MATURE FINE TAILINGS (MFTs): A STUDY OF COMPRESSIVE STRENGTH AND RHEOLOGICAL PROPERTIES OF ATHABASCA OIL SANDS PETROLEUM MINING WASTE APPLIED IN CONCRETE MIXTURES

This study investigates the compressive properties of concrete incorporating Mature Fine Tailings (MFTs) waste stream from a tar sands mining operation. The objectives of this study are to investigate material properties of the MFT material itself, as well as establish general feasibility of the utilization of MFT material in concrete mixtures through empirical data and visual observations. Investigations undertaken in this study consist of moisture content, materials finer than No. 200 sieve, Atterburg Limits as well as visual observations performed on MFT material as obtained. Control concrete mixtures as well as MFT replacement mixture designs (% by wt. of water) were guided by properties of the MFT material that were experimentally established. The experimental design consists of compression testing of 4”-diameter concrete cylinders of a control mixture, 30% MFT, 50% MFT and 70% MFT replacement mixtures with air-entrainer additive, as well as a control mixture and 30% MFT replacement mixture with no air-entrainer. A total of 6 mixtures (2 control mixtures, 4 replacement mixtures) moist-cured in lime water after 24 hours initial curing were tested for ultimate compressive strength at 7 days and 28 days in accordance to ASTM C39. The test results of fresh concrete material show that the addition of air-entrainer to the control mixture increases slump from 4” to 5.5”. However, the use of MFT material in concrete mixtures significantly decreases slump as compared to controls. All MFT replacement mixtures (30%, 50%, and 70%) with air-entrainer present slumps of 1”. 30% MFT with no air-entrainer presents a slump of 1.5”. It was found that 7-day ultimate compressive stress was not a good predictor of 28-day ultimate compressive stress. 28-day results indicate that the use of MFT material in concrete with air-entrainer decreases ultimate compressive stress for 30%, 50% and 70% MFT replacement amounts by 14.2%, 17.3% and 25.1% respectively.

Some Notes on the Composition of "Copper Pitch"

A supply of so-called "copper pitch" ore was received by the Montana Bureau of Mines and Geology in response to a request by them from a resident of Kalispell, who had previously sent a specimen to the Bureau for a mineralogical analysis. Since this material was little known and had apparently received but little study under a reflec­ting microscope, it was thought that such a study might throw some light on the mineralogical and chemical composition of the material.

History of Petroleum Engineering at Montana Tech

In January, 2010, the Petroleum Engineering department at Montana Tech moved into a new building, the Natural Resources Building, to start a new chapter in the history of the program on campus. Occupying a new building is a positive event, and it coincides with a surge of student enrollment which is prompted by industry needs and world energy demand. This time of new facilities and growing student numbers leads to the question of what the future has in store for the department. It also leads to reflection about where the department has been in the past. This history is a record and a story of that past.

EMPLOYMENT AND EXPOSURES IN THE PETROLEUM REFINING AND PETROCHEMICAL INDUSTRIES AND THE RISK OF LUNG CANCER (EPIDEMIOLOGY, ASSESSMENT)

This dissertation addresses the risk of lung cancer associated with occupational exposures in the petroleum refining and petrochemical industries. Earlier epidemiologic studies of this association did not adjust for cigarette smoking or have specific exposure classifications. The Texas EXposure Assessment System (TEXAS) was developed with data from a population-based, case-comparison study conducted in five southeast Texas counties between 1976 and 1980. The Texas Exposure Assessment System uses job and process categories developed by the American Petroleum Institute, as well as time-oriented variables to identify high risk groups.^ An industry-wide, increased risk for lung cancer was associated with jobs having low-level hydrocarbon exposure that also include other occupational inhalation exposures (OR = 2.0--adjusted for smoking and latency effects). The prohibition of cigarette smoking for jobs with high-level hydrocarbon exposure might explain part of the increased risk for jobs with low-level hydrocarbon exposures. Asbestos exposure comprises a large part of the risk associated with jobs having other inhalation exposures besides hydrocarbons. Workers in petroleum refineries were not shown to have an increased, occupational risk for lung cancer. The increased risk for lung cancer among petrochemical workers (OR = 3.1--smoking and latency adjusted) is associated with all jobs that involve other inhalation exposure characteristics (not only low-level hydrocarbon exposures). Findings for contract workers and workers exposed to specific chemicals were inconclusive although some hypotheses for future research were identified.^ The study results demonstrate that the predominant risk for lung cancer is due to cigarette smoking (OR = 9.8). Cigarette smoking accounts for 86.5% of the incident lung cancer cases within the study area. Workers in the petroleum industry smoke significantly less than persons employed in other industries (p << 0.001). Only 2.2% of the incident lung cancer cases may be attributed to petroleum industry jobs; lifestyle factors (e.g., nutrition) may be associated with the balance of the cases. The results from this study also suggest possible high risk time periods (OR = 3.9--smoking and occupation adjusted). Artifacts in time-oriented findings may result because of the latency interval for lung cancer, secular peaks in age-, sex-specific incidence rates, or periods of hazardous exposures in the petroleum industry. ^

