No anticorrelation between cyclotron line energy and X-ray flux in 4U 0115+634

We report on an outburst of the high mass X-ray binary 4U 0115+634 with a pulse period of 3.6 s in 2008 March/April as observed with RXTE and INTEGRAL. During the outburst the neutron star’s luminosity varied by a factor of 10 in the 3–50 keV band. In agreement with earlier work we find evidence of five cyclotron resonance scattering features at ~10.7, 21.8, 35.5, 46.7, and 59.7 keV. Previous work had found an anticorrelation between the fundamental cyclotron line energy and the X-ray flux. We show that this apparent anticorrelation is probably due to the unphysical interplay of parameters of the cyclotron line with the continuum models used previously, e.g., the negative and positive exponent power law (NPEX). For this model, we show that cyclotron line modeling erroneously leads to describing part of the exponential cutoff and the continuum variability, and not the cyclotron lines. When the X-ray continuum is modeled with a simple exponentially cutoff power law modified by a Gaussian emission feature around 10 keV, the correlation between the line energy and the flux vanishes, and the line parameters remain virtually constant over the outburst. We therefore conclude that the previously reported anticorrelation is an artifact of the assumptions adopted in the modeling of the continuum.

On-line microwave-based preconcentration device for inductively coupled plasma atomic emission spectrometry: Application to the elemental analysis of spirit samples

A microwave-based thermal nebulizer (MWTN) has been employed for the first time as on-line preconcentration device in inductively coupled plasma atomic emission spectrometry (ICP-AES). By the appropriate selection of the experimental conditions, the MWTN could be either operated as a conventional thermal nebulizer or as on-line analyte preconcentration and nebulization device. Thus, when operating at microwave power values above 100 W and highly concentrated alcohol solutions, the amount of energy per solvent mass liquid unit (EMR) is high enough to completely evaporate the solvent inside the system and, as a consequence, the analyte is deposited (and then preconcentrated) on the inner walls of the MWTN capillary. When reducing the EMR to the appropriate value (e.g., by reducing the microwave power at a constant sample uptake rate) the retained analyte is swept along by the liquid-gas stream and an analyte-enriched aerosol is generated and next introduced into the plasma cell. Emission signals obtained with the MWTN operating in preconcentration-nebulization mode improved when increasing preconcentration time and sample uptake rate as well as when decreasing the nozzle inner diameter. When running with pure ethanol solution at its optimum experimental conditions, the MWTN in preconcentration-nebulization mode afforded limits of detection up to one order of magnitude lowers than those obtained operating the MWTN exclusively as a nebulizer. To validate the method, the multi-element analysis (i.e. Al, Ca, Cd, Cr, Cu, Fe, K, Mg, Mn, Na, Pb and Zn) of different commercial spirit samples in ICP-AES has been performed. Analyte recoveries for all the elements studied ranged between 93% and 107% and the dynamic linear range covered up to 4 orders of magnitude (i.e. from 0.1 to 1000 μg L−1). In these analysis, both MWTN operating modes afforded similar results. Nevertheless, the preconcentration-nebulization mode permits to determine a higher number of analytes due to its higher detection capabilities.

Nuevas perspectivas de la contratación on line de servicios turísticos y paquetes dinámicos de turismo

La implementación de las nuevas tecnologías o TIC’s en el sector turístico se ha visto favorecida, en los últimos años, por las posibilidades que Internet ofrece de poder comprobar instantáneamente la existencia real del proveedor del servicio, la veracidad del servicio prestado o las condiciones en que se presta.. El aumento de la contratación electrónica de servicios turísticos exige que los proveedores de estos servicios y los turistas tengan en cuenta las diferentes normas jurídicas que resultan de aplicación en el ámbito de los servicios de la sociedad de la información, principalmente, la Ley 34/2002, de 11 de julio, de Servicios de la Sociedad de la Información y de Comercio Electrónico (LSSI), las normas reguladoras del consumo, en concreto, el Real Decreto legislativo 1/2007, de 16 de noviembre, por el que se aprueba el texto refundido de la Ley General para la Defensa de los Consumidores y Usuarios y otras leyes complementarias (TRLGDCU) y su modificación por la Ley 3/2014, de 27 de marzo, así como las diferentes normas autonómicas reguladoras del turismo que existen en la actualidad. En definitiva, un estudio detallado de las implicaciones que la contratación electrónica de servicios turísticos supone realizar una descripción legal del régimen jurídico que resulta de aplicación a los diferentes oferentes e intermediarios que intervienen esta nueva modalidad contractual y a los denominados paquetes dinámicos de turismo.

