伊乐藻对Cu Cd污染底泥修复的应用研究

在自然条件下,采用人工模拟水缸培养方法,研究了湖泊底泥不同Cu、Cd处理对沉水植物伊乐藻生长、叶绿素含量以及Cu、Cd吸收和积累的影响。结果表明,较低浓度Cu刺激伊乐藻的生长(生物量、叶绿素),高浓度抑制伊乐藻的生长;随着Cd处理浓度的增加,伊乐藻的生物量、叶绿素含量均一直降低,在底泥Cd含量为168.69mg·kg-1DW(含背景值)时,植株出现死亡。随着Cu处理浓度的增加,伊乐藻体内的Cu含量一直增加,在底泥Cu含量为414mg·kg-1DW(含背景值)时,根部、叶部的富集系数均达到最大(0.21和0

The parameter space of graphene chemical vapor deposition on polycrystalline Cu

A systematic study of the parameter space of graphene chemical vapor deposition (CVD) on polycrystalline Cu foils is presented, aiming at a more fundamental process rationale in particular regarding the choice of carbon precursor and mitigation of Cu sublimation. CH 4 as precursor requires H 2 dilution and temperatures ≥1000 °C to keep the Cu surface reduced and yield a high-quality, complete monolayer graphene coverage. The H 2 atmosphere etches as-grown graphene; hence, maintaining a balanced CH 4/H 2 ratio is critical. Such balance is more easily achieved at low-pressure conditions, at which however Cu sublimation reaches deleterious levels. In contrast, C 6H 6 as precursor requires no reactive diluent and consistently gives similar graphene quality at 100-150 °C lower temperatures. The lower process temperature and more robust processing conditions allow the problem of Cu sublimation to be effectively addressed. Graphene formation is not inherently self-limited to a monolayer for any of the precursors. Rather, the higher the supplied carbon chemical potential, the higher the likelihood of film inhomogeneity and primary and secondary multilayer graphene nucleation. For the latter, domain boundaries of the inherently polycrystalline CVD graphene offer pathways for a continued carbon supply to the catalyst. Graphene formation is significantly affected by the Cu crystallography; i.e., the evolution of microstructure and texture of the catalyst template form an integral part of the CVD process. © 2012 American Chemical Society.

The influence of a grain boundary on the thermal transport properties of bulk, melt-processed Y-Ba-Cu-O

We report the dependence of thermal conductivity, thermoelectric power and electrical resistivity on temperature for a bulk, large grain melt-processed Y-Ba-Cu-O (YBCO) high temperature superconductor (HTS) containing two grains separated by a well-defined grain boundary. Transport measurements at temperatures between 10 and 300 K were carried out both within one single grain (intra-granular properties) and across the grain boundary (inter-granular properties). The influence of an applied external magnetic field of up to 8 T on the measured sample properties was also investigated. The presence of the grain boundary is found to affect strongly the electrical resistivity of the melt-processed bulk sample, but has almost no effect on its thermoelectric power and thermal conductivity, within experimental error. The results of this study provide direct evidence that the heat flow in multi-granular melt-processed YBCO bulk samples should be virtually unaffected by the presence of grain boundaries in the material. © 2013 IOP Publishing Ltd.

Cd~(2+)和Cu~(2+)对美人蕉的氧化胁迫及抗性机理研究

通过测定植物的丙二醛(MDA)含量、酸溶性SH含量以及两种抗氧化酶(超氧化物歧化酶SOD和愈创木酚过氧化物酶GPX)的酶活,研究了重金属镉(Cd)和铜(Cu)对美人蕉(Cannaindica Linn.)的氧化胁迫。结果表明,20μmol·L~(-1)和100μmol·L~(-1)的Cd~(2+)和Cu~(2+)均使其根部MDA含量显著增加,但除了100μmol·L~(-1)的Cd~(2+),叶部MDA含量无明显变化。与Cu~(2+)相比,Cd~(2+)能引起植物根部GSH的明显提高,并能诱导PCs的产生

