Molecular dynamics simulation of fracture strength and morphology of defective graphene

Different types of defects can be introduced into graphene during material synthesis, and significantly influence the properties of graphene. In this work, we investigated the effects of structural defects, edge functionalisation and reconstruction on the fracture strength and morphology of graphene by molecular dynamics simulations. The minimum energy path analysis was conducted to investigate the formation of Stone-Wales defects. We also employed out-of-plane perturbation and energy minimization principle to study the possi-ble morphology of graphene nanoribbons with edge-termination. Our numerical results show that the fracture strength of graphene is dependent on defects and environmental temperature. However, pre-existing defects may be healed, resulting in strength recovery. Edge functionalization can induce compressive stress and ripples in the edge areas of gra-phene nanoribbons. On the other hand, edge reconstruction contributed to the tensile stress and curved shape in the graphene nanoribbons.

The population dynamics of the Galapagos Flightless Cormorant Phalacrocorax harrisi in relation to sea temperature

The Flightless Cormorant Phalacrocorax harrisi is restricted to c. 400 km of the western coastline of the Galápagos archipelago coinciding with the local occurrence of seasonal upwelling of oceanic currents. Individuals frequently make more than one breeding attempt per year, usually change mates, and when juveniles are raised, females desert them to the further care of their mates who complete the rearing alone. Here we report data from a ten-year historical study of a colony stretching c.2 km along the coast-line and representing c. 12% of the total population of the species. The number of clutches laid and juveniles fledged were linked to the occurrence of cold water in off-shore foraging grounds. Most Flightless Cormorants have attachments to local stretches of coastline several hundred metres long. However, a few birds travelled many kilometres, including between colonies, sometimes over open sea. We show that males invest more in nest-building and feeding of the offspring than their mates, and we relate this to the (presumed) in-bred nature of the colony and to male and female reproductive strategies. Our data validate a published demographic model of the species (Valle 1995).

Insights into the nature of the coupling interactions between uracil corrosion inhibitors and copper : a DFT and molecular dynamics study

In this study, the nature of the coupling interactions between copper and uracil as well as its several derivatives has been systematically investigated employing the atoms in molecules (AIM) theory and energy decomposition analyses. The whole interaction process has been investigated through the analyses of the radial distribution functions of the Cu⋯X (X = S and O) contact on the basis of the ab initio molecular dynamics. No direct relationship between the adsorption strengths and inhibition efficiencies of the inhibitors has been observed. Additionally, the possibility of the methyl-substituted dithiouracil species to act as copper corrosion inhibitors has been tested.

Hepatitis C in the workplace : a survey of women’s occupational health and safety in the beauty therapy industry

Objective: To examine current knowledge and practice of occupational health and safety (OH&S) regarding hepatitis C in beauty therapy practice. Methods: A questionnaire was sent to all beauty therapy practices identified through the Telstra Yellow Pages and distributed via beauty therapy product agencies. Results: 119 questionnaires were completed by employers and employees in 99 beauty therapy practices in metropolitan Adelaide. Beauty therapists reported carrying out many practices that had exposed them to blood in the past. More than 80% of the procedures carried out by beauty therapists in the previous week were reported to have led to exposure to blood. 39.5% of respondents had not received information about OH&S practices related to blood spills and 77.5% of respondents had received no OH&S information about hepatitis C. Knowledge of hepatitis C and its transmission was poor, with 62% of respondents incorrectly identifying the prevalence of hepatitis C and respondents incorrectly identifying sneezing (28%), kissing (46%) and sharing coffee cups (42%) as a modes of transmission. 80% of beauty therapy practices had no OH&S representative. Conclusion: Beauty therapy practice can expose both operator and client to blood and is therefore a potential site for the transmission of blood-borne diseases including hepatitis C. OH&S information is inadequate in this industry and knowledge of hepatitis C is poor.

Population Dynamics of RNA viruses

Between 50 and 100 million people are infected with dengue viruses each year and more than 100,000 of these die. Dr Choudhury has demonstrated that populations of dengue viruses in individual patients are genetically and functionally very diverse and that this diversity changes significantly at the time of major outbreaks of disease. The results of his studies may inform strategies which will make dengue vaccines far more effective.

