Characterisation of carbon nano-onions using Raman spectroscopy

Characteristics of the Raman spectrum from carbon onions have been identified in terms of the position of the G peak and appearance of the transverse optic phonon peaks. Five new peaks were observed in the low wavenumber region, at about 1100, 861, 700, 450 and 250 cm(-1). The origins of these peaks are discussed in terms of the phonon density of states (PDOS) and phonon dispersion curves of graphite. The curvature of the graphene planes is invoked to explain the relaxation of the Raman selection rules and the appearance of the new peaks. The Raman spectrum of carbon onions is compared with that of highly oriented pyrolytic graphite (HOPG). The strain of graphene planes due to curvature has been estimated analytically and is used to account for the downward shift of the G peak. (C) 2003 Elsevier Science B.V. All rights reserved.

Nano-Tribological Study on a Super-Hydrophobic Film Formed on Rough Aluminum

A novel super-hydrophobic stearic acid (STA) film with a water contact angle of 166° was prepared by chemical adsorption on aluminum wafer coated with polyethyleneimine (PEI) film. The micro-tribological behavior of the super-hydrophobic STA monolayer was compared with that of the polished and PEI-coated Al surfaces. The effect of relative humidity on the adhesion and friction was investigated as well. It was found that the STA monolayer showed decreased friction, while the adhesive force was greatly decreased by increasing the surface roughness of the Al wafer to reduce the contact area between the atomic force microscope (AFM) tip and the sample surface to be tested. Thus the friction and adhesion of the Al wafer was effectively decreased by generating the STA monolayer, which indicated that it could be feasible and rational to prepare a surface with good adhesion resistance and lubricity by properly controlling the surface morphology and the chemical composition. Both the adhesion and friction decreased as the relative humidity was lowered from 65% to 10%, though the decrease extent became insignificant for the STA monolayer.

Optical fringe multiplication technique with TEM nano-moiré method

In this paper, a nano-moiré fringe multiplication method is proposed, which can be used to measure nano-deformation of single crystal materials. The lattice structure of Si (111) is recorded on a film at a given magnification under a transmission microscope, which acts as a specimen grating. A parallel grating (binary type) on glass or film is selected as a reference grating. A multiplied nano-moiré fringe pattern can be reproduced in a 4f optical filter system with the specimen grating and the prepared reference grating. The successful results illustrate that this method can be used to measure deformation in nanometre scale. The method is especially useful in the measurement of the inhomogeneous displacement field, and can be utilized to characterize nano-mechanical behaviour of materials such as dislocation and atomic bond failure.

Utilización de la resina de neem (Azadirachta indica) como desparasitante externo en el tratamiento del tórsalo (Dermatobia hominis) en bovinos del municipio de Muy Muy, departamento de Matagalpa

El presente estudio se realizó con el objetivo de evaluar la utilización de la Resina de Neem (Azadirachta indica)como desparasitante externo en el tratamiento del tórsalo (Dermatobia hominis)en bovinos del Municipio de Muy Muy, Departamento de Matagalpa. El Municipio de Muy Muy esta ubicado en las Coordenadas 12º45'48" de latitud Norte con 85° 37' 36" de Longitud Oeste, con una altura sobre el nivel del mar de 337.6 metros, una precipitación promedio entre 1400-1800 mm, con una temperatura promedio 24°C., La topografía del terreno en que se ubica el Municipio de MUY MUY, presenta las siguientes características: 32.1% Terrenos Plano, 41.0% Terrenos Ondulados y 26.9% Terrenos Quebrados. Y los tipos de suelos son arcillosos y rocosos. En el trabajo experimental se utilizó un diseño completamen te al azar (D.C.A) el que estuvo compuesto por un lote de 18 animales divididos en 3 grupos, cada grupo formado por 6 animales seleccionadas al azar y sometidas a tratamientos distintos Tratamiento I: Ivermectina al 1%, Tratamiento II: Resina del Neem al 5%. Tratamiento III: Resina de Neem al 10%. Para evaluar la efectividad de los distintos tratamientos se hizo conteos periódicos de tórsalos cada siete días, cuantificando la cantidad de nódulos por animal y región anatómica a los 7, 14, 21, 28, 35, 42, 49, 56 días. La efectividad de todos los tratamientos se observó a partir de los 21 días después de la aplicación. Los tratamientos II y I tuvieron las mejores respuestas en el control, del tórsalo, con un porcentaje de efectividad del 91.6%, y 72.7% respectivamente y con un 62.5% para el tratamiento III. El área anatómica mas afectada fue la del miembro anterior derecho seguido del lateral derecho. Según el análisis del costo de la dosis, se puede decir que la resina de Neem es un desparasita nte económico para los productores.

