Transfer of cadmium and zinc from sewage sludge amended soil through a plant–aphid system to newly emerged adult ladybirds (Coccinella septempunctata)

An agricultural soil was amended with sewage sludge at rates equivalent to 0, 10 and 30 t (dry solids) ha−1 and the subsequent transfer of zinc and cadmium through a soil–plant–arthropod system was investigated. Zinc concentration in soil, wheat and aphids increased significantly with sludge amendment rate. Zinc was biomagnified during transfer along the pathway, resulting in concentrations in the aphids four times greater than in the soil. Cadmium concentration in the soil was also significantly elevated by the addition of sludge, but there was no significant difference in cadmium concentration in the shoots of wheat plants. Cadmium concentration in aphids followed the pattern found in plants, but again, differences between treatments were not significant. Aphids collected from the plants were subsequently fed to fourth instar Coccinella septempunctata. Consumption of these aphids did not result in significant differences between treatments in the body burden of newly emerged adult C. septempunctata for either metal. Sequestration of cadmium in the pupal exuviae had a greater effect on the body burden of newly emerged adult ladybirds than for zinc. Results are discussed in relation to possible risks posed by the transfer of trace metals via the soil–plant–arthropod system to predatory arthropods.

Sedimentation rates in Atibaia River basin, São Paulo State, Brazil, using Pb-210 as geochronometer

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Sedimentation rates in the Corumbatai River basin, Brazil, derived from Pb-210 measurements

Activity profiles of excess Pb-210 measured in four sediment cores from the Corumbatai River basin, São Paulo State, Brazil, provided an opportunity to evaluate sedimentation rates that are helpful for defining appropriate management strategies for the hydrological resources in the basin. This is because Rio Claro city and other municipalities make extensive use of surface waters for drinking water supply. The radiochemical analysis of the sediment cores yielded apparent sediment mass accumulation rates of between 406 and 1014 mg cm(-2) year(-1) for secondary drainage lines, whereas an intermediate value of 546 mg cm(-2) year(-1) was found in the Corumbatai River, the main drainage system of the studied area. These values provided estimates of average linear sedimentation rates of between 3.1 and 16.2 mm year(-1) that are compatible with field evidence, with the highest value corresponding with an area characterized by accumulation of sediment.

Sedimentation rates of tripton in Jurumirim Reservoir (São Paulo, Brazil)

Sedimentation rates of particulate material and some physicochemical parameters of water were determined in October, January, April and July 1990-91 at seven stations in the Jurumirim Reservoir (São Paulo, Brazil), three located in the Paranapanema arm, three in the Taquari arm and one near the dam. Higher sedimentation rates of tripton were found in the Paranapanema arm, followed by those from the Taquari arm and the dam. Suspended matter (2.5-48.7 mg · 1-1) and chlorophyll-a (0.7-8.1 mg · m-3) concentrations in the Paranapanema arm were in general higher resulting in lower water transparency (0.3-1.7m) than in the Taquari arm. Temporal and spatial variations in the tripton sedimentation rates were mainly influenced by allochthonous input at the stations near the river mouth. The settling fluxes at station near the dam of the reservoir were affected rather by a small autochthonous production (65 g C ass m-2 ;yr-1), indicated by a higher organic content (64-87%). Therefore, sedimentation rates measured by bottom traps were affected by sediment ressuspension especially at isothermal conditions. With respect to sedimentation, the riverine, the transition and the lacustrine zones commonly found in reservoires could be distinguished. The extent of the riverine zone in each arm of the Jurumirim Reservoir depends on the seasonal change of allochthonous input.

