Experimental Investigation On The Slip Between Oil And Water In Horizontal Pipes

This work is devoted to study of the slip phenomenon between phases in water-oil two-phase flow in horizontal pipes. The emphasis is placed on the effects of input fluids flow rates, pipe diameter and viscosities of oil phase on the slip. Experiments were conducted to measure the holdup in two horizontal pipes with 0.05 m diameter and 0.025 m diameter, respectively, using two different viscosities of white oil and tap water as liquid phases. Results showed that the ratios of in situ oil to water velocity at the pipe of small diameter are higher than those at the pipe of big diameter when having same input flow rates. At low input water flow rate, there is a large deviation on the holdup between two flow systems with different oil viscosities and the deviation becomes gradually smaller with further increased input water flow rate. (C) 2008 Elsevier Inc. All rights reserved.

Studies on two-phase co-current air/non-Newtonian shear-thinning fluid flows in inclined smooth pipes

In this work. co-current flow characteristics of air/non-Newtonian liquid systems in inclined smooth pipes are studied experimentally and theoretically using transparent tubes of 20, 40 and 60 turn in diameter. Each tube includes two 10 m lone pipe branches connected by a U-bend that is capable of being inclined to any angle, from a completely horizontal to a fully vertical position. The flow rate of each phase is varied over a wide range. The studied flow phenomena are bubbly, plug flow, slug flow, churn flow and annular flow. These are observed and recorded by a high flow. stratified flow. -speed camera over a wide range of operating conditions. The effects of the liquid phase properties, the inclination angle and the pipe diameter on two-phase flow characteristics are systematically studied. The Heywood-Charles model for horizontal flow was modified to accommodate stratified flow in inclined pipes, taking into account the average void fraction and pressure drop of the mixture flow of a gas/non-Newtonian liquid. The pressure drop gradient model of Taitel and Barnea for a gas/Newtonian liquid slug flow was extended to include liquids possessing shear-thinning flow behaviour in inclined pipes. The comparison of the predicted values with the experimental data shows that the models presented here provide a reasonable estimate of the average void fraction and the corresponding pressure drop for the mixture flow of a gas/ non-Newtonian liquid. (C) 2007 Elsevier Ltd. All rights reserved.

Did bankruptcy reform lead to looser mortgage lending standard? : evidence from the U. S. mortgage market 2000-2007

Resumen: El presente trabajo intenta encontrar una causa exógena al deterioro, a partir de 2005, en los estándares de crédito hipotecario que contribuyeron a la crisis subprime en los Estados Unidos. Sostenemos que la nueva provisión de la prueba de medios de la ley Bankruptcy Abuse Prevention and Consumer Protection Act (BAPCPA) de 2005 fue dicho shock exógeno en el mercado hipotecario. Mostramos que la prueba de medios, que impide solicitar la bancarrota bajo Chapter 7 a los deudores con mayores ingresos relativos, causó un desplazamiento de la oferta de crédito hipotecario de deudores con mayores ingresos a deudores con menores ingresos relativos. Simultáneamente, observamos que todos los deudores debieron pagar tasas de interés más altas, independientemente del nivel de ingresos. Nuestros resultados implican que la ley BAPCPA podría ser un factor que contribuyó al deterioro en los estándares de crédito en el mercado hipotecario de los Estados Unidos.

New Keynesian Model Features that Can Reproduce Lead, Lag and Persistence Patterns

This paper uses a new method for describing dynamic comovement and persistence in economic time series which builds on the contemporaneous forecast error method developed in den Haan (2000). This data description method is then used to address issues in New Keynesian model performance in two ways. First, well known data patterns, such as output and inflation leads and lags and inflation persistence, are decomposed into forecast horizon components to give a more complete description of the data patterns. These results show that the well known lead and lag patterns between output and inflation arise mostly in the medium term forecasts horizons. Second, the data summary method is used to investigate a rich New Keynesian model with many modeling features to see which of these features can reproduce lead, lag and persistence patterns seen in the data. Many studies have suggested that a backward looking component in the Phillips curve is needed to match the data, but our simulations show this is not necessary. We show that a simple general equilibrium model with persistent IS curve shocks and persistent supply shocks can reproduce the lead, lag and persistence patterns seen in the data.

