Geochemistry of vein rocks of ODP Hole 118-735B

Rock samples from Hole 735B, Southwest Indian Ridge, were examined to determine the principal vein-related types of alteration that occurred, the nature of fluids that were present, and the temperatures and pressures of these fluids. Samples studied included veined metagabbro, veined mylonitic metagabbro, felsic trondhjemite, and late-stage leucocratic diopside-bearing veins. The methods used were standard petrographic analysis, mineral chemical analysis by electron microprobe, fluid inclusion petrography and analysis by heating/freezing techniques and laser Raman microspectroscopy, and oxygen isotopic analyses of mineral separates. Alteration in lithologic Units I and II (above the level of Core 118-735B-3OR; approximately 140 meters below the seafloor) is dominated by hydration by seawater-derived fluids at high temperature, up to about 700°C, and low water/rock ratio, during and immediately after pervasive ductile deformation. Below Core 118-735B-30R, pervasive deformation is less common, and brittle veining and brecciation are the major alteration styles. Leucocratic centimeter-scale veins, often containing diopside and plagioclase, were produced by interaction of hot (about 500°C) seawater-derived fluid and gabbro. The water/rock ratio was locally high at the veins and breccia zones, but the integrated water/rock ratio for the lower part of the hole is probably low. Accessory hydrous magmatic or deuteric phases formed from magmatic volatiles in some gabbro and in trondhjemite. Most subsequent alteration was affected by fluids that were seawater-derived, based on isotopic and chemical analyses of minerals and analyses of fluid inclusions. Many early-generation fluid inclusions, associated with high-temperature veining, contain appreciable methane as well as saline water. The source of methane is unclear, but it may have formed as seawater was reduced during low water/rock interaction with ultramafic upper mantle or ultramafic and mafic layer 3. Temperatures of alteration were calculated on the basis of coexisting mineral chemistry and isotopic values. Hydrothermal metamorphism commenced at about 720°C and continued to about 550°C. Leucocratic veining took place at about 500°C. Alteration within brecciated horizons was also at about 500° to less than 400°C, and the trondhjemite was altered at about 550° to below 490°C. Pressures calculated from a diopside-bearing vein, based on a combination of fluid inclusion and isotopic analysis, were 90 to 100 MPa. This pressure places the sample, from Core 118-735B-70R in Unit V, at about 2 km below the seafloor.

Organic carbon analyses of ODP Site 160-971 in the Mediterranean Sea

Mud volcanism on the Mediterranean Ridge is caused by extrusion of overpressured sediments, with consequent formation of spectacular dome-shaped features composed of mud breccias at the seafloor. The organic material in the mud breccia of the Napoli mud volcano is a mixture of different facies, stratigraphic origin and thermal maturities. One portion is synsedimentary organic material with only minor diagenetic alterations and represents sedimenting material that was embedded into the mud volcano during its extrusion. The mud breccia also contains thermally mature organic material of mainly terrestrial provenance with algae of fresh- and brackish-water origin. Vitrinite reflectance data of this maturity generation range from 0.65 to 0.90% R(oil) and thus characterize thermally mature source rocks, a rank which is corroborated by fluorescence and molecular characteristics. The predominance of vitrinite in the maceral assemblages and the occurrence of biomarkers of terrigenous origin suggest that the major part of the mud matrix derives from a lacustrine or riverine sedimentary unit in the subsurface, possibly from the Messinian stage. A third generation of organic material includes inertinites and vitrinites of high reflectance, which represent recycled organic matter present in any marine sediment. By use of the Lopatin method for modelling the thermal maturation of hydrocarbon source rocks from the vitrinite reflectance data, we calculated that the depth of mobilization ranges from 4900 m to 7500 m, depending upon the temperature gradient used.

Geochemistry of peridotites from ODP Leg 125 diapiric serpentinites

Refractory spinel peridotites were drilled during Leg 125 from two diapiric serpentinite seamounts: Conical Seamount in the Mariana forearc (Sites 778-780) and Torishima Forearc Seamount (Sites 783-784) in the Izu-Ogasawara forearc. Harzburgite is the predominant rock type in the recovered samples, with subordinate dunite; no lherzolite was found. The harzburgite is diopside-free to sparsely diopside-bearing, with modal percentages of diopside that range from 0% to 2%. Spinels in the harzburgites are chrome-rich (Cr/[Cr + Al] = 0.38-0.83; Fe3+/[Fe3+ + Cr + Al] = 0.01-0.07). Olivine and orthopyroxene are magnesian (Mg# = 0.92). Discrete diopsides reveal extreme depletion of light rare earth elements. Primary hornblende is rare. The bulk major-element chemistry shows low average values of TiO2 (trace), Al2O3 (0.55%) and CaO (0.60%), but high Mg# (0.90). These rocks are more depleted than the abyssal peridotites from the mid-oceanic ridge. They are interpreted as residues of extensive partial melting (= 30%), of which the last episode was in the mantle wedge, probably associated with the generation of incipient island-arc magma, including boninite and/or arc-tholeiite. These depleted peridotites probably represent the residues of melting within mantle diapirs that developed within the mantle wedge.