Who Is Influential and Why? The Determinants of Reputational Power

Power is one of the most fundamental concepts in political science, and it is a crucial aspect of decision-making structures. The distribution of power between political actors and coalitions of actors informs us about who is actually able to influence decision-making processes. It is thus no surprise that power is a centerpiece of our assessment of political decision-making in Switzerland. In line with the main argument of this book, Chapter 3 has uncovered important changes in decision-making structures, which resulted in a rebalancing of power between governing parties, interest groups and state executive actors. Conjecturing about the reasons that may account for these changes, we pointed to factors of an organizational and institutional nature. For example, we put forward the decline of pre-parliamentary procedures oriented towards corporatist intermediation as a possible explanation for the weakening of interest groups. More generally, in several chapters it has been suggested that there is a relationship between the institutional design of a decision-making process, the related importance of decision-making phases and an actor's participation in these phases on the one hand, and the power of actors (and coalitions of actors) on the other. In addition, the analyses carried out in Chapters 2 to 5 draw our attention to the differences in power structure across decision-making processes or types of processes.

Malin-Warner 230 kV transmission line construction (OR,CA), environmental assessment (EA), Finding of no significant impact (FONSI).

Mode of access: Internet.

Environmental assessment using remotely sensed data : application of remote sensing data to environmental impact studies for transmission line routes /

Mode of access: Internet.

Beyond the battle line : US air attack theory and doctrine, 1919-1941 /

"April 1996."

Power flow based monetary flow method for electricity transmission and wheeling pricing

This paper proposes a transmission and wheeling pricing method based on the monetary flow tracing along power flow paths: the monetary flow-monetary path method. Active and reactive power flows are converted into monetary flows by using nodal prices. The method introduces a uniform measurement for transmission service usages by active and reactive powers. Because monetary flows are related to the nodal prices, the impacts of generators and loads on operation constraints and the interactive impacts between active and reactive powers can be considered. Total transmission service cost is separated into more practical line-related costs and system-wide cost, and can be flexibly distributed between generators and loads. The method is able to reconcile transmission service cost fairly and to optimize transmission system operation and development. The case study on the IEEE 30 bus test system shows that the proposed pricing method is effective in creating economic signals towards the efficient use and operation of the transmission system. (c) 2005 Elsevier B.V. All rights reserved.

Effect of line of sight propagation on capacity of an indoor MIMO system

In this paper the performance of a multiple input multiple output (MIMO) wireless communication system operating in an indoor environment, featuring both line of sight (LOS) and non-line of sight (NLOS) signal propagation, is assessed. In the model the scattering objects are assumed to be uniformly distributed in an area surrounding the transmitting and receiving array antennas. Mutual coupling effects in the arrays are treated in an exact manner. However interactions with scattering objects are taken into account via a single bounce approach. Computer simulations are carried out for the system capacity for varying inter-element spacing in the receiving array for assumed values of LOS/NLOS power fraction and signal to noise ratio (SNR).

Maximising the information gained from an experimental analysis of code inspection and static analysis for concurrent Java components

The results of empirical studies are limited to particular contexts, difficult to generalise and the studies themselves are expensive to perform. Despite these problems, empirical studies in software engineering can be made effective and they are important to both researchers and practitioners. The key to their effectiveness lies in the maximisation of the information that can be gained by examining existing studies, conducting power analyses for an accurate minimum sample size and benefiting from previous studies through replication. This approach was applied in a controlled experiment examining the combination of automated static analysis tools and code inspection in the context of verification and validation (V&V) of concurrent Java components. The combination of these V&V technologies was shown to be cost-effective despite the size of the study, which thus contributes to research in V&V technology evaluation.

