Microtensile vs Microshear Bond Strength of All-in-One Adhesives to Unground Enamel

Purpose To determine the bond strength to unground enamel of all in one adhesives in comparison with an etch and rinse system and to compare the reliability of microtensile and microshear methods in providing such measurements Materials and Methods The bonding procedure was performed on enamel of 64 extracted molars The tested all in one adhesives were Bond Force (Tokuyama), AdheSE One (Ivoclar Vivadent) and Xeno V (Dentsply) Prime&Bond NT (Dentsply) served as control Microtensile specimens were obtained from 4 teeth per group Twelve teeth per group were used for microshear testing Microtensile specimens that failed prior to testing were included in statistical calculations, they were assigned the lowest value measured in the respective group Failure modes were observed under light microscope and classified (cohesive within substrates, adhesive mixed) Statistically significant differences in bond strength were assessed among the adhesives within each testing method and between microshear and microtensile data for each adhesive Failure mode distributions were compared using the chi square test Results All in-one adhesives had similar microshear and microtensile bond strengths In both testing methods, the etch and rinse system achieved the strongest bond For all adhesives significantly higher bond strengths were measured with the microshear test In microtensile testing specimens bonded with the etch and rinse adhesive exhibited a significantly different distribution of failure modes The coefficients of variation were extremely high for microtensile bond strength data, particularly of all in one adhesives Conclusion The adhesive potential to intact enamel of recently introduced all in-one adhesives was inferior to that of an etch and rinse system When testing bond strength to enamel of all in one adhesives, microshear testing may be a more accurate method than microtensile

Analysis of thermodynamic non-ideality in terms of protein solvation

The effects of thermodynamic non-ideality on the forms of sedimentation equilibrium distributions for several isoelectric proteins have been analysed on the statistical-mechanical basis of excluded volume to obtain an estimate of the extent of protein solvation. Values of the effective solvation. parameter delta are reported for ellipsoidal as well as spherical models of the proteins, taken to be rigid, impenetrable macromolecular structures. The dependence of the effective solvated radius upon protein molecular mass exhibits reasonable agreement with the relationship calculated for a model in which the unsolvated protein molecule is surrounded by a 0.52-nm solvation shell. Although the observation that this shell thickness corresponds to a double layer of water molecules may be of questionable relevance to mechanistic interpretation of protein hydration, it augurs well for the assignment of magnitudes to the second virial coefficients of putative complexes in the quantitative characterization of protein-protein interactions under conditions where effects of thermodynamic non-ideality cannot justifiably be neglected. (C) 2001 Elsevier Science B.V. All rights reserved.

Models involving two inverse Weibull distributions

In this paper, we look at three models (mixture, competing risk and multiplicative) involving two inverse Weibull distributions. We study the shapes of the density and failure-rate functions and discuss graphical methods to determine if a given data set can be modelled by one of these models. (C) 2001 Elsevier Science Ltd. All rights reserved.

Calculation of product state distributions from resonance decay via Lanczos subspace filter diagonalization: Application to HO2

Resonance phenomena associated with the unimolecular dissociation of HO2 have been investigated quantum-mechanically by the Lanczos homogeneous filter diagonalization (LHFD) method. The calculated resonance energies, rates (widths), and product state distributions are compared to results from an autocorrelation function-based filter diagonalization (ACFFD) method. For calculating resonance wave functions via ACFFD, an analytical expression for the expansion coefficients of the modified Chebyshev polynomials is introduced. Both dissociation rates and product state distributions of O-2 show strong fluctuations, indicating the dissociation of HO2 is essentially irregular. (C) 2001 American Institute of Physics.

Applying statistical approaches in the dissection of genes versus environment for asthma and allergic disease

Now that some of the genes involved in asthma and allergy have been identified, interest is turning to how genetic predisposition interacts with exposure to environmental risk factors. These questions are best answered by studies in which both genotypes and other risk factors are measured, but even simpler studies, in which family history is used as a proxy for genotype, have made suggestive findings. For example, early breast feeding may increase the risk of allergic disease in genetically susceptible children, and decrease the risk of 'sporadic' allergy. This review also addresses the overall importance of genetic causes of allergic disease in the general population.

Solicitors disciplinary hearings in Queensland 1930-2000: a statistical analysis

This article reports on the results of a study undertaken by the author together with her research assistant, Heather Green. The study collected and analysed data from all disciplinary tribunal decisions heard in Queensland since 1930 in an attempt to provide empirical information which has previously been lacking. This article will outline the main features of the disciplinary system in Queensland, describe the research methodology used in the present study and then report on some findings from the study. Reported findings include a profile of solicitors who have appeared before a disciplinary hearing, the types of matters which have attracted formal discipline and the types of orders made by the tribunal. Much of the data is then presented on a time scale so as to reveal any changes over time.

Characterisation of pore structure of carbon adsorbents using regularisation procedure

The constrained regularisation procedure was applied to compute the pore size distributions (PSDs, f(x)) for a variety of activated carbons using overall adsorption equation based on the combination of the Kelvin equation and the statistical adsorbed film thickness. The impact of the boundary values of relative nitrogen pressure p/p(0) was analysed on the basis of the corresponding alterations in the PSDs. Changes in microporosity and mesoporosity of activated carbons can be described adequately only when the range of p/p(0) is as wide as possible, as at a high initial p/p(0) value, the f(x) curves can be broadened with shifted maxima especially for micropores and narrow mesopores. Comparative analysis of the PSDs and the adsorption potential, adsorption energy and fractal dimension distributions gives useful information on the complete description of the adsorbent characteristics. (C) 2001 Elsevier Science B.V. All rights reserved.