Sulphate and d34S in pore waters and d13C, d18O and mineral composition of carbonate nodules from ODP Leg 188 sites

Carbon and oxygen isotopic compositions of authigenic carbonate nodules or layers reflect the diagenetic conditions at the time of nodule growth. The shallowest samples of carbonate nodules and dissolved inorganic carbon of pore water samples beneath the sulfate reduction zone (0-160 meters below seafloor [mbsf]) at Site 1165 have extremely negative d13C values (-50 per mil and -62 per mil, respectively). These negative d13C values indicate nodule formation in association with anaerobic methane oxidation coupled with sulfate reduction. The 34S of residual sulfate at Site 1165 shows only minor 34S enrichment (+6 per mil), even with complete sulfate reduction. This small degree of apparent 34S enrichment is due to extreme "open-system" sulfate reduction, with sulfate abundantly resupplied by diffusion from overlying seawater. Ten calcite nodules from Site 1165 contain minor quartz and feldspar and have d13C values ranging from -49.7 per mil to -8.2 per mil. The nodules with the most negative d13C values currently are at depths of 273 to 350 mbsf and must have precipitated from carbonate largely derived from subsurface anaerobic methane oxidation. The processes of sulfate reduction coupled with methane oxidation in sediments of Hole 1165B are indicated by characteristic concentration and isotopic (d34S and d13C) profiles of dissolved sulfate and bicarbonate. Three siderite nodules from Site 1166 contain feldspar and mica and one has significant carbonate-apatite. The siderite has d13C values ranging from -15.3 per mil to -7.6 per mil. These siderite nodules probably represent early diagenetic carbonate precipitation during microbial methanogenesis.

Chemistry of serpentinized peridotites from ODP Hole 109-670A

In this paper we describe textural relationships in hydrated upper mantle peridotites emplaced at a nonconstructive ridge segment. Development of serpentinites and partially serpentinized peridotites takes place in four main stages: (1) pervasive serpentinization forming mainly lizardite, (2) a tensional stage forming chrysotile + talc + chlorite, (3) a deformational stage forming antigorite + tremolite, and (4) a late local tensional stage forming another generation of chrysotile veinlets. Mineral chemistry of serpentine pseudomorphs reflects in part primary mineral compositions. Olivine pseudomorphs are typically nickeliferous and depleted in aluminum and chromium. Orthopyroxene pseudomorphs have lower nickel contents and relatively high iron, aluminum, and chromium contents. Clinopyroxene pseudomorphs have very low nickel contents and relatively high aluminum and chromium contents. These chemical patterns in the serpentinites can be used to help discriminate between harzburgitic and lherzolitic protoliths. Oxygen isotopes and mineral parageneses suggest serpentine is derived from circulation of hydrothermal (200?C) fluids through the peridotite body. Crystallization of tremolite, talc, and chlorite may have occurred at temperatures up to 525?C if C02/H20 ratios were less than 0.25. Open fissures developing in aging upper mantle provide paths for important seawater circulation through a thin basaltic carapace down to shallow mantle rocks.

Pore water geochemistry of ODP Hole 169-1037B and Site 196-1038

Data were presented to compare pore fluids from Sites 1037 and 1038 in the Escanaba Trough, Gorda Ridge. Site 1037 constitutes the reference site, and Site 1038 is the hydrothermally affected site. The program was undertaken for two purposes: (1) to make a detailed analysis of the halide chemistry of these two sites, with the specific aim of discerning any potential differences in the generation of dissolved halides as a result of sediment diagenesis in these drill sites and (2) to investigate the geochemistry of Ba2+ and Mn2+ at these two sites to discover potential hydrothermal effects reflected in the concentration-depth distributions of these elements.

(Table 6) Selenium isotopic composition of sediment samples from ODP Site 185-1149

Multiple-collector inductively coupled plasma mass spectrometry has been used for the precise measurement of the isotopic composition of Se in geological samples. Se is chemically purified before analysis by using cotton impregnated with thioglycollic acid. This preconcentration step is required for the removal of matrix-interfering elements for hydride generation, such as transitional metals, and also for the quantitative separation of other hydride-forming elements, such as Ge, Sb, and As. The analyte is introduced in the plasma torch with a continuous-flow hydride generation system. Instrumental mass fractionation is corrected with a "standard-sample bracketing" approach. By use of this new technique, the minimum Se required per analysis is lowered to 10 ng, which is one order of magnitude less than the amount needed for the N-TIMS technique. The estimated external precision calculated for the 82Se/76Se isotope ratio is 0.25? (2 sigma), and the data are reported as delta notation (?) relative to our internal standard (MERCK elemental standard solution). Measurements of Se isotopes are presented for samples of standard solutions and geological reference materials, such as silicate rocks, soils, and sediments. The Se isotopic composition of selected terrestrial and extraterrestrial materials are also presented. An overall Se isotope variation of 8? has been observed, suggesting that Se isotopes fractionate readily and are extremely useful tracers of natural processes.