Ultra-low-dose dual-source CT coronary angiography with high pitch: diagnostic yield of a volumetric planning scan and effects on dose reduction and imaging strategy

OBJECTIVE To evaluate the role of an ultra-low-dose dual-source CT coronary angiography (CTCA) scan with high pitch for delimiting the range of the subsequent standard CTCA scan. METHODS 30 patients with an indication for CTCA were prospectively examined using a two-scan dual-source CTCA protocol (2.0 × 64.0 × 0.6 mm; pitch, 3.4; rotation time of 280 ms; 100 kV): Scan 1 was acquired with one-fifth of the tube current suggested by the automatic exposure control software [CareDose 4D™ (Siemens Healthcare, Erlangen, Germany) using 100 kV and 370 mAs as a reference] with the scan length from the tracheal bifurcation to the diaphragmatic border. Scan 2 was acquired with standard tube current extending with reduced scan length based on Scan 1. Nine central coronary artery segments were analysed qualitatively on both scans. RESULTS Scan 2 (105.1 ± 10.1 mm) was significantly shorter than Scan 1 (127.0 ± 8.7 mm). Image quality scores were significantly better for Scan 2. However, in 5 of 6 (83%) patients with stenotic coronary artery disease, a stenosis was already detected in Scan 1 and in 13 of 24 (54%) patients with non-stenotic coronary arteries, a stenosis was already excluded by Scan 1. Using Scan 2 as reference, the positive- and negative-predictive value of Scan 1 was 83% (5 of 6 patients) and 100% (13 of 13 patients), respectively. CONCLUSION An ultra-low-dose CTCA planning scan enables a reliable scan length reduction of the following standard CTCA scan and allows for correct diagnosis in a substantial proportion of patients. ADVANCES IN KNOWLEDGE Further dose reductions are possible owing to a change in the individual patient's imaging strategy as a prior ultra-low-dose CTCA scan may already rule out the presence of a stenosis or may lead to a direct transferal to an invasive catheter procedure.

Upton Sinclair: "Petroleum". Malik-Verlag, Berlin [Rezension]

Manfred Heß

The role of chronic irritation and inflammation in tumor promotion in CD-1 mice by petroleum middle distillates

An initiation-promotion bioassay in CD-1 mice was used to examine the role of chronic irritation and inflammation in tumor promotion by petroleum middle distillates. A representative hydrodesulfurized middle distillate (API 81-07) was selected as the test article. Test groups (54 mice per group) were initiated once with 50 ug of 7,12-dimethylbenzanthracene (DMBA). Promotion with API 81-07 consisted of twice weekly treatments for 25 weeks with either 25 ul, 50 ul, 50 ul + daily treatment with 15 ug dexamethasone, 50 ul + post-application washings, and 100 ul. Three mice from each group were sacrificed at 21 day intervals (24 total per group). The skin from interim sacrificed (IS) mice was examined histopathologically for tumor, acanthosis, hyperkeratosis, pseudo-epitheliomatous hyperplasia, epidermal crusting, and subacute inflammation. In-life observations included examination of all mice for erythema and edema for 8 weeks following the first promotion treatment. Tumor incident at study termination was as follows: 25 ul (45%), 50 ul (43%), 50 ul + dexamethasone (0%), 50 ul + washing (70%), and 100 ul (81%). An overall correlation of $>$0.90 between tumor incidence and group means for acanthosis and hyperkeratosis was observed in IS mice at all intervals. Correlations of $<$0.75 were observed for other group mean histopathological parameters and tumor incidence. The overall correlation of group mean erythema and edema with tumor incident was $>$0.90. The results of this study support the hypothesis that induction of a lasting, albeit mild, hyperplasia is an essential, but not sufficient requirement, for tumor promotion. Furthermore, subacute inflammation does not appear to be a significant factor in tumor promotion by petroleum middle distillates. However, inflammation may be a factor in tumor progression. ^

Chemical Modification of Partially Hydrogenated Vegetable Oil to Improve its Functional Properties to Replace Petroleum Waxes

A novel, chemically-modified partially hydrogenated vegetable oil (PHVO) is described. The PHVO is produced by a three-step reaction process that includes epoxidation, a ringopening reaction, followed by esterification. The modified PHVO has improved kneadability and, if mixed with fully hydrogenated fat(s ), hardness comparable to umnodified PHVO.