猪囊尾蚴铜/锌超氧化物歧化酶(Cu/ZnSOD)基因的克隆和表达

目的克隆猪囊尾蚴胞质含铜/锌的超氧化物歧化酶基因(Cu/ZnSOD),并比较其与其它寄生蠕虫相应基因结构的相似性。方法通过获取其它生物Cu/ZnSOD基因的保守区域,设计保守引物,用于扩增该寄生虫的Cu/ZnSOD基因。结果Cu/ZnSOD基因编码一15.6kDa的蛋白,该蛋白的推导序列中含有这类酶的活性和二级结构所需要的所有保守的氨基酸残基,并且与其它寄生虫的相应序列有高达70.6%的相似度。抑制剂研究试验表明所克隆的SOD属于Cu/ZnSOD,该蛋白在大肠杆菌中得以成功表达,表达产物具有SOD活性。免

Frame assisted H2O electrolysis induced H2 bubbling transfer of large area graphene grown by chemical vapor deposition on Cu

An improved technique for transferring large area graphene grown by chemical vapor deposition on copper is presented. It is based on mechanical separation of the graphene/copper by H2 bubbles during H2O electrolysis, which only takes a few tens of seconds while leaving the copper cathode intact. A semi-rigid plastic frame in combination with thin polymer layer span on graphene gives a convenient way of handling- and avoiding wrinkles and holes in graphene. Optical and electrical characterizations prove the graphene quality is better than that obtained by traditional wet etching transfer. This technique appears to be highly reproducible and cost efficient. © 2013 American Institute of Physics.

Cu~(2+)对一种绿球藻生长及生理特性的影响

研究了不同浓度的Cu2+(0.01,0.1,1,10,50,100,200mg/L)对绿球藻(Chlorococcumsp.)生长、形态结构及生理特性的影响.结果表明,Cu2+对绿球藻的显微结构、生长及生理状态的影响比较显著.与对照BG11培养的绿球藻比较,0.01～1mg/LCu2+浓度下培养的绿球藻,细胞壁无明显增厚,色素没有多大变化,但蛋白核由一个变为多个;而在高浓度(10～200mg/LCu2+)下,细胞壁明显增厚为多层,色素减少,蛋白核减少并回复到1个或消失.低浓度Cu2+(0.01,0.1mg

利用微量热法研究Cd~(2+)和Cu~(2+)对嗜热四膜虫(Tetrahymena thermophila)的毒性效应

利用微量热法研究Cd2 + 和Cu2 + 对嗜热四膜虫BF5(TetrahymenathermophilaBF5)生长代谢毒性效应 ,结果表明 :①低浓度的Cd2 + (0～ 0 .4mgL-1)和Cu2 + (0～ 10mgL-1)对四膜虫的生长有促进作用 ,而高浓度的Cd2 + (0 .8～ 3.2mgL-1)和Cu2 + (2 0～ 2 0 0mgL-1)则产生抑制作用 ;②Cd2 + 和Cu2 + 的半抑制浓度IC50 分别为 2 .0 4mg/L和15 5 .5mg/L ;③联合毒性为协同作用

湖水含盐量和Cu~(2+)浓度变化对Kinneret湖浮游植物的影响

通过人为改变湖水中的Cu2 + 浓度和含盐量的方法 ,Cu2 + 浓度和含盐量变化对Kinneret湖水中浮游植物可能造成的影响进行了分析。结果表明 ,湖水Cu2 + 浓度增加会抑制Kinneret湖水中藻类等浮游植物的生长 ,这对改善湖水水质来说是非常有利的 ,但高的Cu2 + 浓度对农作物生长和人类健康是有害的。在另一方面 ,对含盐量较低的约旦河水来说 ,适当增加Cu2 + 浓度则有利于藻类的生长。Kinneret湖中浮游植物的年平均生物量随湖水含盐量的下降而有增加的趋势 ,特别是当含盐量低于 2 0

