Comparison between weight loss of bends in a pneumatic conveyor and erosion rate obtained in a centrifugal erosion tester for the same materials

In order to find a link between results obtained from a laboratory erosion tester and tests carried out on a pneumatic conveyor, a comparison has been made between weight loss from bends on an industrial-scale pneumatic conveyor and erosion rates obtained in a small centrifugal erosion tester, for the same materials. Identical test conditions have been applied to both experiments so that comparable test results have been obtained. The erosion rate of mild steel commonly used as the wall material of conveyor pipes and pipe bends was determined individually on both test rigs. A relationship between weight loss from the bends and erosion rate determined from the tester has been developed. A discussion based on the results and their applicability to the prediction of wear in pneumatic conveyors concludes the paper. © 2004 Elsevier B.V. All rights reserved.

The Stability of a Vertical Single-Walled Carbon Nanotube Under Its Own Weight

It has been reported recently that single carbon nanotubes were attached to AFM tips to act as nanotweezers. In order to investigate its stability, a vertical single-walled carbon nanotube (SWCNT) under its own weight is studied in this paper. The lower end of the carbon nanotube is clamped. Firstly the governing dimensionless numbers are derived by dimensional analysis. Then the theoretical analysis based on an elastic column model is carried out. Two ratios, I.e., the ratio of half wall thickness to radius (t=R) and the ratio of gravity to elastic resilience ($\rho$gR=E), and their influences on the ratio of critical length to radius are discussed. It is found that the relationship between the critical ratio of altitude to radius and ratio of half thickness to radius is approximately linear. As the dimensionless number $\rho$gR=E increases, the compressive force per unit length (weight) becomes larger, thus critical ratio of altitude to radius must become smaller to maintain stability. At last the critical length of SWCNT is calculated. The results of this paper will be helpful for the stability design of nanotweezers-like nanostructures.

Semi-weight function method on computation of stress intensity factors in dissimilar materials

Semi-weight function method is developed to solve the plane problem of two bonded dissimilar materials containing a crack along the bond. From equilibrium equation, stress and strain relationship, conditions of continuity across interface and free crack surface, the stress and displacement fields were obtained. The eigenvalue of these fields is lambda. Semi-weight functions were obtained as virtual displacement and stress fields with eigenvalue-lambda. Integral expression of fracture parameters, K-I and K-II, were obtained from reciprocal work theorem with semi-weight functions and approximate displacement and stress values on any integral path around crack tip. The calculation results of applications show that the semi-weight function method is a simple, convenient and high precision calculation method.

A Study of the Tribological Behavior of Carbon-Nanotube-Reinforced Ultrahigh Molecular Weight Polyethylene Composites

The tribological properties of the high-strength and high-modulus ultrahigh molecular weight polyethylene (UHMWPE) film and the UHMWPE composites reinforced by multiwalled carbon nanotubes (MWCNT/UHMWPE) were investigated using a nanoindenter and atomic force microscope (AFM). The MWCNT/UHMWPE composites films exhibited not only high wear resistance but also a low friction coefficient compared to the pure UHMWPE films. We attribute the high wear resistance to the formation of the new microstructure in the composites due to the addition of MWCNTs.

Seasonal foods, gonadal maturation, and length-weight relationships for nine fishes commonly captured by shrimp trawl on the Northwest Gulf of Mexico Continental Shelf

Recent emphasis on ecosystem approaches to fisheries management renews interest in, and the need for, trophic information about fish communities. A program was started in 1980 at the National Marine Fisheries Service Galveston Laboratory to develop a trophic database for continental shelf fishes. Collections were made during 1982-1983 that were processed but never published, yet the data remain valid today for historical purposes and for delimiting food web components within ecosystem assessments. I examined spring, summer, and fall foods in offshore populations of nine common species of trawl-susceptible fishes, with particular reference to predation on commercial penaeid shrimps (Farfantepenaeus and Litopenaeus). Diets were evaluated with the Index of Relative Importance (IRI) which combines the occurrence, number, and weight of each food item. Bank sea bass (Centropristis ocyurus) and bighead searobin (Prionotus tribulus) primarily consumed crabs, more so by larger than smaller fish. Inshore lizardfish (Synodus foetens) was almost entirely piscivorous. Ocellated flounder (Ancylopsetta ommata) consumed fishes, crabs, and stomatopods. Dwarf sand perch (Diplectrum bivittatum), blackwing searobin (Prionotus rubio), rock sea bass (Centropristis philadelphica), southern kingfish (Menticirrhus americanus), and red snapper (Lutjanus campechanus) fed mainly on shrimps. Most fish diets varied with respect to size (age), time of day, area sampled, depth, or season. Rimapenaeus and Sicyonia were the most frequently identified shrimp genera - only five Farfantepenaeus and no Litopenaeus were identified in almost 4,300 fish stomachs. I also examined gonadal development and documented fish length-weight relationships. Ripe gonads were most frequently found during summer in dwarf sand perch, during fall in ocellated flounder and bighead searobin, and during spring for other species, except no ripe red snapper or bank sea bass were collected. Rock sea bass was found to be a protogynous hermaphrodite, while dwarf sand perch is a synchronous hermaphrodite. Only ocellated flounder and southern kingfish exhibited sex-related differences in length-weight relationships. (PDF contains 40 pages.)

