Origins of Australian Football: Victoria's Early History. Volume 1 Amateur Heroes and the Rise of the Clubs, 1858 to 1876

This is volume 1 in a series of four volumes about the origins of Australian football as it evolved in Victoria between 1858 and 1896. This volume addresses its very beginnings as an amateur sport and the rise of the first clubs. Invented by a group of Melbourne cricketers and sports enthusiasts, Australian Rules football was developed through games played on Melbourne's park lands and was originally known as "Melbourne Football Club Rules". This formative period of the game saw the birth of the first 'amateur heroes' of the game. Players such as T.W. Wills, H.C.A. Harrison, Jack Conway, George O'Mullane and Robert Murray Smith emerged as warriors engaged in individual rugby-type scrimmages. The introduction of Challenge Cups was an important spur for this burgeoning sport. Intense competition and growing rivalries between clubs such as Melbourne, South Yarra, Royal Park, and Geelong began to flourish and the game developed as a result. By the 1870s the game "Victorian Rules" had become the most popular outdoor winter sport across the state. In subsequent decades, rapid growth in club football occurred and the game attracted increasing media attention.

Faculty mentoring, evidence-based assessment, and student learning : an Australian exploration of American initiatives

There have been many improvements in Australian engineering education since the 1990s. However, given the recent drive for assuring the achievement of identified academic standards, more progress needs to be made, particularly in the area of evidence-based assessment. This paper reports on initiatives gathered from the literature and engineering academics in the USA, through an Australian National Teaching Fellowship program. The program aims to establish a process to help academics in designing and implementing evidence-based assessments that meet the needs of not only students and the staff that teach them, but also industry as well as accreditation bodies. The paper also examines the kinds and levels of support necessary for engineering academics, especially early career ones, to help meet the expectations of the current drive for assured quality and standards of both research and teaching. Academics are experiencing competing demands on their time and energy with very high expectations in research performance and increased teaching responsibilities, although many are researchers who have not had much pedagogic training. Based on the literature and investigation of relevant initiatives in the USA, we conducted interviews with several identified experts and change agents who have wrought effective academic cultural change within their institutions and beyond. These reveal that assuring the standards and quality of student learning outcomes through evidence-based assessments cannot be appropriately addressed without also addressing the issue of pedagogic training for academic staff. To be sustainable, such training needs to be complemented by a culture of on-going mentoring support from senior academics, formalised through the university administration, so that mentors are afforded resources, time, and appropriate recognition.

The Corio Oval Tribe : a prosopographical perspective of the Geelong Football Club in the nineteenth century

This article analyses the occupational and class status of Geelong footballers in the nineteenth century via the methodology of prosopography. Prosopography is an empirical group biography approach to historical research. The article argues that during the period 1859-78 Geelong's playing group was largely derived from the squattocracy and urban middle class. In the later period 1878-96 the Geelong club recruited more widely from the working class, as in keeping with the increased participation of this class in football from the late 1870s. It can be argued that this more diverse group helped establish Geelong as a footballing power.

Re-melting of Bi-2212/Ag laminated tapes by partial melting process

Bi-2212 tapes are prepared by a combination of dip-coating and partial melt processing. We investigate the effect of re-melting of those tapes by partial melting followed by slow cooling on the structure and superconducting properties. Microstructural studies of re-melted samples show that they have the same overall composition as partially melted tapes. However, the fractional volumes of the secondary phases differ and the amounts and distribution of the secondary phases have a significant effect on the critical current. Critical current of Bi-2212/Ag tapes strongly depends on the maximum processing temperature. Initial J(c)'s of the tapes, which are partially melted, then slowly solidified at optimum conditions and finally post-annealed in an inert atmosphere, are up to 10.4 x 10(3) A/cm(2). It is found that the maximum processing temperature at initial partial melting has an influence on the optimum re-heat treatment conditions for the tapes. Re-melted tapes processed at optimum conditions recover superconducting properties after post-annealing in an inert atmosphere: the J(c) values of the tapes are about 80-110% of initial J(c)'s of those tapes.

