Coupling organic substrate removal to methane production in a fully biological microbial electrolysis cell

Microbial electrolysis cells (MECs) are an innovative and emerging technique based on the use of solid-state electrodes to stimulate microbial metabolism for wastewater treatment and simultaneous production of value-added compounds (such as methane). This research studied the performance of a two-chamber MEC in terms of organic matter oxidation (at the anode) and methane production (at the cathode). MEC‟s anode had been previously inoculated with an activated sludge, whereas the cathode chamber inoculum was an anaerobic sludge (containing methanogenic microorganisms). During the experimentation, the bioanode was continuously fed with synthetic solutions in anaerobic basal medium, at an organic load rate (OLR) of around 1 g L-1 d-1, referred to the chemical oxygen demand (COD). At the beginning (Run I), the feeding solution contained acetate and subsequently (Run II) it was replaced with a more complex solution containing soluble organic compounds other than acetate. For both conditions, the anode potential was controlled at -0.1 V vs. standard hydrogen electrode, by means of a potentiostat. During Run I, over 80% of the influent acetate was anaerobically oxidized at the anode, and the resulting electric current was recovered as methane at the cathode (with a cathode capture efficiency, CCE, accounting around 115 %). The average energy efficiency of the system (i.e., the energy captured into methane relative to the electrical energy input) under these conditions was over 170%. However, reactor‟s performance decreased over time during this run. Throughout Run II, a substrate oxidation over 60% (on COD basis) was observed. The electric current produced (57% of coulombic efficiency) was also recovered as methane, with a CCE of 90%. For this run the MEC‟s average energy efficiency accounted for almost 170 %. During all the experimentation, a very low biomass growth was observed at the anode whereas ammonium was transferred through the cationic membrane and concentrated at the cathode. Tracer experiments and scanning electron microscopy analyses were also carried out to gain a deeper insight into the reactor performance and also to investigate the possible reasons for partial loss of performance. In conclusion, this research suggests the great potential of MEC to successfully treat low-strength wastewaters, with high energy efficiency and very low sludge production.

Search for H→γγ produced in association with top quarks and constraints on the Yukawa coupling between the top quark and the Higgs boson using data taken at 7 TeV and 8 TeV with the ATLAS detector

A search is performed for Higgs bosons produced in association with top quarks using the diphoton decay mode of the Higgs boson. Selection requirements are optimized separately for leptonic and fully hadronic final states from the top quark decays. The dataset used corresponds to an integrated luminosity of 4.5 fb−1 of proton--proton collisions at a center-of-mass energy of 7 TeV and 20.3 fb−1 at 8 TeV recorded by the ATLAS detector at the CERN Large Hadron Collider. No significant excess over the background prediction is observed and upper limits are set on the tt¯H production cross section. The observed exclusion upper limit at 95% confidence level is 6.7 times the predicted Standard Model cross section value. In addition, limits are set on the strength of the Yukawa coupling between the top quark and the Higgs boson, taking into account the dependence of the tt¯H and tH cross sections as well as the H→γγ branching fraction on the Yukawa coupling. Lower and upper limits at 95% confidence level are set at −1.3 and +8.0 times the Yukawa coupling strength in the Standard Model.

Evidence for the Higgs-boson Yukawa coupling to tau leptons with the ATLAS detector

Results of a search for H→ττ decays are presented, based on the full set of proton--proton collision data recorded by the ATLAS experiment at the LHC during 2011 and 2012. The data correspond to integrated luminosities of 4.5 fb−1 and 20.3 fb−1 at centre-of-mass energies of s√ = 7 TeV and s√ = 8 TeV respectively. All combinations of leptonic (τ→ℓνν¯ with ℓ=e,μ) and hadronic (τ→hadrons ν) tau decays are considered. An excess of events over the expected background from other Standard Model processes is found with an observed (expected) significance of 4.5 (3.4) standard deviations. This excess provides evidence for the direct coupling of the recently discovered Higgs boson to fermions. The measured signal strength, normalised to the Standard Model expectation, of μ=1.43+0.43−0.37 is consistent with the predicted Yukawa coupling strength in the Standard Model.