High-Throughput Sequencing of microRNAs in Peripheral Blood Mononuclear Cells: Identification of Potential Weight Loss Biomarkers

INTRODUCTION: MicroRNAs (miRNAs) are being increasingly studied in relation to energy metabolism and body composition homeostasis. Indeed, the quantitative analysis of miRNAs expression in different adiposity conditions may contribute to understand the intimate mechanisms participating in body weight control and to find new biomarkers with diagnostic or prognostic value in obesity management. OBJECTIVE: The aim of this study was the search for miRNAs in blood cells whose expression could be used as prognostic biomarkers of weight loss. METHODS: Ten Caucasian obese women were selected among the participants in a weight-loss trial that consisted in following an energy-restricted treatment. Weight loss was considered unsuccessful when <5% of initial body weight (non-responders) and successful when >5% (responders). At baseline, total miRNA isolated from peripheral blood mononuclear cells (PBMC) was sequenced with SOLiD v4. The miRNA sequencing data were validated by RT-PCR. RESULTS: Differential baseline expression of several miRNAs was found between responders and non-responders. Two miRNAs were up-regulated in the non-responder group (mir-935 and mir-4772) and three others were down-regulated (mir-223, mir-224 and mir-376b). Both mir-935 and mir-4772 showed relevant associations with the magnitude of weight loss, although the expression of other transcripts (mir-874, mir-199b, mir-766, mir-589 and mir-148b) also correlated with weight loss. CONCLUSIONS: This research addresses the use of high-throughput sequencing technologies in the search for miRNA expression biomarkers in obesity, by determining the miRNA transcriptome of PBMC. Basal expression of different miRNAs, particularly mir-935 and mir-4772, could be prognostic biomarkers and may forecast the response to a hypocaloric diet.

Additional information on the length-weight relationship of skipjack tuna from the Eastern Tropical Pacific Ocean

ENGLISH: Results of a study of the length-weight relationships of yellowfin (Neothunnus macropterus) and skipjack (Katsuwonus pelamis) tuna from several fishing areas of the Eastern Tropical Pacific Ocean have been published by Chatwin (1959). In that report, a very low exponential value of 2.6261 was obtained for skipjack from Area 14 (off northern Chile, see Chatwin, Figure 1). It was pointed out, however, that this estimate was based on two samples of fish with a very narrow range of total lengths, not representative of the range in the catch, and that it would be desirable to obtain a further estimate based on a larger range of total lengths. In addition, there proved to be significantly large differences among exponents for the areas sampled, precluding use of a single regression equation for all areas. Two important fishing areas remained unsampled (Areas 10 and 13, see Chatwin, Figure 1), and it appeared desirable to collect length-weight measurement data from them, so that estimating equations would be available for all areas. Subsequent to publication of Chatwin's study, samples of skipjack length-weight measurements were obtained from the desired areas. Estimates derived from these data, and their effects on the previous analysis are presented herein. SPANISH:Los resultados de un estudio sobre las relaciones entre la longitud y el peso del atún aleta amarilla (Neothunnus macropterus) y del barrilete (Katsuwonus pelamis) de las diferentes áreas de pesca en el Pacífico Oriental Tropical ya han sido publicados por Chatwin (1959). En ese informe se obtuvo un valor exponencial muy bajo de 2.626 para el barrilete del Area 14 (frente a la costa norte de Chile, ver Chatwin, Figura 1). Se hizo hincapié, sin embargo, en que esta estimación se basaba en dos muestras de peces con una amplitud muy estrecha de longitudes totales, no representativa de la amplitud en la pesca, y que sería deseable obtener una estimación adicional basada en una amplitud mayor de longitudes totales. Además, se comprobó que habian diferencias significativamente grandes entre los exponentes de las áreas muestreadas lo que impedía el usa de una sola ecuación de regresión para todas las áreas. Se quedaron sin muestrear dos importantes áreas de pesca (Areas 10 y 13, ver Chatwin, Figura 1) y pareció deseable recolectar datos de medidas de longitud y peso de estas áreas, de tal manera que hubiesen disponibles ecuaciones estimadoras para todas las áreas. Después de la publicación del estudio de Chatwin, so obtuvieron muestras de medidas de longitud y peso de barriletes de las áreas deseadas. Las estimaciones derivadas de estos datos y sus efectos sabre el análisis previo se dan en el presente informe.