Estudio preliminar de la utilizacion del aceite y resina de Neem (Azadirachta indica A. Juss) en el tratamiento de la sarna Psoroptica equina en la comarca Pilar del municipio de Santo Domingo, departamento de Chontales

El presente estudio se realizó en la finca "El Porvenir" ubicada en los 12°15' de latitud norte y 85"04' de longitud oeste, en el municipio de Santo Domingo departamento de Chontales, el clima es de sabana tropical con temperaturas entre 25 a 27"C. La duración del experimento fue de 18 días a partir de la selección e identificación de los animales bajo los tratamientos evaluados. Con el objetivo de comparar el efecto del aceite y resina de Neem al 40 % versus lvermectina pasta al 1% en el control de la sama Psoróptica equina. Se utilizó un Diseño Completamente al Azar (D.C.A.). Se seleccionaron 21 equinos con edades promedios de 1O a l 5 años, estos se dividieron en 3 grupos, cada grupo formado por 7 equinos por tratamiento, Tratamiento P: Ivermectina pasta 1% a razón de lg por cada 100 kg de peso vivo, vía oral. Tratamiento A:aceite de Neem acaricida tópico botánico a base de aceite de Neem, se aplicó vía tópica un promedio de 20 mi por cada animal. Tratamiento R: resina de Neem, acaricida tópico botánico a base de resina de Neem, se aplicó vía tópica, un promedio de 20 mi por cada equino. A los equinos se les realizó un examen clinico al inicio del ensayo y a los 14 días post aplicación, se utilizó el diagnóstico clínico y sintomatológico para evaluar el comportamiento de los tratamientos. Para cuantificar las reducciones de las lesiones se utilizaron tres variables: detención, reducción y control de las lesiones. Los tratamientos con Neem aceite y resina al 400/o arrojaron los siguientes resultados: Aceite 40% logró alcanzar un 100% del control de las lesiones y la resina alcanzó 86%. La Ivermectina pasta 1% sólo alcanzó la reducción de las lesiones en un 100%. Entre los tres tratamientos, el que dio mejores resultados fue el aceite de Neem al 40% con un porcentaje de eficiencia en el control de la sama equina en un 100%.

Spark plasma sintering of TiNi nano-powders for biological application

Nano-sized TiNi powder with an average size of 50nm was consolidated using spark plasma sintering (SPS) at 800 °C for 5min. A layer of anatase TiO 2 coating was formed on the sintered TiNi by chemical reaction with a hydrogen peroxide (H2O2) solution at 60 °C followed by heat treatment at 400 °C to enhance the bioactivity of the metal surface. Cell culture using osteoblast cells and a biomimetic test in simulated body fluid proved the biocompatibility of the chemically treated SPS TiNi. © IOP Publishing Ltd.

Resonant Raman characterisation of ultra-thin nano-protective carbon layers for magnetic storage devices

Carbon thin films are very important as protective coatings for a wide range of applications such as magnetic storage devices. The key parameter of interest is the sp3 fraction, since it controls the mechanical properties of the film. Visible Raman spectroscopy is a very popular technique to determine the carbon bonding. However, the visible Raman spectra mainly depend on the configuration and clustering of the sp2 sites. This can result in the Raman spectra of different samples looking similar albeit having a different structure. Thus, visible Raman alone cannot be used to derive the sp3 content. Here we monitor the carbon bonding by using a combined study of Raman spectra taken at two wavelengths (514 and 244 nm). We show how the G peak dispersion is a very useful parameter to investigate the carbon samples and we endorse it as a production-line characterisation tool. The dispersion is proportional to the degree of disorder, thus making it possible to distinguish between graphitic and diamond-like carbon. © 2003 Elsevier B.V. All rights reserved.

Equivalency and Locality in Nano-Scale Measurement

Two principal problems of equivalency and locality in nano-scale measurement are considered in this paper. The conventional measurements of force and displacement are always closely related to the equivalency problem between the measuremental results by experimental system and the real physical status of the sample, and the locality of the mechanical quantities to be measured. There are some noticeable contradictions in nano-scale measurements induced by the two problems. In this paper, by utilizing a coupled molecular-continuum method, we illustrate the important effects of the two principal problems in atomic force microscopy (AFM) measurements on nano-scale. Our calculations and analysis of these typical mechanical measurement problems suggest that in nano-meter scale measurements, the two principal problems must be carefully dealt with. The coupled molecular-continuum method used in this paper is very effective in solving these problems on nano-scale.