The application of statistical process control charts to the detection and monitoring of hospital-acquired infections

The monitoring of infection control indicators including hospital-acquired infections is an established part of quality maintenance programmes in many health-care facilities. However, surveillance data use can be frustrated by the infrequent nature of many infections. Traditional methods of analysis often provide delayed identification of increasing infection occurrence, placing patients at preventable risk. The application of Shewhart, Cumulative Sum (CUSUM) and Exponentially Weighted Moving Average (EWMA) statistical process control charts to the monitoring of indicator infections allows continuous real-time assessment. The Shewhart chart will detect large changes, while CUSUM and EWMA methods are more suited to recognition of small to moderate sustained change. When used together, Shewhart and EWMA methods are ideal for monitoring bacteraemia and multiresistant organism rates. Shewhart and CUSUM charts are suitable for surgical infection surveillance.

The BRCA2 372 HH genotype is associated with risk of breast cancer in Australian women under age 60 years

The BRCA2 N372H nonconservative amino acid substitution polymorphism appears to affect fetal survival in a sex-dependent manner, and the HH genotype was found to be associated with a 1.3-fold risk of breast cancer from pooling five case-control studies of Northern European women. We investigated whether the BR 2 N372H polymorphism was associated with breast cancer in Australian women using a population-based case-control design. The BRCA2 372 genotype was determined in 1397 cases under the age of 60 years at diagnosis of a first primary breast cancer and in 775 population-sampled controls frequency matched for age. Case-control analyses and comparisons of genotype distributions were conducted using logistic regression. All of the statistical tests were two-tailed. The HH genotype was independent of age and family history of breast cancer within cases and controls, and was more common in cases (9.2% versus 6.5%). It was associated with an increased risk of breast cancer, 1.47-fold unadjusted (95% confidence interval, 1.05-2.07; P = 0.02), and 1.42-fold (95% confidence interval, 1.00-2.02; P = 0.05) after adjusting for measured risk factors. This effect was still evident after excluding women with any non-Caucasian ancestry or the 33 cases known to have inherited a mutation in BRCA1 or BRCA2, and would explain similar to3% of breast cancer. The BRCA2 N372H polymorphism appears to be associated with a modest recessively inherited risk of breast cancer in Australian women. This result is consistent with the findings for Northern European women.

Interactive expectations

In modeling expectation formation, economic agents are usually viewed as forming expectations adaptively or in accordance with some rationality postulate. We offer an alternative nonlinear model where agents exchange their opinions and information with each other. Such a model yields multiple equilibria, or attracting distributions, that are persistent but subject to sudden large jumps. Using German Federal Statistical Office economic indicators and German IFO Poll expectational data, we show that this kind of model performs well in simulation experiments. Focusing upon producers' expectations in the consumption goods sector, we also discover evidence that structural change in the interactive process occurred over the period of investigation (1970-1998). Specifically, interactions in expectation formation seem to have become less important over time.

Estimating and evaluating the statistics of gapped local-alignment scores

We present a novel maximum-likelihood-based algorithm for estimating the distribution of alignment scores from the scores of unrelated sequences in a database search. Using a new method for measuring the accuracy of p-values, we show that our maximum-likelihood-based algorithm is more accurate than existing regression-based and lookup table methods. We explore a more sophisticated way of modeling and estimating the score distributions (using a two-component mixture model and expectation maximization), but conclude that this does not improve significantly over simply ignoring scores with small E-values during estimation. Finally, we measure the classification accuracy of p-values estimated in different ways and observe that inaccurate p-values can, somewhat paradoxically, lead to higher classification accuracy. We explain this paradox and argue that statistical accuracy, not classification accuracy, should be the primary criterion in comparisons of similarity search methods that return p-values that adjust for target sequence length.

Close packed transitions in slit-shaped pores: Density functional theory study of methane adsorption capacity in carbon

An important feature of improving lattice gas models and classical isotherms is the incorporation of a pore size dependent capacity, which has hitherto been overlooked. In this paper, we develop a model for predicting the temperature dependent variation in capacity with pore size. The model is based on the analysis of a lattice gas model using a density functional theory approach at the close packed limit. Fluid-fluid and solid-fluid interactions are modeled by the Lennard-Jones 12-6 potential and Steele's 10-4-3, potential respectively. The capacity of methane in a slit-shaped carbon pore is calculated from the characteristic parameters of the unit cell, which are extracted by minimizing the grand potential of the unit cell. The capacities predicted by the proposed model are in good agreement with those obtained from grand canonical Monte Carlo simulation, for pores that can accommodate up to three adsorbed layers. Single particle and pair distributions exhibit characteristic features that correspond to the sequence of buckling and rhombic transitions that occur as the slit pore width is increased. The model provides a useful tool to model continuous variation in the microstructure of an adsorbed phase, namely buckling and rhombic transitions, with increasing pore width. (C) 2002 American Institute of Physics.