Thermoluminescence studies of LiBa2B5O10 : RE3+ (RE = Dy, Tb and Tm)

LiBa2B5O10:RE3+ (RE = Dy, Tb and Tm) was synthesized by the method of high-temperature solid-state reaction and the thermoluminescence (TL) properties of the samples under the irradiation of the gamma-ray were studied. The result showed that Dy3+ ion was the most efficient activator. When the concentration of Dy3+ was 2 mol%, LiBa2B5O10:Dy3+ exhibited a maximum TL output. The kinetic parameter of LiBa2B5O10:0.02Dy was estimated by the peak shape method, for which the average activation energy was 0.757 eV and the frequency factor was 1.50 x 10(7) s(-1). By the three-dimensional (3D) TL spectrum, the TL of the sample was contributed to the characteristic f-f transition of DY3+. The dose-response of LiBa2B5O10:0.02Dy to gamma-ray was linear in the range from 1 to 1000 mGy. In addition, the decay of the TL intensity of LiBa2B5O10:0.02Dy was also investigated.

Surface phase separations of PMMA/SAN blends investigated by atomic force microscopy

The thin films of poly(methyl methacrylate) (PMMA), poly(styrene-co-acrylonitrile) (SAN) and their blends were prepared by means of spin-coating their corresponding solutions onto silicon wafers, followed by being annealed at different temperatures. The surface phase separations of PMMA/SAN blends were characterized by virtue of atomic force microscopy (AFM). By comparing the tapping mode AFM (TM-AFM) phase images of the pure components and their blends, surface phase separation mechanisms of the blends could be identified as the nucleation and growth mechanism or the spinodal decomposition mechanism. Therefore, the phase diagram of the PMMA/SAN system could be obtained by means of TM-AFM. Contact mode AFM was also used to study the surface morphologies of all the samples and the phase separations of the blends occurred by the spinodal decomposition mechanism could be ascertained. Moreover, X-ray photoelectron spectroscopy was used to characterize the chemical compositions on the surfaces of the samples and the miscibility principle of the PMMA/SAN system was discussed.

Preparation of borates doped with divalent rare earth ions (RE2+) in air and spectroscopy of divalent rare earth ions (RE2+ = Sm, Eu, Tm, Yb)

The spectroscopic feature of divalent Sm2+, Eu2+, Tm2+ and Yb2+ is discussed in this paper. Especially the spectroscopic properties of some berates containing tetrahedral BO4 group such as SrB4O7, SrB6O10 and BaB8O13 doped with these divalent ions are reported. When the divalent alkaline earth ion in these berates is replaced partially by the above trivalent rare earth ion, the charge carried in the produced defects can be used as reductant to reduce the doped rare earth ion into divalent state at high temperature even in air. Therefore, a convenient and safe method is provided to prepared phosphors doped with these divalent rare earths.

在空气下制备掺二价稀土的硼酸盐及二价稀土离子(RE~(2+)=Sm,Eu,Tm,Yb)的光谱特征

本文讨论了Sm2 + 、Eu2 + 、Tm2 + 、Yb2 + 等二价稀土离子的光谱特征 ,特别是在一些含四面体硼酸根的硼酸盐如SrB4 O7、SrB6 O10 和BaB8O13中它们的光谱性质。当以三价稀土离子取代化合物中的二价碱土离子时 ,利用不等价取代而产生的缺陷所带的电荷 ,可在高温的空气下使上述的稀土离子还原成二价 ,不需加入化学还原剂 ,从而提出了一个简便、安全的制备含二价稀土离子发光材料的方法

Tb~(3+)在YAG中的发光及Tb~(3+)与Tm~(3 +)间的能量传递

采用溶胶 -凝胶方法合成了系列化合物 (Y1 -x- yTbxTmy) 3Al5O1 2 ,研究了Tb3+在该化合物中的发光及其浓度对发光性质的影响 ,以及Tb3+与Tm3+间的能量传递现象。

Calculation of chemical bond parameters in RBa2Cu4O8(R = Dy,Ho,Er,Tm,Yb) and Y2Ba4Cu7O14.3

Chemical bond parameters in RBa2Cu4O8(R = Dy, Ho, Er, Tm, Yb) and Y2Ba4Cu7O14.3 were calculated by using complex chemical bond theory. The results indicated that the bond covalency in CuO chain was larger than that in CuO2 plane. For metal atoms, the bond covalency of five coordinated case was larger than that of six coordinated case.

