Small-Signal Stability Analysis of an Open-loop Induction Motor Drive Including the Effect of Inverter Dead-Time

This paper demonstrates light-load instability in open-loop induction motor drives on account of inverter dead-time. The dynamic equations of an inverter fed induction motor, incorporating the effect of dead-time, are considered. A procedure to derive the small-signal model of the motor, including the effect of inverter dead-time, is presented. Further, stability analysis is carried out on a 100-kW, 415V, 3-phase induction motor considering no-load. For voltage to frequency (i.e. V/f) ratios between 0.5 and 1 pu, the analysis brings out regions of instability on the V-f plane, in the frequency range between 5Hz and 20Hz. Simulation and experimental results show sub-harmonic oscillations in the motor current in this region, confirming instability as predicted by the analysis.

Open loop Model for WDM Links

Wavelength Division Multiplexing (WDM) techniques overfibrelinks helps to exploit the high bandwidth capacity of single mode fibres. A typical WDM link consisting of laser source, multiplexer/demultiplexer, amplifier and detectoris considered for obtaining the open loop gain model of the link. The methodology used here is to obtain individual component models using mathematical and different curve fitting techniques. These individual models are then combined to obtain the WDM link model. The objective is to deduce a single variable model for the WDM link in terms of input current to system. Thus it provides a black box solution for a link. The Root Mean Square Error (RMSE) associated with each of the approximated models is given for comparison. This will help the designer to select the suitable WDM link model during a complex link design.

A zero charge-pump mismatch current tracking loop for reference spur reduction in PLLs

The charge-pump (CP) mismatch current is a dominant source of static phase error and reference spur in the nano-meter CMOS PLL implementations due to its worsened channel length modulation effect. This paper presents a charge-pump (CP) mismatch current reduction technique utilizing an adaptive body bias tuning of CP transistors and a zero CP mismatch current tracking PLL architecture for reference spur suppression. A chip prototype of the proposed circuit was implemented in 0.13 mu m CMOS technology. The frequency synthesizer consumes 8.2 mA current from a 13 V supply voltage and achieves a phase noise of -96.01 dBc/Hz @ 1 MHz offset from a 2.4 GHz RF carrier. The charge-pump measurements using the proposed calibration technique exhibited a mismatch current of less than 0.3 mu A (0.55%) over the VCO control voltage range of 0.3-1.0 V. The closed loop measurements show a minimized static phase error of within +/- 70 ps and a similar or equal to 9 dB reduction in reference spur level across the PLL output frequency range 2.4-2.5 GHz. The presented CP calibration technique compensates for the DC current mismatch and the mismatch due to channel length modulation effect and therefore improves the performance of CP-PLLs in nano-meter CMOS implementations. (C) 2015 Elsevier Ltd. All rights reserved.

Neoarchean arc magmatism followed by high-temperature, high-pressure metamorphism in the Nilgiri Block, southern India

The Nilgiri Block, southern India is an exhumed lower crust formed through arc magmatic processes in the Neoarchean. The main lithologies in this terrane include charnockites, gneisses, volcanic tuff, metasediments, banded iron formation and mafic-ultramafic bodies. Mafic-ultramafic rocks are present towards the northern and central part of the Nilgiri Block. We examine the evolution of these mafic granulites/metagabbros by phase diagram modeling and U-Pb sensitive high resolution ion microprobe (SHRIMP) dating. They consist of a garnet-clinopyroxene-plagioclase-hornblende-ilmenite +/- orthopyroxene +/- rutile assemblage. Garnet and clinopyroxene form major constituents with labradorite and orthopyroxene as the main mineral inclusions. Labradorite, identified using Raman analysis, shows typical peaks at 508 cm(-1), 479 cm(-1), 287 cm(-1) and 177 cm(-1). It is stable along with orthopyroxene towards the low-pressure high-temperature region of the granulite fades (M1 stage). Subsequently, orthopyroxene reacted with plagioclase to form the peak garnet + clinopyroxene + rutile assemblage (M2 stage). The final stage is represented by amphibolite facies-hornblende and plagioclase-rim around the garnet-clinopyroxene assemblage (M3 stage). Phase diagram modeling shows that these mafic granulites followed an anticlockwise P-T-t path during their evolution. The initial high-temperature metamorphism (M1 stage) was at 850-900 degrees C and similar to 9 kbar followed by high-pressure granulite fades metamorphism (M2 stage) at 850-900 degrees C and 14-15 kbar. U-Pb isotope studies of zircons using SHRIMP revealed late Neoarchean to early paleoproterozoic ages of crystallization and metamorphism respectively. The age data shows that these mafic granulites have undergone arc magmatism at ca. 25392 +/- 3 Ma and high-temperature, high-pressure metamorphism at ca. 2458.9 +/- 8.6 Ma. Thus our results suggests a late Neoarchean arc magmatism followed by early paleoproterozoic high-temperature, high-pressure granulite facies metamorphism due to the crustal thickening and suturing of the Nilgiri Block onto the Dharwar Craton. (C) 2015 Elsevier B.V. All rights reserved.