A Simple Model For Predicting The Void Fraction Of Gas/Non-Newtonian Fluid Intermittent Flows In Upward Inclined Pipes

In this work, a simple correlation, which incorporates the mixture velocity, drift velocity, and the correction factor of Farooqi and Richardson, was proposed to predict the void fraction of gas/non-Newtonian intermittent flow in upward inclined pipes. The correlation was based on 352 data points covering a wide range of flow rates for different CMC solutions at diverse angles. A good agreement was obtained between the predicted and experimental results. These results substantiated the general validity of the model presented for gas/non-Newtonian two-phase intermittent flows.

Lead accumulation by hammerhead shark, Sphyrna couardi (C.) off Lagos coast, Nigeria

Levels of concentration of lead in the hammerhead shark, Sphyrna couardi, off the Lagos Coast of Nigeria were investigated. The standard length of the specimens examined ranged from 31.4cm to 47.2cm while the weights ranged from 451.5 to 1,667g. The lead concentration ranged from 0.11 degree kg/G to 0.38 degree kg/G. The mean lead concentration was 0.56 degree kg/G (dry weight). The gill has the highest lead concentration. There was no linear correlation between the length and weight and the amount of lead concentrated

Investigation on average void fraction for air/non-Newtonian power-law fluids two-phase flow in downward inclined pipes

The present work has been carried out to investigate on the average void fraction of gas/non-Newtonian fluids flow in downward inclined pipes. The influences of pipe inclination angle on the average void fraction were studied experimentally. A simple correlation, which incorporated the method of Vlachos et al. for gas/Newtonain fluid horizontal flow, the correction factor of Farooqi and Richardson and the pipe inclination angle, was proposed to predict the average void fraction of gas/non-Newtonian power-law stratified flow in downward inclined pipes. The correlation was based on 470 data points covering a wide range of flow rates for different systems at diverse angles. A good agreement was obtained between theory and data and the fitting results could describe the majority of the experimental data within ±20%.

Optimización del Lead Time de vehículos mediante la implementación de una solución RTLS (Real Time Location System)

A lo largo de este documento, se va a explicar la implantación del proyecto que he realizado basado en la localización de vehículos en la fábrica de Mercedes Benz España situada en Vitoria-Gasteiz. Durante la realización de este proyecto, se han llevado a cabo diversos estudios con el fin de conseguir la correcta implantación de las tecnologías empleadas. Se han realizado diferentes alternativas de posicionamiento de los componentes y diversas pruebas para comprobar el correcto funcionamiento de la solución. La solución del proyecto se realizará en distintas fases. La primera de ellas tratará sobre el estudio en una determinada zona de la fábrica, más concretamente la denominada “Área Técnica”, en esta zona se encuentran los vehículos que sufren algún retoque una vez están montados, esta zona se utilizará como piloto para una vez finalizado y comprobado su éxito ampliar la solución al resto de zonas. Previamente a mi incorporación se realizó un estudio para la colocación de los elementos necesarios en esta zona y se ha visto las posibilidades y beneficios que aportaría el control de los vehículos dentro de la fábrica. La siguiente fase será implantar la solución en el resto de las áreas que se encuentran dentro de la fábrica de Vitoria-Gasteiz así como la instalación de unos dispositivos que estarán ubicados en las puertas. Estos ayudarán a mejorar la ubicación de los vehículos ya que podremos conocer si los vehículos se encuentran dentro o fuera de la fábrica. Finalmente se ha realizado la integración de la solución en los sistemas actuales que utilizan en la fábrica para la gestión de los vehículos durante su ciclo de vida.

Noninterferometric measurement of lead zirconate titanate inverse piezoelectric extension

A noncontacting and noninterferometric depth discrimination technique, which is based on differential confocal microscopy, was used to measure the inverse piezoelectric extension of a piezoelectric ceramic lead zirconate titanate actuator. The response characteristics of the actuator with respect to the applied voltage, including displacement, linearity, and hysteresis, were obtained with nanometer measurement accuracy. Errors of the measurement have been analyzed. (C) 2001 Society of Photo-Optical Instrumentation Engineers.

