Relação entre força muscular e função motora em pacientes com distrofia muscular de Duchenne: acompanhamento de quatro anos

OBJETIVO: Investigar a relação entre força muscular e função motora, em pacientes com DMD, em um período de 4 anos consecutivos, a partir de avaliações semestrais. MÉTODO: A força muscular foi medida por meio de testes manuais e o cálculo por grupo muscular seguiu o proposto pelo Medical Research Council (MRC) e a função motora pelo método de Medida da Função Motora (MFM), em 43 pacientes (8-30 anos). Foi realizada uma análise descritiva e o teste de correlação de Spearman. Foram investigadas as relações entre pontuações totais e parciais da MRC e da MFM. RESULTADOS: O estudo evidenciou correlações classificadas de moderada a forte relação entre a força muscular e função motora, principalmente com o escore total da MFM e a dimensão D2 (musculatura axial e função motora proximal). Foi encontrada relação negativa moderada entre idade e essas variáveis. CONCLUSÃO: A perda progressiva da função motora tem relação direta e proporcional com a diminuição da força muscular. Quanto maior a idade do paciente, pior sua função motora e força muscular, fornecendo com essa informação, indicadores adicionais da progressão da doença

The comparison of maximal and endurance strength of quadriceps femori in trained and untrained elderly

The purpose of this study was to examine the differences in knee extensor maximal and endurance strength in elderly. Sixteen healthy elderly served as subjects, eight of them trained , age 61.0±8.9 yrs; height, 170.6±6.8 cm; weight, 71.8±11.7 kg [mean ± standard deviation] and eight untrained 61.4±8.1 yrs, height 174.6±7.4 cm; weight 83.9 ±14.2 kg. Maximal strength in single leg extension exercise was measured unilaterally with the dominant leg until the subjects reached their 1 Repetition Maximum (RM) covering the full Range of Motion (ROM). Muscular endurance was obtained with a load of 75% of 1-RM for 3 consecutive sets, with 2 min rest periods till failure. Load at 1 RM was lower in absolute terms in untrained, but not significant, while the relative 1-RM test was significantly lower in untrained subjects (0.20 vs. 0.25 kg load/kg body weight) (p<0.05). The number of repetitions and amount of weight lifted performed of all 3 sets was higher in trained subjects, but not significant. In the trained group both repetitions and the load managed in the third set was significant lower compared with the first two sets. The result that maximal force output is more affected compared to muscular endurance in these subjects might be due to the habitual use of quadriceps femoris muscles during activity of daily living in both trained and untrained elderly.

Correlação entre força muscular do assoalho pélvico, função sexual e qualidade de vida em mulheres de meia idade

Introduction: Menopause is characterized by the depletion of ovarian follicles and the gradual decline in estradiol levels, which ends with the definitive cessation of menstrual periods (menopause). As a result of hypoestrogenism, characteristic symptoms, such as hot flashes, night sweats, vaginal dryness, dyspareunia, insomnia, mood swings and depression can be observed. There is also the weakening of the pelvic floor muscles (MAP) as a result of progressive muscle-aponeurotic and connective atrophy with consequent decreased sexual function. Objective: To evaluate the strength of MAP, sexual function and quality of life of menopausal women. Methodology: This is an observational, analytical, cross-sectional design. The sample consisted of 55 women (35 postmenopausal and 20 perimenopausal), aged between 40 and 65, who were assessed by muscle strength and perineometry test. For the assessment of sexual function and quality of life, used the Female Sexual Function Index (FSFI) and Utian Quality of Life (UQOL), respectively. Statistical analysis was performed using Pearson's correlation and multivariate analysis. Results: The mean age was 52.78 (± 6.47 years). Sexual dysfunction presented, 61.8% of participants (43.62% of postmenopausal and perimenopausal 18.17%). Muscle strength test and the maximum perineometry had a median of 3.00 (Q25: 2 e Q75: 4) and 33,50 cmH20 (Q25: 33,5 e Q75: 46,6), respectively. No correlation was found between sexual function and muscle strength (r = 0.035; p = 0.802) and between sexual function and perineometry (r = 0.126; p = 0.358). The mean total score of UQOL was 74.45 (± 12.23). Weak positive correlation was found between sexual function and quality of life (r = +0.422 p = 0.001). Multivariate analysis identified associations between sexual function and variables: quality of life, climacteric symptoms, physical activity and education level. Conclusions: These results suggest that the climacteric symptoms, quality of life, physical activity and level of education are associated with sexual function in menopausal women. However, the muscular component of sexual function needs to be further investigated in this context.