The relationships between length and weight of yellowfin tuna (Neothunnus macropterus) and skipjack tuna (Katsuwonus pelamis) from the Eastern Tropical Pacific Ocean

ENGLISH: The purposes of the Convention which established the Inter-American Tropical Tuna Commission have been discussed in the Commission's Annual Report for 1950-51 (Schaefer, 1952) and in subsequent Annual Reports. One of its functions is to gather and report on biological information for the tunas of the Eastern Tropical Pacific, the yellowfin tuna (Neothunnus macropterus) and skipjack tuna (Katsuwonus pelamis). This report gives the results of a study of the relationships between the length and the weight of individuals of each of these species, derived from samples of fish of commercial sizes captured during the course of regular fishing operations in several areas of the Eastern Tropical Pacific Ocean SPANISH: Los propósitos de la Convención que estableció la Comisión Interamericana del Atún Tropical han sido expuestos en el Informe Anual de dicho organismo correspondiente a 1950-51 (Schaefer, 1952), y en los siguientes informes anuales. Una de sus funciones es la de recoger información biológica sobre los atunes del Pacífico Oriental Tropical, es decir, el aleta amarilla (Neothunnus macropterus) y el barrilete (Katsuwonus pelamis) y darla a conocer a las partes interesadas. El presente trabajo informativo proporciona los resultados de un estudio de las relaciones entre la longitud y el peso tomados en individuos de cada una de estas especies, mediante muestreo en pescados de tamaños comerciales capturados en el curso de operaciones regulares de pesca, en diversas área del Océano Pacífico Oriental Tropical.

Length-weight relationships of the anchoveta, Cetengraulis mysticetus, in the Gulf of Panama

ENGLISH: Knowledge of the length-frequency distribution and the length-weight relationships of the anchoveta is essential for converting the catch statistics of that species from pounds to numbers of fish. Such conversions are necessary for various types of investigations, especially those involving estimation of the population size and mortality rates. The analysis of the results of a recent tagging program conducted with anchovetas in the Gulf of Panama (Bayliff, 1965) requires that such conversions be made. Length-frequency data for the anchoveta have already been collected and published (Howard and Landa, 1958; Bayliff, 1964). The present report deals with length-weight data from fish collected in various .areas of the Gulf of Panama in all months of the year and in several different years. Opportunity is thus afforded to compare the length-weight relationships of fish of different year classes in different areas, months, and years. SPANISH: El conocimiento de la distribución de la frecuencia de longitud y de las relaciones entre la longitud y el peso de la anchoveta es esencial en las estadísticas de captura de esta especie para la conversión de peso en libras a número de peces. Estas conversiones son necesarias para varios tipos de investigación, especialmente las que se refieren a la estimación del tamaño de la población y de las tasas de mortalidad. Estas conversiones se requieren para analizar los resultados de un programa reciente de marcación de anchovetas en el Golfo de Panamá (Bayliff, 1965). Los datos de la frecuencia de longitud de la anchoveta ya han sido recolectados y publicados (Howard y Landa, 1958; Bayliff, 1964). El presente informe trata de los datos de longitud y peso de los peces recolectados en varias áreas del Golfo de Panamá durante todos los meses del año y durante varios años. Esto ofrece la oportunidad de comparar las relaciones entre la longitud y el peso de peces pertenecientes a varias clases anuales en áreas, meses y años diferentes.

Influences of Structural Damping and Buoyancy-Weight Ratio on Dynamic Responses of Submerged Floating Tunnel

The recent progress of submerged floating tunnel (SFT) investigation and SFT prototype (SFTP) project in Qiandao Lake (Zhejiang Province, P.R. China) is the background of this research. Structural damping effect is brought into present computation model in terms of Rayleigh damping. Based on the FEM computational results of SFTPs as a function of buoyancy-weight ratio (BWR) under hydrodynamic loads, the effect of BWR on the dynamic response of SFT is illustrated. In addition, human comfort index is adopted to discuss the comfort status of the SFTP.

Length-weight relationship and the diets of Clarias lazera (Cuvier and Valenciennes), family Clariidae (Osteichthyes: Siluriformes) in Zaria, Nigeria

The length-weight relationship and the diets of Clarias lazera were investigated between July 1981 and June 1982. About 450 specimens were examined. The standard lengths of the fish ranged from 8.5 cm to 42.2 cm. Significant differences were found between the standard lengths of the males and females with the latter slightly shorter. Somatic weights varied between 10 g to 502 g. Length-weight regression analysis gave a "b" value of 3.02 for both males and females combined; thus indicating an isometric growth. Analysis of the food in the stomachs showed that the fish is an omnivore although, it fed more on insects and fish than other food items