Simulação da Química da Atmosfera Poluída por Automóveis Movidos a Álcool

Numerical modeling studies of urban atmospheres were performed with a photochemical box submodel which incorporates primary emission rates, temperature and solar irradiance rate coefficients. Actinic flux calculations were made for an appropriate latitude for Rio de Janeiro and initial concentrations and emission rates were taken from experimental data. The relative importance of individual reactions is discussed as well as the effect of enhanced aldehyde emissions from vehicles using ethanol and ethanol-containing fuel.

Gotas suspensas: uma proposta para amostragem e análise de gases traços da atmosfera

In the present paper, we report on the analytical use of a dynamic droplet based gas collection and an analysis system. A droplet formed at the tip of a tube represents a sampling approach that provides an indefinitely renewable surface and uses very little reagent. Sample gas flows past the droplet at a low flow rate. After the gas was sampled , the analysis can be carried out by different methodologies. The feasibility of the sensor is demonstrated by continuos determination of gaseous as: NO2, Cl2 and SO2.

Sistema com atmosfera controlada para a caracterização de sensores a gases

This paper describes a sample holder for the electrical measurement of oxides or conducting polymers in the form of pellets or films which are used as gas sensors. The system makes it possible to control the sample temperature, the gas pressure and composition. The temperature in the sample can be changed from 25ºC to 450ºC, and the gas pressure in the chamber is controlled between 5 ¥ 10-4 and 1000 mbar. The performance of the system in resistance measurements of doped tin oxide pellets and polyaniline films deposited on platinum electrodes for methane is analyzed.

Determinação dos hidrocarbonetos saturados e policíclicos aromáticos presentes no material particulado da atmosfera amazônica

It was identified and quantified several organic compounds in the atmosphere of a site into Amazon Basin with high impact of biomass burning emission. It was important to know the particulate matter composition with respect to n-alkanes and PAH associated with the particulate matter because they provided indication on the main sources contributing to airborne particles, the contribution of natural vs. man-made emission and the aging of the particles. The main classes of compounds observed were n-alkanes, PAH and nitro-PAH. It was observed the formation of nitro-PAH from photochemical reactions. The aerosol mass concentration is mainly associated with fluoranthene, pyrene and benzo(ghi)perylene. Environmental and direct emissions samples (flaming and smoldering) were collected and analysed.

Fontes, reatividade e quantificação de metanol e etanol na atmosfera

In the last two decades, the use of oxygenated fuels, like methanol and ethanol, pure or in mixture with gasoline, has been growing due to benefits introduced into the air quality. In Brasil, the fraction of light duty vehicles powered by pure hydrated ethanol is estimated at about 4 million, while the remaining vehicles actually utilize a mixture (22:78 v/v) of ethanol:gasoline. As a consequence, there's a need for the availability of methods that can provide the evaluation of possible impacts of alcohol emissions in the formation of chemical species in the atmosphere, as ozone, aldehydes, carboxylic acids and so on. In this paper, methanol and ethanol are discussed in their general aspects, as well as their atmospheric sources, chemical reactivity and available methods of analysis.

Adsorção do complexo H[Ru(III)Cl2(H2EDTA)] sobre a superfície da sílica gel modificada com [3-(2-aminoetil) aminopropil]trimetoxissilano em soluções etanólicas

Silica gel was functionalized with [3-(2-aminoethyl)aminopropyl]trimethoxysilane group (SF-AEATS) and the characterization by chemical analysis (N) and infrared spectroscopy confirmed the functionalization. The capacity of the modified silica to adsorb the complex Ru(III)-EDTA from ethanolic solution was studied. The selectivity coefficients of the complex formed on the support obtained was (Gñ), 2,07 x 10(4) L/mol and the average number of ligand bonded by one metal ion on the support (ñ) was ~ 1.

Otimização de um mecanismo fotoquímico para a simulação da atmosfera urbana brasileira

A photochemical reaction mechanism for the description of air quality in Brazilian urban regions is described and evaluated by comparison with chamber experiments. The mechanism was developed for use in ozone modeling and application of control strategies. The oxidation of ethanol and methyl-ter-butyl-ether is also considered. Using this chemical model, a trajectory simulation of Brazil Avenue, Rio de Janeiro, was performed. The model predicts that ozone should reach a maximum of 22.4 ppb at 14:57 h. This value is in good agreement with the experimental measurements of 22.5 ppb for 14:00 h and 22.3 ppb for 15:00 h.

Estudo eletroquímico do azul de metileno adsorvido sobre sílica gel quimicamente modificada com óxido de nióbio

Methylene blue (AM) was immobilised on surface of the silica gel modified with niobium oxide. This material was incorporated in a carbon paste electrode, which showed a redox couple in a potential of E= -113 mV vs SCE in KCl solution at pH 7.0. The formal potential, in 0.5 mol L-1 KCl at pH 7.0, shifted about 290 mV towards more positive values compared to those observed for AM solubilized in aqueous solution. The dependence on the formal potential with solution pH between 2 and 7 was much lower than those observed for AM solubilized in aqueous solution.

Origem e implicações dos ácidos carboxílicos na atmosfera

A general overview about the ambient levels of low molecular weight carboxylic acids and their possible emission sources, as well as the implication of them in the atmosphere is presented. Carboxylic acids are considered to be one of the dominant classes of organic compounds found in the atmosphere in a variety of phases, such as in rainwater, snow and ice, on aerosol particles and gas phase. They may be originated from biogenic and anthropogenic direct emissions and by photochemical reaction in situ. Emission sources and formation mechanisms of organic acids in the atmosphere are discussed.

