(Table 1) Light minerals in sand at DSDP Leg 84 holes

The Middle America active continental margin is the best-sampled active plate margin to date, having been drilled during Legs 84, 67, and 66. With nine sites drilled on the continental slope of Guatemala and an additional site drilled on the Costa Rican slope, a summary of slope sediments and sedimentary processes can be made. Sediments are easily subdivided into a thick apron of Neogene and Quaternary volcanically derived hemipelagic and turbidite mud and mudstone and a thinner, more varied assemblage of mostly Paleogene mudstone, radiolarian mudstone, and limestone. This latter assemblage may contain hiatuses or be completely lacking between slope deposits and basement. Cores from the foot of the continental slope (Core 567A-19) consist of Campanian micrite. The pre-Neogene section is much thicker and of more terrigenous provenance beneath the forearc basin landward of the forearc structural high than on the continental slope. Sedimentary processes of the Neogene and Quaternary slope sediments include reworking of hemipelagic and turbidite deposits. Redeposition by slumping, plastic flow, and turbidity current-documentable through benthic foraminiferal analysis-occurs in intracanyon and canyon settings. Erosion by slumping and by turbidity current and deposition of mud or sand in canyons and in local depressions on the continental slope and different rates of sediment accumulation result in dramatic thickness variations of lithologic units over small distances in localized pockets of sand in small filled canyons on the slope or in sediment ponds, and in high-relief basement topography. The age of sediment overlying igneous basement ranges from Cretaceous to Quaternary. Gas hydrate was visible or inferred present at every site drilled during Leg 84. Nevertheless, except for a small amount in the last core, it was not recovered in sufficient quantities to be visible at Site 568, a site specifically chosen for the study of hydrate and located near Site 496, which was abandoned during Leg 67 because of the dangerous abundance of hydrates. The association of hydrate with porous, coarser sediment results in a distribution as localized and unpredictable as the slope sands off Guatemala, which do not occur in beds coherent enough to produce acoustic reflection. Although the normal lithologic section at Sites 567 and 496 limits the volume of sediment that could be part of an accretionary prism offshore Guatemala and the volume of sediment in the Trench axis is not sufficient to argue for significant accumulation of Cocos Plate sediments, the varied lithology and attenuated thickness of pre-Neogene sediment seaward of the forearc structural high do not exclude earlier accretion from the history of the Guatemalan continental margin.

(Table 1) Summary of magnetic properties and chemical composition of opaque minerals in DSDP Leg 58 Holes basallts

The Curie temperature and thermomagnetic behavior of wholerock samples were measured in basalts recovered from Sites 442, 443, and 444 of DSDP Leg 58 in the Shikoku Basin, and from Site 446 in the Daito Basin, north Philippine Sea. Chemical composition and microscopic features of opaque oxides in the same samples were also investigated. Degree and mode of oxidation of titanomagnetite vary irrespective of site, lithology, or magnetic polarity, and no systematic correlation has been found between any two of these characteristics. Magnetic properties are systematically different between massive flows recovered at Hole 444A (Shikoku Basin) and Hole 446A (Daito Basin), although the controlling factor is unknown.

Clay minerals in Mesozoic and Cenozoic sediments at DSDP Leg 62 Holes

The main tasks of this study were (1) identification of minerals of the clay fraction, (2) identification of clay-mineral associations in relation to stratigraphic intervals, and (3) elucidation of genetic relations of clay minerals with types of sediments and factors of sedimentation. Identification of clay minerals was carried out mainly with an X-ray diffractometer (DRON-I). X-ray diffractograms were prepared by means of CuKalpha radiation, at 35 kW and a current of 20 ma. The scanning rate was 2°/min. Oriented specimens were prepared for the <1-µm fraction (and partly for the <10-µm fraction because of insufficient core material) in three states: air-dried, saturated with glycerine, and heated at 550°C.