Small-Signal Stability Analysis of an Open-Loop Induction Motor Drive Including the Effect of Inverter Deadtime

This paper demonstrates light-load instability in a 100-kW open-loop induction motor drive on account of inverter deadtime. An improved small-signal model of an inverter-fed induction motor is proposed. This improved model is derived by linearizing the nonlinear dynamic equations of the motor, which include the inverter deadtime effect. Stability analysis is carried out on the 100-kW415-V three-phase induction motor considering no load. The analysis brings out the region of instability of this motor drive on the voltage versus frequency (V-f) plane. This region of light-load instability is found to expand with increase in inverter deadtime. Subharmonic oscillations of significant amplitude are observed in the steady-state simulated and measured current waveforms, at numerous operating points in the unstable region predicted, confirming the validity of the stability analysis. Furthermore, simulation and experimental results demonstrate that the proposed model is more accurate than an existing small-signal model in predicting the region of instability.

Modelling and analysis of an open-loop induction motor drive incorporating the effect of inverter dead-time

The objective of this paper is to study the influence of inverter dead-time on steady as well as dynamic operation of an open-loop induction motor drive fed from a voltage source inverter (VSI). Towards this goal, this paper presents a systematic derivation of a dynamic model for an inverter-fed induction motor, incorporating the effect of inverter dead-time, in the synchronously revolving dq reference frame. Simulation results based on this dynamic model bring out the impact of inverter dead-time on both the transient response and steady-state operation of the motor drive. For the purpose of steady-state analysis, the dynamic model of the motor drive is used to derive a steady-state model, which is found to be non-linear. The steady-state model shows that the impact of dead-time can be seen as an additional resistance in the stator circuit, whose value depends on the stator current. Towards precise evaluation of this dead-time equivalent resistance, an analytical expression is proposed for the same in terms of inverter dead-time, switching frequency, modulation index and load impedance. The notion of dead-time equivalent resistance is shown to simplify the solution of the non-linear steady-state model. The analytically evaluated steady-state solutions are validated through numerical simulations and experiments.

Connecting Active-Site Loop Conformations and Catalysis in Triosephosphate Isomerase: Insights from a Rare Variation at Residue96 in the Plasmodial Enzyme

Despite extensive research into triosephosphate isomerases (TIMs), there exists a gap in understanding of the remarkable conjunction between catalytic loop-6 (residues 166-176) movement and the conformational flip of Glu165 (catalytic base) upon substrate binding that primes the active site for efficient catalysis. The overwhelming occurrence of serine at position96 (98% of the 6277 unique TIM sequences), spatially proximal to E165 and the loop-6 residues, raises questions about its role in catalysis. Notably, Plasmodium falciparum TIM has an extremely rare residuephenylalanineat this position whereas, curiously, the mutant F96S was catalytically defective. We have obtained insights into the influence of residue96 on the loop-6 conformational flip and E165 positioning by combining kinetic and structural studies on the PfTIM F96 mutants F96Y, F96A, F96S/S73A, and F96S/L167V with sequence conservation analysis and comparative analysis of the available apo and holo structures of the enzyme from diverse organisms.