Petroleum-generating potential of sediments at DSDP Leg 64 Holes

Sediments from the Gulf of California contain sufficient amounts of thermally reactive organic matter to be considered fair-to-good potential petroleum source rocks. While sediments deposited within the present oxygen-minimum zone have the greatest amounts of organic matter, those deposited below the oxygen-minimum contain sufficient organic matter to be considered potential source rocks. The organic matter in the sediment is almost exclusively marine, Type II kerogen. Different techniques of determining kerogen composition produce generally compatible answers, although pyrolysis gives somewhat misleading results. Elemental analysis of the kerogen and vitrinite reflectance measurements indicate that the organic matter is not buried to sufficiently great depth for significant petroleum generation, despite the high temperature gradients.

Nature, origin, and petroleum source potential of organic matter at DSDP Leg 56-57 Holes

As part of a continuing program of organic-geochemistry studies of sediments recovered by the Deep Sea Drilling Project, we have analyzed the types, amounts, and thermal-alteration indices of organic matter in samples collected from the landward wall of the Japan Trench on Legs 56 and 57. The samples were canned aboard ship, enabling us to measure also their gas contents. In addition, we analyzed the heavy C15+ hydrocarbons, NSO compounds, and asphaltenes extracted from selected samples. Our samples form a transect down the trench wall, from Holes 438 and 438A (water depth 1558 m), through Holes 435 and 435A (water depth 3401 m), and 440 (water depth 4507 m), to Holes 434 and 434B (water depth 5986 m). The trench wall is the continental slope of Japan. Its sediments are Cenozoic hemipelagic diatomaceous muds that were deposited where they are found or have slumped from farther up the slope. Their terrigenous components probably were deposited from near-bottom nepheloid layers transported by bottom currents or in low density flows (Arthur et al., 1978). Our objective was to find out what types of organic matter exist in the sediment and to estimate their potential for generation of hydrocarbons.

Heavy metal and petroleum product concentrations in waters at the Obskaya 1 drill site

During recent years, the basins of the Kara Sea (Kamennomysskaya, Obskaya, and Chugor'yakhinskaya structures) in the Russian Federation have been considered as promising regions for oil and gas exploration and, simultaneously, as possible paths of relatively cheap pipeline and tanker transportation of hydrocarbons projected for recovery. On the other hand, exploration operations, recovery, and transportation of gas pose a considerable risk of accidents and environmental pollution, which causes a justified concern about the future state of the ecological system of the Gulf of Ob and the adjoining parts of the Kara Sea. Therefore, regular combined environmental investigations (monitoring) are the most important factor for estimating the current state and forecasting the dynamics of the development of estuary systems. The program of investigations (schedule, station network, and measured parameters) is standardized in accordance with the international practice of such work and accounts for the experience of monitoring studies of Russian and foreign researchers. Two measurement sessions were performed during ecological investigations in the region of exploration drilling: at the beginning at final stage of drilling operations and borehole testing; in addition, natural parameters were determined in various parts of the Ob estuary before the beginning of investigations. Hydrophysical and hydrochemical characteristics of the water medium were determined and bottom sediments and water were analyzed for various pollutants (petroleum products, heavy metals, and radionuclides). The forms of heavy-metal occurrence in river and sea waters were determined by the method of continuous multistep filtration, which is based on water component fractionation on membrane filters of various pore sizes. These investigations revealed environmental pollution by chemical substances during the initial stage of drilling operations, when remains of fuels, oils, and solutions could be spilled, and part of the chemical pollutants could enter the environment. Owing to horizontal and vertical turbulent diffusion, wave mixing, and the effect of the general direction of currents in the Ob estuary from south to north, areas are formed with elevated concentrations of the analyzed elements and compounds. However, the concentration levels of chemical pollutants are practically no higher than the maximum admissible concentrations, and their substantial dissipation to the average regional background contents can be expected in the near future. Our investigations allowed us to determine in detail the parameters of anthropogenic pollution in the regions affected by hydrocarbon exploration drilling in the Obskii and Kamennomysskii prospects in the Gulf of Ob and estimate their influence on the ecological state of the basin of the Ob River and the Kara Sea on the whole.