendicula e S. pellucida em Campinas (São Paulo). This study was performed to evaluate the occurrence and to isolate and identify diazotrophic bacteria and arbuscular mycorrhizal fungi associated with the cassava (Manihot esculenta) crop. Samples from rhizosperical soil, roots, tubers, stems and leaves from several localities of the States of Rio de Janeiro, Sao Paulo and Parana, in Brazil, were inoculated in three media specific for diazotrophic associative bacteria, LG1-P, NFb-malate and NFb-GOC, evaluating the most probable number of cells and the acetylene-reducing activity. Diazotrophic bacteria were detected in all plant parts except for the leaves, and were identified as Klebsiella sp., Azospirillum lipoferum and a bacterium called "E", probably belonging to the Burkholderia genus. Bacterium E was able to accumulate, in the N-free semi-solid media, from 7.63 to 14.84 mg of N/g of C and to maintain N fixation capacity after ten consecutive transferences. Mycorrhizal root colonization varied from 31% to 69% and spore density from 10 to 384 spores/100 mL of soil, predominanting the species Entrophospora colombiana and Acaulospora scrobiculata in Rio de Janeiro, A. scrobiculata and Scutellospora heterogama in Parana and in Piracicaba (Sao Paulo), and A. appendicula and S. pellucida in Campinas (Sao Paulo).