The initial phase of sodium sulfite pulping of softwood : A comparison of different pulping options

Single stage and two-stage sodium sulfite cooking were carried out on either spruce, pine or pure pine heartwood chips to investigate the influence of several process parameters on the initial phase of such a cook down to about 60 % pulp yield. The cooking experiments were carried out in the laboratory with either a lab-prepared or a mill-prepared cooking acid and the temperature and time were varied. The influences of dissolved organic and inorganic components in the cooking liquor on the final pulp composition and on the extent of side reactions were investigated. Kinetic equations were developed and the activation energies for delignification and carbohydrate dissolution were calculated using the Arrhenius equation. A better understanding of the delignification mechanisms during bisulfite and acid sulfite cooking was obtained by analyzing the lignin carbohydrate complexes (LCC) present in the pulp when different cooking conditions were used. It was found that using a mill-prepared cooking acid beneficial effect with respect to side reactions, extractives removal and higher stability in pH during the cook were observed compared to a lab-prepared cooking acid. However, no significant difference in degrees of delignification or carbohydrate degradation was seen.  The cellulose yield was not affected in the initial phase of the cook however; temperature had an influence on the rates of both delignification and hemicellulose removal. It was also found that the  corresponding activation energies increased in the order:  xylan, glucomannan, lignin and cellulose. The cooking temperature could thus be used to control the cook to a given carbohydrate composition in the final pulp. Lignin condensation reactions were observed during acid sulfite cooking, especially at higher temperatures. The LCC studies indicated the existence of covalent bonds between lignin and hemicellulose components with respect to xylan and glucomannan. LCC in native wood showed the presence of phenyl glycosides, ϒ-esters and α-ethers; whereas the α-ethers  were affected during sulfite pulping. The existence of covalent bonds between lignin and wood polysaccharides might be the rate-limiting factor in sulfite pulping.

Gold Catalyzed Functionalization Of Alkynes And Allenamides

The gold(I)-catalyzed chemoselective dearomatization of β-naphthols is reported through a straightforward approach via [3,3]-sigmatropic rearrangement /allene-cyclyzation cascade processes. Easily accessed naphthyl-propargyl ethers and derivatives in this work are employed as starting materials. Delightfully, an array of deoramatized dyhydrofuryl -naphthalen-2(1H)-ones featured densely functional groups are obtained in high yields (up to 98%) in 10 min reaction time under extremely mild reaction conditions like reagent grade solvent and exposure to air. The potential of accessing to high enantioselectivety on the dearomatized dyhydrofuryl- naphthalen-2(1H)-ones is also approved by the good ee (65%) relying on (R)-xylyl- BINAP(AuCl)2. In addition, complete theoretical elucidation of the reaction pathway is also proposed which addresses a rationale for essential motivation such as regio- and chemoselectivity. Moreover, an efficient gold catalyzed intermolecular dearomatization of substituted β-naphthols with allenamides is presented here. PPh3AuTFA (5 mol %) approves the efficient dearomatively allylation protocol under mild conditions and exhibits high tolerance on substrates scope (24 examples) in good to excellent yield accompanied with high regioselectivity and stereoselectivity. Moreover, the synergistic catalytic system also highlight the synergistic function between the [PPh3Au]+ (π-acid) and TFA− (Lewis base). At last, a new chiral BINOL phosphoric acid silver salt is successfully synthesized and used as the chiral counter anion, which strongly promotes the enantioselectivity (up to 92%). At last but not least, crucially, SmI2 induced enantioselective formal synthesis of strychnine, a complex alkaloid and a classical target used to benchmark new synthetic methods is developed. Enantioselective dearomatising radical cyclisation on to the indole unit and further ET will then give organosamarium that is quenched diastereoselectively by the ester to deliver Strychnine in 7 steps.

Photoactive (supra)molecular devices in double layer membranes

Biological systems are complex and highly organized architectures governed by non-covalent interactions responsible for the regulation of essential tasks in all living organisms. These systems are a constant source of inspiration for supramolecular chemists aiming to design multicomponent molecular assemblies able to perform elaborated tasks, thanks to the role and action of the components that constitute them. Artificial supramolecular systems exploit non-covalent interactions to mimic naturally occurring events. In this context, stimuli-responsive supramolecular systems have attracted attention due to the possibility to control macroscopic effects through modifications at the nanoscale. This thesis is divided in three experimental chapters, characterized by a progressive increase in molecular complexity. Initially, the preparation and studies of liposomes functionalized with a photoactive guest such as azobenzene in the bilayer were tackled, in order to evaluate the effect of such photochrome on the vesicle properties. Subsequently, the synthesis and studies of thread-like molecules comprising an azobenzene functionality was reported. Such molecules were conceived to be intercalated in the bilayer membrane of liposomes with the aim to be used as components for photoresponsive transmembrane molecular pumps. Finally, a [3]rotaxane was developed and studied in solution. This system is composed of two crown ether rings interlocked with an axle containing three recognition sites for the macrocycles, i.e. two pH-switchable ammonium stations and a permanent triazolium station. Such molecule was designed to achieve a change in the ratio between the recognition sites and the crown ethers as a consequence of acid-base inputs. This leads to the formation of rotaxanes containing a number of recognition sites respectively larger, equal or lower than the number of interlocked rings and connected by a network of acid-base reactions.