长白山地区近50年气候变化及其预估

收集长白山地区15个气象站1953-2007年气温、降水、蒸发、日照时数和水汽压观测数据和国家气候中心整理的2001-2099年的 气温、降水预估资料，利用数理统计方法，系统分析长白山地区气候现状、变化及其预估，为气候变化对人类生存环境影响研究并制定适应对策提供依据。主要结论如下： 1.长白山地区气温、降水日数、日照时数和不同界限温度（≥0℃、≥5℃、≥10℃和<0℃）积温均有显著趋势。年极端最低、年平均、平均最高/最低气温和气温日/年较差在1984、1992、1995、1985、1972和1979年发生突变。所有最高/最低气温与日照百分率有显著负相关关系，一定程度是温室效应结果；最高、最低气温变化不同步造成气温日较差和年较差的非对称性。 2.长白山地区生长季节合计降水量和降水强度日际变化较大。降水以7月30日为界，呈现前升后降极显著的线性趋势，且发生均值突变。降水强度以6月27日和9月3日为分界点，分为三个阶段。降水集中度、集中期和集中时段时空非均一性分布明显。 3.在SRES A1B、SRES A2和SRES B1三种情景下年平均气温均为上升趋势，年内变化一致为冬季升温最迅速，夏季则相对缓慢；而年降水强度总体增加，年内变化比较一致：冬季增加最为明显，而夏季变化不大。 4.未来长白山地区各站≥0℃、≥5℃和≥10℃的积温均有不同程度增加，持续时间延长。负积温增加，持续时间缩短，开始日期推迟，而结束时间提前。

Promotion of cooperation in the form C0C1D classified by 'degree grads' in a scale-free network

In this paper, we revisit the issue of the public goods game (PGG) on a heterogeneous graph. By introducing a new effective topology parameter, 'degree grads' phi, we clearly classify the agents into three kinds, namely, C-0, C-1, and D. The mechanism for the heterogeneous topology promoting cooperation is discussed in detail from the perspective of C0C1D, which reflects the fact that the unreasoning imitation behaviour of C-1 agents, who are 'cheated' by the well-paid C-0 agents inhabiting special positions, stabilizes the formation of the cooperation community. The analytical and simulation results for certain parameters are found to coincide well with each other. The C0C1D case provides a picture of the actual behaviours in real society and thus is potentially of interest.

Preparation and characterization of cationic corn starch with a high degree of substitution in dioxane-THF-water media

Cationic corn starch derivatives with a high degree of substitution are prepared in alkaline solution or in mixed media of organic solvent and water with different levels of the cationic reagent, 2,3-epoxypropyltrimethylammonium chloride. The starch cationization yield is investigated, and the results indicate that the degree of substitution (DS) of the samples depends on the reaction conditions and reaction media. The maximum DS values are up to 1.37 in 1,4-dioxane alkali ne-aqueous solution. Meanwhile, the structures of the cationic starch derivatives are characterized by elemental analyses, FTIR spectroscopy, X-ray diffraction, and C-13 NMR spectroscopy, as well as by SEM techniques.

SYNTHESIS AND CHARACTERIZATION OF A CROSSLINKING POLYETHYLENIMINE AS SMART GENE CARRIER AND EFFECTS OF PEGYLATION DEGREE

A smart biodegradable cationic polymer (CBA-PEI) based on the disulfide bond-containing cross-linker cystamine bisacrylamide (CBA) and low molecular weight branched polyethylenimine (1800-Da, PEI1800) was successfully synthesized by Michael addition reaction in our recent study. Furthermore, a series of copolymers (CBA-PEI-PEG) with different PEGylation degree were obtained by the mPEG-SPA (5000-Da) reacting with CBA-PEI at various weight ratios directly. The molecular structures of the resulting polymers CBA-PEI and CBA-PEI-PEG were evaluated by nuclear magnetic resonance spectroscopy (H-1-NMR) and capillary viscosity measurements, all of which had successfully verified formation of the copolymers. The polymer/DNA complexes based on CBA-PEI and CBA-PEI-PEG were measured by dynamic light scattering and gel retardation assay. The results showed that the particle size and zeta potential of complexes were reduced with increasing amount of PEG grafting, even no particle formation. The particle size of CBA-PEI/DNA complexes was in range of 103.1 to 129.1 nm, and the zeta potential was in range of 14.2 to 24.3 mV above the 2:1 weight ratio. In the same measure condition, the particle size of CBA-PEI-PEG complexes was reduced to a range of 32.2 to 55 nm, and the zeta potential was in range of 9.3 to 13.8 mV at the 2:1 weight ratio.

Determination of degree of crystallinity of Nylon 1212 by wide-angle X-ray diffraction

Based on the X-ray scattering intensity theory and using the approximate expression for the atomic scattering factor, the correction factors for three crystalline peaks and an amorphous peak of Nylon 1212 were calculated and the formula of degree of crystallinity of Nylon 1212 was derived by a graphic multipeak resolution method. The degree of crystallinity calculated from the WARD method is compatible with those obtained by density and calorimetry methods.

Influence of the degree of grafting on the morphology and mechanical properties of blends of poly(butylene terephthalate) and glycidyl methacrylate grafted poly(ethylene-co-propylene) (EPR)

Poly(ethylene-co-propylene) (EPR) was functionalized to varying degrees with glycidyl methacrylate (GMA) by melt grafting processes. The EPR-graft-GMA elastomers were used to toughen poly(butylene terephthalate) (PBT). Results showed that the grafting degree strongly influenced the morphology and mechanical properties of PBT/EPR-graft-GMA blends. Compatibilization reactions between the carboxyl and/or hydroxyl of PBT and epoxy groups of EPR-graft-GMA induced smaller dispersed phase sizes and uniform dispersed phase distributions. However, higher degrees of grafting (>1.3) and dispersed phase contents (>10 wt%) led to higher viscosities and severe crosslinking reactions in PBT/EPR-graft-GMA blends, resulting in larger dispersed domains of PBT blends. Consistent with the change in morphology, the impact strength of the PBT blends increased with the increase in EPR-graft-GMA degrees of grafting for the same dispersion phase content when the degree of grafting was below 1.8. However, PBT/EPR-graft-GMA1.8 displayed much lower impact strength in the ductile region than a comparable PBT/EPR-graft-GMA1.3 blend (1.3 indicates degree of grafting).

Effect of heat treatment on the parameters of crystal structure and degree of crystallinity of poly(aryl-ether-ether-ketone)

The variations of unit cell parameters and crystallite size of nine PEEK samples treated at various temperatures have been studied by using Wide-Angle X-ray Diffraction (WAXD), The results indicate a decrease in unit cell parameter a,b and c but an increase in crystallite size L(hkl) With the increase beat treatment temperature. Based on X-ray scattering intensity theory and using the graphic multipeak resolution method, the formula of degree of crystallinity (W-c,W-X) for PEEK is derived. The results calculated are compatible with the density measurement and calorimetry.