RBa_2Cu_4O_8(R=Dy,Ho,Er,Tm,Yb)和Y_2Ba_4Cu_7O_(14.3)的化学键参数计算

使用复杂晶体上化学键理论计算了 RBa2 Cu4 O8(R=Dy,Ho,Er,Tm ,Yb)和 Y2 Ba4 Cu7O14 .3 的化学键参数 .结果表明 ,Cu O链上的 Cu O键共价性大于它们在 Cu O2 面的共价性 .当金属元素与氧形成五配位时 ,其共价性的数值大于这些元素在六配位时的情形

The reduction of RE3+ in SrB6O10 prepared in air and the luminescence of SrB6O10 : RE2+ (RE=Eu, Sm, Tm)

The reduction of RE3+ to RE2+ (RE=Eu, Sm and Tm) in SrB6O10 prepared in air by high-temperature solid state reaction was observed. The luminescent properties of Eu2+ and Tm2+ show f-d transition and Sm2+ shows f-f transition at room temperature. Three crystallographic sites for Sm2+ in matrix are available. Vibronic transition of D-5(0)-F-7(0) of Sm2+ was studied. The coupled phonon energy about 108 cm(-1), was determined: from the vibronic transition. Due to the thermal population from D-5(0) level, (D1-FJ)-D-5-F-7 (J=0, 1, 2) transitions of Sm2+ were observed at room temperature. A charge compensation mechanism is proposed as a possible explanation.

Bond covalencies in R2BaCuO5 (R = Sm, Gd, Dy, Ho, Y, Er, Tm, Yb, Lu)

Bond covalencies in R2BaCuO5 (R = Sm, Gd, Dy, Ho, Y, Er, Tm, Yb, Lu) were calculated by means of a semiempirical method. This method is the generalization of the dielectric description theory of Phillips-Van Vechten-Levine-Tanaka scheme. The present paper presents the formula concerning the decomposing of complex crystals which are usually anisotropic systems into the sum of binary crystals which are isotropic systems. It can be seen that although the bond covalency is related to many physical quantities, it is mainly influenced by bond valence or bond charge, and a higher bond valence will produce higher bond covalency.

The bond ionicity in RBa2Cu3O7 (R=Pr, Sm, Eu, Gd, Dy, Y, Ho, Er, Tm)

RBa2Cu3O7 (R = Pr, Sm, Eu, Gd, Dy, Y, Ho, Er, Tm) has been studied using complex chemical bond theory. The results indicated that with the decreasing of R radius, the ionicities for all considered types of bond decrease. This is in good agreement with the experimental fact that T-c decreases with the decreasing of R radius. PrBa2Cu3O7 with no Ba-site Pr in this calculation is also predicted to be a superconductor. This supports the conclusion obtained by Blackstead et al. The ionicity for each bond obeys the following order: Ba-O > R-O > Cu(2)-O(1) > Cu(2)-O(2,3) > Cu(1)-O(4) similar to Cu(1)-O(1).

LiMgAlF_6 : Tm~(3+) 的合成与光谱特性

采用高温固相反应法，ＬｉＦ／ＭｇＦ２／ＡｌＦ３＝１２０／１１０／１００，烧结温度为１００８Ｋ，烧结时间为４ｈ，在流动的高纯Ａｒ中合成了ＬｉＭｇＡｌＦ６：Ｔｍ３＋。对其结构和发光特性进行了研究。

YP_5O_(14):Er~(3+),Tm~(3+)晶体的合成

研究了水热法合成晶体,浓度配比、生长温度对晶体生长习性的影响.合成了一系列化学计量比的Y_(1-x-0.3)Er_(0.3)Tm_xP_5O_(14)(x=0.01～0.1)晶体,观察和分析了晶体的缺陷及成因,测定和讨论了晶体结构.

Analysis of urinary 8-hydroxydeoxyguanosine by capillary electrophoresis and solid-phase extraction

Urinary 8-hydroxydeoxyguanosine (80HdG) has been considered as an excellent marker of individuals at high risk of developing cancer. Until now, urinary 80HdG has largely been measured by high-performance liquid chromatography with electrochemical detection. A new method for the analysis of urinary 80HdG by high-performance capillary electrophoresis has been developed and optimized in our laboratory. A single step solid-phase extraction procedure was optimized and used for extracting 80HdG from human urine. Separations were performed in an uncoated silica capillary (50 cm x 50 tm i.d.) using a P/ACE MDQ system with UV detection. The separation of 80HdG from interfering urinary matrix components is optimized with regard to pH, applied voltage, pressure injection time and concentration of SDS in running buffer. The detection limit of this method is 0.4 mug/ml, the linear range is 0.8-500 mug/ml, the correlation coefficients levels is better than 0.999. The developed method is simple, fast and good reproducibility, furthermore, it requires a very small injection volumes and low costs of analysis, which makes it possible to provide a new noninvasive assay for an indirect measurement of oxidative DNA damage.