Bi-2212/Ag laminated tapes: Bending and joining effects

Superconducting composite Bi-2212/Ag tapes and their joints are fabricated by a combination of dip-coating and partial melt processing. The heat treated tapes have a critical current (Ic) between 8 and 26A, depending on tape thickness and the number of Bi-2212 layers. Current transmissions between 80% and 100% have been achieved through the joints of tapes. Different types of HTS joints of Bi-2212/Ag laminated tapes are made and their transport properties during winding operations are investigated. Irreversible strain values (ε irrev) for laminated tapes and their joints are determined and it is found that the degradation of Ic during tape bending depends on the type of joint.

Superconducting joints of Bi-2212/Ag tapes and laminates

Different types of HTS joints of Bi-2212/Ag tapes and laminates, which are fabricated by dip-coating and partial-melt processes, have been investigated. All joints are prepared using green single and laminated tapes and according to the scheme: coating-joining-processing. The heat treated tapes have critical current (Ic) between 7 and 27 A, depending on tape thickness and the number of Bi-2212 ceramic layers in laminated tapes. It is found that the current transport properties of joints depend on the type of laminate, joint configuration and joint treatment, Ic losses in joints of Bi-2212 tapes and laminates are attributed to defects in their structure, such as pores, secondary phases and misalignment of Bi-2212 grains near the Ag edges. By optimizing joint configuration, current transmission up to 100% is achieved for both single tapes and laminated tapes.

Bi-2212/Ag tapes and laminates : effects of bending

Superconducting Bi-2212 tapes and laminates are fabricated by a combination of dip-coating and partial melt processing. The heat treated tapes have critical current densities (Jc) up to 11 kAcm -2. We investigate the degradation of critical current (Ic) during bending experiments for both single tapes and tapes with laminate structure. Although degradation of Ic is observed in both forms, the characteristics of the degradation differ. It is determined that laminated tapes perform better than single tapes when critical current is measured against bending radius, and laminated tapes tolerate a higher strain for a given reduction in critical current. It is found that increasing the number of Bi-2212 layers increases the total Ic of the laminated tape, but degradation of critical current is more pronounced during bending because of the increased total thickness of the laminate structure. It is also found that addition of silver to the Bi-2212 layers reduces critical current degradation during bending for both tapes and laminates.

Pore structure characterization of North American shale gas reservoirs using USANS/SANS, gas adsorption, and mercury intrusion

Small-angle and ultra-small-angle neutron scattering (SANS and USANS), low-pressure adsorption (N2 and CO2), and high-pressure mercury intrusion measurements were performed on a suite of North American shale reservoir samples providing the first ever comparison of all these techniques for characterizing the complex pore structure of shales. The techniques were used to gain insight into the nature of the pore structure including pore geometry, pore size distribution and accessible versus inaccessible porosity. Reservoir samples for analysis were taken from currently-active shale gas plays including the Barnett, Marcellus, Haynesville, Eagle Ford, Woodford, Muskwa, and Duvernay shales. Low-pressure adsorption revealed strong differences in BET surface area and pore volumes for the sample suite, consistent with variability in composition of the samples. The combination of CO2 and N2 adsorption data allowed pore size distributions to be created for micro–meso–macroporosity up to a limit of �1000 Å. Pore size distributions are either uni- or multi-modal. The adsorption-derived pore size distributions for some samples are inconsistent with mercury intrusion data, likely owing to a combination of grain compression during high-pressure intrusion, and the fact that mercury intrusion yields information about pore throat rather than pore body distributions. SANS/USANS scattering data indicate a fractal geometry (power-law scattering) for a wide range of pore sizes and provide evidence that nanometer-scale spatial ordering occurs in lower mesopore–micropore range for some samples, which may be associated with inter-layer spacing in clay minerals. SANS/USANS pore radius distributions were converted to pore volume distributions for direct comparison with adsorption data. For the overlap region between the two methods, the agreement is quite good. Accessible porosity in the pore size (radius) range 5 nm–10 lm was determined for a Barnett shale sample using the contrast matching method with pressurized deuterated methane fluid. The results demonstrate that accessible porosity is pore-size dependent.