'Information in context' : co-designing workplace structures and systems for organizational learning

With the aim of advancing professional practice through better understanding how to create workplace contexts that cultivate individual and collective learning through situated 'information in context' experiences, this paper presents insights gained from three North American collaborative design (co-design) implementations. In the current project at the Auraria Library in Denver, Colorado, USA, participants use collaborative information practices to redesign face-to-face and technology-enabled communication, decision making, and planning systems. Design processes are described and results-to-date described, within an appreciative framework which values information sharing and enables knowledge creation through shared leadership.

Growth of C36-films on diamond surface through molecular dynamics simulation

In this paper, the initial stage of films assembled by energetic C36 fullerenes on diamond (001)–(2 × 1) surface at low-temperature was investigated by molecular dynamics simulation using the Brenner potential. The incident energy was first uniformly distributed within an energy interval 20–50 eV, which was known to be the optimum energy range for chemisorption of single C36 on diamond (001) surface. More than one hundred C36 cages were impacted one after the other onto the diamond surface by randomly selecting their orientation as well as the impact position relative to the surface. The growth of films was found to be in three-dimensional island mode, where the deposited C36 acted as building blocks. The study of film morphology shows that it retains the structure of a free C36 cage, which is consistent with Low Energy Cluster Beam Deposition (LECBD) experiments. The adlayer is composed of many C36-monomers as well as the covalently bonded C36 dimers and trimers which is quite different from that of C20 fullerene-assembled film, where a big polymerlike chain was observed due to the stronger interaction between C20 cages. In addition, the chemisorption probability of C36 fullerenes is decreased with increasing coverage because the interaction between these clusters is weaker than that between the cluster and the surface. When the incident energy is increased to 40–65 eV, the chemisorption probability is found to increased and more dimers and trimers as well as polymerlike-C36 were observed on the deposited films. Furthermore, C36 film also showed high thermal stability even when the temperature was raised to 1500 K.

Molecular dynamics simulation of structural characteristics in metal cluster deposition on surfaces

The deposition of small metal clusters (Cu, Au and Al) on f.c.c. metals (Cu, Au and Ni) has been studied by molecular dynamics simulation using Finnis–Sinclair (FS) potential. The impact energy varied from 0.01 to 10 eV/atom. First, the deposition of single cluster was simulated. We observed that, even at much lower energy, a small cluster with (Ih) icosahedral symmetry was reconstructed to match the substrate structure (f.c.c.) after deposition. Next, clusters were modeled to drop, one after the other, on the surface. The nanostructure was found by soft landing of Au clusters on Cu with increasing coverage, where interfacial energy dominates. While at relatively higher deposition energy (a few eV), the ordered f.c.c.-like structure was observed in the first adlayer of the film formed by Al clusters depositing on Ni substrate. This characteristic is mainly attributive to the ballistic collision. Our results indicate that the surface morphology synthesized by cluster deposition could be controlled by experimental parameters, which will be helpful for controlled design of nanostructure.

Molecular dynamics study of ‘contact epitaxy’ in Ag clusters supported on a copper (001) surface

In this paper, the formation of heteroepitaxial interfacial layers was investigated by molecular dynamics simulation of soft silver particles landing on the (001) surface of single-crystal copper. In our simulations, the clusters Ag13, Ag55, Ag147 and Ag688 were chosen as projectiles. A small cluster will rearrange into an f.c.c. structure when it is supported on the substrate, due to the large value of its surface/volume ratio. Contact epitaxy appeared in large clusters. The characteristic structure of an epitaxial layer in large silver cluster shows the 〈111〉 direction to be the preferential orientation of heteroepitaxial layers on the surface because of the lattice mismatch between the cluster and the substrate. This was confirmed by studying soft landing events in other systems (Au/Cu and Al/Ni).

