Efficiency, costs and trade-offs in marine reserve system design

With marine biodiversity conservation the primary goal for reserve planning initiatives, a site's conservation potential is typically evaluated on the basis of the biological and physical features it contains. By comparison, socio-economic information is seldom a formal consideration of the reserve system design problem and generally limited to an assessment of threats, vulnerability or compatibility with surrounding uses. This is perhaps surprising given broad recognition that the success of reserve establishment is highly dependent on widespread stakeholder and community support. Using information on the spatial distribution and intensity of commercial rock lobster catch in South Australia, we demonstrate the capacity of mathematical reserve selection procedures to integrate socio-economic and biophysical information for marine reserve system design. Analyses of trade-offs highlight the opportunities to design representative, efficient and practical marine reserve systems that minimise potential loss to commercial users. We found that the objective of minimising the areal extent of the reserve system was barely compromised by incorporating economic design constraints. With a small increase in area (< 3%) and boundary length (< 10%), the economic impact of marine reserves on the commercial rock lobster fishery was reduced by more than a third. We considered also how a reserve planner might prioritise conservation areas using information on a planning units selection frequency. We found that selection frequencies alone were not a reliable guide for the selection of marine reserve systems, but could be used with approaches such as summed irreplaceability to direct conservation effort for efficient marine reserve design.

Empirical investigation of investment behaviour in Australia's pastoral region

Optimal intertemporal investment behaviour of Australian pastoralists is modelled using panel data for the period 1979-1993. Results indicate that quasi-fixity of inputs of labour, capital, sheep numbers and cattle numbers is characteristic of production in the pastoral region. It takes about two years for labour, four years for capital and a little over two years for both sheep numbers and cattle numbers to adjust towards long-run optimal levels. Results also indicate that, after accounting for adjustment costs, own-price product supply and input demand responses are inelastic in both the short and long run.

Integrating JERS-1 imaging radar and elevation models for mapping tropical rainforest communities in far North Queensland, Australia

The Wet Tropics World Heritage Area in Far North Queens- land, Australia consists predominantly of tropical rainforest and wet sclerophyll forest in areas of variable relief. Previous maps of vegetation communities in the area were produced by a labor-intensive combination of field survey and air-photo interpretation. Thus,. the aim of this work was to develop a new vegetation mapping method based on imaging radar that incorporates topographical corrections, which could be repeated frequently, and which would reduce the need for detailed field assessments and associated costs. The method employed G topographic correction and mapping procedure that was developed to enable vegetation structural classes to be mapped from satellite imaging radar. Eight JERS-1 scenes covering the Wet Tropics area for 1996 were acquired from NASDA under the auspices of the Global Rainforest Mapping Project. JERS scenes were geometrically corrected for topographic distortion using an 80 m DEM and a combination of polynomial warping and radar viewing geometry modeling. An image mosaic was created to cover the Wet Tropics region, and a new technique for image smoothing was applied to the JERS texture bonds and DEM before a Maximum Likelihood classification was applied to identify major land-cover and vegetation communities. Despite these efforts, dominant vegetation community classes could only be classified to low levels of accuracy (57.5 percent) which were partly explained by the significantly larger pixel size of the DEM in comparison to the JERS image (12.5 m). In addition, the spatial and floristic detail contained in the classes of the original validation maps were much finer than the JERS classification product was able to distinguish. In comparison to field and aerial photo-based approaches for mapping the vegetation of the Wet Tropics, appropriately corrected SAR data provides a more regional scale, all-weather mapping technique for broader vegetation classes. Further work is required to establish an appropriate combination of imaging radar with elevation data and other environmental surrogates to accurately map vegetation communities across the entire Wet Tropics.

Modeling the economic losses from pressure ulcers among hospitalized patients in Australia

The objective of this study was to predict the number of cases of pressure ulcer, the bed days lost, and the economic value of these losses at Australian public hospitals. All adults (>= 18 years of age) with a minimum stay of 1 night and discharged from selected clinical units from all Australian public hospitals in 2001-02 were included in the study. The main outcome measures were the number of cases of pressure ulcer, bed days lost to pressure ulcer, and economic value of these losses. We predict a median of 95,695 cases of pressure ulcer with a median of 398,432 bed days lost, incurring median opportunity costs of AU$285 M. The number of cases, and so costs, were greatest in New South Wales and lowest in Australian Capitol Territory. We conclude that pressure ulcers represent a serious clinical and economic problem for a resource-constrained public hospital system. The most cost-effective, risk-reducing interventions should be pursued up to a point where the marginal benefit of prevention is equalized with marginal cost. By preventing pressure ulcers, public hospitals can improve efficiency and the quality of the patient's experience and health outcome.