Sedimentation rates in the Corumbataí River basin, Brazil, derived from 210Pb measurements

Activity profiles of excess 210Pb measured in four sediment cores from the Corumbataí River basin, São Paulo State, Brazil, provided an opportunity to evaluate sedimentation rates that are helpful for defining appropriate management strategies for the hydrological resources in the basin. This is because Rio Claro city and other municipalities make extensive use of surface waters for drinking water supply. The radiochemical analysis of the sediment cores yielded apparent sediment mass accumulation rates of between 406 and 1014 mg cm-2 year-1 for secondary drainage lines, whereas an intermediate value of 546 mg cm-2 year-1 was found in the Corumbataí River, the main drainage system of the studied area. These values provided estimates of average linear sedimentation rates of between 3.1 and 16.2 mm year-1 that are compatible with field evidence, with the highest value corresponding with an area characterized by accumulation of sediment.

Effects of tannery sludge application on physiological and fatty acid profiles of the soil microbial community

The impact of tannery sludge application on soil microbial community and diversity is poorly understood. We studied the microbial community in an agricultural soil following two applications (2006 and 2007) of tannery sludge with annual application rates of 0.0,2.3 and 22.6 Mg ha(-1). The soil was sampled 12 and 271 days after the second (2007) application. Community structure was assessed via a phospholipid fatty acid analysis, and the physiological profile of the soil microbial community via the Biolog method. Tannery sludge application changed soil chemical properties, increasing the soil pH and electrical conductivity as well as available P and mineral N concentrations. The higher sludge application rate changed the community structure and the physiological profile of the microbial community at both sampling dates. However, there is no clear link between community structure and carbon substrate utilization. According to the Distance Based Linear Models Analysis, the fatty acids 16:0 and 117:0 together contributed 84% to the observed PLFA patterns, whereas the chemical properties available P, mineral N, and Ca, and pH together contributed 54%. At 12 days, tannery sludge application increased the average well color development from 0.46 to 0.87 after 48 h, and reduced the time elapsed before reaching the midpoint carbon substrate utilization (s) from 71 to 44 h, an effect still apparent nine months after application of the higher sludge application rate. The dominant signature fatty acids and kinetic parameters (r and s) were correlated to the concentrations of available P. Ca, mineral N, pH and EC. (c) 2012 Elsevier B.V. All rights reserved.

Quartz content, accumulation and sedimentation rates at DSDP Hole 91-595A

The quartz contents of sediments from Hole 595A, determined by X-ray diffractometry, serve as an indicator of eolian transport of terrigenous material to the central southern Pacific. The quartz contents are very small and, within limits of analytical resolution, vary only slightly from the Cretaceous to the present. However, the accumulation rate of the eolian quartz does change significantly. The quartz accumulation reflects the changing position of the site with respect to the terrigenous source areas and the variations in wind systems through time.

CaCO3, density, sedimentation and accumulation rates at DSDP Hole 68-503B

Pelagic sediments from DSDP Hole 5O3B contain, in their carbonate abundance data, a clear record of glacial-interglacial cycles. The eolian component of those sediments was analyzed over the past four carbonate cycles, and the mass accumulation rate (MAR) and grain size of the eolian component was determined. Eolian MARs range from 24 to 169 mg/cm**2/10**3y. and commonly are higher by a factor of three to five during times of glacial retreat. Reduced contribution during periods of glaciation most likely reflects glacial-age humidity in the American source. Grain-size values (phi50) range from 8.25 to a minimum of 8.79phi-a variation in grain mass by a factor of 3.1. Larger grains reflect more vigorous atmospheric circulation, but sizes do not covary with the carbonate or eolian accumulation curves. These data suggest that the intensity of atmospheric circulation in the tropics may reflect the 42,000 y.-tilt cycle rather than the 100,000 y.-cycle of glacial advance.

(Table 3) Sedimentation rates of stage 1 and last glacial maximum from different Holes during cruises of RRS Discovery in 1984-1985 and 1987-1988, and RRS James Clark Ross in 1992-1993