Efeito do treinamento muscular inspiratório com diferentes cargas na força e função de músculos respiratórios

Background: The inspiratory muscle training (IMT) has been considered an option in reversing or preventing decrease in respiratory muscle strength, however, little is known about the adaptations of these muscles arising from the training with charge. Objectives: To investigate the effect of IMT on the diaphragmatic muscle strength and function neural and structural adjustment of diaphragm in sedentary young people, compare the effects of low intensity IMT with moderate intensity IMT on the thickness, mobility and electrical activity of diaphragm and in inspiratory muscles strength and establish a protocol for conducting a systematic review to evaluate the effects of respiratory muscle training in children and adults with neuromuscular diseases. Materials and Methods: A randomized, double-blind, parallel-group, controlled trial, sample of 28 healthy, both sexes, and sedentary young people, divided into two groups: 14 in the low load training group (G10%) and 14 in the moderate load training group (G55%). The volunteers performed for 9 weeks a home IMT protocol with POWERbreathe®. The G55% trained with 55% of maximal inspiratory pressure (MIP) and the G10% used a charge of 10% of MIP. The training was conducted in sessions of 30 repetitions, twice a day, six days per week. Every two weeks was evaluated MIP and adjusted the load. Volunteers were submitted by ultrasound, surface electromyography, spirometry and manometer before and after IMT. Data were analyzed by SPSS 20.0. Were performed Student's t-test for paired samples to compare diaphragmatic thickness, MIP and MEP before and after IMT protocol and Wilcoxon to compare the RMS (root mean square) and median frequency (MedF) values also before and after training protocol. They were then performed the Student t test for independent samples to compare mobility and diaphragm thickness, MIP and MEP between two groups and the Mann-Whitney test to compare the RMS and MedF values also between the two groups. Parallel to experimental study, we developed a protocol with support from the Cochrane Collaboration on IMT in people with neuromuscular diseases. Results: There was, in both groups, increased inspiratory muscle strength (P <0.05) and expiratory in G10% (P = 0.009) increase in RMS and thickness of relaxed muscle in G55% (P = 0.005; P = 0.026) and there was no change in the MedF (P> 0.05). The comparison between two groups showed a difference in RMS (P = 0.04) and no difference in diaphragm thickness and diaphragm mobility and respiratory muscle strength. Conclusions: It was identified increased neural activity and diagrammatic structure with consequent increase in respiratory muscle strength after the IMT with moderate load. IMT with load of 10% of MIP cannot be considered as a placebo dose, it increases the inspiratory muscle strength and IMT with moderate intensity is able to enhance the recruitment of muscle fibers of diaphragm and promote their hypertrophy. The protocol for carrying out the systematic review published in The Cochrane Library.

Effect of explosive mixture on quality of explosive welds of copper to aluminium

The aim of this research is to investigate the influence of explosive ratio and type of sensitizer on the quality of explosive welds between copper and aluminium alloy plates. The welds were performed on a partially overlapping joint configuration using an emulsion explosive (EE) with two different sensitizers, hollow glass microspheres (HGMS) and expanded polystyrene spheres (EPS). Welds with an improved surface were achieved by using the HGMS sensitizer. A higher wave amplitude was registered in welds produced with the EPS sensitizer. In turn, the dimension of the molten pockets was influenced by the explosive ratio, increasing in size with increases in the values of this parameter. The intermetallic content of these zones varied according to the sensitizer type. Unlike the CuAl2 phase, the Cu-richer phases CuAl and Cu9Al4 were only identified in welds performed using the EPS sensitizer. An increase in hardness was observed at the interface of all welds, which resulted from both the presence of intermetallic phases and the plastic deformation of the materials promoted by the impact. This effect was most evident on the aluminium alloy side. All the welds had a greater strength than copper, i.e. the weakest material of the joint. (C) 2016 Elsevier Ltd. All rights reserved.

Efeitos do Dynamic Tape na prevenção da sensação retardada de desconforto muscular no quadricípite

Projeto de Graduação apresentado à Universidade Fernando Pessoa como parte dos requisitos para obtenção do grau de Licenciado em Fisioterapia

Efeito do encurtamento muscular dos flexores da anca na actividade muscular dos extensores da anca, durante uma tarefa de agachamento, em jovens jogadores de futebol

Projeto de Graduação apresentado à Universidade Fernando Pessoa como parte dos requisitos para obtenção do grau de Licenciado em Fisioterapia

Comparación entre los efectos de un programa de entrenamiento de fuerza explosiva mediante bandas elásticas y un programa de entrenamiento con electro-estimulación de cuerpo completo