Trends in morphine prescriptions, illicit morphine use and associated harms among regular injecting drug users in Australia

This paper examines population trends in morphine prescriptions in Australia, and contrasts them with findings from annual surveys with regular injecting drug users (IDU). Data on morphine prescriptions from 1995 to 2003 were obtained from the Drug Monitoring System (DRUMS) run by the Australian Government Department of Health and Ageing. Data collected from regular IDU as part of the Australian Illicit Drug Reporting System (IDRS) were analysed (2001-2004). The rate of morphine prescription per person aged 15-54 years increased by 89% across Australia between 1995 and 2003 (from 46.3 to 85.9 mg per person). Almost half (46%) of IDU surveyed in 2004 reported illicit morphine use, with the highest rates in jurisdictions where heroin was less available. Recent morphine injectors were significantly more likely to be male, unemployed, out of treatment and homeless in comparison to IDU who had not injected morphine. They were also more likely to have injected other pharmaceutical drugs and to report injection related problems. Among those who had injected morphine recently, the most commonly reported injecting harms were morphine dependence (38%), difficulty finding veins into which to inject (36%) and scarring or bruising (27%). Morphine use and injection is a common practice among regular IDU in Australia. In some cases, morphine may be a substitute for illicit heroin; in others, it may be being used to treat heroin dependence where other pharmacotherapies, such as methadone and buprenorphine, are perceived as being unavailable or undesirable by IDU. Morphine injection appears to be associated with polydrug use, and with it, a range of problems related to drug injection. Further research is required to monitor and reduce morphine diversion and related harms by such polydrug injectors.

Searching for cancer deaths in Australia: National Death Index vs Cancer Registries

OBJECTIVE: To compare the accuracy, costs and utility of using the National Death Index (NDI) and state-based cancer registries in determining the mortality status of a cohort of women diagnosed with ovarian cancer in the early 1990s. METHODS: As part of a large prognostic study, identifying information on 822 women diagnosed with ovarian cancer between 1990 and 1993, was simultaneously submitted to the NDI and three state-based cancer registries to identify deceased women as of June 30, 1999. This was compared to the gold standard of "definite deaths". A comparative evaluation was also made of the time and costs associated with the two methods. RESULTS: Of the 450 definite deaths in our cohort the NDI correctly identified 417 and all of the 372 women known to be alive (sensitivity 93%, specificity 100%). Inconsistencies in identifiers recorded in our cohort files, particularly names, were responsible for the majority of known deaths not matching with the NDI, and if eliminated would increase the sensitivity to 98%. The cancer registries correctly identified 431 of the 450 definite deaths (sensitivity 96%). The costs associated with the NDI search were the same as the cancer registry searches, but the cancer registries took two months longer to conduct the searches. CONCLUSIONS AND IMPLICATIONS: This study indicates that the cancer registries are valuable, cost effective agencies for follow-up of mortality outcome in cancer cohorts, particularly where cohort members were residents of those states. For following large national cohorts the NDI provides additional information and flexibility when searching for deaths in Australia. This study also shows that women can be followed up for mortality with a high degree of accuracy using either service. Because each service makes a valuable contribution to the identification of deceased cancer subjects, both should be considered for optimal mortality follow-up in studies of cancer patients.

Extent and economic effect of heat loads on dairy cattle production in Australia

Objective To investigate the extent of heat load problems, caused by the combination of excessive temperature and humidity, in Holstein-Friesian cows in Australia. Also, to outline how milk production losses and consequent costs from this can be estimated and minimised. Procedures Long-term meteorological data for Australia were analysed to determine the distribution of hot conditions over space and time. Fifteen dairy production regions were identified for higher-resolution data analysis. Both the raw meteorological data and their integration into a temperature-humidity thermal index were compiled onto a computer program. This mapping software displays the distribution of climatic patterns, both Australia-wide and within the selected dairying regions. Graphical displays of the variation in historical records for 200 locations in the 15 dairying regions are also available. As a separate study, production data from research stations, on-farm trials and milk factory records were statistically analysed and correlated with the climatic indices, to estimate production losses due to hot conditions. Results Both milk yields and milk constituents declined with increases in the temperature-humidity index. The onset and rate of this decline are dependent on a number of factors, including location, level of production, adaptation, and management regime. These results have been integrated into a farm-level economic analysis for managers of dairy properties. Conclusion By considering the historical patterns of hot conditions over time and space, along with expected production losses, managers of dairy farms can now conduct an economic evaluation of investment strategies to alleviate heat loads. These strategies include the provision of sprinklers, shade structures, or combinations of these.