Within the Scotia Sea, the axis of the Antarctic Circumpolar Current (ACC) is geographically confined, and sediments therefore contain a record of palaeo-flow speed uncomplicated by ACC axis migration. We outline Holocene and Last Glacial Maximum (LGM) current-controlled sedimentation using data from 3.5-kHz profiles, cores and current meter moorings. Geophysical surveys show areas of erosion and deposition controlled by Neogene basement topography. Deposition occurs in mounded sediment drifts or flatter areas, where 500-1000 m of sediment overlies acoustic basement. 3.5-kHz profiles show parallel, continuous sub-bottom reflectors with highest sedimentation rates in the centre of the drifts, and reflectors converging towards marginal zones of non-deposition. Locally, on the flanks of continental blocks (e.g. South Georgia), downslope processes are dominant. The absence of mudwaves on the sediment drifts may result from the unsteadiness of ACC flow. A core transect from the ACC axis south to the boundary with the Weddell Gyre shows a southward decrease in biogenic content, controlled by the Polar Front and the spring sea-ice edge. Both these features lay farther north at LGM. The cores have been dated by relative abundance of the radiolarian Cycladophora davisiana, and by changes in the biogenic Ba content, a palaeoproductivity indicator. Sedimentation rates range from 3 to 17 cm/ka. The grain size of Holocene sediments shows a coarsening trend from south to north, consistent with strongest bottom-current flow near the ACC axis, though interpretation is complicated by the presence of biogenic grains. Year-long current meter records indicate mean speeds from 7 cm/s in the south to 12 cm/s in the north, with benthic storm frequency increasing northwards. LGM sediments are predominantly terrigenous and show a clearer northward-coarsening trend, with well-sorted silts in the northern Scotia Sea. Assuming a constant terrigenous source, this implies stronger ACC flow at the LGM, contrasting with weaker Weddell Gyre flow deduced from earlier work.

Late Neogene carbonate sedimentation and stable isotope record of ODP Site 121-758

The evolution of oceanic and climatic conditions the northeast Indian Ocean during the last 7 m.y. is revealed in the sediments from Site 758. We present detailed and continuous records of d18O and d13C from planktonic foraminifers, weight percent calcium carbonate, weight percent coarse fraction, magnetic susceptibility, and geomagnetic reversals. Sample spacing of the records ranges from 3 to 10 cm and is equivalent to an average time interval of 2000 to 6000 yr. Despite the fact that core recovery ranged between 100% and 105%, recovery gaps as large as 2.7 m occurred at nearly every break between advanced hydraulic piston cores. Approximately 12% of the late Neogene sequence was not recovered in each of the two holes drilled at Site 758. To circumvent the discontinuity introduced by the gaps, a composite depth section was constructed from multiple cores taken from offset holes at Site 758. The resulting composite depth section extends continuously from 0 to 116 mbsf, from the Holocene to the upper Miocene. A detailed chronostratigraphy is based on geomagnetic reversals which extend from the Brunhes Chron to Chron 6, and on d18O stages 1 through 105, which span from 0 to 2.5 Ma. The d18O record is dominated by a ~40-k.y. cycle in the late Pliocene and early Pleistocene, and is followed by a change to a ~100-k.y. cycle in the late Pleistocene. The mid-Pleistocene transition between these two modes of variability occurs between d18O stages 25 and 22 (between 860 and 800 Ka). Thirteen major volcanic ash horizons from the Indonesian arc are observed throughout the sedimentary section and are dated by their relative position within the geomagnetic reversals and the d18O chronostratigraphy. Since 5 Ma, there has been a long-term decline in weight percent CaCO3 and CaCO3 mass accumulation rates, and an associated rise in non-CaCO3 mass accumulation rates. We attribute these changes to a decrease in CaCO3 productivity and an increase in terrigenous sedimentation through enhanced riverine input. Such input may be linked to rapid tectonic uplift of the Himalayas and the Tibetan Plateau via mechanisms such as the intensification of the monsoonal rains, increased fluvial erosion, and regional glaciation. The long-term increase in percent coarse fraction since 5 Ma suggests a gradual increase in CaCO3 preservation. Higher frequency fluctuations in CaCO3 preservation are superimposed on the long-term trend and are related to climate fluctuations. The abrupt drop (-50%) in CaCO3 accumulation at 3.4 Ma signals a dramatic decrease in CaCO3 production that occurred over much of the Indian Ocean.