"Evaluación del carbono almacenado en la biomasa y suelo del bosque tropical seco en el municipio de Nandaime, departamento de Granada, Nicaragua"

El dióxido de carbono es el más importante de los Gases de Efecto Invernadero, por la actividad humana, tanto en términos de su cantidad como de su potencial efecto sobre el calentamiento global. Este es producido cuando se usa combustible fósil para generar energía y cuando los bosques son deforestados y quemados. La vegetación arbórea es una fuente y a la vez un sumidero natural de CO2. El presente estudio se realizó en el municipio de Nandaime departamento de Granada 20 10, con el objetivo de evaluar el carbono almacenado en los componentes biomasa aérea, hojarasca y suelo en tres sucesiones de edad (9, 15 y 19 años), en bosque seco tropical. Se hizo un inventario forestal (fustal 200 m2 y latizal 25 m2). Se cortó el árbol promedio en fustales Se pesó y muestreo la biomasa aérea y hojarasca, en las cuales se determinó en laboratorio el porcentaje de humedad y contenido de carbono. La mayor cantidad de árboles fue en la edad de 9 años con 2,366.7 árboles/ha. Los promedios de diámetro en fustal fueron 10.92, 14.7 y 15.97 cm, para 9, 15 y 19 años respectivamente. Los promedios de diámetro en latizal fueron 6.29, 6.41 y 6.43 cm, para 9 15 y 19 años respectivamente. Los promedios de altura en fustal fueron 6.92, 10.21 y 10.78 m, para 9 15 y19 años respectivamente. Los promedios de altura en latizal fueron 5.25, 6.00 y 8.13 m, para 9 15 y19 años respectivamente. La mayor cantidad de área basal y volumen fue en la edad de 9 años con 38.66 m 2/a y 356.83 m3/ha. Según el índice de diversidad Shannon-Wiener y Simpson se determinó que el sitio más diverso en fustal fue la sucesión de 15 años de edad y el menos diverso el nivel de 19 años, en latizal el más diverso fue el de 15 años y el menos diverso el de 19. En la edad 19 años , se cuantifico la mayor cantidad de hojarasca con 5.69 t/ha, pero el mayor contenido de carbono fue en 9 años con 1.11 t/ha. En la edad 9 años, se cuantifico la mayor cantidad de biomasa y carbono en ramas y hojas con 206.82 y 37.49t/ha, respectivamente. Para fuste, se cuantifico la mayor cantidad de biomasa y carbono en la edad de 9 años con 149.98 y 47.63 t/ha, respectivamente. El carbono almacenado en el suelo fueron 22.5, 27.68 y 42.39 t/ha, para 9, 15 y19 años respectivamente. La tasa de fijación de la biomasa aérea fue 9.46, 7.11 y 6.23 t/año, para 9, 15 y 19 años respectivamente.

Comportamiento in vitro de tres variedades de papa (Solanum tuberosum L.) en tres variantes del medio básico de Murashige y Skoog (1962) y tres subcultivos

Actualmente el cultivo de tejidos vegetales como una de las técnicas más modernas en la agricultura, permite obtener elevados volúmenes de material vegetal de buena calidad para la siembra en numerosos cultivos, impactando directamente en el incremento de la calidad y rendimiento de las cosechas. El objetivo del presente trabajo fue evaluar el comportamiento de las variedades de papa Desirée, DT0-28 y Baraka en tres medios de cultivo: Ml (Sales MS + 0.5 mg/l * AIA + 0.2 mg/l Kinetina + 0.2 mg/1 Tiamina-HCL); M2 (Sales MS + 0.2 mg/l Tiamina-HCL) y M3 (Sales MS + 0.25 mg/l **GA3 + 0.2 mg/l Tiamina-HCL) y tres subcultivos continuos. Se evaluaron las variables Altura de plántula, Longitud de entrenudos y Número de hojas. Las tres variedades manifestaron una dinámica de crecimiento muy variada en los medios de cultivo y en los subcultivos, Desirée registró disminución del número de hojas en la medida que incrementaron los subcultivos. Igual tendencia mostró DT0-28. Por el contrario Baraka superó ligeramente el número de hojas en el subcultivo dos al obtenido en el subcultivo uno, alcanzando los valores más altos en el subcultivo tres. Desirée y Baraka presentaron un comportamiento aceptable en el medio dos y DT0-28 en el medio tres. *AlA = Acido lndolAcético **G3 = Acido Giberélico