High temperature transport properties of lead chalcogenides and their alloys

This thesis describes a series of experimental studies of lead chalcogenide thermoelectric semiconductors, mainly PbSe. Focusing on a well-studied semiconductor and reporting good but not extraordinary zT, this thesis distinguishes itself by answering the following questions that haven’t been answered: What represents the thermoelectric performance of PbSe? Where does the high zT come from? How (and how much) can we make it better? For the first question, samples were made with highest quality. Each transport property was carefully measured, cross-verified and compared with both historical and contemporary report to overturn commonly believed underestimation of zT. For n- and p-type PbSe zT at 850 K can be 1.1 and 1.0, respectively. For the second question, a systematic approach of quality factor B was used. In n-type PbSe zT is benefited from its high-quality conduction band that combines good degeneracy, low band mass and low deformation potential, whereas zT of p-type is boosted when two mediocre valence bands converge (in band edge energy). In both cases the thermal conductivity from PbSe lattice is inherently low. For the third question, the use of solid solution lead chalcogenide alloys was first evaluated. Simple criteria were proposed to help quickly evaluate the potential of improving zT by introducing atomic disorder. For both PbTe1-xSex and PbSe1-xSx, the impacts in electron and phonon transport compensate each other. Thus, zT in each case was roughly the average of two binary compounds. In p-type Pb1-xSrxSe alloys an improvement of zT from 1.1 to 1.5 at 900 K was achieved, due to the band engineering effect that moves the two valence bands closer in energy. To date, making n-type PbSe better hasn’t been accomplished, but possible strategy is discussed.

Pulse NMR in solids : chemical shift, lead fluoride and thorium hydride

Part one of this thesis consists of two sections. In the first section the fluorine chemical shift of a single crystal CaF_2 has been measured as a function of external pressure up to 4 kilobar at room temperature using multiple pulse NMR techniques. The pressure dependence of the shift is found to be -1.7 ± 1 ppm/kbar, while a theoretical calculation using an overlap model predicts a shift of -0.46 ppm/kbar. In the second section a separation of the chemical shift tensor into physically meaningful "geometrical" and "chemical" contributions is presented and a comparison of the proposed model calculations with recently reported data on hydroxyl proton chemical shift tensors demonstrates, that for this system, the geometrical portion accounts for the qualitative features of the measured tensors.

Part two of the thesis consists of a study of fluoride ion motion in β-PbF_2 doped with NaF by measurement of the ^(19)F transverse relaxation time (T_2), spin lattice relaxation time (T_1) and the spin lattice relaxation time in the rotating frame (T_(1r)). Measurements over the temperature range of -50°C to 160°C lead to activation energies for T_1, T_(1r) and T_2 of 0.205 ± 0.01, 0.29 + 0.02 and 0.27 ± 0.01 ev/ion, and a T_(1r) minimum at 56°C yields a correlation time of 0.74 μsec. Pressure dependence of T_1 and T_2 yields activation volumes of <0.2 cm^3/g-mole and 1.76 ± 0.05 cm^3/g-mole respectively. These data along with the measured magnetic field independence of T_1 suggest that the measured T_1's are not caused by ^(19)F motion, but by thermally excited carriers.

Part three of the thesis consists of a study of two samples of Th_4H_(15), prepared under different conditions but both having the proper ratio of H/Th (to within 1%). The structure of the Th_4H_(15) as suggested by X-ray measurements is confirmed through a moment analysis of the rigid lattice line shape. T_1 and T_2 measurements above 390 K furnish activation energies of 16.3 ± 1.2 kcal/mole and 18.0 ± 3.0 kcal/mole, respectively. Below 350 K, T_(1r) measurements furnish an activation energy of 10.9 ± 0.7 kcal/mole, indicating most probably more than a single mechanism for proton motion. A time-temperature hysteresis effect of the proton motion was found in one of the two samples and is strongly indicative of a phase change. T_1 at room temperature and below is dominated by relaxation due to conduction electrons with the product T_1T being 180 ± 10 K-sec. Using multiple pulse techniques to greatly reduce homonuclear dipolar broadening, a temperature-dependent line shift was observed, and the chemical shift anisotropy is estimated to be less than 16 ppm.