A Constrained Particle Dynamics for Continuum-Particle Hybrid Method in Micro- and Nano-Fluidics

A hybrid method of continuum and particle dynamics is developed for micro- and nano-fluidics, where fluids are described by a molecular dynamics (MD) in one domain and by the Navier-Stokes (NS) equations in another domain. In order to ensure the continuity of momentum flux, the continuum and molecular dynamics in the overlap domain are coupled through a constrained particle dynamics. The constrained particle dynamics is constructed with a virtual damping force and a virtual added mass force. The sudden-start Couette flows with either non-slip or slip boundary condition are used to test the hybrid method. It is shown that the results obtained are quantitatively in agreement with the analytical solutions under the non-slip boundary conditions and the full MD simulations under the slip boundary conditions.

Preparation And Optical Properties Of Cdte/Cdo Center Dot Nh(2)O Core/Shell Nano-Composites In Aqueous Solution

The deposition of CdO center dot nH(2)O On CdTe nanoparticles was studied in an aqueous phase. The CdTe nanocrystals (NCs) were prepared in aqueous solution through the reaction between Cd2+ and NaHTe in the presence of thioglycolic acid as a stabilizer. The molar ratio of the Cd2+ to Te2- in the precursory solution played an important role in the photoluminescence of the ultimate CdTe NCs. The strongest photoluminescence was obtained under 4.0 of [Cd2+]/[Te2-] at pH similar to 8.2. With the optimum dosage of Cd(II) hydrous oxide deposited on the CdTe NCs, the photoluminescence was enhanced greatly. The photoluminescence of these nanocomposites was kept constant in the pH range of 8.0-10.0, but dramatically decreased with an obvious blue-shifted peak while the pH was below 8.0. In addition, the photochemical oxidation of CdTe NCs with cadmium hydrous oxide deposition was markedly inhibited.

Simulations of Mechanical Behavior of Polycrystalline Copper with Nano-Twins

Mechanical behavior and microstructure evolution of polycrystalline copper with nano-twins were investigated in the present work by finite element simulations. The fracture of grain boundaries are described by a cohesive interface constitutive model based on the strain gradient plasticity theory. A systematic study of the strength and ductility for different grain sizes and twin lamellae distributions is performed. The results show that the material strength and ductility strongly depend on the grain size and the distribution of twin lamellae microstructures in the polycrystalline copper.

The Capillary Force In Micro- And Nano-Indentation With Different Indenter Shapes

The influence of the indenter shapes and various parameters on the magnitude of the capillary force is studied on the basis of models describing the wet adhesion of indenters and substrates joined by liquid bridges. In the former, we consider several shapes, such as conical, spherical and truncated conical one with a spherical end. In the latter, the effects of the contact angle, the radius of the wetting circle, the volume of the liquid bridge, the environmental humidity, the gap between the indenter and the substrate, the conical angle, the radius of the spherical indenter, the opening angle of the spherical end in the truncated conical indenter are included. The meniscus of the bridge is described using a circular approximation, which is reasonable under some conditions. Different dependences of the capillary force on the indenter shapes and the geometric parameters are observed. The results can be applicable to the micro- and nano-indentation experiments. It shows that the measured hardness is underestimated due to the effect of the capillary force. (c) 2008 Elsevier Ltd. All rights reserved.

Small scale, grain size and substrate effects in nano-indentation experiment of film-substrate systems

The mechanical properties of film-substrate systems have been investigated through nano-indentation experiments in our former paper (Chen, S.H., Liu, L., Wang, T.C., 2005. Investigation of the mechanical properties of thin films by nano-indentation, considering the effects of thickness and different coating-substrate combinations. Surf. Coat. Technol., 191, 25-32), in which Al-Glass with three different film thicknesses are adopted and it is found that the relation between the hardness H and normalized indentation depth h/t, where t denotes the film thickness, exhibits three different regimes: (i) the hardness decreases obviously with increasing indentation depth; (ii) then, the hardness keeps an almost constant value in the range of 0.1-0.7 of the normalized indentation depth h/t; (iii) after that, the hardness increases with increasing indentation depth. In this paper, the indentation image is further investigated and finite element method is used to analyze the nano-indentation phenomena with both classical plasticity and strain gradient plasticity theories. Not only the case with an ideal sharp indenter tip but also that with a round one is considered in both theories. Finally, we find that the classical plasticity theory can not predict the experimental results, even considering the indenter tip curvature. However, the strain gradient plasticity theory can describe the experimental data very well not only at a shallow indentation depth but also at a deep depth. Strain gradient and substrate effects are proved to coexist in film-substrate nano-indentation experiments. (c) 2006 Elsevier Ltd. All rights reserved.