Síntese de nanotubos de carbono de parede simples por sublimação de grafite em atmosfera de hélio

Macroscopic samples of fullerene nanostructures are obtained in a modified arc furnace using the electric arc method with a Helium atmosphere at low pressures. High purity graphite rods are used as electrodes but, when drilled and the orifices filled with powders of transition metals (Fe, Co, Ni) acting as catalysts, the resulting particles are carbon nanostructures of the fullerene family, known as Single Wall Nanotubes (SWNTs). They have typical diameters of 1.4 nm, lengths up to tenths of microns and they are arranged together in bundles containing several SWNTs. Those samples are observed and analyzed using Scanning Electron Microscopy (SEM) and Transmission Electron Microscopy (TEM) techniques.

Quantificação de fluxos de mercúrio gasoso na interface solo/atmosfera utilizando câmara de fluxo dinâmica: aplicação na bacia do Rio Negro

Gaseous mercury sampling conditions were optimized and a dynamic flux chamber was used to measure the air/surface exchange of mercury in some areas of the Negro river basin with different vegetal coverings. At the two forest sites (flooding and non-flooding), low mercury fluxes were observed: maximum of 3 pmol m-2 h-1 - day and minimum of -1 pmol m-2 h-1 - night. At the deforested site, the mercury fluxes were higher and always positive: maximum of 26 pmol m-2 h-1 - day and 17 pmol m-2 h-1 - night. Our results showed that deforestation could be responsible for significantly increasing soil Hg emissions, mainly because of the high soil temperatures reached at deforested sites.

Determinação de hidrocarbonetos voláteis e semi-voláteis na atmosfera

This paper focuses: (i) the development of a measurement technique for the determination of atmospheric C2-C6 hydrocarbons with sampling in canisters and analysis by gas chromatography/flame ionisation detector (GC/FID), (ii) the improvement of an existent adsorption-sampling technique with Tenax TA tubes for the determination of C6-C11 hydrocarbons and analysis by GC/FID after thermal desorption and cryogenic concentration, (iii) the identification of compounds present in ambient air by gas chromatography/mass spectrometry (GC/MS) for both canister and Tenax samples, (iv) a program of interlaboratorial comparison for quality control of C2-C11 analyses, and (v) the seasonal characterisation of ambient air C2-C11 hydrocarbons.

O emprego de quitosana quimicamente modificada com anidrido succínico na adsorção de azul de metileno

The adsorption capacity of alpha-chitosan and its modified form with succinic anhydride was compared with the traditional adsorbent active carbon by using the dye methylene blue, employed in the textile industry. The isotherms for both biopolymers were classified as SSA systems in the Giles model, more specifically in L class and subgroup 3. The dye concentration in the supernatant in the adsorption assay was determined through electronic spectroscopy. By calorimetric titration thermodynamic data of the interaction between methyene blue and the chemically modified chitosan at the solid/liquid interface were obtained. The enthalpy of the dye/chitosan interaction gave 2.47 ± 0.02 kJ mol-1 with an equilibrium constant of 7350 ± 10 and for the carbon/dye interaction this constant gave 5951 ± 8. The spontaneity of these adsorptions are reflected by the free Gibbs energies of -22.1 ± 0.4 and -21.5 ± 0.2 kJ mol-1, respectively, found for these systems. This new adsorbent derived from a natural polysaccharide is as efficient as activated carbon. However 97% of the bonded dye can be eluted by sodium chloride solution, while this same operation elutes only 42% from carbon. Chitosan is efficient in dye removal with the additional advantage of being cheap, non-toxic, biocompatible and biodegradable.

Determinação das propriedades catalíticas em meio aquoso e orgânico da lipase de Candida rugosa imobilizada em celulignina quimicamente modificada por carbonildiimidazol

Microbial lipase from Candida rugosa was immobilized by covalent binding on wood cellulignin (Eucaliptus grandis) chemically modified with carbonyldiimidazole. The immobilized system was fully evaluated in aqueous (olive oil hydrolysis) and organic (ester synthesis) media. A comparative study between free and immobilized lipase was carried out in terms of pH, temperature and thermal stability. A higher pH value (8.0) was found optimal for the immobilized lipase. The optimal reaction temperature shifted from 37 °C for the free lipase to 45 °C for the immobilized lipase. The pattern of heat stability indicated that the immobilization process tends to stabilize the enzyme. Kinetics tests at 37 °C following the hydrolysis of olive oil obeyed the Michaelis-Menten rate equation. Values for Km = 924.9 mM and Vmax = 198.3 U/mg were lower than for free lipase, suggesting that the affinity towards the substrate changed and the activity of the immobilized lipase decreased during the course of immobilization. The immobilized derivative was also tested in the ester synthesis from several alcohols and carboxylic acids.

Estudo termogravimétrico do efeito da temperatura e da atmosfera na absorção de dióxido de enxofre por calcário

Thermogravimetry was applied to investigate the effects of temperature and atmosphere on conversion of sulfur dioxide (SO2) absorbed by limestone. Ranges of temperature and particle size were studied, typical of fluidized-bed coal combustion. Isothermal experiments were performed at different temperatures (between 750 and 950 ºC) under local atmospheric pressure (~ 697 mmHg) in dynamic atmospheres of air and nitrogen. The maximum conversion was 29% higher in nitrogen atmosphere than in air atmosphere. The optimum conversion temperature was found at 831 ºC in air atmosphere and at 894 ºC in nitrogen atmosphere.