Fast response static var generator for improving the power system performance of an electric arc furnace (EAF)

Cascaded multilevel inverters-based Static Var Generators (SVGs) are FACTS equipment introduced for active and reactive power flow control. They eliminate the need for zigzag transformers and give a fast response. However, with regard to their application for flicker reduction in using Electric Arc Furnace (EAF), the existing multilevel inverter-based SVGs suffer from the following disadvantages. (1) To control the reactive power, an off-line calculation of Modulation Index (MI) is required to adjust the SVG output voltage. This slows down the transient response to the changes of reactive power; and (2) Random active power exchange may cause unbalance to the voltage of the d.c. link (HBI) capacitor when the reactive power control is done by adjusting the power angle d alone. To resolve these problems, a mathematical model of 11-level cascaded SVG, was developed. A new control strategy involving both MI (modulation index) and power angle (d) is proposed. A selected harmonics elimination method (SHEM) is taken for switching pattern calculations. To shorten the response time and simplify the controls system, feed forward neural networks are used for on-line computation of the switching patterns instead of using look-up tables. The proposed controller updates the MI and switching patterns once each line-cycle according to the sampled reactive power Qs. Meanwhile, the remainder reactive power (compensated by the MI) and the reactive power variations during the line-cycle will be continuously compensated by adjusting the power angles, d. The scheme senses both variables MI and d, and takes action through the inverter switching angle, qi. As a result, the proposed SVG is expected to give a faster and more accurate response than present designs allow. In support of the proposal there is a mathematical model for reactive powered distribution and a sensitivity matrix for voltage regulation assessment, MATLAB simulation results are provided to validate the proposed schemes. The performance with non-linear time varying loads is analysed and refers to a general review of flicker, of methods for measuring flickers due to arc furnace and means for mitigation.

Role of power jitter induced by interchannel interactions in dispersion-managed lines

Collision induced power jitter is examined in dispersion-managed wavelength division-multiplexed transmission systems. The power jitter causes ’ a serious problem for a singly-periodic dispersion managed line having almost zero average dispersion, which can be reduced by applying doubly-periodic dispersion management.

Analysis of power jitter induced by interchannel interactions in dispersion-managed optical soliton transmission systems

Collision-induced power jitter is theoretically and numerically examined in dispersion-managed wavelength-division-multiplexed optical soliton transmission systems. The variational method is mainly used to develop a time efficient jitter calculation approach. The power jitter causes a serious problem for a singly periodic dispersion managed line having almost zero average dispersion, which can be reduced by applying doubly periodic dispersion management.

Modelling and benchmarking business processes: The supply-line example

Benchmarking techniques have evolved over the years since Xerox’s pioneering visits to Japan in the late 1970s. The focus of benchmarking has also shifted during this period. By tracing in detail the evolution of benchmarking in one specific area of business activity, supply and distribution management, as seen by the participants in that evolution, creates a picture of a movement from single function, cost-focused, competitive benchmarking, through cross-functional, cross-sectoral, value-oriented benchmarking to process benchmarking. As process efficiency and effectiveness become the primary foci of benchmarking activities, the measurement parameters used to benchmark performance converge with the factors used in business process modelling. The possibility is therefore emerging of modelling business processes and then feeding the models with actual data from benchmarking exercises. This would overcome the most common criticism of benchmarking, namely that it intrinsically lacks the ability to move beyond current best practice. In fact the combined power of modelling and benchmarking may prove to be the basic building block of informed business process re-engineering.

Strategizing networks of power and influence:the internet and the struggle over contested space

Whilst some authors have portrayed the Internet as a powerful tool for business and political institutions, others have highlighted the potential of this technology for those vying to constrain or counter-balance the power of organizations, through e-collectivism and on-line action. What appears to be emerging is a contested space that has the potential to simultaneously enhance the power of organizations, whilst also acting as an enabling technology for the empowerment of grass-root networks. In this struggle, organizations are fighting for the retention of “old economy” positions, as well as the development of “new economy” power-bases. In realizing these positions, organizations and institutions are strategizing and manoeuvering in order to shape on-line networks and communications. For example, the on-line activities of individuals can be contained through various technological means, such as surveillance, and the structuring of the virtual world through the use of portals and “walled gardens”. However, loose groupings of individuals are also strategizing to ensure there is a liberation of their communication paths and practices, and to maintain the potential for mobilization within and across traditional boundaries. In this article, the unique nature and potential of the Internet are evaluated, and the struggle over this contested virtual space is explored.