El objetivo del presente estudio fue analizar los cambios en el rendimiento en función de dos métodos de entrenamiento, el desarrollado mediante electro-estimulación muscular integral (EMI) frente a otro en el que se utilizaron bandas elásticas y que denominamos entrenamiento funcional con elásticos (EFE). La muestra estuvo compuesta por un grupo de diez (N=10) personas físicamente activas (23,04 ± 2,5 años). Se utilizó un diseño cuasi-experimental con medidas pre-post. Y fueron analizados los resultados de las pruebas: salto vertical con ayuda de brazos; y velocidad de desplazamiento en una carrera de ida y vuelta de 12 metros de distancia (6+6). Se realizó un análisis descriptivo de casos y medias. Y dado el tamaño de la muestra se calculó el tamaño del efecto, el cual fue bajo o moderado (d<0,5). Por último se compararon las diferencias de las medias de los grupos mediante la U de Mann Whitney, y las diferencias de las medias en función del tiempo (pre-post) mediante Friedman; en ambos casos los resultados no fueron significativos (p<0,5). En cuanto a los valores descriptivos del pre-post en ambos grupos: el grupo que entrenó con bandas elásticas obtuvo mejores resultados en ambas pruebas que el grupo que entrenó con EMI. En conclusión, el entrenamiento con bandas elásticas, a pesar de no ser significativo, parece mostrarse más efectivo que el entrenamiento con electro-estimulación muscular integral. Si bien, dadas las limitaciones del estudio estos datos hay que tomarlos con la pertinente cautela.

Efectos del tipo de recuperación sobre la oxigenación muscular durante el ejercicio de sentadilla

El objetivo de esta investigación es comprobar los cambios en la oxigenación muscular del recto anterior durante la realización del ejercicio de sentadilla según el tipo de recuperación. Para ello, 11 sujetos varones bien entrenados fueron distribuidos aleatoriamente a tres grupos experimentales: grupo que realiza recuperación pasiva con 2 minutos de descanso (GC), grupo que realiza recuperación activa hasta la estabilización de oxígeno (GA), grupo que realiza recuperación pasiva hasta la estabilización de oxígeno (GP). Todos realizaron la sentadilla hasta los 90º al 65% del 1RM con un 80% del carácter del esfuerzo (CE) (4x10). Los resultados muestran que el tiempo de reoxigenación (TrecSmO2) fue inferior significativamente en GA (77,94 ± 11,08) que en GC (p<0.001). En las inclinaciones medias de ejecución y reoxigenación el GA obtuvo los menores y mayores valores respectivamente y de forma significativa respecto a GC (p<0.001). Estas dos variables obtuvieron una relación inversamente proporcional con una r=-0.9585 (p<0.001). Estos resultados muestran una mejor reoxigenación en el grupo que realizó descanso de forma activa. Se muestra una relación inversamente proporcional entre la inclinaciones de ejecución y recuperación por lo que cuanto más rápida y completa sea la desoxigenación más lenta resultará la reoxigenación. Además, la saturación de oxígeno puede ser un factor de la fatiga neuromuscular y su control durante el entrenamiento de fuerza podría facilitar los objetivos de entrenamiento. Estos resultados muestran, a priori, una mejor recuperación entre series a nivel oxidativo cuando los sujetos realizan una recuperación de forma activa, en comparación con la pasiva.

The mechanical strength of phosphates under friction-induced cross-linking

Purpose: In the present study, we consider mechanical properties of phosphate glasses under high temperatureinduced and under friction-induced cross-linking, which enhance the modulus of elasticity. Design/methodology/approach: Two nanomechanical properties are evaluated, the first parameter is the modulus of elasticity (E) (or Young's modulus) and the second parameter is the hardness (H). Zinc meta-, pyro - and orthophosphates were recognized as amorphous-colloidal nanoparticles were synthesized under laboratory conditions and showed antiwear properties in engine oil. Findings: Young's modulus of the phosphate glasses formed under high temperature was in the 60-89 GPa range. For phosphate tribofilm formed under friction hardness and the Young's modulus were in the range of 2-10 GPa and 40-215 GPa, respectively. The degree of cross-linking during friction is provided by internal pressure of about 600 MPa and temperature close to 1000°C enhancing mechanical properties by factor of 3 (see Fig 1). Research limitations/implications: The addition of iron or aluminum ions to phosphate glasses under high temperature - and friction-induced amorphization of zinc metaphosphate and pyrophosphate tends to provide more cross-linking and mechanically stronger structures. Iron and aluminum (FeO4 or AlO4 units), incorporated into phosphate structure as network formers, contribute to the anion network bonding by converting the P=O bonds into bridging oxygen. Future work should consider on development of new of materials prepared by solgel processes, eg., zinc (II)-silicic acid. Originality/value: This paper analyses the friction pressure-induced and temperature–induced the two factors lead phosphate tribofilm glasses to chemically advanced glass structures, which may enhance the wear inhibition. Adding the coordinating ions alters the pressure at which cross-linking occurs and increases the antiwear properties of the surface material significantly.