Facilitative effects of bi-hemispheric tDCS in cognitive deficits of Parkinson Disease patients

Parkinson’s disease (PD) is a progressive neurodegenerative disorder, primarily characterized by motor symptoms such as tremor, rigidity, bradykinesia, stiffness, slowness and impaired equilibrium. Although the motor symptoms have been the focus in PD, slight cognitive deficits are commonly found in non-demented and non-depressed PD patients, even in early stages of the disease, which have been linked to the subsequent development of pathological dementia. Thus, strongly reducing the quality of life (QoL). Both levodopa therapy and deep brain stimulation (DBS) have yield controversial results concerning the cognitive symptoms amelioration in PD patients. That does not seems to be the case with transcranial direct current stimulation (tDCS), although better stimulation parameters are needed. Therefore we hypothesize that simultaneously delivering cathodal tDCS (or ctDCS), over the right prefrontal cortex delivered with anodal tDCS (or atDCS) to left prefrontal cortex could be potentially beneficial for PD patients, either by mechanisms of homeostatic plasticity and by increases in the extracellular dopamine levels over the striatum.

Measurement of transverse energy-energy correlations in multi-jet events in pp collisions at s√=7 TeV using the ATLAS detector and determination of the strong coupling constant αs(mZ)

High transverse momentum jets produced in pp collisions at a centre of mass energy of 7 TeV are used to measure the transverse energy--energy correlation function and its associated azimuthal asymmetry. The data were recorded with the ATLAS detector at the LHC in the year 2011 and correspond to an integrated luminosity of 158 pb−1. The selection criteria demand the average transverse momentum of the two leading jets in an event to be larger than 250 GeV. The data at detector level are well described by Monte Carlo event generators. They are unfolded to the particle level and compared with theoretical calculations at next-to-leading-order accuracy. The agreement between data and theory is good and provides a precision test of perturbative Quantum Chromodynamics at large momentum transfers. From this comparison, the strong coupling constant given at the Z boson mass is determined to be αs(mZ)=0.1173±0.0010 (exp.) +0.0065−0.0026 (theo.).

Marcapasso bi-atrial epicárdico subxifóide na obstrução da veia cava superior

Um paciente portador de marcapasso definitivo bi-atrial-ventricular por fibrilação atrial paroxística e bradicardia sinusal, em uso crônico de anticoagulante oral, apresentou sinais clínicos da síndrome da veia cava superior. A venografia por subtração digital mostrou obstrução total do tronco braquiocefálico venoso direito e grande dificuldade de fluxo sangüíneo da veia inominada para a veia cava superior. A abordagem terapêutica constou da remoção completa do sistema transvenoso seguida de reimplante do sistema bi-atrial-ventricular por técnica epimiocárdica pela via subxifóide assistida por fluoroscopia.

Negotiating cultural values in bi-national relationships : a comparative research on children from German-Chinese families

Magdeburg, Univ., Fak. für Geistes-, Sozial- und Erziehungswiss., Diss., 2012

Cross-frequency coupling tracks motor automization and execution in the human motor system

Magdeburg, Univ., Fak. für Naturwiss., Diss., 2014

Sobre o bi-iodeto de cobre: ensaios de farmacodinamica

O Cul² prepara-se sob a forma de hidrosol cuja dosagem pode ser rigorosa. De suas propriedades quimicas já estudadas por TRAUBE é mais notavel a sensibilidade desse corpo ao oxijeno nacente. Basta em verdade 0,00001 de H²O² para que o Cul² se decomponha desprendendo-se I. Inversamente ele decompõe a agua oxijenada em solução neutra a 1 % (Perhydrol MERCK). O oxijeno do ar atmosferico só o decompõe muito lentamente. As soluções se conservam bem por 6 mezes em vidro escuro. Mesmo em 24 horas, uma corrente de ar não o altera. A ação hemolitica desse hidrosol depende principalmente da H²O distilada que entra em sua composição. Em uma solução isotonisada pelo NaCl, a ação hemolitica diminue proporcionalmente ao aumento de concentração de NaCl, ainda mesmo que se aumente a concentração em Cul². A concentração em Cul² só tem influencia manifesta sobre o fenomeno da precipitação da hemoglobina, sobre a qual ele aje como redutor. Tem ação fixadora sobre os leucocitos, e aglutinante sobre as hematias. Não destroe o fermento da fibrina nem a catalase do sangue. Precipita os albuminoides do soro, pelo menos in vitro. In vivo, esses fenomenos não são aparentes. Foi possivel a aplicação do Cul² por via venosa, sem que isso tivesse determinado acidentes nos animais experimentados (cão, cobaia, coelho, rato). Por via peritoneal não era suportado pelo coelho, nem pela cobaia, morrendo os animais dentro das primeiras 24 horas. Por via subcutanea não era tolerado facilmente por cobaias e ratos. Formava-se sempre escara no ponto da inoculação. O cão tolerava bem as inoculaçõis subcutaneas. Mostrou-se esse hidrosol ineficaz na esporotricose e tuberculose experimentais. Ao terminar, deixo aqui consignado ao distinto colega Dr. ANTONIO PINTO JNR. os meus agradecimentos pelo valioso concurso prestado em toda a parte experimental por ele acompanhada com a maior dedicação e boa vontade.