Cu~(2+)、Zn~(2+)诱导稀有鮈鲫应激蛋白质的研究

以稀有鲫为材料 ,研究了应激蛋白质作为生物学指标的敏感性。结果表明 ,在无可观察效应浓度下 ,经 5d亚慢性胁迫暴露 ,以Cu2 +为胁迫因子 ,稀有鲫被诱导出约 54KDa的应激蛋白质 ;以Zn2 +为胁迫因子 ,稀有鲫被诱导出约 94KDa ,67KDa和 40KDa的应激蛋白质。应激蛋白质有可能成为一种生物学指标运用于生态风险性早期预警。

Cu~(2+)对红豆杉培养细胞中紫杉醇形成的影响

用Ｃｕ２＋对红豆杉（Ｔａｘｕｓｃｈｉｎｅｎｓｉｓ）培养细胞中紫杉醇形成的影响进行了研究。在红豆杉细胞悬浮培养２０ｄ即指数生长期末，每１Ｌ细胞悬浮培养物中加入３０μｍｏｌＣｕＣｌ２，Ｃｕ２＋促进紫杉醇形成的作用最大。添加ＣｕＣｌ２对红豆杉细胞生长没有明显影响，但引起培养细胞中可溶性蛋白质含量、苯丙氨酸解氨酶活性及培养基ｐＨ值的变化。

Improving the superconducting properties of single grain Sm-Ba-Cu-O bulk superconductors fabricated in air by increased control of Sm/Ba substitution effects

The extreme sensitivity of Sm/Ba at high temperature in air becomes an obstacle to the fabrication of SmBCO single grains that exhibit stable and reliable superconducting properties. In this research, the superconducting properties of SmBCO single grains fabricated by top seeded melt growth (TSMG) from different batches of commercial SmBa2Cu3O 7-d (Sm-123) precursor powder using different processing atmospheres (air and 0.1% O2 in Ar), different processing methods (isothermal growth and continuous cooling) and different amounts of BaO2 content to suppress Sm/Ba substitution in air have been investigated in an attempt to understand fully the TSMG process for this system. As a result, based on extensive data, a novel and simple, low temperature post-annealing approach is proposed specifically to overcome the sensitivity of Tc to Sm/Ba substitution in order to simplify the fabrication of SmBCO and to increase its reliability with a view to the practical processing of these materials. Initial processing trials have been performed successfully to demonstrate the viability of the novel post-annealing process. © 2013 IOP Publishing Ltd.

Electrical properties of LiNbO3 (electrolyte)/Cu (anode) bi-layers

In this work specific film structures of Li-Nb-O/Li/Li-Nb-O are investigated by AC Impedance Spectroscopy measurements at different temperatures. This gives the opportunity to investigate properties of the material itself and, at the same time, to consider the influence of the grain boundaries on the ionic behavior of the polycrystalline Lithium Niobate. On the other hand, LiNbO3/Li/Cu multi-layers are studied as electrolyte/anode bi-layers and potential parts of "Li-free" microbatteries. The Li deficiency in the as deposited Li-Nb-O films is cured by forming a "sandwich" of Li-Nb-O/Li/Li-Nb-O, which after annealing becomes ionic conductor. The electrical behavior of an annealed film depends on two sources. The first is due to properties of the material itself and the second is based on the network of the grain boundaries. The average size of the grains is strongly influenced by the structure of the ohmic-contact/substrate. The electrical behavior of the electrolyte/anode interface of the "Li-free" structure LiNbO3/Li/Cu/Au is very similar to the impedance measurements of the single LiNbO3 single films. The whole multilayer structure, though, presents a third relaxation time which is consistent of a small resistance. This resistance is independent of temperature and it seems that is due to the metallic interface Li/Cu/Au. © 2010 Elsevier B.V. All rights reserved.