Workplace information literacy : cultivation strategies for 'working smarter' in 21st century libraries

This paper presents a hybrid framework of Swedish cultural practices and Australian grounded theory for organizational development and suggests practical strategies for 'working smarter' in 21st Century libraries. Toward that end, reflective evidence-based practices are offered to incrementally build organizational capacity for asking good questions, selecting authoritative sources, evaluating multiple perspectives, organizing emerging insights, and communicating them to inform, educate, and influence. In addition, to ensure the robust information exchange necessary to collective workplace learning, leadership traits are proposed for ensuring inclusive communication, decision making, and planning processes. These findings emerge from action research projects conducted from 2003 to 2008 in two North American libraries.

Monster factory : International dynamics of the Australian horror movie industry

From the early-to-mid 2000s, the Australian horror film production sector has achieved growth and prosperity of a kind not seen since its heyday of the 1980s. Australian horror films can be traced back to the early 1970s, when they experienced a measure of commercial success. However, throughout the twenty-first-century Australian horror gained levels of international recognition that have surpassed the cult status enjoyed by some of the films in the 1970s and 1980s. In recent years, Australia has emerged as a significant producer of breakout, cult, and solid B-grade horror films, which have circulated in markets worldwide. Australian horror’s recent successes have been driven by one of its distinguishing features: its international dimensions. As this chapter argues, the Australian horror film production sector is an export-oriented industry that relies heavily on international partnerships and presales (the sale of distribution rights prior to a film’s completion), and on its relationships with overseas distributors. Yet, these traits vary from film to film as the sector is comprised of several distinct domains of production activity, from guerrilla films destined for niche video markets like specialist cult video stores and online mail-order websites to high(er)-end pictures made for theatrical markets. Furthermore, the content and style of Australian horror movies has often been tailored for export. While some horror filmmakers have sought to play up the Australianness of their product, others have attempted to pass off their films as faux-American or as placeless films effaced of national reference points.

Systems thinking : an approach for advancing workplace information literacy

As the importance of information literacy has gained increased recognition, so too have academic library professionals intensified their efforts to champion, activate, and advance these capabilities in others. To date, however, little attention has focused on advancing these essential competencies amongst practitioner advocates.This paper helps redress the paucity of professional literature on the topic of workplace information literacy among library professionals.

Molecular dynamics simulation of fracture strength and morphology of defective graphene

Different types of defects can be introduced into graphene during material synthesis, and significantly influence the properties of graphene. In this work, we investigated the effects of structural defects, edge functionalisation and reconstruction on the fracture strength and morphology of graphene by molecular dynamics simulations. The minimum energy path analysis was conducted to investigate the formation of Stone-Wales defects. We also employed out-of-plane perturbation and energy minimization principle to study the possible morphology of graphene nanoribbons with edge-termination. Our numerical results show that the fracture strength of graphene is dependent on defects and environmental temperature. However, pre-existing defects may be healed, resulting in strength recovery. Edge functionalization can induce compressive stress and ripples in the edge areas of graphene nanoribbons. On the other hand, edge reconstruction contributed to the tensile stress and curved shape in the graphene nanoribbons.

The John Lewis model reveals the tensions and paradoxes at the heart of workplace democracy

Politicians of all parties have been keen to promote the ‘John Lewis model’ of industrial organisation, emphasising its features of employee ownership and workplace democracy. Dr Abby Cathcart’s research into the company shows that management and workers have different visions of what ‘partnership’ means, with ongoing struggle taking place via the organisation’s democratic structures. This, she argues, has stark implications for other organisations with partnership models that are less robust.

Workplace human rights reporting : a study of Australian garment and retail companies

The opening of the Australian economy in a globalised world has led to Australian garment and retail corporations moving their manufacturing overseas and acquiring goods from overseas providers. This is usually better for the corporations’ bottom-line, as they can purchase goods overseas at a fraction of their local cost, partly due to cheap labour. Australia is one of the many OECD countries not to have a well regulated environment for workplace human rights. This study examines 18 major Australian retail and garment manufacturing corporations and finds that workplace human rights reporting is poor, based on content analysis of their annual reports, corporate social responsibility reports and websites. This is probably due to the failure of the Australian Government to provide adequate oversight by promulgating mandatory reporting standards for both local and overseas operations of Australian companies. This permits corporations to avoid reporting their workplace human rights standards and breaches.