Coupling and monotonicity of queueing processes

The main purpose of this work is to give a survey of main monotonicity properties of queueing processes based on the coupling method. The literature on this topic is quite extensive, and we do not consider all aspects of this topic. Our more concrete goal is to select the most interesting basic monotonicity results and give simple and elegant proofs. Also we give a few new (or revised) proofs of a few important monotonicity properties for the queue-size and workload processes both in single-server and multi- server systems. The paper is organized as follows. In Section 1, the basic notions and results on coupling method are given. Section 2 contains known coupling results for renewal processes with focus on construction of synchronized renewal instants for a superposition of independent renewal processes. In Section 3, we present basic monotonicity results for the queue-size and workload processes. We consider both discrete-and continuous-time queueing systems with single and multi servers. Less known results on monotonicity of queueing processes with dependent service times and interarrival times are also presented. Section 4 is devoted to monotonicity of general Jackson-type queueing networks with Markovian routing. This section is based on the notable paper [17]. Finally, Section 5 contains elements of stability analysis of regenerative queues and networks, where coupling and monotonicity results play a crucial role to establish minimal suficient stability conditions. Besides, we present some new monotonicity results for tandem networks.

Screening of highly modular sugar-based ligand libraries in the enantioselective C-C coupling reactions

Projecte de recerca elaborat a partir d’una estada a la University of Nottingham, Gran Bretanya, entre març i abril del 2007. Aquest treball s’ha centrat en l’aplicació de compostos derivats de la D-(+)-glucosa, de la D-(+)-fructosa i la D-galactosa com a lligands de catalitzadors homogenis quirals en dos reaccions asimètriques: addició 1,2 a aldehids catalitzada per níquel i addició 1,4 conjugada catalitzada per coure.(veure figura adjunta al final del document). En primer lloc, s’ha estudiat l’aplicació dels compostos L1-L6 a les reaccions d’addició 1,2 a aldehids catalitzades per níquel. S’ha observat que la selectivitat del procés depèn principalment del grup funcional unit a l’esquelet del lligand, de les propietats estèriques del substituent en la funció oxazolina i de l’estructura del substrat. S’ha obtingut fins a un 59% d’excés enantiomèric utilitzant el precursor de catalitzador que conté el lligand L3a. En segon lloc, aquest treball descriu l’aplicació de les tres famílies de compostos (L1-L11) com a lligands en la reacció d’addició 1,4 catalitzada per coure de compostos organometàl•lics a diferents enones amb diferents propietats estèriques. L’ús de les llibreries de compostos fosfit-oxazolina (L1-L5) i fosfit-fosforamidit (L6) han proporcionat bones enantioselectivitats (fins a 80%) en l’addició de reactius de trialquilalumini a diferents enones. En canvi, la llibreria de compostos monofosfit (L7-L11) ha mostrat bones activitats però enantioselectivitats fins a 57%.

Responsibility for regional waste generation: A single region extended input-output analysis with uni-directional trade flows

The paper uses a regional input-output (IO) framework and data derived on waste generation by industry to examine regional accountability for waste generation. In addition to estimating a series of industry output-waste coefficients, the paper considers two methods for waste attribution but focuses first on one (trade endogenised linear attribution system (TELAS)) that permits a greater focus on private and public final consumption as the main exogenous driver of waste generation. Second, the paper uses a domestic technology assumption (DTA) to consider a regional ‘waste footprint’ where local consumption requirements are assumed to be met through domestic production.

Directional discrepancy in two dimensions

In the present paper, we study the geometric discrepancy with respect to families of rotated rectangles. The well-known extremal cases are the axis-parallel rectangles (logarithmic discrepancy) and rectangles rotated in all possible directions (polynomial discrepancy). We study several intermediate situations: lacunary sequences of directions, lacunary sets of finite order, and sets with small Minkowski dimension. In each of these cases, extensions of a lemma due to Davenport allow us to construct appropriate rotations of the integer lattice which yield small discrepancy.

A Schoenflies extension theorem for a class of locally bi-Lipschitz homeomorphisms

"Vegeu el resum a l'inici del document del fitxer adjunt."