Effects of a defender on run-up velocity and ball speed when crossing a football

This study evaluated effects of defensive pressure on running velocity in footballers during the approach to kick a stationary football. Approach velocity and ball speed/accuracy data were recorded from eight football youth academy participants (15.25, SD=0.46 yrs). Participants were required to run to a football to cross it to a receiver to score against a goal-keeper. Defensive pressure was manipulated across three counterbalanced conditions: defender-absent (DA); defender-far (DF) and defender-near (DN). Pass accuracy (percentages of a total of 32 trials with 95% confidence limits in parenthesis) did not significantly reduce under changing defensive pressure: DA, 78% (55–100%); DF, 78% (61–96%); DN, 59% (40–79%). Ball speed (m·s−1) significantly reduced as defensive pressure was included and increased: DA, 23.10 (22.38–23.83); DF, 20.40 (19.69–21.11); DN, 19.22 (18.51–19.93). When defensive pressure was introduced, average running velocity of attackers did not change significantly: DA versus DF (m·s−1), 5.40 (5.30–5.51) versus 5.41 (5.34–5.48). Scaling defender starting positions closer to the start position of the attacker (DN) significantly increased average running velocity relative to the DA and DF conditions, 5.60 (5.50–5.71). In the final approach footfalls, all conditions significantly differed: DA, 5.69 (5.35–6.03); DF, 6 .22 (5.93–6.50); DN, 6.52 (6.23–6.80). Data suggested that approach velocity is constrained by both presence and initial distance of the defender during task performance. Implications are that the expression of kicking behaviour is specific to a performance context and some movement regulation features will not emerge unless a defender is present as a task constraint in practice.

Not just another ball game : young adult and adult football fictions are different

Current media attention on the crossover novel highlights the increasing permeability of the boundaries between young adult and adult fiction. This paper will focus upon some of the difficulties around definitions of young adult fiction before considering the fiction of football, or soccer as it is more commonly known in Australia. The football genre exhibits a number of discrete and identifiable differences between young adult and adult readerships including, for example, the role of the protagonist, and the narrative’s distance from the game. This paper will use Franco Moretti’s Mapping as Distant Reading model of abstraction to highlight and unpack these and other characteristic differences in the narratological and stylistic techniques employed across adult and young adult texts. Close reading analysis of the adult football fiction Striker (1992) by Hunter Davies and young adult football fiction Lucy Zeezou’s Goal (2008) by Liz Deep-Jones’ will further illustrate the range of tensions and divergences as they are reflected across those readerships. The texts have been selected because they speak to themes of fear and safety; Joe Swift (Striker) is driven by a need to move away from childhood poverty and insecurity, while Lucy Zeezou shelters a homeless friend. With both protagonists being kidnapped for ransom for example, the texts have also been selected for their striking similarities in form and content.

Carnivore : an investigation into the ways that serial killers in the Silence of the Lambs, American Psycho and Darkly Dreaming Dexter are representative of consumers

Serial killers are among the most popular and enduring character types in contemporary culture. In this exegesis I investigate one of the reasons for this popularity by examining the representational relationships between serial killers and serial consumers. I initially establish that all monsters, whether they are vampires, werewolves or serial killers, emerge from cultural anxieties and signify the anxiety which gave them birth. I go on to identify that the cultural anxiety at play with serial killers is consumerism and in doing so, I identify two key parallels between the serial killer and the consumer, namely a sense of lack and a desire for transformation. I then examine the ways in which the serial killer is representative of the consumer in three exemplar texts, The Silence of the Lambs by Thomas Harris, American Psycho by Bret Easton Ellis and Darkly Dreaming Dexter by Jeff Lindsay. I go on to self-reflexively examine the creation of my novel Carnivore, the accompanying draft of which has been influenced by both the exemplar texts and the findings of the exegesis.