National culture, infrastructure, and costs: Factors that lead to the use of wireless technologies

This research-in-progress paper utilizes the Technology Acceptance Model (TAM) to assess the effects of National Culture, Infrastructure, and Access Costs on the adoption of Wireless Technologies in Australia. The cultural dimensions emanating from the GLOBE project were chosen because of their broad coverage and contemporary nature. Australia is unique in that it has one of the lowest population densities in the world. The provision of wireless technologies is challenging in such an environment, and I believe the model developed in this research will have applicability in other similarly populated countries.

Costs and decisions in population management: Koalas on Kangaroo Island

Many populations have a negative impact on their habitat, or upon other species in the environment, if their numbers become too large. For this reason they are often managed using some form of control. The objective is to keep numbers at a sustainable level, while ensuring survival of the population.+Here we present models that allow population management programs to be assessed. Two common control regimes will be considered: reduction and suppression. Under the suppression regime the previous population is maintained close to a particular threshold through near continuous control, while under the reduction regime, control begins once the previous population reaches a certain threshold and continues until it falls below a lower pre-defined level. We discuss how to best choose the control parameters, and we provide tools that allow population managers to select reduction levels and control rates. Additional tools will be provided to assess the effect of different control regimes, in terms of population persistence and cost.In particular we consider the effects of each regime on the probability of extinction and the expected time to extinction, and compare the control methods in terms of the expected total cost of each regime over the life of the population. The usefulness of our results will be illustrated with reference to the control of a koala population inhabiting Kangaroo Island, Australia.

Monitoring the condition of savanna riparian zones in Northern Australia using high spatial resolution imagery and a field based rapid assessment method

Government agencies responsible for riparian environments are assessing the combined utility of field survey and remote sensing for mapping and monitoring indicators of riparian zone condition. The objective of this work was to compare the Tropical Rapid Appraisal of Riparian Condition (TRARC) method to a satellite image based approach. TRARC was developed for rapid assessment of the environmental condition of savanna riparian zones. The comparison assessed mapping accuracy, representativeness of TRARC assessment, cost-effectiveness, and suitability for multi-temporal analysis. Two multi-spectral QuickBird images captured in 2004 and 2005 and coincident field data covering sections of the Daly River in the Northern Territory, Australia were used in this work. Both field and image data were processed to map riparian health indicators (RHIs) including percentage canopy cover, organic litter, canopy continuity, stream bank stability, and extent of tree clearing. Spectral vegetation indices, image segmentation and supervised classification were used to produce RHI maps. QuickBird image data were used to examine if the spatial distribution of TRARC transects provided a representative sample of ground based RHI measurements. Results showed that TRARC transects were required to cover at least 3% of the study area to obtain a representative sample. The mapping accuracy and costs of the image based approach were compared to those of the ground based TRARC approach. Results proved that TRARC was more cost-effective at smaller scales (1-100km), while image based assessment becomes more feasible at regional scales (100-1000km). Finally, the ability to use both the image and field based approaches for multi-temporal analysis of RHIs was assessed. Change detection analysis demonstrated that image data can provide detailed information on gradual change, while the TRARC method was only able to identify more gross scale changes. In conclusion, results from both methods were considered to complement each other if used at appropriate spatial scales.

Comparing the conditions for small business and entrepreneurship in Sweden and Australia: Lessons for the European Charter for Small Enterprises

A growing body of literature is concerned with explaining cross-national performance of small business and entrepreneurs in advanced economies. This literature has considered a range of policy and institutional variables which create an environment supportive of small firms and entrepreneurial activities including macroeconomic variables such as taxation, labour market regulation, social security and income policy; regulatory factors such as establishment legislation, bankruptcy policy, administrative burdens, compliance costs, deregulation and competition policy; and cultural factors such as social and cultural norms that support entrepreneurship. However, this literature has not always distinguished between the policy environment of small firms operating in different industry sectors. The purpose of this paper is to examine the institutional and policy environment of small firms in knowledge intensive sectors. The characteristics of the business environment of particular relevance to knowledge intensive firms are somewhat different from the conditions for entrepreneurship and small business success more generally. This paper compares the science, technology and industry infrastructure of Australia, Denmark, Sweden with other OECD countries. The purpose of the paper is to identify cross-national differences in the business environment of small knowledge intensive firms. The paper seeks to explore whether particular institutional environments appear to be more supportive of small firms in knowledge intensive sectors.